My 2003 Volvo S40 Turbo (140K miles) came back with the following during emissions inspection (and failed). Is it worth fixing?
P0420 Catalyst system efficiency below threshold - bank 1 and P0015 "B" Camshaft position timing over retarded - bank 1....
My '03 XC90 T6 starts right up when cold. It runs fine when hot. but now I have an engine light and these two OBD codes: P0420 & P0607
What would cause this hard starting.
And if I open the hood on the car for about 1/2 hour in the cold, it starts right up. Otherwise, it just cranks and cranks. Fuel rail seems to be getting fuel b/c when I'm cranking the engine then I turn the key off (not started), the fuel line has pressurized fuel in it.
The check engine light on my sons 03 celica is on. Went to autozone and they got the codes for me. They are P0420, P0442, P0446, P0456. I realize that I should probably have an OBD11 reader. What steps do I take to fix this?
View 2 RepliesWeekend trip in the 09 Avalon and after stopping for fuel i end up with a check engine light and two codes P0014 and P0015, camshaft over advance bank 1. Cleared the codes but came back hours later. What am i looking at to correct this problem?
View 14 RepliesSo i've had this volvo for about 6 months now.I knew when I purchased it that the two codes being thrown were p0128-Engine coolant temperature, and p0420- Cat efficiency Bank 1.Inspecting mechanic said it needed a new cat to clear the p0420....I went ahead replaced the thermostat and changed the coolant to "fix" the p0128, and cleared the codes, I think the jiffy lube state inspector did not notice the that the catalytic converter test was Incomplete when he passed it. Lucky me I guess.
But now I know that I'll probably have to fix before it gets inspected again. Eventually the p0128 came back on, so I went and got a new ECT sensor. Still doesn't clear the p0128. What am i missing? Coolant temperature sits at a 3'oclock position pretty regularly and quickly. Where to start on the p0420 besides understanding its the Pre-cat o2 sensor that is throwing the code, is there anyway that these are related?
Looked around and could not find info on 2 codes. 2004 Prius : P0420 and U0293. One I believe is lost communication with hybrid system. Are these serious?
View 3 RepliesA few weeks back I got my ARK exhaust installed with no problems. Due to some personal reasons I had it removed and my stock exhaust reinstalled by a different shop over this past weekend. I've been driving it fine for the past few days but today I noticed the CEL on with codes P0420 and P0430. I hit up the shop to see what was up and he told me he didn't touch anything that should have caused this. What should I do....
View 3 RepliesAfter changing 3coilpacks on my Passat 04 1.8T soo far finally the last one went out. The codes I got are P0301 (which is misfire cylinder1) and the other code is p0420 which I do not know what it is... I think it might do something with cat or something.
View 1 RepliesThe wifes camry all of a sudden tossed up CEL. Codes read P0100, P0110, and P0420. Car has about 125K miles, runs fine. I cleaned the MAF sensor with CRC cleaner just for that, pulled EFI fuse to reset, came back on immediately when started.
I was thinking of getting a used one from pull-a-part, but they only have 98 camrys at the moment. Any chance MAF is the same?
I just picked up a MK4 gls 1.8t jetta for a project car.... I wanted to keep the miles off my MK6 gti.... The jetta has 92k miles and the first thing I had done was the timing belt service done as well as a new alternator clutch pulley and oil change... 1 day after I got the car i was driving to work and the CEL came on took it to auto parts store... 2 codes came up
P0420: catalyst system. efficiency below threshold bank1
P2181 cooling system performance
I have the green sensor and I think its time to change the thermostat... My question is is it just a coincidence that both codes came up at the same time or is i possible it is a sign for something else... i just had the thermostat changed 10 min ago...CEL light is gone so i will wait to see if the cat code comes back.
We bought the 2010 RX350 a couple of weeks ago and have gotten these codes twice.. I have a good scanner and know what the codes say about Cat's bank 1 and 2 operating below threshold. I know some of you are going to say replace the cat's, others are going to say replace the sensors and neither should be the problem... If it were a cat or sensor, then they would not come in at the identical same time... It has to be something common such as a throttle body, charcoal canister, or another item upstream of the cat's... Not the gas cap either...Maybe a vacuum hose..
View 14 RepliesCheck engine light came on while driving home from work. The car seems to be running fine but I got the following codes p2195, p0420, p2096. I have a 2006 elantra with 184000 miles. Should I just replace the upstream oxygen sensor or is there a more likely problem? I rather not spend the money if this combination of codes is likely has a different cause but replacing the sensor appears to be the quickest and easiest solution.
View 5 RepliesWhat I need to do to fix these codes
p0171 system too lean bank 1
p2637 torque management
p0420 ...
I took my car to get inspected today and it was rejected because of P0420 and P0430: Both Catalyst system efficiency below... My check engine is also on.
I have the full Meisterschaft exhaust installed (+midpipe) PPE headers and K&N intake. Whats the problem and how can I get this fixed so I can pass the inspection?
1998 Chevy C1500 4.3L V6 170,000 miles
My truck is stumbling and losing engine power sporadically. When this is happening I can usually drive it if I am real easy on the gas and slowly build up speed but if I mash it the engine will eventually just die completely. It has had this problem off and on for several years and now it's back with a vengeance. It always seemed to happen after a heavy rain but now I'm not sure.
Last week I had a mechanic look at the codes and he cleared them saying that once it happened again the code(s) that showed up would be a good indicator of the actual problem. The codes that were there were for a couple O2 sensors, catalytic converter and loss of vacuum I think. It happened again and his shop was closed so I got it read and cleared somewhere else and it was P0131 bank 1 sensor 1 and since I knew that one had come up before I went ahead and replaced it myself.
The next day the CEL came back on without any noticeable engine trouble. That was yesterday, this morning it rained and the problem is back and I went to get the code read and it was the P0420. There was also C0281 stop lamp circuit something or other that was new.
My gas mileage has stayed pretty good this whole time, always 15+mpg. Just wondering if my catalytic converter probably needs replaced, if I should replace other O2 sensors, or if this all might indicate something else in the engine.
I just bought a used Toyota Corolla 2002 CE with 120K miles two months ago. the car seemed fine and drives fine too. After a while I found out that the seller had removed the "check engine" light, so I read the error code by a instrument and I got these errors. 171,420,441. And I noticed that the engine burn a quarter oil every 200 miles on long drives!I checked the VSV valve and connected hoses but no problem there. Since the car has just 120K miles, I'm not sure that the piston rings are worn out! I'm wondering what could cause all of these errors?
View 19 RepliesI have a 2013 F350 Crew Cab Long bed xl with 128000 miles on it. I just barely bought it from a small dealer and had a check engine light come on for the cats.(P0420 and 0430)
I have spoke with the dealer and he assured me that he would replace the cats. He stated he had O2 sensors replaced and thought he had fixed the problem. Not sure if he replaced all sensors or just the fronts.
He has been avoiding calls lately and will not return my messages. Anyways, My question is what should I be looking for to prevent future cats from going bad. I just ordered a bluetooth OBD 2 scanner and bought the Torque Pro App.
I am not new to working on trucks but they have all been 1995 and older and i am new to anything scanner wise and do not know what I should be monitoring. If I can't get this guy to replace the cats I want to monitor everything to make sure the cats are bad.
BTW, Fuel Mileage is at best 12.3 with an extremely light foot, Driving normal it drops off to about 11.8-12. Is this a normal MPG in these trucks? I have seen post about people getting close to 16 unloaded not smashing throttle?
On another note, I just remembered that my traction control light will come on with no wheel spin at times after starting the truck and driving away.
I just recently purchased a 2008 ford f350 5.4L gasser, supercab long box. The truck has 167,000km on it. I flew about 700km from my hometown to pick up the truck and drive it home. After driving about 300km I started noticing a few problems.
The engine light codes that have been stored as of now:
P0420 (Catalyst code)
P0420 (Catalyst code)
P0191 (Fuel rail pressure sensor i think?)
The issue I'm having is that the truck has absolutely no power going uphill or accelerating. If I'm climbing a hill and have the gas pedal pushed in at a steady rate its almost as if the transmission wont shift, and if i push harder on the gas the truck begins to shudder. When the truck is cold it runs normal and climbs hills no problem, but once it heats up the problem returns. Another odd thing I noticed under the hood on my drive home was that they disconnected the vacuum line from the fuel rail pressure sensor and simply plugged the line on a random bolt.
Also, the truck apparently has a cam phaser lockout on it and I dont know if that could be causing the issue? Here's a list of some of the troubleshooting ive done so far.
-checked all fuses(start at the basics eh)
-checked resistance of coils(checked out fine, even after engine was warm)
-pulled spark plug 1 and 5, they both seemed fairly clean, not fowled up
-generally looked over all the vacuum lines, seemed fine couldn't see anything else really out of the ordinary
-while the truck was running I used a temperature gauge to see what the exhaust system was doing. On the drivers side when the truck was warm before the cat I had 140C and after the cat it was 80C(good indication the cat is plugged?) The other side tested fairly consistent.
I have recently picked up a 2005 F350 with the 5.4, which has 212k on it. Has a check engine light on for P0420 and P0430, as well as some kind of a 'ignition coil 'D'', I forgot which code it was as I deleted them at first to see which would come back. After driving it, the P0420 and the P0430 came back, but not the other, yet probably. I'm guessing the misfire due to the ignition coil caused the cats to go bad and the 420/430 codes, unless these codes are coincidental and the cats went due to high mileage.
Either way, I'm pretty sure I will need to replace the cats and was wondering what is the cheapest route. Should I get individual cats and have a shop weld them on? Should I go to Advance Auto parts or Auto Zone and get the whole pipe with the cats attached to them already and then get them installed? I anything will involve welding, I would have to bring it in to a shop. Also, in regards to the ignition coil misfire, what a good way to check which one it is?
I bought this truck (2011 F-350 6.2l) used a month ago with 125000 miles on it. Of course the MIL light came on as soon as the ink dried. The codes read PO420 & PO430 and my local Ford Service said replace the cats. I said what is the cause of the failure, ford said here is a list of possible causes but it's not reading other codes so they don't know what caused the failure.
Well, I went ahead and replaced both catalytic converters, all four O2 sensors, and I replaced all sixteen spark plugs. Guess what, the MIL light is back on not 24 hours later reading PO420, PO430, and now PO620 and PO645. So I just went back to Ford today and all they did was cleared the codes and told me to call if the light comes back on. They said my PCM is up to date but why it's now reading GENCOM code or AC Clutch code.
I have a 2002 volvo S60 2.4T that I just had the check engine light come on so I pulled the codes and here is what I found,
PO403
PO611
P1378
P2623
So my question is what does this mean ? what is wrong ?