Toyota - Matrix :: 2005 - Temp Gauge Won't Reading Correctly?
Dec 8, 2011
I have a 2005 Toyota Matrix with 250k on it. It has run like a champ so far, with the only problem being an ECM recall last year. I have noticed a few problems recently; the heat blows cold air for quite awhile, and the temperature gauge, while not reading hot, sort of fluctuates between normal and a little warm. When the ECM was being replaced, the dealer said the serpentine belt was overdue for replacement, and I know he's probably right about that. He also said the water pump needed replacing, although I have never seen any signs of leaking. This car has been a champ, and I'd like to try and get another 100k out of it if possible. I'm pretty handy around a car, I've replaced an alternator and radiator before, and I'm working on a limited budget, so if any of this is doable by me, I'm up for it.
View 11 Replies
Advertisement
I have a 2007 Sante Fe with the 3.3 engine. Having a problem with the Fuel gauge not reading correctly and a check engine light. The engine code indicated that the problem was with the sending unit in the tank on the "A" side (behind the driver). I checked with Hyundai and with a tech line service and they indicated that it was a common problem and I needed to replace both the "A" & "B" units to correct the problem. I did that and cleared the codes and it set another code indicating that the "B" unit was the source of the code. I pulled the "B" unit again and checked the wiring and the problem still was there. I switched out the units on the "B" side again with the old unit and the problem is still there.
View 4 Replies
It is a garage queen 1994 4.0 AWD with 42,000 miles in nearly perfect shape. Except for the dent in the rear on the passenger side.
I have posted a picture of the dash when going down the road. As you see the engine light is on. It comes on intermittently, pulled the codes, indicated MAF, 02 sensor, running lean/rich. Runs like a champ, no hesitation, still gets up and goes, gets the appropriate gas mileage. I replaced the 02 sensor with the original Ford Part. Didn't cause the engine light to stop going on after about 20 to 60 minutes driving, sometimes it doesn't come on at all.
Could this thermostat be running too cool and causing the engine to throw those codes? Would gladly take it to a mechanic, but seems like it might be a fishing trip with my dollars for them. Next I was going to replace the MAS myself, easily done with the original remanufactured part at a cost of 150.00, 70 for the core, but don't want to chase my tail with these engine lights on when it runs nearly perfect.
Have sprayed the MAF. Checked for air leaks anywhere. Done all the things I could do by just lifting the hood.
So the picture shows the Temp gauge barely touching the N flying down the road at 70 on a level surface, outside temp about 60. Reading the posts says they all run in the cool section of the temp gauge.
So the question is, do they run this cool? Heater works fine and the gauge goes up past the N resting before the O when going up hills on the way to Tahoe. Is this a thermostat problem on a 20 year vehicle with low mileage, or am I going to have to bite the bullet and let the mechanic go wandering through the vehicle?
View 14 Replies
I have a 77 F100 2wd 302/c4. I recently replaced the rear plate to my gauge cluster after it crumbled to pieces. I swapped all the gauges to the new plate minus the fuel gauge since it decided it couldn't live if livin was without the old plate. I have a gauge cluster out of my 75 and decided to swap in my fuel gauge from that one. I put the cluster in the truck and fire it up for 10 mins or so and everything is working great except the temp gauge isn't moving. I figure it romeo and Juliet with the fuel gauge so I just swap all gauges from the 75 into the 77 cluster except the speedo. Same result.
So I figure its the sending unit now and maybe both gauges were fine to begin with. I put in a new sending unit and now the gauges works but the needle sits on the P in the word TEMP on the gauge which makes me uncomfortable. That's about 1/4 inch or so from being past the end of the gauge. I don't believe the truck is running that hot. The gauge was more or less straight vertical before the swap sitting right at the end of the E on TEMP. Did I get a bad sending unit? Is it a bad ground on the gauge? Was I supposed to take off the teflon tape that came on the threads of the sending unit? I'm gonna try removing that first and see if it lowers the needle.
View 3 Replies
I have a 2001 Excursion Limited V10. 146000 miles 2 wheel drive. I have had it about a year and this is my first winter to really have experience with her.
When the outside temperature is very cold and the engine is cold from sitting all night, at start up, the oil pressure gauge reads nothing and the oil pressure/temp idiot light is on. Only does this during the first very cold start up or after sitting and engine getting very cold again.
I can drive just a short distance (2 blocks) and both gauge and light go to normal and stay there for the rest of my drive. I am using a quality 5/20 oil and filter and the level is good. Warmer days it has never happened. Truck runs fine, smooth idle, no "limp mode". She has not had any recent work done. All the other dash gauges read fine.
There is something about really cold temperatures that have to be causing the issue , I think. ??
View 5 Replies
I was recently given my first Volvo. Its an 88 240dl. While driving my temp gauge climbs up to the red and sometimes hovers inside of it. It normally climbs up at stop signs and comes down on straight always then climbs right back up close to red. When the gauge was in the red i stopped the car and popped the hood open to see that the engine was not actually overly hot.
first i replaced coolant. nothing
then i replaced the thermostat. nothing
flushed radiator. nothing
Today i finally had enough and decided to switch out the water pump with a new one hoping that it would solve the problem seeing as it still had the factory one on. It did nothing. the gauge continues to climb up. I did replace one of the two senders in hope that it would fix the gauge reading but nothing.
View 4 Replies
Every now and then when I slow down the temp gauge drops about 1 notch below its normal 200 reading. It's nerver done this before. Car runs great and heat is strong. Is this a sign of a failing thermostat? If so, where is the thermostat located, is it hard to replace, and should I get OEM or is OTC ok? Car has 89K on it.
View 11 Replies
I have a 98 trans sport and the temp gauge is reading low. Only on the first line when driving then when i pulled into the garage it went up one line and heat got warmer. Felt both upper and lower hoses and i can press them both in Fluids are full no leaks anywhere. oil is good tranny fluid is good. I just got it on a trade it runs and drives great no problems at all.
View 6 Replies
I have a 2006 Jeep Liberty 3.7L that has a temperature gauge on the dash that reads an overheat when driving. The oil looks normal, there is no white smoke, no bubbling from reservoir. I have replaced the following:
Radiator
Thermostat
Water Pump
Coolant Temperature Sensor
Coolant Reservoir Tank
I am not leaking any coolant and the reservoir level has been fine. I have let the vehicle idle for 20+minutes, with no overheat. When I drive it around, the temperature gauge will read an overheat. When I stop the car and pop the hood, the engine is not overheated and both rubber hoses to/from radiator are flowing the coolant. The only thing that will bring the gauge down is turning on the heater full blast. Could this be the gauge itself being bad? Could it be a short in a wire somewhere? I had thought maybe a head gasket, but have no symptoms of a head gasket.
View 9 Replies
I have a 2003 Excursion 6.0. I didn't post this in the 6.0 section because it may not be just a 6.0 issue. (See what I get) On cold starts, anything under 150 degree water temp reading on the SGII. I get a CHECK GAGE light on accompanied by the check engine light. No codes read on the SGII pending or stored. Just some of the time I get a water in fuel light too. This tends to go out fairly soon after driving. (Even after I just drain the fuel pump it still happens.) other issues that accompany the lights are as follows.
The trans temp does not give a reading to the dash. The oil temp does not give a reading the dash. Both show proper temp on the SGII. When in reverse the back up alarm beeps as if something is behind me. And the auto door locks will not activate after 10 mph. The tach also will not show a reading in the dash. SGII shows the numbers. Now the kicker, this ALL gets resolved the instant the water temp hits 150 degrees. The only lingering issue is the that the tach will surge or drop every now and then. The tow/haul light does not come on when this is going on. I've checked the battery terminals all are clean. Both batteries are brand new.
View 9 Replies
I just filled up my gas tank and when I turned on my car the gas light turned on and the needle read empty. But before I put gas, the gas light wasn't on yet and. Was at 1/4 of a tank. Maybe I filled it up too much and it'll resolve itself after the gas goes down?
It's a 10.5 if it matters.
View 4 Replies
I have a 2005 v6 ford mustang and lately the rpm and the gas gauge have been misreading. At first the it was the gas gauge that was reading off then the rpm gauge soon after. However, sometimes the rpm gauge will be working right but my gas gauge is just completely wrong. The other two gauges are working just fine( temperature & speedometer) ...
View 1 Replies
The outside temp gauge on my '05 Treg has never read correctly. It reads approx. +5 degrees F. throughout the range. Can this be recalibrated, by Vag-Com or otherwise, or is it a faulty sensor, needing the dealer's attention? Where is the sensor, anyhow?
View 3 Replies
I have a 2009 Avalon XLS with about 60,000 miles. While my wife was driving home from work today the following happened:
AC compressor off (blows hot air), temp gauge not operating, abs light on, brake light on, avg. mileage and distance to empty display displays blanks, shift indicator on dash not lighting.
Rest of dash works fine, audio works, lights work, car runs fine.
I tried finding a common fuse, but really don't know what to look for.
View 10 Replies
I have been battling this for some time. The check engine light comes after a period of time from reset. I have changed the thermostat, temp sensor, coolant flush and added per MFG.
I am down to clutch fan. The temp gauge sits right at 210.
From what I can tell is the check engine light comes on because the engine reaches operating temp to SLOWLY. Im guessing because the clutch fan is spinning to early in the game.
View 5 Replies
At idle temperature is above middle. Upper radiator hose, which is connected to the thermostat is hot. Lower radiator hose that feeds back to the engine is cold. Radiator fan will not stop running if the temp guage is at middle to needle above middle. When running the temperature reading is normal at 30 mi/hr (middle to just below middle). Temperature will also go down if at high rpm idle, about 2,500 RPM.
New thermostat replaced last week. Water pump replaced less than one year ago. Upper radiator and lower radiator hoses are pressurized when running and off.
I suspect the thermostat was installed incorrectly. Pressurized hoses mean excess air in the cooling circuit/system. If so, does it mean I have to bleed out the air? How do you bleed out the air on a cooling circuit of a car, I thought the reservoir tank already does that naturally? I think the normal range for the temp guage should be 1/3 of the whole range of the guage, right?
View 19 Replies
Got a 1995 Toyota Tercel. As the temps have dropped, I have started to use the heat again.
The heat comes on, but not nearly as warm as I remember. And now the temp gauge barely nudges - but does seem to nudge - above stone cold.
I checked the coolant today while the engine was cold. The reservoir is empty but the radiator is filled to the brim.
This isn't the first time this season it has been cold. My best recollection is that, until this week, the heater and the temp gauge had both been working fine.
View 19 Replies
We have a 2005 Chevy Tahoe. Been running great. Has 140,000 miles on it 80% open road. Couple of weeks ago was highway driving and noticed the coolant temp gauge went all the way down to nothing, and then back up to normal (middle of the dial) This happened 5-6 times and each time as the temp rose back to normal, the transmission would lurch.
I took it to a mechanic who could not figure out what was wrong, but acknowledged it was running terribly. He said that was what he would try before going to a dealer. I agreed and the car instantly seemed to be running perfectly. Now a couple of weeks later, the coolant temp gauge is dropping again. It is not going all the way to nothing, and the transmission is not lurching. It goes down from half to a quarter and then back again. So something still seems to be wrong. Otherwise all seems to be well.
View 4 Replies
I have a 2005 mk4 gli and the other morning I went out to start my car for work and all I got was crank no start. I then realized my fuel pump wasn't priming when I opened the driver door. After work I came back and checked the fuel pump fuse and swapped the relay with another I had, still nothing. A buddy of mine came to me and decided to check the connector at the fuel pump for power, using a power probe I believe he hit all or the majority of the wires with 12v of negative and/or positive power. He then unplugged the connector and plugged it back in and the car fired right up. But I noticed that my fuel gauge, engine temp gauge, and outside air temp readout were all not functioning.
View 1 Replies
'05 Ex overhead console temp is showing -40 deg... Had the board out looking for loose diodes, didn't see any. Have any of you ran into this before?
View 14 Replies
At idle, on hot days (90+) after about a minute, the A/C cuts out and the temp gauge begins to rise. Gets about 3/4 of the way to the red zone, but never reaches it. I changed radiator cap, but still does it. Fluid level is fine; no coolant leaks that I can see. Called a mechanic and asked about a radiator flush. He said he'd do one, but it probably wouldn't work and I should just bring it in for a diagnostic.
View 7 Replies
