Chevrolet - 1500 :: 1991 Truck Died For 2 - 3 Seconds Only To Refire Itself
Feb 5, 2014
1991 chevy silverado 1500 4.3 ... Cruising at 55 down highway truck died for 2-3 seconds only to refire itself. After doing so for a few days it wouldn't start at all. Changed fuel pump,fuel filter and all spark plugs. Now runs fine until I shut it off briefly. Then it stalls on me on 3rd,4th and 5th gears. Bucks badly. Is it a fuel issue or something to do with starting it while it's warm. Also it runs good with the check light ON. Soon as it goes off it starts shutting off and refiring itself when I give it gas.
View 1 Replies
Advertisement
My truck hasn't run for over a year and no one seems to be able to tell me why. The fuel pump supposedly has 10 lbs of pressure, it has new fuel pump relay, new throttle body, and probably more new things (can't remember exactly). It will start up normally and then it will act like it's not getting fuel and within seconds die. If I keep my foot on the gas and kind of pump it (I know it's EFI) it will try to keep running, but will die, and it really gets rough toward the end like the whole engine's going to fall out. The truck has 300K+ on it but the engine was replaced about 10,000 miles ago. It still has a lot of original equipment.
View 14 Replies
Alright. I'm a handyman by trade but have only done regular maintenance on my vehicles - I'm no expert. I've searched several forums for this information but have found 1000 different answers, mostly for other makes and models. My truck is a 1998 Chevy Cheyenne 1500, 5.0L V8, 137k miles, last tune up at 110k miles. Use valvoline oil explicitly, and change every 4k miles.
I got into my truck this morning, it turned over, and then died. The gauges all activated and displayed adequate oil pressure, battery power, etc. My RPMs got to 1000 for a second and then back to zero. I tried pumping the gas pedal a bit and nothing changed. It will do the same trick over and over with no difference based on time in between.
So I pulled the air filter off and changed the spark plugs and wires. The spark plugs were moderately worn and two had some corrosion. I used the correct gap on my gauge (.06 or .6, don't remember) and I've done spark plug changes a few times in different vehicles. I'm pretty sure it was done correctly. Also, I noticed that the coolant was low, so I filled it up, and added a quart of oil.
No luck. Exact same thing is happening. I really want to avoid electrical issues (don't we all!) and would like to check other things first...
View 15 Replies
1991 Chevy 1500 pickup truck. The heater is ALWAYS on, no matter what I do. I suspect that some sort of mechanical controller or vent shut off device/air mixer is malfunctioning because I don't think the heat is actually coming from the heater core, I think it's just engine heat.
I pulled the fuse on the heater which turned off the blower and controls, but the heat is still coming out the vents, especially at highway speeds. So this leads me to believe that exterior air is pulling engine heat into the cab.
I don't know how I would even begin to fix this. I need a starting point. Where would I look for the vent or flap or whatever that mixes the cool air with the hot air? The AC hasn't worked since I bought the truck about 18 months ago.
View 2 Replies
1999 Chevrolet Silverado 4.3 ltr ....
I was riding along the other day at about 40 mph and my engine just DIED. No sputtering, jerking, lurching, etc.. I have a 1999 Silverado 1500 4.3.
Since then I've tried swapping the fuel filter out. When I took the old one off I did the blow test and could barely get a bit of air through it. Put in a brand new one. Still won't start. It cranks but it won't turn over. It's like it is starved for gas I suppose.
All electrical faculties are functioning seemingly normal. (Of course I have to charge the battery every time I want to try and crank it because it doesn't charge itself because IT WON'T CRANK!)
I've had to change the fuel pump twice in the past 2 years. The last time was about 5 months ago.
For the past week or two my "Change Engine Oil" light has been on even though I've had my oil changed a month ago.
View 19 Replies
What would cause my 1993 silverado 5.0 133K miles, to knock for a few seconds when started. Sounds like the back of the engine area.
View 3 Replies
After my truck sits overnight it starts immediately and goes to fast idle for a few seconds, then ithe idle starts dropping until it gets to approx. 400 RPM.If I drive off immediately it will correct itself in a short while, otherwise I need to baby the engine speed until it runs on its own - usually five minutes.I cleaned the MAF and performed a MAF tap test with no success.
View 3 Replies
1992 WT pick up 263,000 miles had new head gasket installed valves lapped and tune up it was doing it before and does get better when truck warms up, but still can hesitate at times. When cold you have to feather gas pedal to truck accelerating, you can hear truck motor pop through throttle body but will continue to speed up.
View 2 Replies
Just got a 1990 k1500 with the 4.3 v6 and 5 speed and it backfires. A buddy told me it was shooting flames out of my exhaust. What does that mean?
View 7 Replies
1991 4x4 f250 idi w e4od w 3:55 ratio... The truck is slow to engage in reverse, about 5-10 sec. It also has a very hard shift 1-2. All other shift points are good. Drop down is good, and TC lock up happens at all the right points (feels like anyway).
I've had the truck for about 2 years now, replaced several sensors an harnesses and a full fluid change to solve other problems but this still remains.
Sometimes when I start it in the morning if I let it sit and idle for a few min it will engage reverse much quicker AND shifts way smoother and constant. Shifts smoothly thro all gears, holding a constant 1800-2000 rpms with no drop or lug. Or do I need a rebuild?
View 4 Replies
I have a '96 Chevy Silverado that twice (in about as many months) has had some trouble starting. When I turn the key the engine starts to crank, then there is a loud pop and the engine stops. When I crank it again the engine will start, although more slowly than usual. What could be wrong?
View 19 Replies
My 1995 chevy c1500 cuts out at idle or the moment the brakes are applied to shift into drive. I replaced the passenger wheel cylinder and bled the brakes and it ran fine for a few hours, then the idle problem stated again. I have check the map senor and a few other electronic component as my mechanic said the problem " might be electrical."
View 6 Replies
1990 chevy silverado 4x4... My truck stumbles when you start it and within 5 seconds or so clears up and runs smooth.. I changed the fuel filter , still the same result.
View 1 Replies
i have a 1982 chevy 1500 4x4 with a 700R4 and it has never give me any problems at all has always shifted firm and smooth goes instantly in to drive and reverse. One day last week i got in and the truck will not shift in to second actually wont come out of first the reverse still works fine and the first is still fine it does not slip or hesitate at all. I pulled the gear cover off and can spin it!
View 8 Replies
So I used my 2000 silverado 1500 to remove a willow trunk from my yard. 4 Lo, took a bit of work but I tried not to overdo it. Now, truck sputters when accelerating. Once it gets going it's good but the startup is sputtery and bucks a little. What did I do?
View 1 Replies
My truck just recently started to vibrate like it is going over rumble strips. It only happens over 40MPH and sporadically. It seems to happen when I'm just giving enough gas to maintain speed. Once it starts if I let off the gas or give it more gas it goes away. It reoccurs anywhere from 20 seconds up to a few minutes. I'm afraid my tire is going to fly off or my drive shaft is going to drop. There is no unusual noises or thuds if I go on and off the gas and the universal joints seem tight, and there is no vibrations from on steering wheel.
View 10 Replies
Several years ago I had to replace the fuel pump - truck had about 100,000 miles. Within the last 4 - 5 months I have replaced the fuel pump twice and just today (about two months since the last replacement), the fuel pump has failed again. That has been the pattern now for the last several months. I have had the work done by one of the reputable car repair shops in town - they have also done work on my 2004 Impala with no issues with the repair. There must be something else going on besides just the fuel pump going bad. What would cause so many fuel pump failures.
View 16 Replies
I have a 1998 Chevy K1500 4x4 which is experiencing issues on two fronts: brakes and general operation.
For the brakes, over the last couple years, we have replaced just about every part of the system, including - master cylinder - calipers - brake lines. In addition, in the last week, I worked with a local mechanic to bleed the lines and he turned the rotors as well. The result is that while the truck does stop, the pedal height is still really high and feels like there's no pressure until the pedal's nearly to the floor. I get the feeling that if I needed to stop abruptly or at a higher speed than 35mph, I wouldn't be able to. I'm not sure what needs to happen next.
As to the general operation: the first time I start the truck on any given day, it fires up and runs smoothly. If I take it across town, however, and put it in the park, it gasps, sputters, and dies. It is then very difficult to get the vehicle to start again--usually, I have to push the gas pedal all the way to the floor and grind the starter until the engine turns over. After that, I have to keep my foot on the accelerator for 15-30 seconds at around 3000 RPM as the truck shudders and lurches, until it smooths out. Once I put it into drive or reverse, however, it dies, unless I am quick to push the accelerator again. Until recently, the truck had only been driven four times in the last two years or so. So far, I have: - replaced the air filter - added fresh gas (to the old) - added an engine treatment (Sea-Foam) Everything I have done is stuff that needs to be taken care of anyway, and I want to take care of all the little things before I take it to a dealership to have a full diagnostic run on it. I also plan to have an oil change done on it this week.
View 5 Replies
Six months ago we purchased a '91 Chevy Pickup and 3 months ago the truck started to "sneeze". Sometimes while accelerating the truck makes a "toot" noise from in front of the driver under the hood, and with the noise I have a momentary loss of RPMs. This can happen a number of times in a row, making pulling out on to busy streets difficult and dangerous. Most of the time, I take my foot completely off the gas and then re-apply it, and the issue goes away. It happens both with a cold engine and a warm/hot engine. This problem started when it was cold out (around 10 degrees Fahrenheit) and the mechanic I talked to about it thought it was the E10 87 gas I was putting in.
I switched to a 97 octane/no-ethenol fuel and the problem went away, until about a week ago when our temperatures finally broke 50 consistently. The problem is back and with it is a minor fluctuation of RPM when idling in neutral. The truck also created a new symptom, I was driving at about 50mph and the truck acted like it slipped on ice... I had evened out my speed and the truck seemed to start coasting then got back to driving at speed, it jerked the whole truck, like driving over a patch of ice. I don't know if it has anything to do with the original problem but all symptoms may be the same thing....
The truck is a 91 Chevy 1500K, 5.7L V8 and has 74,000 miles (mostly highway towing). It had been sitting 2 years, not really being used, before we bought it. We had the fuel injection system cleaned when they did the oil change, right after we purchased the vehicle.
View 4 Replies
I'm working on getting my GMC seirra 1500 5.0 L running. Last fall When I was making a trip to another town, it broke down. When it broke down it smelt like plastic was burning, I was unable to figure out what the smell was.
First I though it was a bad battery connection, or that the starter had went.
I changed the Battery, made sure the cables were good. changed the starter and it still doesn't work.
I know the battery is working for sure because There is power to the lights so I can turn on the brights. There is no power to anywhere else on the dash though other then the icon that shows the brights are on.
When I try to turn the engine over, nothing happens at all. Doesn't even make a clicking noise.
View 1 Replies
I was driving my 91 Volvo 940 Turbo Wagon yesterday morning when, out of the blue, the warning lights came on and the engine shut down. I was still able to utilize the wipers and radio as I sat there for an hour waiting for a tow, but whenever I attempted to start the engine, I got a few rumbles but the engine would not turn over. All belts seem to be in place. I just had the water pump replaced. I replaced the alternator 2 years ago when I first bought the car and installed a new battery about 1 year ago.
Any thoughts on what could be the root problem here?
View 4 Replies
