We have an 86 Chevy Silverado C10, all of the lights work on the truck except the headlights. We have replaced the switch, it has new head lamps. We hear that there is no fuse for these lights, that there is a circuit breaker but how to locate it or if it is really the issue. How to get the lights back on?
View 2 RepliesWhile raising both front doors windows, both windows stopped moving. Checked power locks and they didn't work either. Manual said to reset circuit breaker for this problem but where it's located and the manual doesn't specify either. Just need to know where the circuit breaker for the power windows and locks is located.
View 1 Repliescourtesy "dome" lights do not work when doors are opened or when dash switch is activated. Fuse (under driver seat) and Relay switch have been replaced. Can hear relay switch activated with dash switch. Lights work individual (toggle style ceiling lights). Dash lights dim with dash switch.
View 1 RepliesOur son has a 97 Chevy C/K pickup truck and told me about a problem that I thought was easy to solve, and we tried, but it wasn't. The driver's side front turn signal flashes fast. I checked the rear lights on that side and the turn signal wasn't working at all, let alone the tail lights, so I replaced the bulbs. They're the kind with the 2 filaments. I noticed the old bulbs were covered with some nasty yellow corrosion. Now the turn signal problem is the same and still no brake light on that side but he has tail lights at night. I tried to clean up the corrosion in the circuit board (none on the bottom light, which is the reverse light) with a neighbor's wire brush but it didn't change anything, so he suggested I change the circuit board.
View 6 RepliesHaving issues with the gauges in my truck. Usually only in the mornings, the tach will quit working and the speedo will go to 70 or 80 (this morning 100), the check gauges light comes on and the tranny is stuck usually in 3rd (auto). The indicator light for the gearshift (P,R,D,3,2,1) also goes out. I swapped out the fuel injector spider a while back and that's when the problem began.
View 1 RepliesI have a 1999 Chevy Suburban. The blower fan for the heater/AC was only working on high so I replaced the resistor and relay at the same time. Still no change so I replaced the switch and 30 amp fuse. The first three settings worked but not the high. I checked continuity of the wires between the switch and relay and they were fine. I then thought it might be the blower fan which I replaced but still not working on high.
View 4 RepliesThe truck has a 300 straight 6 and runs pretty good until you turn the headlights on or anything that uses current for that matter ie. Radio , Fan ect. But is worst with lights. Just got the truck last week and can't seem to figure this one out.
View 1 RepliesI recently purchased for my son a 1986 camaro 2.8 MFI v6 the car had been sitting for over a year in the previous owner's back yard because it would not start.I have had a mechanic do the following: heads redone, replace the distributor, replace the timing chain and gears, new wires, and emptied the fuel tank and replaced the fuel filter.
I picked up the car and it ran for about two week no problem. Then it started diying occasionally when you let of the gas to come to a stop, so he replaced the fuel relay switch thinking that it may be going bad. The next day he had been driving it about 15 miles when it just died and would not restart. We shot a little starting fluid to see if we could get it to start and get it back home. it fired up and ran all the way home and died when turning into the driveway. and would not start again.
We replace the fuel regulator the car started right up and he took it for a test drive. The car ran about 4 miles, long enough to warm up and died again and would start. and again we were about to get it started with starting fluid to get it back home. pulled in the driveway and it dies. again it would not start, let it sit all night and the next morning still would not start finally got it to start with a squirt of starting fluid and moved it into the garage. shut if off and then tried to start it and it worked 5 times in a row.
A friend of mine has an 86 Chevy 1/2 ton, all origional. His problem is that the truck is "slow" going into reverse, but once there, feels "solid". I haven't personally looked at the truck, and am not sure what his concept of "slow" is. I understand there's probably not enough information to determine the cause, but it doesn't hurt to try.
View 7 RepliesI have 1986 Gold Corvette, which now has Antique Virginia Plates. I had a terrible Vibration at 65 - 75 MPH that would shake the car so bad I could not drive it more than 20 minutes and I could not tell if it was in the front or the back.
I had the following installed: Front and Rear Wheel Bearing/Hub Assembly (Timken), Front and Rear Brake Rotors, Front and Rear Rebuilt Calipers, Front and Rear Hawk/ Wellman HPS Brake Pads and four Stainless Steel Brake Hoses.
Now the vibration is about half-gone, but still shakes the GoldVette at 65 - 75 MPH, and I still cannot tell if it is in the front or the back.
A few years ago, I replaced the Rack-in-pinion and Tie Rod Ends. What do I replace next to eliminate the vibration so that I can drive it about 100 miles?
i got a 1986 chevy g20 conversion van for camping trips and the dash lights and tail lights don't work but the turn signal works and the brake lights work and the headlights work i put in a new fuse and they worked for about 5 minutes then quit working there did apper to be a little watter in one of the tail light bulbs if that works.
View 2 Replies86 Diesel Suburban
Lately the voltage gauge sometimes starts to wander upwards toward the 18v red zone. When it does it wanders up and down a lot, but mostly well above the center 13v. Sometimes I left of the throttle a little and it goes back and stays at normal, and sometimes it doesn't and bounces up again as soon as I press the throttle. Doesn't happen on every drive, just sometimes.
I thought it unlikely this was a bad voltage regulator, since it's a pretty new alternator, 2 years tops. So I thought I'd see what other possible causes could be. (Why do they make the voltage regulator internal to the alternator now anyways, since they seem to go bad more often than the core? Can I just add an external regulator like the older trucks had?)
I've heard over-voltage can ironically sometimes be caused by a short, since the regulator dumps more voltage into the field coils because the main coils are showing they aren't delivering enough current (because it's all being soaked up by the short), resulting in an overall over voltage as the alternator tries to compensate for the voltage drop of the short.
How do I tell if this is the cause of the overvoltage or if it's something else instead? If it is a short, where could it be? I'm assuming it must be somewhere weird, because almost any normal place I could think of for a short would simply blow a fuse. Or is there such a thing as a partial short-- high enough resistance to not blow a fuse, but low enough to drive the alternator nuts?
Could it be related to overheating? I initially thought that was a possibility, because it began around the time the weather turned warm here, but on any given day it seems pretty random and not tied strongly to excessive speed or going up hills.
I have a 1986 Chevrolet El Camino with a small V-8 engine. The vehicle has 150,000 miles on it. It starts and runs fine. It does not use oil. My problem is the oil pressure. After the car runs for a short time, the oil pressure starts dropping. It will drop all the way to 0 if I let it. I have had the sending unit replaced and it did not work.
I have had two mechanics look at it and they have not been able to solve the problem. One checked it with a mechanical gauge and confirmed the low pressure. He suggested a higher weight oil and an additive. The other mechanic's solution was to raise the idle speed. I have had this vehicle since it was new and always kept the oil changed and all other maintenance done. I would like to keep the vehicle and complete any repairs necessary.
My question: Is the engine repairable economically or does the engine need to be replaced and what is causing this problem.
I have a 86 K5 Blazer. Six years ago put a new gm 350 a rebuilt trans. and had all the work performed for inspection. Truck was run once or twice over the years. This winter I got it on the road to push snow. I ran the blazer once for about 12 hours pushing snow, on the way home I thought I had a problem with the trans. Took the k5 out today 2/20 to pick up my kid at a neighbors house. Started out fine but at the large steep hill my k5 lost power. I pulled over to check the blazer over. It was idling fine but when I would rev the engine it was muffled. I drove up the rest of the hill (barely)and picked up my kid. On the way back I was quickly throttling the gas pedal which seemed to give little bursts of power. I am thinking that I have an airflow problem.
View 11 RepliesI got a 1986 chevy g20 conversion van and I am having a problem with it once in a while it will stall out after putting it into gear it does not do this a lot but it does happen also smells like its running rich and until it warms up while the van is in park you can hear a intermittent click sound goes click click............................click...click no real rhythm just kinda does it then stops when in any gear besides park friend said it could be a small backfire. The engine is a 350 V8 4 barrel carbed.
View 1 RepliesI have a 1986 Monte Carlo SS with 305 HO engine. Recently when driving along suddenly I have hot air blowing out of the vents, then in a few minutes it goes back to the cool air. This happens whether it is set to vent or air conditioner. How can I fix it??
View 8 RepliesI just purchased an 86 turbo diesel jetta. The low beams aren't working. First of all, I must admit, how to turn them on. Second, the problem is probably not the bulbs, since the bulbs seam fine. I would like to try and fix this myself.
View 3 RepliesI have a 97 chevy and the only way to start it is to jump the starter relay, not sure if it is the key switch ot the nuetral saftey switch.
View 2 RepliesI have a 1997 Chevy C1500 with about 85k miles on it. I had the breaks checked and replaced over a year ago and this problem is pretty recent. When I got the brakes done I had the pads replaced on the front disks and I had the back drum pads and some brake part replaced that was inside the drum. Looked like a little hydraulic piston of sorts (sorry, not to up on my car lingo here lol)
My issue is my ABS light comes on from time to time for no apparent reason at all (at least that I notice). I can be just sitting at a stop light and I will notice it comes on, stays on, then randomly will go off. The car seems to break fine, especially at higher speeds (30-70mph). On occasion however at low speeds (5-15mph) when coming to a some what sudden stop my brakes seem to skip? Kind of feels like a grinding feeling. No gravel or slick road, just plane ol pavement. I think this is the ABS system but Ive only ever driven one other car with ABS breaks that the I believe the ABS system activated while stopping on ice and it felt the exact same.
I have not noticed if the light comes on during these low speed stops, as I am just now putting all these pieces of a puzzle together to figure out if something is really wrong with my ABS system or if its just a sensor or something.
I have a 1997 Chevy C1500 with about 85k miles on it. I had the breaks checked and replaced over a year ago and this problem is pretty recent. When I got the brakes done I had the pads replaced on the front disks and I had the back drum pads and some brake part replaced that was inside the drum. Looked like a little hydraulic piston of sorts...
My issue is my ABS light comes on from time to time for no apparent reason at all (at least that I notice). I can be just sitting at a stop light and I will notice it comes on, stays on, then randomly will go off. The car seems to break fine, especially at higher speeds (30-70mph). On occasion however at low speeds (5-15mph) when coming to a some what sudden stop my brakes seem to skip? Kind of feels like a grinding feeling. No gravel or slick road, just plane ol pavement. I think this is the ABS system but Ive only ever driven one other car with ABS breaks that the I believe the ABS system activated while stopping on ice and it felt the exact same.
I have not noticed if the light comes on during these low speed stops, as I am just now putting all these pieces of a puzzle together to figure out if something is really wrong with my ABS system or if its just a sensor or something.
I would like to have some knowledge or information in case I have to take it to a mechanic to have it looked at. The last people (Just Breaks) I took it to really tried to screw me over. After they worked on it the Emergency break light was on and his fix was to just "unplug" the sensor. I said Heck no! Fix it! after three bleeds it tripped the sensor off. So I am a bit hesitant to have them looked at after that experience.
I don't have power 12V inside car, means I cant charge my phone, nor anything else. On both places, on dashboard below radio/CD and inside compartment between front seats.
I'm assuming cct breaker died and have to replace it.
I know where cct breaker panel is but how to know which one I have to replace?