Ford - Taurus - Vibration :: 2003 - Wobble While Going Between 60 - 80
Mar 27, 2011
My 2003 Ford Taurus vibrates when I am going between 60-80. Before and after those speeds it is fine. I read an article from Tom and Ray in my local paper that instructed to do a couple things to see what it could be. I cut out the article and have never seen it again! One step was to drive on the freeway and take your foot off the gas to see if the vibration stopped. If it did, such and such was the problem, etc. I think another thing to try was put it in N.
View 4 Replies
Advertisement
I had reason to believe that my back brakes needed replacing. While I was at it, I also attempted to swap out my front rotors, but was stopped when I was unable to remove my front brake calipers. All in all, I essentially did nothing. I checked the back brake drums and put those tires back on and then took front tires off and put them back on. I woke up today to drive to work, and and after getting about a mile down the road and going about 30-35 mph I noticed my wobble. It seemed to be coming from the front, but still hard to be sure. I know my rotors are a little warped, but I usually always experience that when braking, not when just coasting or accelerating. What to check on, or what I could have done? If it makes any difference, I am driving a 2002 Ford Taurus.
View 5 Replies
I recently bought some used rockstar 1s off a buddy, installed new tires, balanced, put tapered lug nuts on and I'm still getting a slight vibration above 40mph. Do I need hub centric rings? XD says no, I think I do.
View 2 Replies
So I've got a 2000 F350 7.3. Just replaced all the ball joints, sway bar end links, carrier bearing, balanced the tires... a bunch of stuff to try and eradicate this weird wobble I have and I just can't seem to figure out what it is.
The wobble happens at and around 35mph, and then once I break 70mpis on the speedo (I have a 4" lift and am running 35's so it's not actually 70). I've experienced death wobble before in a jeep I had, and it is nothing like that, and I can't see it being driveline related but I could be wrong.
View 1 Replies
I'm having the same issue that I had on my previous Mkv car. Around 55-80mph the steering wheel will wobble back and forth at about a quarter of an inch very quickly. It's an identical shake to my last Mkv. I had the wheels balanced and checked for bends and the car aligned. Didn't work. Went to various shops spent too much on balancing. One shop showed me that one of my tires was slightly out of round. So I bought 4 new tires and had them road forced shop said everything was great. Hopped on the freeway and the same wobble was still there. Car is at 52k miles and I've been battling this problem for about 5k miles now.
I've had the entire car checked. One tech told me that the axels could have gone bad so it is going in under warranty to get new axels on Tuesday, then going back in for an alignment. My last Mkv had the same issue around the same mileage and I spent so much on trying to figure it out I eventually got sick of it and traded it in on this GTI. My girl friend just bought an 09 Jetta and it seems to be having early signs of the same vibration. I'm starting to think its an issue with the generation. My mk3 with 200k miles drives smoother than this thing. I love the car but me driving on the freeway so often really kills the enjoyment.
View 22 Replies
I purchased a used 2006 Toyota Highlander AWD about 4 months ago. Ever since I bought it, it has had a vibration / wobble from the front end that can be felt through the steering wheel and acceleration petal. Only happens between 40-45 mph. I have brought it to the dealer many times and every time they balance the tires. Last time they said it was a faulty motor mount and replaced it. The problem has not been fixed with this repair.
View 1 Replies
I was wondering if a bad/leaking steering rack would cause a clunking sound when turning. Also if the rack is bad how many hours should it take to change?
When I am making turns I hear a clunking noise coming from the passenger side and the boot has oil on it but the fluid in the reservoir doesn't seem low.
When I am driving there is a lot of vibration and when I go over 60 the front end starts to wobble.
View 2 Replies
I had all my brakes done on my 2000 Ford Taurus but my mechanic cant seam to fix my front right brake. The problem is the front right brake grabs unevenly after driving the car for twenty minutes. The vibration happens mostly between 20 and 30 mph when I apply the brake. First he put new ceramic brake pads on and machines the rotor. Then the original calipers seized. He then replaced the calipers. Then the calipers they replaced seized. He then replaced the calipers and pads again. Two weeks later the uneven braking starts again. He then re-machines the rotor or replaces them. Two weeks later the uneven braking starts again. What is going on?
View 3 Replies
Ok so we all know it's usually warped rotors or possibly a caliber problem. But let's say u have new of both. And still I'm getting a wobble, not only when I brake at higher speeds, but when I'm on certain roads. Only certain roads. Say about 20% of other roads while driving I get a slight wobble. Not too bad, but a very annoying wobble. I bought this CTS at 35k and now has 45k on it. And again I bought this car for my long commute and a smooth drive. Which I'm not getting. I can't take it anymore! I've got to figure this out. Getting a wobble in the steering while on super smooth roads. And I know it's the car because I have a Chevy Cavalier and a Dodge truck in the family that don't wobble on the same roads.
View 16 Replies
Could the constant wobble be caused from a bad wheel bearing? The wobbling and vibration gets really bad and it try's to setup an insistent shaking & vibrating at 35mph and I have to slow down to around 18 - 20mph to make it calm down. It sounds and feels like it wants to turn into the 'death wobble thing'. It is coming from the drivers side and after removing the drivers side front wheel, I've noticed the wheel bearing grease has all squished out all around the bearing on the inside of the bearing where the axle enters the bearing right after the ribbed boot. See the attached video. Does this grease coming out all over indicate that the wheel bearing is completely blown out thereby causing this extreme wobble and vibration?
Or could it be a from a combination of a worn tire on that side (which it has) and worn tie rods, ball joints, etc? ...after all the car is 19 years old.
I also have a problem with the heater blower - it does not work at any speed, doesn't even turn on. I can feel heat coming up into the car defrost and vents, but without the assistance of the blower. I can hear the relay click when I turn the heat on and off, and I already put in a new blower motor resistor. Could it be the fan switch itself? Or could the blower motor be blown? The fuses have been checked and are all good.
View 5 Replies
My 2002 Taurus has developed a slight vibration but loud groaning sound in what I think is coming from the right or left front side. It gets louder at around 40 - 60 MPH and its hard to pin point. it actually feels like it's coming from the middle of the vehicle and sounds/feels a lot like a clothes washer machine going on the spin cycle. As I turn the steering wheel slightly to the right and listening for a change of the tone of the noise is go away. What this could be? bearing? CV joint?
View 1 Replies
My 2003 Taurus wagon stalled and ran out of gas even though the gauge read 1/4 full. Called AAA they came and put a can of gas (less than 2 gals.) in and the car started. I went to the nearest gas station a block away and filled the tank. It took only 10 gals. That means that there was 3 or 4 gal. in the tank when it stalled. What gives?
View 6 Replies
I have a 2003 Ford Taurus with over 117,000 miles on it. I use the car to get home from Texas to Florida about twice a year, but otherwise hardly touch it since I'm a college student. I've noticed lately that the car has been jumping when either waiting at a light or driving at lower speeds.
However, yesterday something strange happened. I was waiting at a light and the car started bucking more than usual. It was at night, so the dashboard lights started fading and the car stopped. The air and radio worked still after the car shut off, but the car wouldn't move. I tried cranking it, but it wouldn't crank. I pulled the keys out, cranked and it started it successfully. While it waited at the light it bucked violently. Then, when the light turned green it ran no problem like it normally does at normal speeds. When I got to my car parked at my place, I let it sit in the parking lot for five minutes running and it didn't buck once.
I am about due for an oil change. I haven't reached 3,000 miles yet, but my last change was in August. I've read a few other topics with similar problems on here and people have suggested transmission flushes. I did have my transmission fluid flushed at about 70,000 miles. Is it possibly due for another one?
View 2 Replies
The manually-controlled air conditioning in my 2003 Ford Taurus can't take the heat (literally). If the outside air temperature is under 85 degrees, it works like a champ, but as the day gets hotter, the cold air disappears. This happens regardless of whether I've driven the car previously that day. My mechanic checked the coolant level, compressor, and sensors and all were fine and the AC was cold. He left the car sit outside in the sun for a few hours and voila - no AC! (BTW, it can happen when the car is parked in my garage too if it's a hot day). He says something is triggering a false temperature message telling the system to shut down. He wants to dig into the wiring in the system to look for a problem.
View 2 Replies
My 2003 shakes/jerks back and forth at 55 mph. Took to a mechanic, they found nothing...car did not jerk. Check engine light on (although it has been on for years)... Checked transmission codes and found nothing...could be oxygen sensor?
View 3 Replies
My 2003 Taurus sometimes refuses to start. There's no real pattern: sometimes it's after the car has run for a while and other times not. Sometimes the starter clicks, other times the engine lights come on with no sound at all from starter/engine. Thing is, the car always ends up starting if I let it sit long enough (15 minutes--several hours). I've read around on the internet and realize this seems to be a problem experienced by many owners. I've changed the battery, checked all the connections, cleaned the starter connections and the Mass Air Flow Sensor. If the starter was bad, it seems like it wouldn't start at all, right?
View 1 Replies
i have an 03 ford taurus. recently i noticed a grinding sound when braking. My first thought was that i needed new brakes. I want to the mechanic, they did a courtesy inspection and found nothing wrong with them! the rotors are smooth with no grooves, the pads look almost brand new! the mechanic seemed baffled. when i bought the car the brakes that are on now. it's just recently that i have noticed the grinding sound. The mechanic ruled out other possible problems such as bad bearings and shocks...etc.. What could be the problem?
View 2 Replies
2003 Ford Taurus, 49k miles, 3.0 OHV V6 (Vulcan).
It's my daughter's car, she's away at college, so it only gets driven once a week at the most. For the last year or so when I turn the key to start, the starter starts to turn, hesitates for a second, and then turns over and starts the car. I've been assuming the battery was a little run down from sitting so much. There are no noises, clicking or grinding, just this slight hesitation. The battery terminals are clean.
Last night it wouldn't start on the first try, I had to turn the key 2 to 3 times before the starter would turn the engine over. I took the battery to Advance Auto and it tested fine but needs a charge (~12.2V). I'm slow charging the battery with a Battery Tender so it's going to take a while.
This hesitation, is it a sign of a failing starter?
View 6 Replies
On Monday, I was driving my 03 Ford Taurus. I had my cruise set at 57mph, all the sudden I started slowing down. I pushed the gas to the floor to try speeding up, but I kept slowing down. The car never shut off. I still had all of the electronics and the motor was still running, had my power steering as well. I pulled over and shut the car off. I started it back up and continued down the road and it happened again. Same thing, slowed down and pressing the gas and no speed. This happened 5 times within 65 miles. I got to my destination and was there for about 15 minutes, when I made the return trip. On my way home, I didn't experience this issue at all. What the cause may be?
View 10 Replies
I have a 2003 Ford Taurus. It has been running rough for awhile. It doesn't happen all the time, alas. I took it to my local repair guy. They first said, oh this happens when the AC is on. But I knew it happened otherwise.
The check engine light came on yesterday, blinking, but didn't stay on. And it was running rough. Check engine light came on, on a Sunday so I had to wait until Monday to bring the car in. They just called and said they can't find anything wrong, ran it on the computer, says it's running fine. I said, did you check the spark plugs, wires, etc? (I am good at googling, to be armed with some kind of info)
I am thinking they just put it on the computer. I suppose it has to be running bad to show anything (?) and even then, it's no guarantee. Anyway. It seems like I am "sentenced" to driving this car until it strands me, catches on fire (I read about that possibility and I have on occasion smelled something burning), or if luck has it, when it is running rough, and I bring it in while it's running rough, the computer finds the problem.
View 7 Replies
My 2003 ford taurus SES randomly has problems with the speedometer fluctuating from 0 to 10 mph upon idling. Sometimes the car will eventually stall out but always restarts without a problem. You can feel it "jerk" when changing gears or what I describe as a "hesitation" once in awhile. The car is an automatic and we have already replaced the relay and the voltage regulator/alternator - that has not workeded. I can't afford to keep throwing money into it replacing parts that don't fix the problem. What could be wrong?
View 5 Replies
