I have 93 cavalier 2.2l will start up and run for 5 or 10 min then start sputtering and then will stop running acts like it has bad gas, but once it does this it will not start for rest of the day will start next morning. I have seen liquid coming out of tail pipe.
View 1 Replies2003 Cavalier auto 116K miles - Car is sputtering and stalling at stoplights with a/c on. What can I check?
View 6 RepliesMy sister has a 98 chevy cavalier and it is sputtering i changed the fuel filter but that did not work.
View 6 RepliesMy car dies when I come to a stop unless I gently press on the gas pedal while holding done the brake. What can cause this?
View 4 RepliesI have a 1996 Chevy Cavalier, which I purchased used Two years ago, and lately I've been having a problem with it. I live in the area where Temps rub pretty high here. Recently, with three digit weather, my car stalls when I'm in stop and go traffic. I would have to turn off the car and restart it. The car temp gauge in car doesn't show the car overheating. What is the possible cause of the car stalling?
View 1 RepliesOur '93 Escort, Gilligan, (1.pL, 125K, manual and under our ownership for less than 6 months) has recently developed the shameful habit of chugging and glugging during acceleration, most specifically second and third gears, with the occasional hiccups at cruising speeds. If Gil is driven a little "harder" then there is little issue with sputtering, but then we are killing our MPG and beating the crud out of his motor. Using a careful foot there are better "zones" that can be found via the accelerator than others, but no "safe zone".
He has had several bottles of fuel injector cleaner, new spark plugs (the wires looked fairly new and clean), fuel filter and a replacement ignition coil pack, so these have been ruled out. I thought it might be the Mass Air Flow Sensor, so I drove him around with it unplugged, but that made no difference. If there is a clog in a injector is it possible to "flush" it out or would he require a more in depth cleaning?
Recently my car has been sputtering a bit after I start it. It starts fine, but it sputters like it is going to run out of gas, but it's always at least 1/2 full.
To get it to stop I have had to pull over, turn it off, and restart it after a few minutes of running, then I haven't noticed anything again until the next morning when I start it again.
One time it turned off by itself when I stopped it and put it in park.
If at all possible we'd like to repair it ourselves, but we are not sure what could be wrong.
Our thoughts are: clogging/clogged fuel filter or spark plug issues. What could be causing this sputtering?
Again, it is not constant, as after restarting I continue to drive almost 60 miles to work, then back home in the evening with no issues yet. It has stopped once, but never while moving.
My 2010 LE has been having this issue for a little while now. Whenever I start up the car when the engine is still warm, (an hour or two after initially driving it), the engine will sputter for around 3-4 seconds, but will always start up. On cold starts, like every morning, the car will start normally. There are no noticeable rpm problems while driving either.
View 2 Replies 93 explorer 215000 miles on it runs like a champ 99.9% of the time. I am on my way home today on the highway going 75mph when all of sudden it started slowing down and sputtering. I quickly pulled over and as I did the car shut off. When I was pumping the pedal nothing would happen. I initially thought fuel pump is dead as I dont know if its been replaced. 45 minutes later on the side of the highway after multiple times trying to start, it does and I cruise the next 20 miles home no problems at all????
Got home started it a few times, NO PROBLEMS!
I'm having some serious trouble with a 2000 4Runner with the 5FVZFE V-6 with 165,000mi. The engine is bogging down/ sputtering and dying on startup, won't drive over apx. 20-30mph, doesn't seem to want to shift up or down, and won't rev past 3000rpms, stopped or driving. I've been a mechanic for awhile and never seen this issue before. But here's the kicker... I'm in bfe Afghanistan, have almost no access to parts (if I do it takes quite awhile to get them and even the easy stuff is hard to find), no diagnostic comp, and only the tools in my toolbox, air compressor, and solvent tank.
View 4 RepliesCar won't start after filling up with gas. I have tried a new fuel filter, new gas tank cap, checked for pressure on fuel pump. We have gottenit to start (but barely) when either hit gas tank with hammer or shake the back of the car, otherwise you have to set and wait 15-30 minutes before it will start and when it does it smells very weird (like it's flooded but an extra strange smell with it). I have seen a similar posting on here and someone suggested it might be a purge value problem. In talking with someone at auto store they didn't think this was the issue. I do have my check engine light on all the time and when checked the code , it said oxygen sensor. My two other Cavaliers have also had the oxygen sensor problem but it never did this with that code.
View 9 RepliesHad a directional bulb go out recently and replaced it without any problem. About 3 days ago it went again, I bought a 2 pack of bulbs - replaced it and drove on. Almost instantly right after I turned and signaled the right directional bulb blew again, I grabbed the extra bulb put it into plug and started car - first right turn with directional bulb blows again. I'm at a loss as to where this can be happening. Is this in the steering column or elsewhere, where do I even begin to look.
View 3 RepliesMy daughter says that the AC on her 2001 Chevy Cavalier cuts off when she is idling.
View 4 RepliesI have a 2004 Chevy Cavalier. I am having some issues with it.
When it first starts it idles really hard. The RPMs are up and if will try to accelerate without hitting the gas. This stops after the first minute.
The second part is that when stopped, but in drive, it idles hard. It does it though when the AC is turned off. You can see the RPM gauge go above and below the normal 500 RPM. If you turn the AC on then it levels out. It will occasionally idle hard with the AC on, but rarely and not as much.
The car drives well and is not overheating.
The cold air box is a black plastic box that sits forward of the engine/valve cover. It connects via black plastic tube to the air filter box on one end and to the engine on the other. I took it off it. 'Lo and behold it was full of oil.
View 1 RepliesSo I'm driving to work this morning, 35 miles one way, and I get to my destination, or almost. 1999 Cavalier, automatic transmission, 215,000 miles.
As I get to the red light where I need to turn, it seemed as if it was not upshifting on its own. It is an automatic. I made the turn, then made another turn and as I pressed the gas, it seemed to do the same, not wanting to shift into second.
As I turned to go up to the second level of the parking lot, it gave up about 3/4 of the way up to level 2. Pressing the gas just revved the engine. I tried switching into 1, 2, back to D, even to R, but nothing worked. It is like it just gave up and decided the only thing that would work is neutral.
When I switch into gear normally, you hear that slight thud as it falls into gear, but when I try it now, nothing happens.
What's going on with my '93 240. When I first go out to start my car in the morning, it starts up fine. After that, however, is when the trouble begins. If it's hot out, or if I've driven the car that day, there's a 50% I'll have trouble keeping the engine running. The engine will run rich, and chugs on startup, eventually stalling out after a few revolutions. During this time, the engine revs low, don't have a tac so I can't say how low, but definitely below idle.
If hold the accelerator to increase the RPM, the engine will run fine, but once I let off the gas, chances are it will stall out again. Eventually, after doing this a few times, something seems to catch the car as it begins to stall again, as in, just before the car is about to stall, the idle speed kicks up to normal. After that, the car runs fine.
I've had a code for the MAF for a long time. I tested the resistance across the meter, and it indicates the wire is still good. Even at that, I've replaced the MAF, but nothing has changed. Still have the same problem. What could be causing this?
I have a 2001 Chevrolet Cavalier. I've been getting a pulsing vibration which feels like the left front. It starts at about 40mph and gets worse the faster I go. The vibration completely goes away with the slightest left turn on the freeway. It vibrates on acceleration and deceleration, in neutral and in gear (5spd manual). I've currently replaced the front struts, strut mounts, pads and rotors, left front wheel bearing, tie rod ends, had the front end aligned and the tires balanced.
View 2 RepliesRecently I had my check engine light come on in my car as well as a service light. My car is at 140,000 miles and I drive it around the county for work so I knew I would have some expensive repairs in my future. My stepdad disconnected my car battery and then reconnected it which caused the light to go out so my mechanic was not able to read the code to find the issue. (We did find that my service light was coming on right before my headlight went out so I replaced the bulb and have not had the service light come back on since.)
My mechanic let me know my catalytic converter pipe was rusting and falling on my exhaust and gave me an estimate for the cost of a new pipe, O2 sensor and labor charge. He quoted the catalytic converter pipe at $304.25 and with everything else involved, the total for my estimate came to $521.00.
I have read before that some people suggested possibly finding a used pipe at a salvage yard to save money on the repair. I called around and found a place that would sell it to me for around $100.00. I'm not handy with cars and know the bare minimum when it comes to repairs, so what I don't know is if it is safe to use a pipe from a salvage yard compared to buying a new one.
So, starting about 2 months ago my car started starting kind of hard and the CEL came on. It would crank for a few seconds, start to turn over but sound like it was going to sputter out, but ultimately turn over. It seemed to be exacerbated the longer the car sat between times running. I let the car sit for about a week while I was waiting for parts to come in to change out my front brakes, and now it won't start.
I hooked up my newly acquired OBD II reader and got the following DTCs:P0130 - O2 Sensor Circuit Malfunction Bank 1 Sensor 1P0130 P - Same, P for PendingP0336 - Crankshaft Position Sensor A CKT Range/PerformanceP0340 - Camshaft Position Sensor A Bank 1 Circuit Malfunction
Based on my limited understanding, I would think something having to do with the last two codes would be why the car isn't starting, but it seems like it could also easily be something else not directly indicated by those codes. So what I'm wondering is, do I need sensors replaced, or is there something else that needs to be replaced on the car. The car has ~130k on the odo.
I recently bought an 2003 manual transmission Cavalier which looks and drives great, albeit for one (hopefully minor) issue:
The front end repetitively squeaks like a squeaky toy (does not sound like metal-on-metal) when driving. The squeaking is not constant ("Squeak....") but has a rhythm (Squeak....Squeak...Squeak...Squeak...Squeak). The tempo of the squeaking increases the faster I go and appears to be loudest (or most annoying) around 30 mph. In addition, some bumps will cause the squeaking to occur, but the squeaking will return to its original rhythm immediately afterward. The squeaking sounds similar/equal distance whether I'm driving or riding in the passenger seat.