Accent LC (2000-05) :: Thud Noise When Going Over 15mph And Gets Faster With Speed
Jul 31, 2015
My i40 (18 months old and already on it's 5th problem) has just developed an enormous noise (thud thud thud) when going over 15mph and gets faster with speed. If I go into neutral and turn the engine off at speed it is still there. The crazy thing is as soon as I veer or turn right it stops but when I turn left it does not stop. It's really lot and I can feel it through my feet and on the steering wheel. I am taking it into Hyundai (again) but I'd like to understand possible issues before I go in.
View 5 Replies
Advertisement
I have an '05 accent with an auto trans. The car only has 25k on it with the original trans fluid. Every once in a while the trans will thud when coming to a quick stop. It actually doesn't even make a noise, but you can feel it going into presumably 1st gear. It only happens when I need to semi-quickly stop for a yellow light etc. right as I'm coming to a complete stop. Trans seems completely fine otherwise. Is this a normal thing? Just an older style/technology auto?
View 1 Replies
I recently had my 2002 1.8T in for clutch replacement at the dealer and they came back and said the crankshaft was bad ( the car was occasionally making noise when pushing the clutch in, they thought it was a throwout bearing) I took the car back to bring it back to an indie, and it is loud at idle and while accelerating (sounds like a chattering noise that gets faster as speed increases) It's now sitting in the parking lot. My question is, am I going to have to put in a whole new engine to fix this problem? can just a crankshaft be replaced?
View 2 Replies
This week I noticed a sound that sounds low that increases then the vehicle goes faster and decreases when it slows down. It is not wheel bearing noise. Took a doctors type scope and put it on the pulleys listening for the bearing noise in each pulley and found my alternator pulley making more noise than usual, My car needs new accessory belts so I ordered 3 new belts and will be replacing them soon. I am hoping the noise is from worn belts and not the alternator. If it is the alternator its going to cost me 250 bucks for a rebuilt one. I'm not sure if I can tear the alternator apart and replace the part bearing part. Have to look into this. Is this normal for a car with 161 thousand klm for accessory belt bearings on items to start to go bad? I sure hope the water pump and power steering and ac compressor and ac tensioner last. These all have bearings in them as well.
View 10 Replies
Having an issue with the 09 Platinum 5.4. Recently the air ducts to the passenger side have been routed straight to hell. The blow hot regardless of the setting, the driver side is fine. I can hear a clicking noise that gets faster/louder with the fan speed on the passenger side. I am thinking blend door motor? Possible location of this part and some replacement instructions? Wife and kids aren't digging this hot heat all the time, its a very uncomfortable ride in such a great truck!
View 4 Replies
I have a 2012 Camry SE I4. The problem is my car speed odometer is faster than my radar detector speed. I have 2 detectors and they are both not show the same speed compare to the speed odometer. For example, I am going 70mph, the detector reads like 67-68mph. So the speed odometer is off about 2-3mph. I have OEM size on my car. I know the GPS on my detector is more accurate. So my speed odometer has problem?
View 14 Replies
When I'm on highway (between 90 and 120 KM/H) I heard a whistle when speed is stable. it happen frequently in the last week. I notice it happen approximately at 95 and 110 KM/H. When I remove my feet from accelerator, I don't hear the noise anymore.
(Accent 2002 hatchback).....
View 3 Replies
trying to find the speed sensor on a 03 accent manual so I can fit cruise control
View 1 Replies
Just experienced the teeth jarring "thud" from going over a speed bump. That was bad. I want to fix the issue right now for cheap. I plan on doing the full blown V/B mod swap out later, but don't want to buy new rubber when my current is nearly new. Dealership wanted ALOT of money for replacement leafs. This is just a temporary temporary measure to stop the slamming.
Front
Option 1: 2" Lift Shackles
Option 2: 3" Mini-Pack Leveling Kit
Rear
Option 1: OEM F-350 4" blocks
Option 2: Generic 4-5 Lift blocks
I really like the shackles for their price. Flip side though, I feel the mini-pack would firm up the ride a tad. My old F-250 rode like a truck, and the X just doesn't.
Are the factory front shocks long enough to support 2" of extension without breaking? I really didn't want to mess with the rear suspension, but she sits pretty level right now and I'm not a fan of the Bulldog look.
View 12 Replies
My 2000 1.8t passat is quiet sick and i am unsure of where to start. here are the symptoms:
- rough idle for a minute or two when started cold
- occasional erratic idle
- low power
- the CEL would blink for 10-20 seconds on startup
- checked and cleared the codes at autozone, and now the car seems to be in limp mode. engine has NO power, cannot get speed above 20, misfires
when you try to go faster
Where are the codes that were stored:
-P1136 Air/fuel metering
- P1128 Air/fuel metering
- P0507 Idle control system, RPM high
- P0300 Random Misfire
- P0301 Cyl. 1 misfire
- P0302 Cyl. 2 misfire
- P03011 Cyl. 4 Misfire
View 6 Replies
A few months ago my automatic 2000 hyundai accent GL was having problems reversing. Some times it would, sometimes it would move a few feet then fall out of gear and stop, sometimes it would not move at all.
The reversing problem fixed itself about a month ago.
Recently i started having problems accelerating, it was noticeably slower to get to speed and had problems upshifting.
Today, it started to make a buzzing when in Drive, while decelerating after getting to speed. This buzz is nonexistent in neutral, 2nd, or low gear.
Here is a video of the sound it is making, with captions to explain what i am doing... 2000 accent transmission problem - YouTube
View 2 Replies
The MIL light up and I got the P0501 Code. (Speed Sensor. I use a Scangauge II and the Speed is 0 KM/H at any speed. (was working before). But the in dash Speedometer work no problem. I look on the HMAservice web page and did not found where is located the Speed Sensor.
View 9 Replies
I have a '05 Accent GLS Hatchback. 5-speed, manual transmission with about 82 thousand miles on it. I bought the vehicle used about 2 years ago. Ever since I've had it, its been a little jumpy in first gear when going at very low speed. Especially during traffic jams, barely pressing on the gas will cause it to jump a little bit until you put the pedal down further. Lately its starting to do something similar when it 4th gear. When you push your foot on the pedal it jumps a little and does the same thing when you take the foot off the pedal. What may be the cause? O2 or TPS sensor maybe? It did give me a flashing check engine light for about 10 seconds this morning but it hasn't done that since.
View 5 Replies
My hyundai accent 2005, have problem of jerks /die speed after engine get warm, also increase if AC on, when I starts car in morning it works great and no problem but after 3 or 5 km as engine get hotter speed kills,but it happens more or worst in evening at 4 when returning from office and temp is 45+ in riyadh, saudiarabia.
I change air filter, fuel filter, spark plugs, spark cables, also use fuel injector cleaner but still problem remains, I want to tell you its start when I changed engine valve cover gasket due to oil leak, as I changed this problem suddenly appeared, I went to other mechanic but he told me the problem not in valve cover gasket,it is somewhere else he clean my throttle body ,and its works for 2 day only that i felt the problem solved but after two days problem appeared again,there is no engine light power on for any electronic malfunctioning.
View 15 Replies
3 times now in the last week, my 2000 accent has stalled. each time it was at a low idle, slow moving speed. I was rolling up to a red light twice, and gliding into a parking spot the other. There was no coughing or sputtering. It just stopped. Each time, after about 20minutes or so, the car fires right up. it happened twice today after about 4 miles of driving. If the car sits for a day without running (on an off day from work) its a bit hard to start sometimes, but not consistently. Does this sound like a Crankshaft position sensor? or possible a fuel filter?
View 5 Replies
I have a 2001 accent 1.6 5 speed manual. When I put it into reverse it dont fully engage until I give it some gas and then it slams into reverse with a bang. I am not really sure but I think it only does this with the car is cold I may be wrong though it started this a few weeks ago.
View 3 Replies
Have replaced BOTH half axles. Clicking sound present when driving - does NOT change when turning right or left. Seems slightly affected by acceleration/deceleration - makes clicking slightly louder/quieter. Clicking is DIRECTLY proportional to speed - slows down until car stops. Transmission works fine, fluid level is correct. New trans fluid and filter. What the heck could this be? Wheel bearings seem solid - jack up car and try to wiggle wheel - solid as a rock both right and left sides. WHAT ELSE COULD THIS BE???
View 4 Replies
I'm having an issue with my transmission. When driving it shifts just fine, but I have to let it accelerate slowly. If I press to hard on the accelerator pedal the engine ron races. So I ease up and it catches and slowly accelerates. For example going up hill, I press the accelerator and the car doesn't speed up, the engine races, so I have to just let the car slowly increase in speed by lightly pressing the gas pedal, no get up and go! Only occurs in 4th and 5th gears. What could be causing this. I have already flushed the gear oil as I had to replace the output shaft seal as it was leaking.
2000 Hyundai Accent 5 Speed Manual Transmission....
View 3 Replies
I have a 2005 accent gls. I use the car for deliveries so a lot of stopping/starting. when the car is hot, the AC compressor will shut off after 5 seconds, and not re-engage until about 20 seconds, then only on for 5, so not keeping cool air. I noticed when I turn the AC on, the condenser fan (i think) kicks into high speed so I assume that's what it should do, but when the issue is happening, it does not go into high speed. the shop I went to wasn't able to determine the problem. they checked pressure and evacuated the system. when it works, it blows cold as it should.
View 3 Replies
2005 hyundai accent, I've noticed something unusual with my trans, whenever I start driving at lower speeds ( which I do all the time to save gas) the transmission shifts into 2nd and 3rd just fine, but in 3rd gear ( at around 2.5 rpm ) the RPM gage goes down a little bit ( about 2.1 rmp), it almost feels like it went into 4th gear and it happens really smooth, it almost feels like its supposed to do that, the car later shifts into 4rd at around 3 rpm, there's no jerking, stalling or sounds at all, this does NOT happen when I take off at a higher speed and acceleration. This transmission has 55.000 miles on it and besides this it works perfectly fine.
View 1 Replies
I have a 2004 Accent with 150,000km on it. I've done a number of jobs on it, and I find it to be a relatively DIY-friendly vehicle. A little while ago I had an issue where it would die after warming up, sometimes at a stoplight. Otherwise, it would intermittently fail to start after it had been parked for a very short time. This was fairly obviously the crank position sensor, which I replaced. At this time, I haven't had the same issue again.
Since that small repair, however, I have been noticing other issues. From inside the cabin I can hear a distinct whine that climbs 1:1 with the engine RPM, whether or not the clutch is engaged. Once the RPMs hit the power-band(ha-ha), the whine is joined by a metallic jingle. From outside the car, both whine and jingle are audible through the entire RPM range. It sounds to me like a clear case of bearing noise coming from the belt and pulley system.
Since this whine started, the car has been giving lazier starts, requiring slightly longer to fire up. The noise changes significantly when the AC/defrost system are engaged, although I'm not sure if this is because the faulty part is connected to that system, or because the RPMs drop once it's engaged, both, or neither.
I will be doing a timing belt and water pump change before the snow flies, and I would love to find the parts that I need to treat the jingle at the same time as the rest of the belt system replacements.
View 1 Replies
