Pontiac - Bonneville :: 2000 - Starts Only When Starting Spray Is Sprayed Down The Intake?
Jan 26, 2014
I have a 2000 Pontiac Bonneville ssei (Supercharged) 3.8L V-6. I had a issue with the fuel injectors now that problem is fixed. I can't get the car to start on it's own. I and a auto garage have replaced the MAF,MAP,Camshaft Pos Sensor, Crankshaft POS Sensor, FPR, ICM, IAC, Someone had the TPS in wrong and I was missing 5 volts at pin B of the TPS. I corrected that and now it's ok. The engine cranks but it will not start on it's own, I have about 54 psi on the fuel rail.
The ECM was replaced by the dealer before i fixed the fuel injector problem but that did not work so the original is back in place. The car runs like a top after I shoot some starting spray down the intake and will run until I shut it off. I try to restart it and it won't start until I spray it again. I am very careful not to spray on the MAF sensor. Even with that being said I use Electronic spray cleaner to start it. All Sensor wires have been checked with the exception of the crankshaft position sensor which I'm going to do today going to the icm.
View 18 Replies
Advertisement
Just today,when replacing the UIM on a naturally aspirated 95 Pontiac Bonneville 3.8 with a Dorman upgraded type from my local auto parts, I ran into an issue. When following specified torquing sequences and specs , be very careful with the 1 long stud (#7), as it will split your new manifold there if you try to torque to 89 in/lbs. Took 1st back for replacement ,and the second new one started to split at the same place. Was using a brand new Craftsman in/lb torque wrench set correctly and following instructions exactly. I've seen a lot of excellent info on this UIM issue with the GM 3.8 ltr 1995-2004 years, but never this issue with the replacement ones. If I have to change this again will definitely go with the aluminum one.
View 1 Replies
I've currently have 114,000 miles on this Pontiac Bonneville and I replaced the intake manifold last summer. Recently, I have been having issues with the intake manifold leaking a fluid on the right side of it (facing the engine) and been having dirt or some other type of fluid mixing in my fluid tank. The leak has been causing some smoking issues. Also, when I start the car in the morning white smoke comes out of the back of it. Where I need to start so that I can get this fixed. I'm assuming something went wrong in the replacement.
View 6 Replies
My 1986 Ranger 2.9 starts only when I spray starter fluid into the air intake. It does stay running and it drives fine. The engine will not fire up unless I do this process. I have cleaned out the fuel rail, fuel injectors, purchased new fuel filter, and tested fuel pressure (which is good).
View 9 Replies
I was driving to church this morning when my brake light inside my car starts beeping. As soon as I put it in park and back into reverse it quit beeping. I am just wondering if this needs to be looked at asap. My brakes work fine. I can stop suddenly and everything. My dad changed my front brakes earlier this year and is going to do my back ones soon.
View 4 Replies
My wife's '97 Bonneville has recently begun acting up. It especially seems to not like the cold weather. It starts hard then the motor will fluctuate and hesitate and die. It usually stays running the second time. Then when I put it into gear pushing the throttle doesn't do anything. It seems to stumble and falter. Sometimes, if I pump the gas it works other times if I move the pedal up and down slowly I can find the "sweet spot" and it will accelerate. I'm not sure if it's related or not, but sometimes going down the highway on long trips it will seem like the transmission is slipping and the car lurches or slows down. It's really weird. Then if you shut it off, it won't turn back on for 15 minutes or so.
View 11 Replies
2005 Bonneville SE. 3.8 liter V6 46,000 miles.
I just purchased the car in September of 2013 and it's in great shape. Over the past couple of months, I have noticed every once in a while, it won't fire right away after turning over. To get it to start, I have to press down on the accelerator once or twice while cranking. The problem seems to occur when the engine is relatively warm. It seems to have no issues after the car has been sitting over night.
View 1 Replies
2001 Pontiac Bonneville. 135000 miles. Running well. Only in the morning for about 10 minutes after starting and riding there is a strong burning smell. Don't see any leaks.
View 7 Replies
I have a 1995 Bonneville with about 160k miles. I have a problem with the PARKING light on the dash coming on, accompanied by a chime. This happens fairly consistently after first starting the car and driving off, or after coming to a full stop (e.g., stop sign) and then pulling away again. The light and chime come on for only 5 or 10 seconds before stopping all on it's own. One suggestion was that the parking brake pedal was sagging, but pulling up on the pedal does nothing (it's up all the way and doesn't budge). I've also read that a leaking master cylinder may cause the light and alarm to activate, but I can't see any evidence of leaks when I examine the MC.
View 3 Replies
I was surprised this morning by my 2000 Pontiac Bonneville not starting. All the other devices and systems activated but the engine made no attempt to turn over at all. It's a rebuilt title but the car has shown no signs of difficulty except a small bit of sputtering last night when it was unfortunately running on fumes and the service light activating after the gas tank was filled. My limited experience and lack of funds makes me hope this is a blown fuse as that would be relatively quick and painless (so I understand it) to fix but a friend has suggested it may be the starter and I am not foolish enough to believe it couldn't be something even worse. Of course I want to be appraised of more serious concerns in case I need to start making long term plans to restore my mobility.
View 2 Replies
1993 ford ranger 4 CLY 2 WD getting spark gas to injectors will only start when fluid is sprayed in air intake. have replaced fuel pu,p. fuel filter air intake regulator. ran okay till ran out of gas.
View 2 Replies
I just wanted to make sure. I'm using starter fluid which I heard causes a bigger explosion and can damage piston rings and whatnot so I figured can I just spray some gasoline into the air intake?
View 19 Replies
Ok the icp .hpop.ipop.crank ps and ficm is all good but still no start. I've sprayed alittle starting fluid and still don't start idk what else to do this truck is driving me up the wall it's been down for 2 weeks.
View 5 Replies
1995 Pontiac Bonneville cranks but wont start.
I've replaced the crank sensor and also the cam sensor with no luck, the car cranks with no start, when I used starter fluid the car runs, when i stop using fluid it shuts off what could it be.
Only has 38,000 Miles on it.
View 2 Replies
Well I have to make a long story short, suffice it to say this is a bit embarrassing, but I need an answer: I removed the 440-t4 transmission from my daughter's 1987 Pontiac Bonneville and had it rebuilt. After I replaced the unit I discovered I left off (and lost) the TV link and cable. I (miraculously)found the link and the cable, and I am wondering if I can replace the link without having to remove the side cover of the transmission, and what I can do to avoid dropping the TV link rod down into the trans while I am trying to reattach it to the linkage arm inside the trans thru the little TV link hole on the top of the trans.
View 5 Replies
I have a beautiful 2002 Pontiac Bonneville SSEI with just over 100k miles on it. I've been saving for a new set of tires and a new regulator for the rear window. The window suffers from the "pop and drop" syndrome but I have instructions on how to fix it myself when I can get the parts.
Yesterday, I started her up to go to my second job when I discovered I had no reverse. In drive, I could just creep forward at 3000 rpm. Fixing a transmission is probably the worst case scenario I could imagine happening.
I'm left with two options: Either find something simple I can do myself to get it moving again or get what I can for it and use the proceeds to buy a piece of metal to get back and forth to work.
View 7 Replies
Air ventilation on my 92 pontiac bonneville ssei. There is no air coming out of the dashboard or the floor. only to the windshield. What can be the problem?
View 3 Replies
My Pontiac also has oil on the engine now with the oil pressure at 120. It started at 40 then went to 60. I had the oil changed and they put 5w30 which they were not supposed to do. I wanted 10w30.
Is this a common problem with Pontiacs? Is there a non engine replacing solution? Will I have to tow it to the mechanic?
View 10 Replies
Yesterday this thing died on me twice. 30mph to 0 in nothing flat. No problems with stalling before yesterday. It's at the shop now, but they tell me they aren't finding anything and probably won't if they can't get it to die on them too. It had only been driven for about 5 minutes before each occurrence, and each time I had just topped a small hill(if that matters). The second time, it did slightly hesitate to restart and seems to me there was some light smoke from the tailend.
View 19 Replies
I have a 1996 Pontiac Bonneville, when i bought it it came with a remote that was broken, so i have an old remote from a 2000 Chevy Venture that i want to program to work with my Bonneville, my owners manual has no information on reprogramming and I don't want to pay a dealer or mechanic money to do it, looking for the process of re-programming this for my car?
View 3 Replies
On Sept 10, 2011 I was driving towards a major highway when my airbag light came on. I just figured it was a sensor malfunction and kept driving. I proceeded to the highway and when I was up to 57MPH I put my cruise control on. About 3 minutes later both of my airbags deployed while I was driving. Do you think I need a lawyer?
View 19 Replies
