Chrysler - Towncountry :: 2003 - Transmission Shudders / Light Clunk
Mar 18, 2013
I recently picked up a 2003 chrysler town and country from a local GM dealer in central MN. After filling out the paperwork etc I was on my way home and the transmission made a loud CLUNK. I thought I must be imagining things. At the next intersection as I accelerated from the light "CLUNK". I called the dealer right away and they stood behind the van. The dealer had me bring it to the transmission shop covering all expenses. They fixed it, or so they said. We had it for a few days and had similar problems. Back to the transmission shop. They then completely went through the transmission. We got it back and again had issues... this time it was a slight shudder in the transmission as you slowly accelerated. I brought it back again. They replaced the torque convertor. I've only had it back for a few days and it still has an occasional slight shudder under slow acceleration... it usually happens around 30mph.
View 10 Replies
Advertisement
My Town & Country 07 shudders (best word I can use to describe the sensation) between 40-42 MPH. First repair place convinced me I need tie rods, did not resolve problem. Next place said I need struts and new tires but the problem is not solved. Why the van would do this shudder, rumble, whatever - but only at 40? If I rapidly accelerate, like getting on the highway, it doesn't happen.
View 3 Replies
I have a 2003 T&C 3.6L with tow package, purchased used (privately) with 25K miles in 2006. Since I have owned it, it will occasionally not go into any gear when first started after sitting at least overnight- basically stays in neutral until engine is revved to about 2500 RPM. You can rev it in neutral or while it's in gear. This always works, and the transmission will then work fine until another overnight stay. I have had the transmission serviced 3-4 times (once when it first happened, and then at recommended intervals. The car now has 96K on it, and it has been happening less frequently (in fact, it hasn't occurred in about two weeks). I have discussed this with two Chrysler dealers, and have left it overnight twice, but of course it didn't repeat at the dealer. I haven't been able to correlate when it happens with anything except: it seems to occur more frequently when garaged in Pittsburgh than when sitting outside in Myrtle Beach (I spend time in both places).
View 3 Replies
I have a 2003 Chrysler Town & Country and the check engine light is on. I brought the van to my mechanic and he told me there was a code that told him there was a misfire on cylinder #1. He started out with replacing the wire to cylinder #1, no change. He replaced the spark plug, no change. He installed a new fuel injector, no change. The van runs a little ruff at idle and when at a stop light.
View 9 Replies
my daughter has a 2005 Chrysler minivan -- v 6 automatic -- the transmission will not lock in park -- it free wheels -- only stops moving when emergency break is applied --the wheels will move separately -- will not move the other wheel when in park -- if picked up one wheel -- and in park -- it still moves -- there is a gear that is rubbing the cover in back of transmission -- the upper gear iseems loose -- and wobbly -- is there a simple repair there
View 1 Replies
I poured 2 ounces of power steering fluid into an automatic transmission. What a wake up when I saw gold instead of red dumping into the funnel. I then poured 14 ounces of ATF+4 into the transmission to top it off. It's been only 8,000 miles since the transmission was flushed. Should I flush now or is the power steering fluid compatible?
View 4 Replies
I had a mechanic replace my original engine 0f 120k with a 60k engine. Seems like I ran out of oil and warped my original engine and this was my only option. So as soon as I get the van back the transmission is dripping fluid and the mechanic said that some thing in the transmission went bad and must be replaced. This has nothing to do with replacing your engine. Can this be true?
View 7 Replies
When backing up in reverse I come to a stop and shift into drive. About 60% of the time it slams into gear (Drive). It feels as if someone rearended me. It's a 2012 Chrysler Town and Country with 40K miles. 2 dealers worked on it, reprogramed the computer and replaced 2 seloniods and the problem is still there. What is wrong but said thats typical on that 6 speed. What to do next?
View 2 Replies
2002 Chrysler Town and Country. My speedometer jumps wildly and then goes clockwise and rest without working. The trany hesitates and has a jerking when sitting in drive, and slow to shift into 2nd gear. We have replaced speed sensors, wiring and connectors, and now are thinking the chassis control box may be next.
View 1 Replies
I own a 2003 Chrysler town and country. I was driving home and all of a sudden the car just shut off. I coasted to the side of the road and tried to restart and nothing. The warning signals( i.e., seat belt etc.) came on normal but when I turned the key nothing no sound. I have no clue as to what is wrong with it. Had it towed home and here it sits.
View 6 Replies
The oil light on my 2005 Chrysler Town & Country comes on when started when it is cold outside. It stays on until I turn the key off and restart, then it goes out and does not come back on. My mechanic cannot find anything wrong. This only happens in cold weather, not in the summer.
View 15 Replies
We have had an engine light that comes on when it is wet out. (Usually from rain) Until recently, the codes were not stored in memory. The last time we tried this, there was a 420 code set. Our mechanic said it was the catalytic converter. This vehicle is a 2006 and only has a 100,000 miles on it. Neither of the oxygen sensors have been replaced. The car doesn't seem to run any differently when the engine light comes on.
View 10 Replies
The oil light on my 2005 Chryler Town & Country comes on when started when it is cold outside. It stays on until I turn the key off and restart, then it goes out and does not come back on. My mechanic cannot find anything wrong. This only happens in cold weather, not in the summer.
View 10 Replies
I am about an hour and a half from home at my cousins when my oil light came on. It only comes on when I have come to a complete stop. Once I accelerate it goes away. I checked the dipstick and it is full. Here is my question: what do you think this could be and would it be safe to drive home to my trusted mechanic. The car has 160,000 miles on it.
View 5 Replies
Very loud very violent thump while driving at all speeds. Becomes more often and not as loud while accelerating. Decelerating becomes loud and violent again. Tranny fluid is fine and doesn't smell burnt. I haven't owned the vehicle very long but my family enjoys it.
View 7 Replies
While driving idle seemed to increase. Noticed at red lite where van seemed to want to move forward with brakes applied. Went to parking lot put van in park engine RPM rose to around 2500 RPM on it's own. Opened hood and fiddled around with a wire???/hose thing near the throttle control line (wire that connects foot piece to engine). A bunch of black powder (carbon?) fell out. Turned the van off then back on a couple of times. On the third time idle returned to normal and has operated normal since. What caused this? What do I tell my mechanic? What was the wire/tube thing (it entered what I assume is the air intake at a right angle) right in front of where the wire from the foot control hooks up.
View 1 Replies
2007 Chrysler Town and Country, 123k.
It's had an intermittent airbag light for a few weeks now. When it does come on, it stays on until the car is shut off. When I turn it back on, sometimes it comes on and sometimes it doesn't. Sometimes it comes on at startup and sometimes it comes on in the middle of driving. I took it into the shop when the light was off and the shop said whatever's wrong with it, it wasn't storing the code and to run it back in when the light is on.
Since yesterday, the fuel has been overflowing at fill up. I get maybe a half gallon in and then it overflows. I can hear it glug-glugging in when I pull out the gas hose. The flap at the neck of the tank seems to have gone missing too.
View 16 Replies
2007 Chrysler Town & Country with 74K. The check engine light comes on and the parts store diagnostic says P0404, a clogged EGR valve. On my model, replacing the EGR valve involves taking out the alternator, which involves removing the passenger wheel. That's beyond my skill set.
So, can I just replace the EGR tube and pour some Sea Foam motor treatment directly into the EGR? Would that hurt anything?
View 2 Replies
Yesterday afternoon the "Service Engine Soon" light turned on in our '97 Town & Country (3.8L engine). A few minutes later (while I headed to Autozone to get the code read) the light went out. They were still able to retrieve 2 codes: P0700 and P1775. Internet searches suggest a possible bad solenoid pack for the transmission.
More background: The van has 161,000 miles, and the original owners got the transmission replaced at 40,000 miles under warranty (4 speed automatic). The transmission fluid was replaced (pan drop method) at about 153,000 miles and at 112,000 miles, etc., with Chrysler ATF +4 fluid. The van got new plugs and wires about 15,000 miles ago. (It also got a new radiator and hoses yesterday morning which I think is unrelated.) Another possible clue: On long trips sometimes the 2nd transmission shift will become slightly rough but it still shifts and after it has rested everything returns to normal. This occasional shifting issue has been going on for over 5 years and again when it manifests itself it is very slight.
View 2 Replies
My Chysler Town and Country started fine on a morning when it was 9 degrees. (no garage, so it was out in the weather.) I let it run for a couple of minutes so things would begin to thaw and then I drove to work. It ran really rough. I figured that once it warmed up, it would smooth out, but it did not. Even after the weather warmed up into the 50's 5 days later, it still runs rough. Now, I am also getting a check engine light. What could be wrong?
View 3 Replies
When I had 67 miles on my 2013 Chrysler T&C Van it stalled and would not immediately restart. The Electronic Vehicle Information Center revealed both the coolant and engine oil temp was in excess of 300 degrees. After 15 minutes the temps were between 280 and 285. The engine started and I drove slowly the3 miles to my house and had it towed to the dealership the next day. Mechanic found the quick connect coolant line to 3rd seat heater was improperly installed at factory allowing 1 gallon plus of coolant to escape.
A mechanical engineer and a Chrysler mech ( not one from the dealership) advises it is just a matter of time until I have internal engine damage. Chrysler Owner Assistance Dept assigned a case mgr. She reported the van was repaired and operating properly because the coolant line was repaired. Their first offer was 1 months loan payment, which I refused.
View 7 Replies
