2 days after replacing a weak battery during a cold snap the engine light came on. 2 days prior to replacement the gas cap warning and engine light came on, but immediately after the installation both warnings went off. Only the engine light came back on 2 days later. I have driven the Jeep 3 times since for about 20 miles total. Total mileage, 18,200. What the cause may be and how to proceed?
View 2 RepliesI have a 2000 Jeep Wrangler, manual transmission, 6-cylinder. I accidentally let the battery die in September. I got a jump, and it was fine until we got a cold snap. (We live in NJ.) On the first cold day (October), the battery was dead again. The battery is about 4 years old. I got it jumped, and it was fine, but the CE light came on. I have been dealing with the CE light and generally lousy engine performance ever since. (The car is lurching and hiccuping.) I have had it to the shop four times since the initial dead battery in September.
I bring it to the shop, they hook it up to the computer, and each time it indicates a sensor problem. They have replaced the 02 sensor, the TPS sensor, cleaned the throttle body, replaced several spark plugs, and swapped out the clockspring. It has been to the shop four times in the past 5 weeks. I even switched mechanics after the first one said he was going to replace the 02 sensor and I looked at my records and pointed out that he had already done that back in June. (At that point, they said "Oh"" and tried replacing the TPS sensor.) The 2nd mechanic also got the TPS sensor code and I told him that the previous mechanic had already replaced that one, as well.
He went to a discussion website for mechanics and discovered a "design flaw" that a majority of mechanics said could be rectified by replacing the clockspring. So he tried that. Every time one of these guys does something, the CE light goes off and they test-drive it and it seems fine. Then I come to pick it up, after hours, hours later, when the car has completely cooled off, and the CE light is back on. Yesterday I picked it up and the CE light was on but at least it was running better. Then I drove it 90 miles and it was hiccuping badly by the end of the trip. Also, I filled up my gas tank at the beginning of the trip, and the tank is now between 1/2 and 3/4 full. Horrible mileage. My husband made the same trip in a different car, also a Jeep, and also filled up at the beginning, and his tank is more than 3/4 full.
I know I can take it to Auto Zone and get the code, but I'm not hopeful that the code will say anything other than what it has already said, i.e. O2 or TPS sensor.
I am having a “Check Engine” light problem on a stock 06, 4 cylinder Jeep Wrangler with manual transmission. A local highly regarded independent mechanic has had it in his shop 3 or 4 times for more than a day each time. On the first visit he replaced a purge solenoid valve and reset the light. It stayed off for more than 400 miles and then relit. He went over it and checked the wires and connections and reset the light. Again it stayed off for some time and then relit. He has checked the Jeep site.
After the last visit he suggested I drive it and see if it would reset itself as it had been doing in the past. It did reset itself twice but it only stayed off for 10 miles the first time and 2 the second. The code indicates an electrical problem and he is now planning to drop the fuel tank and check the wires and sensors there. The next step may be an ECM transplant. This is only an emission system problem and the mechanic says it is OK to drive. We do not have emission inspections here. How important is it to fix the problem?
I tried starting my 2005 Jeep Wrangler yesterday and there wasn't enough charge to get it started. I got a few slow revolutions and that was it. I gave it a jump and it started fine. Drove it for an hour or so and then went to restart it 3 hours after I shut it off and it was dead again. Another jump and I drove it for an hour (home). I was able to start it a few hours after that on its own, though it struggled to a bit.
Tried again this morning and it was dead from sitting overnight. A few other bits of info:
With the key in the ignition, the charge indicator is hovering just above 9V (it is a 12V battery) before I try to start it. When engine is running after start, it jumps to around 12V.
I am pretty sure I didn't leave the lights on or door open overnight. I haven't noticed the engine struggling to start leading up to the dead battery.
After I jumped it again this morning, it seems to be idling very low. In fact, the engine shutoff when I let it idle in neutral with my foot off the gas for a few seconds.
When I got in the Jeep this morning before trying to start it, it had enough charge for the radio and dashboard. When I turn on the lights/highbeams it struggled and the high beam indicator on the dashboard (blue light) was flashing. Battery is not too old. I don't have the receipt with me, but I think I bought a new one 3-4 years ago. The +/- connections are clean with no corrosion. I didn't look too closely, but I didn't notice any obvious connection issues from the battery leading into other components.
I'll probably go buy another battery, but wanted to check with the experts out there to see if there is anything else I should be checking. If I do get another battery
Over the past year or so I have noticed that when I press the clutch on my 1985 CJ-7 258 that the headlights would get brighter. This happens when driving or just sitting at an idle. This happens only after you press the clutch enough to take up the usual 1/2-1 inch of play in the clutch pedal. When you release the pedal, the lights dim slightly. Another thing that may be related---over the past few months, it has been a bit sluggish to start until, finally, it wouldn't start at all. I looked at the battery and the cable connector on the negative battery pole is partially melted and ran down onto the top of the battery. What the problem might be? I'd hate to get a new battery and just have the same thing happen again.
View 15 RepliesMy 2008 jeep wrangler x 6 cyl pings upon acceleration. 62000 miles.
View 6 RepliesI recently purchased a 2004 Jeep wrangler Sahara. In retrospect, I probably should have inspected it more closely. The underside, including the sides of the engine block (below the heads, etc.) have a lot of rust. With little effort I can flake off pieces as thick as a quarter for example. How concerned I should be and what I need to do???
View 5 RepliesI own a jeep wrangler with a 7.2 hemi engine. Manual transmission. When driving and want to stop on a traffic light. The rpm will stay at 2000 rpm until complete stop and then it goes down to 850 rpm.
View 19 RepliesThe engine was running rough when it hit 2K RPM only. above and below it is fine. replaced the injectors/O2 sensor and it ran well for a couple of months but it is doing it again. when engine hits 2K rpm it will sputter and run rough. engine light gives me code 171 engine running rich or lean. What else to look at..
View 8 RepliesI have a 97 Wrangler 4 liter that lurches violently. It runs fine until the engine is warmed up. After the engine warms up it it begins lurching. When I put the clutch in, the lurching stops. When I let the clutch out, it is okay for 1-2 seconds (i can get power and advance the vehicle), then I put the clutch in and repeat that process. When I give it a little gas with the clutch in, the engine runs smooth - so it doesn't appear to be a gas problem. When I give it gas with the clutch out it lurches violently.
After pulling it into my garage I let it idle to about 5 minutes. It idles rough and is about to stall, when it apparently shoots a little more gas preventing it from stalling.The check engine light has come on. I took it to my local mechanic who cannot find the problem. The "computer code" indicates a faulty oxygen sensor. He also checked the fuel pressure which is okay.It has 120K miles and otherwise has been a great vehicle. It has been well maintained.
I own a 2003 Jeep Wrangler and for the past 4 months. I have had a squeal coming from the right side front of the engine when coming off the gas. However when I get below 25mph while slowing to a complete stop the sound goes away in most cases. My mechanic has replace the tension pulley along the the serpentine belt and the sound still persists...
View 5 Replies2003 Jeep Wrangler LOUD squeal when coming off the accelerator. I've had changed the Tension Pulley, The Belt, Checked the Power Steering, Removed the belt from the AC unit..smaller belt now....Tested the Alternator, it's working like a champ. I have a 4.0L 6 Cylinder. My mechanic wants to check the intake gasket and another intake which he spoke of and I can't remember at the moment however with no guarantees these or one of the two could be the problem. He expects it to be a 5 hour job. The sound seems to be generated from the lower backside of the engine...
View 2 RepliesI just replaced my batteries today on my 2011 F250 because of a no start situation. I guess it was about due since they were original and that gives me 5 + years of service and it happened in my driveway so I definitely am not complaining. However after I replaced them and started the truck the check eng lite came on....
View 8 RepliesI have a 2006 4 cylinder JEEP Wrangler. Right around 50 mph the whole car starts to shake pretty violently. I have to slow down back to 40 to get it back to normal. I can seem to get past this most of the time by waiting to shift into fifth gear until after 50 mph but not always!
View 1 RepliesJeep Wrangler Owners excessive engine oil consumption [URL] .... Caused engine failure with my Jeep. Chrysler aware of problem. Local dealership stating Chrysler may not honor 100,000 mile warranty due to 1missed oil change.
View 5 RepliesVehicle will not exceed 20mph. Vacuum leak can be heard coming from around the intake area on the driver side. Cannot detect where it is coming from. All vacuum hoses seem to be connected.
View 3 RepliesI have a 1995 Jeep Wrangler Rio Grande named El Burro.I have replaced the shocks and am awaiting an alignment next week.The Jeep doesn't shake or jump all over unless I hit a bump and then it jumps all over the place.
View 15 RepliesI own a 98 jeep wrangler. Love the little jeep. But....big BUT...at random it chooses not to start, not sluggish start, dead absolutely no noise. I have spent well over 1500. dollars on new starters, batteries, ignitions, ignition cylinders you name it I have replaced it. This last time it started every time for well over a month, then one evening it just didn't so I let it set for a couple of hours as usual and then it started and we came home. I love my mechanic he is patient and doesn't make fun of me when I ask dumb questions...but this he can't figure out.
View 2 RepliesI have a 01 Jeep and the AC is not blowing cold air. When I went to get my oil changed they did a check over and said that it is in working order just lacks any freon to get it cold. So I went to get a bottle to do it myself. Doing what it said to do on the bottle I got nothing. The meter says that there is pressure in the system, but no cold air coming out. I noticed that it would engage and then stop after a second, but still will not fully engage or blow cold air.
View 5 RepliesWe have a 97 Jeep Wrangler that I have serviced regularly since I purchased new. It only has 97,000 miles since my wife and children drove it locally. During winter, the Jeep drives fine. As the weather warms up and especially when using the air conditioning system, the engine heats up within 10 to 15 minutes of driving. Once, when my daughter was driving in warm Spring weather, the Jeep engine seized up on a highway. We had it towed and the dealership flushed the coolant and it drove OK for a few days. We have noticed that the coolant is burning up in Spring and Summer needing replenishment frequently. We also had the thermostat, water pump, belts, and hoses replaced. The overheating problem (needle moves to red zone) still persists in Spring and Summer. If we switch off the A/C, the vehicle drives OK for about a 1/2 hour but Atlanta summer can be brutal without A/C.
Except for this issue, the vehicle is well maintained and in fact every time I get the oil changed, the mechanics ask if I would sell the vehicle as it is in such great shape.
when the jeep warms up the transmission wont shift out of second gear.it is an automatic.had solenoid packs replaced and no mechanic has an idea.external cooler has been mentioned along with replacing pcm.
View 2 Replies