Saturn - Ion :: 2003 - Makes Grinding Sound?
Apr 29, 2015
This car makes this grinding sound whenever you first start the car in the morning on a cold day and take a left turn. After 5 minutes it won't do it anymore. I can't tell if it's coming from the transmission but that's what one mechanic said. He said it was the transmission but he couldn't target where. His first diagnoses was the struts but that proved incorrect so I'm taking what he says with a grain of salt.
VIDEO WITH SOUND : [URL]......
This car has the notorious GM lawsuit CVT transmission..
View 6 Replies
Advertisement
2003 Saturn Vue V. 61,000 miles. Drives ,steers and turns normally except when you do a very tight 360 circle. Tremendous grinding sound and shuddering coming from the rear of the vehicle. Return to driving a straight line and everything returns to normal. What is the issue and what would it cost to repair?
View 1 Replies
I have a 2001 saturn l200. On monday I went outside to start the car and I heard clicking sound coming from motor. I did have a new battery put in. As so I push on the gas a little bit I hear it clicking as soon the car warms up its stop clicking and i did have a oil change done...
View 5 Replies
I have a 1996 Saturn SW2. When I turn hard left at a bit of speed (like about 20 mph), the left read end of my car makes a BOING sound... what could be causing this??
View 2 Replies
I have a 2012 L100 Saturn with just over 189K miles (yes, it's been an awesome car). In October 2012 I both sets of breaks replaced plus rotors. About 2 months after the service, I started hearing a knocking and grinding sound coming from the bottom of the car, about 80% of the time when I apply the breaks. The car does not make the sound if idle or while accelerating. The knocking seems to be loud at times and less present other times. The grinding sounds like a large wire cable is being pulled right underneath the car.
I took it back to the break place and they replaced the Master Cylinder under the warranty. The sound went away for about a month and then came back with about the same frequency. Took it back to the same place and this time they replaced the Wheel cylinder. Sound again went away, but this time came back 2 days later. I'm puzzled because for some reason the sound seems to go away and come back when the car is serviced. It;s also not consistent, but it's there. Not sure what it could be related to if not the break job. I'm bracing myself for some really bad news as this car has been a life saver since I bought it.
View 1 Replies
We got the clutch replaced on our 1996 Saturn several weeks ago and ever since we get grinding when shifting from 2nd to 3rd. The mechanic said the synch ring was shot and it wasn't their fault...this problem did not exist before the replacement. Whether this sounds plausible and what we can do to rectify i
View 18 Replies
I have a 2007 Toyota Camry 4 cylinder and the ABS light comes on intermittently. Not only does the light come on, but sometimes when I apply the brakes, the brake pedal makes a grinding, vibrating sound that I can hear and feel under my foot, and feels as if the brake pedal is going to go all the way to the floorboard. If I quickly pump the brake, it stops that sound and the brake works fine.
I have taken the car to O'Rileys and Firestone and they put it on the analyzer. Two codes come up which indicate that the right front ABS was bad and/or an open circuit. I replaced the ABS sensor, but the problem described above persists. I took it back to Firestone and the same codes displayed. Firestone said it was an open circuit and that I should take it to the Toyota Dealer. I called the Dealer and they want $135 to analyze the car. They won't tell me what they will do in the analysis. I also took it to Just Brakes and they kept it for 3 days and could not or did not do much other than suggest I take it to the Dealership. I have read that the Dealership will probably say the ABS computer needs to be replaced ($1,000). I have also read that the 2007 Camry Hybrid ABS brake system has been recalled, although my Camry is NOT the hybrid.
There has had two fender benders on the left front side and the right front passenger tire hit a curb which bent the tire, but the tire has been balanced (not sure if the wheels were damaged in these minor accidents or if the wheels could be causing this?) Other thing that occurred right before the ABS light started coming on, and the brake issue, is that the air conditioner went toes up, and there were small metal fragments within the air condition housing unit. I replaced the whole A/C unit. I haven't been able to assess if one would have anything to do with the other, but it is interesting that the ABS and brake issue all started within a few days of the A/C unit being replaced.
View 1 Replies
I have a 2001 Ford F-250 with the gas v-10. Yesterday it started just fine as always. Today I get into it and it starts to turn over just fine then starts to make a grinding sound and the truck won't start. I have had a fuel issue in the mornings with once it started you had to barely press the gass to keep it running. But never makes a funny sound and always runs fine. This only last for a couple of min and then it runs fine for the rest of the day. The grinding is not the starter. I took it off and had it checked and it was fine.
The truck had been using oil. When I checked the oil level it was low but it was still on the stick. "I know a motor needs oil to run smooth but it's my dads truck and well let's just say he is not the best on maintenance". Also I smelled the oil and it does have a gas smell to it. So it definitely does have some gas in the oil. I tried to light the dipstick with a lighter and it wouldn't light. So not sure how much gas is in it but that's what I did.
So the question is, would something just in mid crank go bad and then not let the motor crank. Truck made no weird noises before this so I find it hard to believe the barrings just went out in mid crank and now it is shot.
Also I just checked compression on front cylinders.
Driver side read 75lbs
passenger side read 100lbs
View 4 Replies
I have a 2003 f150 4X4. Whenever I go around a round about slowly, the truck sort of grind under the frame and shakes a little bit like I am in 4 wheel drive.
View 2 Replies
2005 Chevy Malibu
When the driver side door is opened there is a clunk sound about half way through the swing. When the door is closed there is a couple clunks then a thud. The sound is coming from the front of the door.
What is causing this and does it mean big trouble soon?
View 11 Replies
I have a 97 F150, 2wd, 4.6, auto bought for a great price agout 3 months ago.... I installed a cold air intake (air raid) and a throttle body spacer with the swirling cuts.
Since the cold air intake add, the truck occasionally makes a load "roaring" sound from the intake system. At same time rpms increase 500-1000 rpms...
it doesn't do it all the time, mostly at low throttle, and a quick jab on the accelerator usually stops it. sometimes such as when parking, holding the brake and applying a bit of throttle with load from the brake will also stop it.
Guys at local garage seem to think it has something to do with lower outside temps, (denser) and addition of cold air intake. it made the noise before the throttle body spacer.
View 4 Replies
When I turn on my fan for the AC or vent or heat, it works just fine on the first and second settings. When I move the fan speed to the third and last speed, I hear this sound that sounds like the blower fan is hitting something. I turn the speed back to the lower two settings and noise goes away. Sometimes I turn it back to the higher settings and the noise actually will go away but most of the time the noise is there.
I pulled the blower motor out yesterday and set it to where I can turn it on while out of the compartment and I didn't really notice a noise. I wonder if the noise is there but I am just not hearing it since it is not enclosed in the compartment? I also noticed there is a crack in the fan where it mounts to the shaft starting at the shaft and extending out one direction and also 180 degrees the other direction. Thoughts on if the motor is bad or just the fan? Or even something else that I may not be seeing?
View 4 Replies
I have a 2003 Saturn Vue, been a pretty car, bought used. It has been making this obnoxious moaning sound when I turn the steering wheel. Had one mechanic say he thought it was some bearings? But I would have to bring back (was having something else fixed at the time). I am financially challenged at the moment, and I am concerned this is going to be costly. The sound doesn't seem to be affecting the mechanics of the car, it is just annoying.
View 5 Replies
My 2001 4.6L F-150 has been sitting on the driveway, used once every 2 weeks or so for the last 3 yrs. I came to start it a few days ago and it kept turning over but not starting. The key security chip is working, battery is charged, all plugs are firing, fuel pump fuse and relay check good. When I turn the key to ON, sometimes I hear the fuel pump priming, other times it doesn't. The times it does prime, the truck fires right up.
The times it doesn't prime, engine won't start. When the pump does prime, and while the engine is running, the pump makes a noticeable buzzing sound, much louder than normal. When the pump primes. fuel pressure measures at 42psi in the ON position, 36psi with engine running, and 46psi with engine running and vacuum hose removed. I believe all these are within specs.
My question is this: Is it safe to assume that the pump is going bad and will eventually fail completely? My second question is (and I know this can be debated til the end of time) should I get the Motorcraft or aftermarket? I have Airtex, Spectra, Carter, and Delphi available locally.
View 4 Replies
I've got an 03 Camry (211K mi.) with front and rear disk brakes. I have a pulsing/grinding sound from the rear brakes. I think the pulse is from the run-out of the disk/rotor. Took it to a Toyota dealership last year and they pulled apart, cleaned and lubricated the parking brake assemblies on both sides. Brakes ran quiet for about 3 months and then the noise came back. When the climate is dry, it makes all kinds of noise. When it's humid (above 80%) or raining it's quiet. It still stops good and there is no pulling to one side or another, so I figure my calipers aren't leaking.
I bought the car used a little over 3 years ago and don't know when the last brake job was done. I was going to replace the front and rear disks and pads and inspect the calipers for cracked cups or seals. I was talking to an old school mechanic and he said something about opening the bleeder line(s) when I compressed the cups or I'd damage the ABS control. I looked at my manual and it said nothing about this. I'm not looking to replace the ABS controller because of a silly mistake on my part. Looking for info about cracking the bleeder when compressing a caliper??
View 10 Replies
My car just started making a grinding noise when accelerating. It does not make it while maintaining a constant speed or revving the engine in neutral. I never had this problem before and I am at a loss to explain it. Car is 1995 Camry for what that is worth.
View 4 Replies
Fearing the worse here on my 2011 Prius Four, not IV. When I press the "on" A/C button I hear a grinding noise for about two seconds. Seems to be coming from a low area in engine.
View 15 Replies
I have a 2003 Impala, total mileage little of 122,000 miles, I bought the car back in Dec 2014. When I bought the car I got all the paper work on the work the dealership did on the car prior to me buying it. One of the things they did was put new brakes and rotors on the front. Since then I have replaced the backs. However after about 4-5 months I notices that from the front passenger side when I had to slam on the brakes or was braking from high speed I would hear a grinding sound coming from that area. I have taken it to two places and both have inspected both the wheels and rotor's and say they are fine, they commented that the pads were not the best but more then adequate for this car. Of course when they drove it around it didn't happen and it doesn't always happen. Both places said it could be the pads or rotors but without replacing them there is no real way to tell. How can they both be viewed as good and in good condition and I get this grinding sound from the one front wheel from time to time when I break.
View 12 Replies
Back in December i purchased a 2003 Impala LS. It has about 103,000 miles on it now. Overall the car runs and drives great. However on very rare occasions I have noticed if I have to slam on the brakes or really break hard I hear a grinding sound. Now I have only heard it maybe 3 times in the time since buying the car and never hear anything under normal braking. I had the brakes checked and was told they didn't see anything wrong, but what might cause this grinding sound I have heard a few times?
View 6 Replies
My 03 Jetta TDI wagon, with 210,000 miles, had a grinding sound about 10% of the time when I braked, BUT ONLY AT UNDER 5 mph...that is the last couple of seconds before completely stopping. The car braked fine, but the periodic grinding worried me. Two weeks ago, my mechanic couldn't reproduce it; today, however, we did and he identified it as the ABS (and I remembered that sound from the couple of times the ABS has kicked in during winter driving. But my question was safety, and my mechanic says the car brakes fine...he has checked them all around and driven with me...and the fault is the ABS system and not the brakes themselves. Need to verify this? The car runs fine (I am the original owner, and for the first 7 or 8 years had it solely dealer maintained) and I plan a road trip this summer, but I need a little more comfort that the ABS acting up won't result in a more serious problem.
View 2 Replies
01 Passat v6 150K tiptronic. When cold, the tranny makes an occasional grinding noise however when at operating temp it runs fine with no slippage. Changed the fluid/filter and added lucas treatment. It worked a little but my mech said to warm up the car before driving. Might be the torque converter?
View 3 Replies
