I have an automatic 2002 Echo. Like 2 or 3 days ago I started hearing a noise when I drive in reverse. Is a mix of friction and vibration and it gets louder the faster I drive, only in reverse. I read that this could be the symptom of a bad engine mount but I haven't been able to pinpoint it.
View 1 RepliesI'm troubleshooting my sons 2000 Echo with a manual transmission. No reverse light. Very puzzling? The red wire with blue stripe in the trunk area is always hot. Makes no difference if the shifter is in reverse gear or not. Yet, the reverse lamps don't come on. I removed both bulbs and tested them at the battery using jumpers. They both come on. I have not gone under the car yet. My question is: does this car have a neutral start switch, and a back up light switch. If yes, which switch is feeding the other? Any pictures of where these switches are located? My guess is that the back up light switch is faulty, if there is one.
View 4 RepliesMy car started popping out of reverse a little while ago and its started happening more often. I asked my mechanic uncle about it and he said its probably the synchronous. From my understanding, that means a rebuild of the tranny. I just got this car in Nov after writing off my Corolla in Oct. Is there anything else minor I could check?
View 3 RepliesI have a 2002 Toyota Echo. I just purchases a Creader V code scanner. My car is throwing a P0171 code. The light only comes on at idle or while going under 10 mph.
The data from the reader was:
Trouble Code: P0171
Fuel System sta B1 : CL, using HO2S
Calculated Load: 11.76%
Coolant Temp 188.59 degrees
The Freeze frame data was:
ST Fuel B1: -3.91%
LF Fuel B1: 36.7%
Engine speed: 795.5 RPM
Vehicle speed: 0 mph
Intake Air Temp: 82.4 degrees.
I went back today and ran live feed on the O2 sensors. I'm not sure what STF of O2S: STF means. That was another figure displayed on my code scanner.
The O2S S1 was reading between .04 and about .82. The graph looked pretty normal (I guess) in regards to going up and back down between 0 and 1. I don't know alot about mechanics, but I seen a youtube video of a graph showing it going up and down and what is normal. Mine did that on S1.
O2S S1: STF was: 3.89 and -1.57%
O2S: S2 was a different story. It was between like .58 and .66.
The O2S S2: STF didn't give me a value at all. It just said " --% ". The graph of this was slowly going up but in a small range. It started at like maybe .4 and would go up to say .5. The next wave would be like .45 to .55, then .50 to .60, then .58 to .66 etc. So it was not ranging just between 0 and 1. It had a very tight range that gradually increased upwards.
I built my own smoke machine before testing with the code scanner and I didn't get any smoke coming out of the car except for around the air filter housing where the lid meets the bottom portion. I don't know if it's because I had the air filter wrapped in plastic wrap. Can I have an air leak where the filter cartridge connects that would case a lean code P0171? Maybe I should go try to smoke test again. I did it about 3 weeks ago and I can't recall exactly where I had the smoke going into. I thought I disconnected the PVC hose from the brake booster and plugged it in there. I assume the smoke would get thru the whole system. It took about 2 min before the smoke came out of the filter housing.
The car only sets a lean code at idle or going less than 10mph and I'm coasting in a residential area.
I have an inspection coming up in May and need to get this thing fixed before that. I can't find any other air leak, but I wasn't sure a leak around the filter would cause this and I'm not sure the leak wasn't caused by the plastic wrap.
I'm thinking my only other prob could be fuel related. Fuel filter, fuel pump, clogged injector, or can my O2 sensor be bad and causing this? I've already replaced all spark plugs and coils as well as the PVC valve and cleaned the MAF sensor with the appropriate spray.
The car runs ok. The exhaust seems to smell RICH. Like Gas. I don't think my fuel economy is as good as it use to be. It has dropped from as hi as 42 mpg to between 38 and 40 if I'm lucky.
Back when I was having problems before and realized I had a bad coil, I had tried some injector cleaner. Why the codes were back then, but I had erased them and the car ran fine for about 2 months and the light came back.
My MAF sensor was .14 lbs when I was watching the live data above. I plugged my fuel pressure tester directly into the fuel line coming from the fuel tank and got a reading of between 42 and 44 lbs (car not running, just by trying to turn the engine over). I don't know if that is as accurate (or useful) as having the fuel pressure tester on the car and in line to allow the car to start up and run and watch the tester. I have to wait until my part comes do run the test that way.
I have a 2001 Toyota echo 2001 210.200 km and my output shaft bearing makes noise and I cant know the level of my transmission fluid bcoz I don't have dipstick and i bought trans 75w90 oil os that ok and how can I add this?
View 1 RepliesJust bought little Echo and it's blowing hot air when the ac is on if I turn the ac off with the selector in the blue it's still hot. I used the gauge off a old ac recharger can and its showing the right amount of Freon and the compressor clutch is spinning. I am really wanting to fix it cheap , since I got it for 1200.
View 2 Replieshow to remove the headlights from an '02 echo? I'm trying to paint the headlight bezel, and can't seem to get the headlights out.
View 2 RepliesMother in laws car had a bad misfire that goes away during idle. It seems to misfire during take off or slowing to a stop and Intermittently during cruise.
Came in with codes p0300 - random misfire and p0304 misfire cylinder 4
What I have done so far.
-Checked the oil
-Checked the plugs - they were bad so replaced them with ngk plugs
-part number - BKR5EGP
Misfire was showing in cylinder 4 on live data still
-Swapped coil 4 and 1
-Misfire moved to cylinder 1
-Swapped cylinder 1 with 3 to be extra sure and mis stayed on 1
-Swapped back to 4 and even 2 mis stayed in 1. Weird
-Pulled all plugs and checked compression getting 170psi
-Swapped plugs around in case 1 is faulty no luck
-Swapped number 1 and 2 injectors with no change.
So my thoughts now are leaning towards an ecm or a valve thing but would those not be on or off fails? It idles great and cruises great it's only bad we coming to and leaving stop.
My 2002 Echo Sportivo is losing power on hills,which is bad news as live in a hilly district. If I don't get a run up i.e lights change it's 40km/h all the way with my foot to the floor and lots of angry drivers behind me. Apart from this runs well?
View 1 RepliesFirst car is an '02 echo and has some things that need to be done. Small exhaust leak, but i don't know where the leak is, how to find it, new one? Where to get replacement taillights, hole in mine.
View 3 RepliesMy Echo died on me this morning and would not restart. I was at a light at the time. I pushed it aside, waited a bit and it restarted. I made it to work and it died again after several hiccups along the way. It then died in my parking spot but would restart. It has 192k miles on it.
It was acting weird earlier this week in that it would lose power (not electricity) while moving and then continue on. It seemed to work if I gave it more throttle. I feel like its fuel related but I don't have a lot of spare money to guess at the problem unsuccessfully.
How to change a 2003 toyota echo blower motor.... Looking for a step by step directions ....
View 2 RepliesI am buying a Toyota Echo that the engine shakes on Idle and the shaking increase a bit when the AC is On ....
View 2 RepliesHow do you remove a right rear 2001 Toyota echo tail light assembly?
View 1 RepliesI have a 2000 Toyota Echo. Symptoms are, the car drives fine until warmed up. Once warmed up, about 10 min or so, there is surging, an inability to maintain idle, periodic loss of brake assist, all consistent with my p1349 code. This happened about two months after I changed my oil (the old oil was in there for an embarrassingly long time). I ran motor flush and again changed the oil; symptoms persist. I have removed the OCV and OCV screen; both look fairly clean. Here's the question: what checks can be done on the OCV itself before I call a bad OCV and replace it? The service manual was of only marginal quality in explaining any checks.
View 2 Repliesis it possible to install an analog temperature gauge on a 2001 Toyota Echo? I live right on the Canadian border here in Mn. and it gets very cold. I have plenty blast from the heater fan but I don't think it's running warm enough. I had a new thermostat installed but it didn't seem to make any difference.
View 1 Replieshow to remove the gear shift console on a 2001 TOYOTA ECHO?
View 1 RepliesI have a 2002 echo 1.3 vvti - will it has been running great and has 200000km on clock . However today i started it it ran for about 1 min then i heard a beeping from under the bonnet, the engine then stopped. The car will start and run for less than a sec then die. will not run no matter how much i play with the throttle .
View 2 RepliesI just bought a 2002 echo recently and it started smoking blue. The car has 135000 miles which seems low to me to be blowing smoke so soon. I grew up around cars since my dad was a mechanic so I checked the compression on a cold engine. Cyl. 1 was 117psi, cyl. 2 was 134, cyl.3 was 127 and cyl. 4 was 117. I realize they are low but the car is blowing a pretty good amount. The car drives pretty good overall and seems to have power, i drove it on the freeway a few times and did 80mph fairly easy. I was wondering if this could possibly be valve stem seals gone bad? I will check the pcv valve as well. I really like the car and have read a lot of good things about the echo.
View 14 RepliesI have a 2002 Echo sedan. I'd like to remove the rear seats completely for more storage (I am a musician). I was able to get the bottom foam off, but the seat "backs" are more stubborn. I see there are two bolts on the floor frame in the middle of the seat backs, and one bolt on each side of the seats where they meet the doors/frame. I tried to remove the bolts on the metal floor, but they do not budge... One socket wrench sheared right off while trying to spin it loose, and when I used a socket bit on my drill with an impact wrench attachment, it still wont budge... Are they locktitied in?
View 1 RepliesMy horn doesn't work consistently. Problem started about 6 months ago. Airbag never been deployed. Never wrecked the car. No liquids ever spilled on steering wheel. There is nothing that could be identified as a precipitating event.
View 8 Replies