Dodge - Ram :: 2004 - Making Rubbing / Chirping Noise At Low Speed
Jul 24, 2011
I have an 04 dodge ram. I have recently encountered a chirping noise at low speed (it may be there at higher speed, but I can't hear it over the engine). It sounds like rubber, rubbing against itself or birds underneath the truck. The noise speeds up and gets a bit louder as I accelerate. The sound generally goes away or I can't hear it after 25-30 mph. This only happens when in motion, so I don't think it's the belts. I've read a number of things from CV Joints to Bushings and not sure if it's either.
View 3 Replies
Advertisement
I'm having an issue where when the fan is set to the lower fan speeds it will make a high pitched, harmonic chirping noise. I've isolated it to the operation of the fan, so I know it's something to do with the HVAC stuff.
View 2 Replies
At 120k miles, my 2003 Camry LE 2.4L started to make some noise when making sharp right turn at low speed (below 5mph) going forward. It sounds like the tire rubbing the fender or somewhere, not metallic, and it's periodic, at 2-3Hz or so. It comes from somewhere on the driver side but I'm not sure. The car doesn't make noise when turning at stop or backing up or going straight, and the noise seems to disappear if turning at higher speed (maybe the turn is not sharp enough).
First I suspect the tire is rubbing the fender. But after inspection, no rubbing marks can be found, and there seems no rubbing when the car is parked and the wheel turn all the way to the right. Then I suspect a bad CV axle. But the boots seem in good shape with no leaking grease, and there's no noise when backing up.
View 1 Replies
I have a 2004 Dodge stratus recently it makes a really loud noise for like 15 seconds then stops if I have the heat or air on. If I don't have it on it doesn't make the sound but either way after 15 mins of driving white smoke will come out of the passenger side and a funny smell. It starts fine isnt overheating, and drives fine.
View 4 Replies
I have an 87 Dakota with a two-piece driveshaft, bought it new. A couple months ago at 140,000 miles there came a chirping noise from the rear at acceleration from a stop. I changed the u-joints with new Moogs and had a new center support bearing pressed on at a driveline shop. Reinstall driveshaft same as it came out. The u-joint at the diff was shot, the other two not far behind. The chirping vanished as expected, but was replaced with a slight vibration felt in the seat starting at 50-55 mph. I dropped the truck off at the driveline shop to get the driveshaft balanced. They put it on the balancer and called to say they couldn't balance it, the indicator kept jumping around and wouldn't stabilize. I asked them to reinstall it and came to pick get the truck. The guy who worked on it said that this was usually a u-joint problem. I asked what brand they used and pulled he out a Neapco u-joint box and said they use them exclusively and have never had any problems. I ordered Neapcos from RockAuto. Will replace the Moogs and see what happens. After they reinstalled the shaft I drove in the freeway and it acted exactly the same.
I was very careful when pressing out the old joints not to stress any of the yokes, applying pressure to the u-joint members at right angles to the cap being pressed out and not to the cap 180 degrees opposite. When installing the new joints, after inserting the clips (interior) I pressed all clips snug against the yoke. The joints all moved freely in all directions. Again, the shaft was replaced exactly as it came out.
View 19 Replies
I have an 87 longbed Dakota that I bought new. It's my work truck. Lately it has developed a chirping noise that I hear best with the rear slider window open. I think it is safe to say that it is not coming from under the hood. When I accelerate from a stop the chirping noise increases in pitch and frequency. The frequency does not change when the auto trans up shifts. There has been no noticeable out-of-the-ordinary vibrations, even at freeway speeds.
I have stopped driving on the freeway since the chirping became impossible to ignore. The chirping becomes less and less audible the faster I go as the pitch and frequency increases. When just starting from a dead stop, it sounds like a metallic scraping noise. Whenever I take my foot off the gas the chirping stops, even when still coasting, so it only occurs under load. It does not occur when the truck is stopped and the engine is revved.
View 9 Replies
My throw out bearing makes a faint chirping noise since I bought the car, but now that the weather has been in teens, it seems to be louder.
I was wondering if it is possible to grease the throw out bearing or something without dropping the transmission.
View 1 Replies
It's darn cold in many parts of the east. -4 this morning. Anyway, driving to work today, I had my heater on about halfpower, and about 30 min. into my commute, the air vent began making a bubbling, chirping sort of noise. I turned it off until I got to work. When I parked, I turned it back on, and it was making a very loud, straining noise.
It's a 2009 Pontiac Vibe (Toyota Matrix twin)...
View 5 Replies
I have a 2012 3.5 eco boost. It has 82,000 miles. I just purchased a large travel trailer. That is the first thing I have ever towed. When I was accelerating onto the interstate the engine started making a chirping noise.( not the normal turbo whistle). It went away when the rpms came down, and now every time I accelerate, it makes the same noise around 2000-2500 under load.
View 6 Replies
my 1992 960 wagon with 332K miles today started making a moaning noise when making a significant turn at low speed. At first it seemed to be only when I was accelerating but if that was true, it now is doing it at any low-speed big turn. Tonight, turning around in the driveway, it added what I call juddering during the turn. So naturally I am concerned.If it is something as minor as power steering fluid I might trust a local gas station to fill it up, but probably not any more than that. (There used to be a dealer about 45" away, but they seem to be gone now, and the closest one is hours away. I am 250 miles and one week away from my own trusted mechanic, so I hope it is something like fluid!).I haven't noticed any puddles on the driveway where it is parked, but I suppose it could leak out only when the engine is on and the car is moving.
View 4 Replies
The steering on my wife's 2010 Tiguan makes a bit of a grinding/rubbing noise at low speeds? Something isn't right, it sounds the same way my X5 did when the Rack needed to be replaced. It would be strange to have 2 cars needing new racks within the same year....especially since they are both 2010 model.
View 9 Replies
Last night on my way home I was cruising took a wrong turn and had to make a u turn. While making the turn i noticed a light rubbing scrapping noise when i had my wheel turned to the passenger side. I got out made sure nothing was suck to the wheel or under the car. Heard it all the way home, got up this morning checked car again nothing seemed wrong drove to school noise was gone.
View 10 Replies
My 05 Jetta TDI is intermittently making a rubbing/grinding noise. Not in stop and go traffic but when I come to a stop at a stop sign, but only just before I come to a complete stop, not as soon as I hit the brakes. The shop that put the brakes on (about 18000 miles ago) looked at pads, rotors and pedal but said it's all fine. Could it be the booster, abs, or something else completely?
View 3 Replies
My car is making the dreaded lifter tick noise. The dealerhip is telling me that my lifters need to be replaced at a cost of $1200. I have been letting my car warm up for about 15 minutes before driving because I cannot stand that noise. I am living near Charlotte, NC and would like to know if there is a cheaper fix for my problem.
View 5 Replies
I have an intermittent brake noise, which sounds like rubber rubbing against rubber. There is no discernable effect on the brakes, pulling, etc. My mechanic can find noting wrong with the brakes.
View 5 Replies
So I own a Dodge Caliber 2007 and it has about 170K miles. This car has been through a lot of trips from IN to PA and many other long trips. A few months ago it started to sound very odd. It's a four cylinder and it sounds like it is only running on three. I don't know too much about cars but the problems that it's facing is that sound for one, it is stuttering in a kind of way, like it's about to die. Also when I accelerate and make a sharp right turn it will start to die and will die on most occasions. This is very dangerous considering it has power steering and I can't maneuver when it does die. Also, I'm not sure if this is related at all, but the front left turn signal and the back right turn signal does not work. It isn't the lights as I have changed them 2 other times, I have been told it might be the computer module but I'm not sure.
View 18 Replies
Truck is 2002 2WD 4.7L Durango and around 164K
I am looking to replace the intermediate steering shaft as it making noise it seems they are common to this problem due to a weak U joint. The problem I have is I can track the correct part. Here is what I have research so far:
Have found this one 55351246AA but it says it will not fit.
Also found the Dorman 425-257 but it says is for 4WD but it reference to this OE part numbers: 55351208AA, 55351208AB, 55351246AA
Have try the Dodge parts website but that is even more confusing. I have already replace the ball joints, wheel bearings and inner and outer tie rods and this is the last part that needs to be replaced if I can track the correct one.
View 3 Replies
I recently bought an 07 Dodge Grand Caravan and noticed that when we shut the rear door(trunk? hatch? whatchamacallit?) it makes an incredibly loud noise...almost like a gunshot. It seems as though the back glass is lifting off a bit and then slamming down. Is that something I can fix on my own?
View 4 Replies
Mostly while negotiating in very crude camp ground roadways, we started to hear a new noise. This started before the incident I will be reporting in my third thread, so I do not attribute this noise to that incident. The noise seems to come from applying the brake when the car is already stopped or nearly stopped. Its a bit of a chirp, but it is a low-throated chirp. It think they come in twos, "chirp, chirp."
View 6 Replies
I've had my MY 08 R32 (Australian delivered) for almost 4 months. It's done about 8300kms so far and I've noticed awhile ago that the car makes clunking noise when I'm turning the steering wheel a lot at low speed (eg. car parks). I'll probably book in for a oil change and ask the service centre to look into it.
View 6 Replies
So ive been having issues with my trans 6 speed manual making noise and took it to the dealer. They more or less told me the trans is done, something with the linkage, need a new trans and clutch. They also told me my warranty was void because there was indication of a cold air intake before i bought the car and have reason to believe it's due to abuse. I've only driven this car 3,000 miles and have taken care not to beat or sport shift the car to avoid this very problem. I can't argue the fact that the previous owner could have very well driven the car hard and the problem might have been a ticking time bomb. I guess my best bet is to find a used trans and install myself but really dont know where to start.
View 24 Replies
