Chrysler :: 1997 - While Shifting Stalls?


Mar 1, 2013

When I am driving my car it will drive fine however, when I slow or take my foot off of the gas pedal to stop my car will stall. I am able to put the car in nuetral and turn it back on and drive againg but when I need to stop it stalls again. What could this be?

View 2 Replies

Advertisement

Chrysler - Towncountry :: 1997 - Stalls When Braking And Idling

My 1997 town and country van stalls when I brake or idle otherwise it drives fine what could that be?

View 2 Replies

Chrysler - Plymouth :: Van Randomly Stalls And Starts

Plymouth Grand Voyager has been randomly stalling. If I'm driving the van will auto restart if I wait long enough. If it stalls as I'm coming to a stop it usually will restart without trouble. If it stalls while I'm stopped already then sometimes it refuses to restart. Once it wouldn't restart so the cops push it to a nearby parking lot and then it started right up, as if the move shifted something. Today I had a similar experience, where it refused to start, so I let it roll and abruptly braked and then it started. This problem disappeared during the winter.

View 9 Replies

Chrysler - Towncountry :: 1996 Van Stalls In Traffic

It stalls when approaching intersections, and sometimes in traffic, always can be restarted, have had battery changed, fuel system checks out. have left at the garage and they can never get it to stall, but it still does it and sometimes three or four times during the day. Have not been to dealer, am frustrated and afraid of getting in accident. What might be causing this?

View 2 Replies

Chrysler - Gasoline :: 1987 - Engine Stalls When Going Downhill

I have a 1987 ramcharger with a 318 and auto tranny. I just put a new carburetor on it. The previous owner partially deleted the lean burn system but didn't change out the carb. I put a Carter 2bbl on it. The truck will start fine and drive fine until I try to go down hill, it then stalls. It doesn't do it as much going up hill, but is still a problem then. If I keep on the accelerator it stays running. I cant figure out what the deal is and is absolutely driving me nuts.

View 2 Replies

Sebring - Chrysler :: 1998 V6 Stalls After 10 Minutes Of Driving At 30 Mph

I have a 98 Sebring Convertible 2.5L V6 that stalls after 10 minutes of driving at 30mph or even at highway speeds (ouch), but it seems only if the car has been sitting parked for 5 days will the stall occur. If I drive it daily/every other day, she seems to run just fine. Somewhere in between 2 and 5 days, there is sometimes a surge at that distance, but not a complete stall. The stall has been a very specific distance that if I let the car sit for 5 days, I can essentially pull over in anticipation of the stall. When the car stalls, the dash gauges all go to 0 and lose all power steering, but headlights stay on. Otherwise, there's been no noticeable loss of power, rough idle or anything else to indicate a problem. There are no codes on the computer. The stall happens once. I can pull over and immediately restart my car and be on my way without experiencing another problem until I let the car sit for 5 days again.

View 2 Replies

Chrysler - Ptcruiser :: 2001 - Stalls Then Starts After 10 Minutes And Repeat

drives nice for mile or 2, stalls. turns and turns for 10 minutes, then starts. drives great for mile or 2, stalls. wait 10 minutes, starts. repeat, repeat!!

View 1 Replies

Sebring - Chrysler :: 2004 - Shifting Out Of Park / Not Always Stay In Gear

I have been driving a 2004 Chrysler Sebring for a few months and noticed that it didn't always stay in gear. I then learned of a problem with another Chrysler model in which there is a "false park" between park and reverse where it seems like the car is in park but it really isn't, and the car will pop into reverse and move. I am not sure if I have the same defect or if there is something else wrong with my car. Sometimes the shifter will move out of park, or even out of drive, with the slightest of nudges of the shifter. There is a button on the shifter that is supposed to be depressed in order to shift, but sometimes it can be moved from park to any other gear, not just reverse, without depressing it or having a foot on the brake. I also found that it would move from drive to neutral while the car was in motion.

View 3 Replies

Grand AM :: 2000 V6 SE - Rough Idle And Stalls / Gears Not Shifting When Car In Motion

My grand am has a gnarly idle issue. It stalls to turn on and once on it has a very rough idle. When I put the car into drive it stales then just turns off. Drained the heck out of my battery so I was thinking it was an alternator issue but I did a quick test and my alternator seems to be working fine. I did manage to drive my car but once in motion, gears wouldn't shift which has me leading to thinking it can be a transmission issue.

Specs:
2000 grand am
3.4L V6 SE model
automatic

View 1 Replies

Camry :: Car Stalls When Shifting Gears / Tire Pressure Sensor Is Blinking

I have a 2007 camry se v6 and I am having a couple problems.

first problem is when i accelerate and hit about 40mph the car kinda stalls when shifting gears, it feels like a .5 second lag. like its trying to catch the next gear.

second problem, my tire pressure sensor is blinking, i've been told it is because one of my sensors is not working, but i don't know how to diagnose which one it is.

View 5 Replies

Ford Ranger / B-Series :: 1995 - Stalls While Shifting From Drive To Neutral Or Park?

"95, 2.3L, automatic. Stalls for a couple of seconds and nearly dies when shifting from drive to neutral or from drive to park. Doesn't do it when cold at high idle or when AC is on. It catches back up and idles fine but nearly dies when coming out of drive. Installed a new idle air control valve but no change.

View 1 Replies

Chrysler - Concorde :: 1997 - Oil Light Blinking?

My 1997 Chrysler Concorde has oil leaks, trying to keep car till this fall. When I am at a stop light or just sitting and idling, the oil light starts blinking and then stops and blinks again. As so as I give it some gas , it goes out. Someone said it may be the oil sending unit or the oil pump.

View 5 Replies

Chrysler - Concorde :: 1997 - Audio Lights But No Sound?

Audio lights but no sound? Chrysler Concord 97. Dealer says replace but what do you think?

View 2 Replies

Chrysler - Cirrus :: 1997 Won't Start On Its Own Without Being Jump Started

I have a '97 Chrysler Cirrus that won't start on it's own without being jump started. Once jump started it runs fine, but then the next time you go to start it the battery is drained again. My highly uneducated guess is that I need to replace the alternator. Am I on the right track? I replaced the battery and the problem persisted.

View 7 Replies

Chrysler - Ptcruiser :: 1997 - Sudden Acceleration Of RPMs

While driving on the highway, I experienced sudden acceleration of the RPM's only on my 1997 PT Cruiser. What would cause this? I had to stop and shut the car off and it was okay when I restarted.

View 15 Replies

Chrysler - Cirrus :: 1997 Will Randomly And Unpredictably Go Into Limp Mode

1997 6 cylinder Chrysler Cirrus 162,000 miles. My car will randomly and unpredictably go into limp mode. I suddenly find myself in second gear while my engine is revving at high speed (3000-5000 RPMs) in order to maintain velocity. The check engine light comes on immediately, but usually switches off after 2-3 days maximum, and typically less than that. If I pull over, and turn off the engine, it re-sets, allowing me to start the car, and continue my journey, shifting normally.

Additional pertinent information:

• it happens more often when the weather is warm
• it has happened while traveling down the highway at 65 mph (scary!)
• at times, the shift into second is so abrupt, it feels as though I have been rear-ended
• once, while in a traffic jam and moving at about 20 mph, I hit a pot hole and the engine started revving at 3000, with no change of gears
• a couple of times, rather than throwing me into second, it has seemed to throw me into neutral, with the familiar high revs, but absolutely no power with increased pressure on the gas pedal
• it is happening with increased frequency i.e. I have had to stop as many as six times during an 16 mile trip.
• Recurring computer codes: P0140, P0141, P0700, P0765, P1494

04/2011 replace right front cam sealFront engine mountReplace front valve cover gasket w/tube sealsFront bank spark plugs & wires (3 platinum plugs)Transmission flush

05/2011 cylinder #5 misfireReplace rear valve cover gasket & tube seals3 platinum plugs (leaky power steering pump fouled the plugs)

05/2011 recall work #C45 floor shifter ignition/park interlockPush rod trans- shifter

09/2012 transmission shift solenoid

10/2012 6 new plugs & wires Plenum gasketDistributor capEGR valve gasket

There has been other service work done during this time period, but (I think) I have included only that which may relate to the transmission. I am so frustrated, and my mechanic is stumped. He has referred me to either a transmission shop, or a Chrysler dealer. After hearing my account of the problems over the phone, the head mechanic at the dealership suggested that it’s time for me to get a new car.

View 2 Replies

Chrysler - Towncountry :: 1997 - Engine Keeps Stalling At Unpredictable Times

my 1997 town and country van with the 3.8 liter engine keeps stalling at unpredictable times. sometimes when it is cold first thing in the morning, other times when fully warmed up at a stop light and sometimes on the interstate at 70 mph. The tach drops to zero, the speedometer drops to zero, the check engine light blinks on and then back off, the computer doesn't record any error codes. it causes the cruise control to drop out while on the hiway. the engine always starts right back up, for how long, its unpredictable. Mechanics have replaced the three engine sensors twice, checked and cleaned wiring contacts at sensors and engine computer. And also the Knock sensor has already been disconnected per a chrysler bulletin. At highway speeds the engine usually bucks and then keeps running, but sometimes dies.

View 2 Replies

Chrysler - Lhs :: 1997 - Replaced Ignition Coil / Crankshaft Sensor But Car Won't Start?

Drove 97 LHS home from work back at the end of June on a 100 plus day, it seemed fine, no indication of any problem. Got in it the next morning to go to work and it would not start. Cranks fine, hear fuel pump. So a few days pass before my husband can look at it. He did get codes. He replaced the ignition coil, put on a new fuel filter, and replaced a couple of modules. It would still not start. We towed it to a service station that we have used for years.

They replaced the camshaft sensor (and fixed the AC). I drove it for 8 days, no problems. Then on the morning of the 9th day, it would not start!! Exact same symptoms. So towed it again back to the service station. Then they said it was the PCM (control module). Husband went to junk yard to get one (much cheaper). Service shop put it in and then said that was not the problem and replaced the crankshaft sensor instead. Say it was ready to pick up. I went and paid again! Got key and came back later with husband to pick it up. IT would not start!!!

View 12 Replies

Chrysler - Towncountry :: 1997 - Service Engine Soon Light Turned On / Codes P0700 And P1775

Yesterday afternoon the "Service Engine Soon" light turned on in our '97 Town & Country (3.8L engine). A few minutes later (while I headed to Autozone to get the code read) the light went out. They were still able to retrieve 2 codes: P0700 and P1775. Internet searches suggest a possible bad solenoid pack for the transmission.

More background: The van has 161,000 miles, and the original owners got the transmission replaced at 40,000 miles under warranty (4 speed automatic). The transmission fluid was replaced (pan drop method) at about 153,000 miles and at 112,000 miles, etc., with Chrysler ATF +4 fluid. The van got new plugs and wires about 15,000 miles ago. (It also got a new radiator and hoses yesterday morning which I think is unrelated.) Another possible clue: On long trips sometimes the 2nd transmission shift will become slightly rough but it still shifts and after it has rested everything returns to normal. This occasional shifting issue has been going on for over 5 years and again when it manifests itself it is very slight.

View 2 Replies

Nissan - Altima :: 1997 - Idles Up And Down / Stalls If Not Given Enough Gas

I have a1997 Nissan Altima 140k miles with the manual transmission. I have a fuel problem that I can't seem to solve. every 1-2 days and only intermittently and unpredictably my car starts to idle up and down and occasionally if I don't give it enough gas they car may stall but the stalls only happen when I am not pressing the accelerator, meaning only at resting idle. since I am fanatic on washing my engine, I initially though that spark plugs were dirty or not working, I changed the spark plugs the distributor cap and the wires but the symptom continues. then I check the resistance of all the four fuel injectors and all of them read at around 12.8 ohms. I have also treated the fuel system twice with injector cleaner, the kind that you find at a gas station but still, the problem persists.

if it is not too much trouble I have another smaller questions. if the car sits overnight or for a couple days, the shift is really easy but as the car warms up the shifting becomes harder. could the transmission fluid need to drained and replaced?

View 3 Replies

Ford F-150 - 1997-2003 :: 1999 - Stalls / Won't Start When Hot

1999 F150. The truck is a 4X4 supercab, with the 4.6 motor, 141,000 mi. During cold weather it runs great, but as soon as the temp gets into the upper 70's or higher I have a recurring problem. The truck starts right up and runs well, but when it is shut off it will not restart until it has sat for over an hour. It has also stalled at speed on the freeway when the outside temp was in the upper 90's to low 100's.

So far it has always restarted after sitting for awhile. I took it to the dealer and they kept it for 3 days, but could not duplicate the problem and found no codes in the computer. I replaced both coils, but it is still not starting after shut down when hot. My next thought is to change the PCM, but that is a big chunk of change to be guessing about.

View 12 Replies





Copyrights 2005-15 www.bigresource.org, All rights reserved