Touareg :: 2012 - Headlight Beam Jiggle With Sharp Bumps
Feb 10, 2012
I have the 2012 Touareg with adaptive head and LED accent lights. I have observed that when the road has sharp bumps and you are going slow enough to observe your light pattern on the ground, the lights, the LEDs I believe, appear to be "Jiggling". I realize there must be a more technical term for it but I would think from the oncoming traffic the appearance would be reminiscent of the old motorcycle light heads that were never very tight and would appear to bounce or "Jiggle" up and down as they approached. The dealership says they all do it and it is because the LEDS are mounted in plastic and the plastic is vibrating.
View 2 Replies
Advertisement
My 04 Toureag has one headlight (low beam) that flickers on and off. I can shut the door and it will flicker on. This happens both for daytime running lights as well as regular headlights. It also at times registers on the dash that a light is burnt out. Yet all the lights are on and working.
View 1 Replies
I drive a 96 Subaru Legacy. What does it mean when one of the high beams is dimmer (less light output) than the low beam? I am using a brand-new bulb. It's not an adjustment issue because I was looking at the bulb when it was outside of the housing and it clearly gets dimmer when you switch to brights. However, they are equally bright when on low-beam, so I don't think its just a crossed wire.
View 2 Replies
Took my 2010 with 10,250 miles to the Dealer yesterday because there is an uncomfortable "tinny" rattle heard under the car when driven over sharp bumps and dips (rough road). Almost like a loose brake shield. At oil change I made mention of this and a missing fastener and nut clip was thought responsible. This time I had a test drive with the mechanic and we verified it was on both sides having done several passes on the same road hazard. After a period of trouble shooting in the shop, a decision was made on the front struts, but none in stock. Brought it back this morning for the replacements and was found not to be the problem.
This is one of those noises you can duplicate on the road, but not easily in the shop. Have had no accidents or run overs, and the car is in perfect condition otherwise. It is not the oil door.
View 12 Replies
I am experiencing issues with front shocks RS2 Coilovers. I have this knock occurring from both front shocks. If they're set the softest, they're the worst...knocking noises over all small sharp bumps or sharp dips in the road. If I set them to full stiff and you drive it immediately after the ride is stiffer, but smoother, almost no noise at all, only when driving over roads that throw weight from side to side quickly will create the knock, but very light. However after a while of driving it just starts to make noise again as if they're unwinding on there own. When I check their position, they're where I left them. It feels as if the shock pressure bleeds until I perform the same routine and it feels tight again for a short period.
Its starting to annoy me now, car has 6000km on it and 600 km on the coilovers.
View 10 Replies
2003 passat gl; 1.8t w/all new front control arms, replaced to cure suspension noise, now metallic clatter persists, but any (even) light application of brake pedal and noise stops.. it is most apparent over sharp bumps...
View 3 Replies
Problem #1: So I've noticed a clunking when I go over sharp bumps or uneven road conditions (think roots under the pavement) at low speeds, such as in a parking lot. The noise is only under the front left tire well area, and the car drives smooth and great otherwise. Is it a bad joint? The closest dealership is over an hour away, so I want to make sure I'm driving there with a real reason. The MDX has about 130K, transmission is great, and new timing belt, so I'm scared it's some sort of axle/joint problem...
Problem #2: The check emissions light came on about two days ago. I have filled up since, but it hasn't gone away. There is not a smell from the exhaust, and there is no rattling. Gas mileage hasn't changed one bit either! What could it be?? The car has been restarted quite a few times, but the light comes on each time.
View 2 Replies
I've had a clinking sound at the front of my car when driving over sharp bumps like seams or cracks ever since about 6k miles. I only notice it with the windows down. I used to think that it was the coils on my Nuespeed sport springs hitting each other, but after I got coilovers and the noise didn't change I was sure that it wasn't the springs. When talking to my mechanic on the phone he suggested that I see if the problem goes away if I apply the brakes when driving over something that causes the noise, and sure enough the noise isn't there when braking.
View 1 Replies
I know lots of you say these stock Rancho's suck, but I'm wondering if it's just the ride that improves? I have some clunking under the truck when I go over "sharp" bumps that normally I would say is something loose or maybe a bad ball joint...except I have it in the rear as well. Is that a symptom of these stock ranchos? I don't mind the stiff ride, it's the noise that's bothering me.
View 3 Replies
When I'm driving over sharp bumps I hear what sounds like a small chain jingling around. I took off the hubcaps and jacked up the car to see if anything loose. I grabbed the exhaust pipe and shook it, but it didn't make any noise. I couldn't see anything that would cause it. The front right strut's rubber cover is off so could the strut make that noise?
I just read a few posts with similar problems, but one was a compression sound and another was a knock, and another was a metallic hick up. Mine is literally like a loose high pitch chain noise and change rattling in your pocket. No uniformity to the sound. But it also only happens over quick small bumps not large ones like speed bumps.
View 5 Replies
I have a 2012 Hyundai Accent GLS and recently noticed that my low beam only works in the high beam setting and the high beam doesn't work.
View 10 Replies
09 stx 2wd 4.6L- I have a 2.5'' leveling kit and 33'' bfg a/t tires. The problem is when I make sharp turns, or turn and go over small bumps. Whats happening is something seems to catching or rubbing it kind of jerks towards the opposite of where I am turning and causes the traction control to slow my truck (sucks on tight off-ramps/ u-turns). this happens at pretty much any speed although it gets worse as speed increases. At first I thought it was the steering stoppers but don't have any wear on them, tires do not rub anywhere. My dealer and a local off road shop cant figure it out...
View 9 Replies
My passenger side low beam head light is dim. I changed the bulb and still have the same issue. High beams are ok.
View 4 Replies
I am planning to replace the headlight (high beam) light of my 2006 Toyota Camry. The original OEM light lasted for nearly 6/7 years.
I noticed in some forum that "Sylvania 9005SU SilverStar Ultra High Performance Headlight Bulbs" is good, but it has short life of less than 1 year.
View 9 Replies
So I finally got my car back after being repaired from the fender bender I was in, and I had to get a new right headlight but I just noticed that the beam pattern isn't right. I just picked up the car and brought it home so I'm not sure if this is a characteristic of a new headlight and bulb. I feel like they put in the wrong bulb or they didn't install it correctly?
View 4 Replies
On my W8 sedan the passenger low beam is out and it looks like its an HID headlight... How do you change them in these cars? Also is it HID? It's odd sometimes it is on and sometimes it is not, but today I think its out completely...
View 4 Replies
Where the adjustment knobs are for the low beam specifically? 07 Santa Fe 3.3L.
View 6 Replies
I have a 2006 VW Passat which has been eating low beam bulbs. I've probably replaced this one 4 times in the last 12 months. The last time I replaced was 2 days ago with a Sylvania bulb. Yesterday on my way to work it burnt out. Then on my way home last night I was pulled over by a cop for it. That really annoyed me.
Having issue with Passat burning through headlight bulbs? Do I need to have the wiring assembly checked or possibly replace the entire headlight assembly? I'm getting really tired of changing these bulbs so often.
View 7 Replies
In December, 2013 I got two new bulbs - according to the invoice they were Xenon D4S. Around July, 2014 the driver side headlight would stay on for 20-30 seconds or so and then go out. I took it to the shop that installed the lights and they said they replaced the headlight and gave me back the car. I noticed that night that the problem wasn't fixed.
I took it back to them and they said it must be the ballast. At this point, I don't trust them, because they didn't stand to gain anything from replacing the bulb as parts and service were under warranty, so I'm not convinced they actually did anything (especially given that they didn't even test it before giving me the car back).
About 2 weeks ago, I noticed that the same thing is happening on the passenger side, and they both go off at the same time. I find it hard to believe that both ballasts would go out and the timing would be identical. The problem is, now, I cannot test it by switching the bulbs from right to left because they both do the same thing. According to Xenon Depot there are a lot of Phillips counterfeits - does that apply to Xenon bulbs as well?
Should I buy new headlights and try to install them? I'm looking at Xenon Depot [URL] .... and it looks like the D4S Xenon bulbs, but there are other bulbs. I don't know which ones to buy. Is it likely that the problem is electrical because they both go out at the same time?
View 4 Replies
My front low beam headlight is out and I only have 2,500 miles on the car. Was it replaced under warranty? If not how can I find out how to replace it myself?
View 8 Replies
When I make low speed sharp turns, (like trying to make a U or K turn) the Treg kind of "lurches". Is this common? Is there a fix?
My Treg is a V8 PPS and is one of the first here in the US (took delivery 7/7/03).
View 2 Replies
