Accent LC (2000-05) :: GL Throwing Itself Into 3rd Gear
May 17, 2014
I have a 2005 Accent GL with about 130k miles. When I start driving it, it seems fine for a little while, then it will throw itself into what I believe is 3rd gear and won't shift out of that for the remainder of the drive. The check engine light is also on now. I had my transmission flushed maybe 6 months prior to the first occurrence.
I took it to a transmission shop, they read the code, and then wanted $485 just to look at the transmission. I believe the code said "3rd gear incorrect ratio," but it could have been 4th gear too.
Is this a common issue? Is it likely a sensor or the transmission itself?
View 3 Replies
Advertisement
Currently throwing both P0441 and P2096, just prior to this I was also throwing P0442.
Read around on web and decided the simplest thing it could be would be the fuel cap, may as well start there. Owners manual even recommends changing at 90k. Got a replacement from advanced (which is supposed to be built to OEM specs), re-set battery light stayed off, attempted to pass emissions but a few systems were "not ready". Was good for 80ish miles. Light came back on throwing P0441 and P2096. I re-tightened fuel cap and re-set battery, light went off.
Did some maintenance; spark plugs, air filter, oil/filter change and replaced the leaky oil pan. Keep putting on miles hoping to get to the recommended 200 mile mark before stopping by the emissions testing facility, 105 miles after re-set same codes came back. I'm almost positive I replaced a o2 sensor 2ish years ago for emissions. Also there is an obvious exhaust leak which could be a culprit. I seem to remember reading somewhere that a weak battery can cause problems with fuel pressure... not sure if it's true or not but for what it's worth I do know my battery is on it's last leg.
I'd like to avoid unnecessary fixes, it's only my winter car so as long as it's nothing major I'm not going to dump money in it. I'm going to take a guess and say the check engine light is coming on when these systems become ready. Plan is to try this re-set one more time hope for the best and if not replace exhaust or at least repair leak. Not sure on my next step for P0441 though. Vehicle is a 2004 Hyundai accent with 86k on it.
View 1 Replies
Twice now I've had my fuel cap/gas cap come loose and throw a CEL regarding emissions. This is fixed by screwing the cap back on and clearing the code. There is no good reason for the fuel cap to unscrew itself so I'm thinking there could be an underlying issue, possibly pressure related.
View 2 Replies
Just bought a 01 Accent hatch the other day. It's a 5 speed 4cyl. First gear through 4th have no problems. If I try to shift into 5th gear or reverse, the car doesn't want to go into them. The dealer I got the car from said that the problem is with a pin or something. I have never bought a Hyundai before this, I've had old 70s american cars. I was thinking it could be a shifter linkage but I figured I would ask you knowledgeable people about it first before I go and break something trying to fix something simple (hopefully simple.
View 8 Replies
I have a 2001 Hyundai Accent GS Hatchback, the car has about 41,6xx miles on it. When i drive it between 2nd and 3rd gear it shift violently, its almost like it shifts due to pressure, it also happens when it downshift too. Also the reverse went out, i can hear the pump running and it goes into reverse but when i press on the gas it acts like it in neutral. This is a daily driver for me.
View 9 Replies
I have a 52 Reg Accent MVi and, occasionally when changing down into 1st gear, My gear stick sometimes doesn't want to go into place, or it will go into place but the car will still be in neutral.
Also, sometimes, when it feels like it hasn't quite gone in right, and i lift off the clutch, the car gets stuck somewhere in between gears and cant move, and i have to yank the gear stick (quite hard) back into neutral.
View 1 Replies
I have a 2005 Accent GL (4dr Sedan) base model, 5 speed. I live in Canada (not sure if that will play a part); I notice that when I shift from first to second there is a 'clunk', not really a grind, and not a major clunk... but it's noticeable. As the car warms-up, it seems to be less pronounced (or maybe I start to ignore it). Is this something to worry about? or could it be the clutch plates.
I have had lots of bikes with wet clutches and this is 'normal' for a bike going into first gear. With the bike it's due to what I call Hydrolic-stick ... (2 or more) plates 'sticking' when you let the clutch out, one spinning faster than the other. Off topic now...
View 5 Replies
I am having a issue that my transmission is popping out of 4th gear on my Accent, particularly on inclines. Have had the transmission (gear) oil checked and filled (was low) and thought that may have been the issue. Got it back from the mechanic and less than an hour later is popped out of 4th 2 times in a 5 minute period. It has only popped out of 4th gear, has not happened from any other gear. I have no check engine light or any other 'idiot' lights that come on when it happens. (Other than replacing the clutch...which I hoping I don't have to do ) cause that's a trip to the mechanic again...
2000 Hyundai Accent
1.5L 5 speed manual
240k miles
View 7 Replies
My car has started to do something odd. Whenever I am in 3rd gear, at about 2000-2200 rpm, the engine will revup 100 rpm or so and then back down (only for a split second). This only happens on 3rd gear and only at about 2000 rpm. Its a 2005 Hyundai Accent Hatchback with an automatic transmission with Royal Purple ATF. I also have a SRI and manga-flow muffler (if that makes any difference).
View 1 Replies
have had this car for 2 years with out any problems whats so ever. Drove home from work today parked in drive went to leave again and transmission is stuck in first will not shift.
View 10 Replies
I have a 2000 hyundai accent 5 speed with 76k and a 1.5. the spark plug boots arc on all 4 plugs and can see a light blue line down the center of the wires also. But while idling you see nothing till u snap the throttle. Also driving while its under load you can really feel the miss in 3rd gear. Ok here"s what I've done I cleaned up all my grounds on motor and body ,also cleaned spark plug threads. i replaced wires with 5 different brands including factory wires and same thing. I've tried all kinds of different plugs from regular coppers to iridium and changing plug gaps with no change. the coil was replaced,crank sensor changed and does same thing.
View 11 Replies
I have a 2000 Accent that wont shift past third gear until the car is warm. The car has 140k miles. When I turn on the car and pull onto the high way it sticks in 3rd. I then have to slow down and drive through a small town. When I get on the other side of the small town and get back up to speed it will shift. Over drive is on.
View 4 Replies
I have a '05 Accent GLS Hatchback. 5-speed, manual transmission with about 82 thousand miles on it. I bought the vehicle used about 2 years ago. Ever since I've had it, its been a little jumpy in first gear when going at very low speed. Especially during traffic jams, barely pressing on the gas will cause it to jump a little bit until you put the pedal down further. Lately its starting to do something similar when it 4th gear. When you push your foot on the pedal it jumps a little and does the same thing when you take the foot off the pedal. What may be the cause? O2 or TPS sensor maybe? It did give me a flashing check engine light for about 10 seconds this morning but it hasn't done that since.
View 5 Replies
I just bought a 2001 Accent, very well taken care of. It is the 1.6, automatic, 148,000 miles. Just before I bought it, the owners put new tires on, replaced the plugs/wires/belts/timing belt/all fluids/head gasket. I did a search on this topic and saw a lot of things, but nothing definitive.
I've noticed that when at a stop (in gear) the car shakes a good amount, and with the A/C on it's significantly worse. There is no check-engine light, and the car seems to run and shift very well. I'm not used to small cars with small engines, so I don't know if it's normal or not.
I did look at the motor mounts (front and passenger side) and from what I can tell just taking a peek, they don't look bad, but again it was just a peek. The mounts don't look like they've ever been changed, but then again the whole car looks brand new, the owners took really good care of it (the inside looks like it's never been ridden in).
I do also have noise coming from the speedometer, that goes away temporarily when the back of the cable/speedo is lubed and then comes back, but my first concern is the shaking.
View 10 Replies
I recently bought a 2002 Accent with the 1.6 auto 133000 miles. I have been reading the postS around here about the crappy transmission. My car seems to have some life in the tranny still but it has slipped from 3rd to 4th gear around 45 mph when i get on the gas too hard. Its also a little sluggish to start off. My question is should i change the fluid out knowing i have a slipping issue? The reason i ask is that last time i changed the fluid and filter on a Jeep that was slipping i ended up having to rebuid it. Is that a real possibility if i change the fluid in this Hyundai?
View 3 Replies
Having had bit of a disaster today (shutting keys in boot that cost me 85 quid, that's why you don't buy from people who've lost the spare key), I noticed back box mounts and back box are rusting.
Is it possible to swap the standard rear silencer for the 2005 1.3/1.5 accent with the twin outlet one for the coupe 1.6?
It looks very similar and the pipe bends look the same..? What a hissing noise is when in gear and running? Stopped it doesn't make the noise, and as soon as clutch is depressed while rolling it stops.. Had a new clutch fairly recently.
View 2 Replies
I have a 2001 Hyundai Accent GL the reverse gear went out but all the forward gears work. Ive been told that I need a new transmission. I found a great deal on a transmission from a 2007 Hyundai Accent. Will this transmission work in my car?
View 1 Replies
So long story short I picked up a 2003 Hyundai accent 5 speed 80xxx miles for $1,000 almost two years ago, vehicle has been running great but the shifter always felt loose and it feels really weird going into second (kinda like the shifter really falls far into gear) I was online searching and found other different type of Hyundai vehicles with the same issue and they replace the shifter bushings oem or after market and fixes the issue. I called hyundai and gave them my vin and they told me for my vehicle they don't sell the bushings , i would need to buy a whole new cable.
My questions is am I looking at the correct place to replace my shifter bushing on the trans or is there something else I should be looking at? Shifter has been getting to the point where it hurts my wrist to shift, I've already replaced the trans fluid and its not hard to go into gear, just feels loose and if I try and go fast and shift fast the car will probably grind second due to the shift lever.
View 12 Replies
I am having a few issues with my 2001 accent. I bought this car for around 500 bucks after my friend hit 3 deer with it. At 101,000 miles the transmission went on it and he had it replace with a new one. At about 113k he hit his third deer and parked it. I bought it off him a few years later and its been running great. It died on me one time and it was the crank position sensor. Now I have about a 156k mile on it and it will not go into overdrive.
I have gotten mis fire codes, I know it needs new O2 sensors, and also P0733 Gear 3 Incorrect ratio. The button on the shifter does nothing, If i press it on or off the light does not come on on my dash. I noticed it was not going into OD this last winter if i dropped it into low and shifted to drive it would no longer go into overdrive until i placed it in park and then drive again. Ive been searching everywhere for an answer I was reading one post that it could be the TPS sensor causing issues but i haven't had time to check the voltage.
View 5 Replies
Why my car is grinding gear when I shift from 1st to 2nd, & yes the clutch is fully depleted and still grinds when I shift.
View 4 Replies
My 2003 made a sharp mechanical noise one day, next thing I knew it lost the ability to shift out of 2nd gear....Now, it can still shift into 2nd gear when cold, but only after holding rpm for a bit and then suddenly jerking into 2nd gear. Once it's warmed up for a few minutes though, after dropping out of 2nd gear, that's it! Then it's stuck in 1st gear the rest of the time. Reverse doesn't work anymore at any time, and it gave me code P0732 to P0734 which should be gears 2 - 4. Is it possible that not being to get out of 1st means 2nd gear is broken, but the other 2 are okay and it just can't get shift past 2nd? Or might all 3 have problems after all?
View 1 Replies
