Acura - TSX :: Pulsating In Steering Wheel (shaking) When Braking At Times
Jan 29, 2016
I have a 2007 Acura TSX with 117k miles. We had the rotors and pads replaced in July of 2014 at Midas (won't go back there again!). Anyway, we are getting a pulsating in the steering wheel (shaking) when braking at times. Sometimes it is much more noticeable than others. This started shortly after having the pads/rotors installed. I took it back to Midas, and of course they couldn't duplicate the issue.
So, here's my question, can we continue to drive the car until it needs new pads (then I'll change the pads and rotors)? I know that the steering vibration can be annoying at times (it's not AWFUL, but you can tell that they're warped). I really hate to have to replace both right now as money is pretty tight with buying a house.
View 4 Replies
Advertisement
After my 2006 Ford F150 Lariet started shaking and pulsating when braking (38,000 miles) I took the truck to the Ford dealer and asked to have my brake pads checked. They came back and siad they looked fine and I had alot of wear left. Then I mentioned that is was shaking and asked them to check it again, they drove it and then said my rotors are warped and I need to replace the rotors and pads. I don't haul, tow or do anything crazy with it.
Now, here's my questions:
1. Can the rotors go bad and the brake pads be fine?
2. Should I go with a ceramic pad or stick with the OEM?
I'm just a female and don't want to be taken advantage of at the dealers. Cost is not an issue when purchasing a good product.
View 14 Replies
My 1.8t gli is giving me this issue, when braking (specially hard) my steering wheel shakes side to side, my rotors got changed less than 20,000 miles ago (all of them) and they seem fine right now.
Could this be my Tie Rod ends? The car has 110,000 miles on it, and i know some bushings if not all need to be changed, which I am gonna be installing when i put on the Raxles i just got.
View 8 Replies
700 miles ago I got new brake pads on all 4 wheels and new rotors on the rear wheels. 700 miles later the steering wheel still shakes when braking at above 60mph speeds. Also there is still a squeak sound coming when braking. Do I need to give the new brakes and rotors more time to adjust or were they installed wrong?
View 7 Replies
Lately my 2007 GX470's steering wheel has a shaking/vibrating problem whenever I apply the brake at speed above 50 mph or so. Without braking or with braking at slower speed, there is no problem at all -- everything is glass smooth.
1. I assume the front brake rotor is warped?
2. Will I need to change the rotor or is there a way to fix the warp (it that's the problem) without changing the rotor?
3. Approximate part & labor cost?
I plan to bring to dealer for a check up but would like to know ahead of time what to expect.
View 14 Replies
I've been chasing this for longer then i can remember. At 40-45mph the rear end feels like its bouncing. no movement from the steering wheel, just a pulsating bounce. Little information about the truck: Has had Napa Gold shocks, Bilstein 5100s and currently Monroe reflex shocks. Installed readylift 4inch rear block kit about 2 years ago. Had 16x9 rims, currently has factory 16x6.5. Tires are 285/75s. New pads rotors and calipers. It's just driving me nuts to have it bounce all the time.
View 9 Replies
My car has shaken from the start but I thought it was because it was a small car that was a great price so this is how it ran. Today it started shaking so badly up through the steering wheel that I was afraid to drive it. Still am. I got the tire pressure checked, the wheel balancing checked - all ok. Took it into the dealership (car is still under warrantee) and they think it's likely the drive train/drive shaft.
View 3 Replies
I just noticed today that when I let of the gas my steering wheel will shake a little bit and when I let off the brake after I come to a stop light my steering wheel would shake. Why the could be happening. Could it be from a bad axle, alignment, something wrong with the brakes, bent wheel, balancing, or something.
View 3 Replies
I have had the O.Z.s balanced about # more times since. The front end is fine, new bearings, new control arm bushings. I have the necessary parts (aftermarket conical bolts and hubcentric rings). There are no noticeable bends or dents in the rims and it's starting to get annoying..so, should I get rid of them or maybe there is something that I'm missing here. Could the wheels just be bad.
View 24 Replies
05 GX 470...no KDDS...100k miles. When I've been driving a few miles, I feel a pulsating when braking. Feels like it's coming from the front (front left if I had to guess). I put in new rotors and brakes in the front, turned the back rotors and problem still persists, no improvement.
I'm now considering the hub-bearing. However, when I do the standard-check (lift wheel and apply stress from top/bottom) there's no indication of a bad hub bearing.
The problem worsens as I drive faster. When on the highway, if I start to turn the wheel right 'then' brake...the steering wheel pulsates bad. When I turn the wheel left 'then' brake, it's not as bad...but still noticeable. When I start pressing the brake pedal 'then' start to turn the wheel right it's still there but not as bad compared to applying the brake after turning.
There's no pulsation in the break pedal, only the steering wheel and body/chassis.
View 13 Replies
I just had new rear drums put on, my front brake pads are new, my rotors are good...but there is still a pulsating when I brake. When I am just about slowed down you can definitely feel a surging coming from somewhere. The steering wheel does not shake, and I don't feel more than a vibration from the brake pedal. I have taken it to 3 mechanics and replacing the drums was given as a solution. But since I have already done that, the problem is obviously not resolved. I know I need new tires as 2 of them are really cupped and loud...could that be it?
View 19 Replies
Got new brakes 4 months ago - except this time put in redstuff ceramic pads.
I've had really bad vibration and grinding lately so I just had the rotors machined and cleaned up.
Some of the vibration is gone but when I apply the brakes more than very lightly I get shaking shuddering including the steering wheel. If I apply the brakes harder it goes away.
I would estimate the pulsating/shuddering/shaking happens when I apply the brakes more than 10 percent up to say 40-50 percent. Very light pressure no problems and hard braking no issues.
This has gotten worse since the servicing. What could be causing this? I've already replaced the propshaft and am replacing the tires.
View 5 Replies
Sometimes my car starts when I turn over the key once. When it won't start, if I jiggle the steering wheel several times it will start. (When it's cold or humid it rarely starts without first jiggling the steering wheel). I'm not locking the steering wheel and I don't have trouble turning over the key. When the problem first developed I was told it's not the battery, alternator or starter. (I have a Toyota Tercel so the key goes into the steering column). (A few months ago a shop had it a whole day but couldn't get it to act up; then the problem went away for a few months).
View 2 Replies
I now have 14500 miles on my R and took it to the dealer Monday because the brakes are shaking the steering wheel again. After I had my R for 3 months and a little over 2000 miles it was taken in with this problem and the dealer turned the rotors. Everything was fine for about 3 more months and now had 5000 miles the brakes started to shake and grind real bad. I took it in again and this time the rotors were replaced. It was good till a month ago and they started to screach when I stopped and shake the steering wheel when I touched the brakes. So this is the 3rd time I have had brake problems and 2nd time the rotors need to be replaced. They can't tell me why this is happening. I was asked if I do a lot of hard driving, and I told them that I average almost 25 mpg and you don't get that driving super hard. I drive 76 miles round trip to work and all but 4 miles is highway with only 3 stop signs so it is easy to average that. I don't know how long the warranty will keep covering rotors if they can't find the cause. I love my R but I am not going to pay $700 - 800 or more for new rotors every 8000 miles.
View 21 Replies
When braking i would feel the pedal pulsating...figured the pads were finished. Checked them out and they were not in that great a shape so I changed them all around. I'm still getting a pulsating feeling in the brake pedal.... I just need to bleed them or are the discs warn or warped or something?
View 8 Replies
I have had a wobbly wheel since I can remember, it starts at about 55. I have replaced the front tires, struts and mounts, new rotors, brakes and I cant seem to figure it out. The front end is tight and the cv axle boot is still intact and I have never seen one go out without ripping the boot. If I lift the car up the front left tire hops a bit so thats the culprit but I cant seem to narrow it down anymore. I think its the cv axle but it seems weird considering the boot isn't torn.
View 4 Replies
I had a problem with my steering wheel shaking at various speeds. Eventually I found a bad inner tie rod and replaced it. The shaking is gone, but whenever I get over 70 mph there is still a very small vibration. I had all 4 wheels aligned after changing the tie rod. Tires are brand new, less than a week old. The mechanic checked my ball joints while doing the alignment and said they were good. Could my struts be causing the vibration? They need replaced, not sure if the previous owner ever replaced them and the car has 225,000 miles.
View 3 Replies
I am currently running 8mm ECS spacers in the front and 17.5mm ECS spacers in the rear. My Summer set up is still stock BBS RC's, but my winter wheels are Lenso's.
Last winter was my first winter running with the Lenso's and had no issues. This past weekend I swapped out the BBS's for the Lenso's, and now I am feeling vibration above 60MPH. I felt no vibration with the BBS's. I just took them in to get balanced (maybe a weight fell off-idk), and they were within 1/4 of 100% balanced. They then thought it may be the spacers I'm running so they cleaned them up, but said that it didn't work.
My alignment is also spot on-so that's not an issue either. I am at a loss as to what would make me feel that vibration after just changing out the wheels.
View 7 Replies
I'm almost at a lose here. I have a 01 1.8t golf and at 60 the steering wheel shakes and at 80+ i feel it in the whole car. I've already replaced both axles, wheel bearings, tie rods, ball joints, new coilovers, new wheels and tires, and passenger side control arm. There's not much more I can replace besides hubs and driver control arm or do u think it could be defective parts like one of the new axles.
View 9 Replies
I've got 2 identical 01 models with 150-200k miles that are having issues with the steering wheel chattering and shaking occasionally, like a pump is gravitating or something. I've only noticed it at low/no speed when turning the wheel. It shakes for a second or two, then quits. No fault lights on, and no codes pulled with mini vci...
View 8 Replies
I have a 05 gli w/ 65k miles. I got new plugs gaped correctly and new coils. When I'm idling at 7-800rpm my steering wheel shakes a little and when I flip on the ac it's even more noticeable. So much the rear view mirror shakes just a tad. What do yall think it could be cause it's not that bad but I'm anal about my cars and I want it to be perfect.
View 11 Replies
