Got a nice rattle coming from the serpentine belt area of the camry, before I order some parts, I'm thinking the bearing in the tensioner is done, I just don't want to swap it out only to find out its my water pump barking or alternator bearing/bushing. doesn't seem to be emanating from the alternator.
Here's the short video : [URL] ....
There has been a noise coming from the serpentine belt area for some times now, and I thought when I get to work on the belt I will get it fixed.
Last night, I replaced the alternator with a brand new one from idpart with a clutch pulley (the original pulley was plastic). I also replaced the tensioner and serpentine belt with this kit from ECS: [URL] .....
Everything was put back tight and nicely. Turned on the engine: the noise is still there.
For sure there is one pulley on its way out, but with one?
Video here: [URL] .....
Noticeable @ 0:47
It's a 2.0 AVH Jetta.
So, when I was leaving work I started my car up and heard what sounds like a low grinding noise coming from the area where the serpentine belt is. Let the car idle and it remained.
Put the car in gear and drove off and the sound was still there. the sound gets louder as I increase my speed. It went away a couple of times when I was braking, then came back.
I stopped at the gas station and could still hear it. After getting gas, fired the car back up and heard nothing. When I drove off, the sound returned.
I got home and put it in park, leaving the car on, opened the hood and could still hear the noise. Pressed and held the gas a few times and the sound did get louder.
I am pretty sure it is coming from some rotating part, but no clue what part. What this could be?
recap:
-get noise on startup
-while driving noise gets louder
-sometimes it stops when braking
-sound coming from area of serpentine belt
I have 1997 F250 LD since i bough it has been doing this chirping sound coming from the serpentine belt and the pulley area but when the truck has been working for 15 - 20 min it goes away
This is apart from the from the problem before I think the fan clutch is broken because when I start the truck I can hear the fan going at the same speed of the engine is that normal ? even when the truck is cold
2005 Camry SE 4cyl 5 speed stick. 126k miles bought new well maintained with a minimum of problems. In the last couple of weeks a funny type of rattle has developed in the right dash area. Sounds like a snapping noise when I go over certain types of road imperfections. Almost like a loose small light bulb socket inside hitting something. Tried it with the glove box open no change. Can't see anything wrong behind the glove box where you change the cabin filter. No recent change in any control operation or electrical issues concerning the dash area.
View 3 RepliesI recently purchased a 2009 Camry with 95,000 miles. The Camry was purchased new at the dealer that I bought it from and all of the maintenance had been done at the same dealer so I have records of everything.
I did not notice any rattles when I test drove the Camry but driving it the next day I noticed two rattles. The first rattle was the deck area behind the back seat. That was easily fixed with some card board shims placed the right places. I will do a permanent fix later.
The other rattle was driving me crazy. It did not do it all of the time and to me it sounded "exactly" like it was coming from the area around or in the glove box. I took the glove box and the area around it off and could not find the source of the rattle. I had my daughter drive the car while I set in the passenger seat and the rattle never occurred.
I finally found the source of the rattle. It was the lid for the center console. The lid originally had two rubber bumpers. Both of the bumpers were either missing or worn completely down. When I had my elbow on the center console lid the rattle did not occur. I fixed it with stick on drawer stops.
Serpentine belt break? My 2005 Prius has 132,000 miles on the original belt, so I thought it's probably due for replacement. I went to an independent garage to get an estimate ($80). But the owner said that he has never heard of one actually breaking. He said that they are reinforced with fiberglass, so they just don't break. He recommended that I look for missing chunks and listen for squealing.
View 2 RepliesI have troubles with what I thought would be a basic job: removing the belt on my 2004 Solara so that I can remove the alternator. I can't get the belt loose enough to slide it off, no matter how hard I try.
The wrench I'm using is about 12" long, I'm a big guy and I've done powerlifting in the past, meaning I can apply lots of strength on that wrench. I've just watched a youtube video of a guy with the same engine removing his belt, and he exerted a lot less effort for a lot more wrench travel. I thought that using a breaker bar is extreme.
I have a 2010 camry SE & have found nothing about how to change the serpentine belt on the 2.5 engine.
View 1 RepliesA noise has been coming from my Serp belt for awhile. My serpentine belt doesn't have any wear. At least It doesn't look like it. Will this noise go away by replacing it? or is it something else? Is it the tensioner? I've noticed when car warms up the noise goes away. I do not know the last time it was replaced.
Here is a video : [URL] .....
Car - 2001 Jetta TDI with 230k miles.
Is it time to replace? There is a noise coming from the belt and when I listen with the hood up my best guess is that it's the tensioner. I'm not sure if it is easy to replace or if that is even the problem. The belt looks fine. It allows me to twist it barely less than halfway so to me it does not seem loose. But in the rain last week got the battery light and lost power steering, power brakes, etc, then it went back to normal and hasn't failed again since. The car has 131,000 miles.
Is there a way to check the tensioner? It's pretty tight in there. Or am I wrong as to what the problem is? The sound is a rubbing/slight clicking sound that is in time with the engine and you can hear it if you listen inside the car when the engine is on. The belt also seems to wander around on the tensioner just a little. One day it was about a mm in too much, a few days later, a few mm out, in relation to the pulley.
I was wondering because serpentine belt is a big thing for 05 corolla since everything runs on it. I also had a 94 camry which had a alternator connected to a belt. and if i wanted to tighten up that belt i would just loosen the alternator and pull it. Is there a way to tighten up serpentine belt in my 05 corolla in the same way?.
View 1 RepliesI have a 2007 ES350. It started making a vibrating noise and sometimes screech coming from the serpentine belt area. It stops when I turn off the A/C and also stops when I accelerate with the A/C on (only does it when idling).
View 3 RepliesI have a '06 sonata 3.3 v6. Let me first describe what was happening to the car before the noise started. When I first started the car and put the ac, the first time turning the steering wheel in either direction the steering wheel would tighten up and the battery indicator light would come on and the fasten seatbelt light would flash even though I had the belt fastened. It would only happen the first time I would make a turn and after that I could turn with no problem. So in recap, it would only happen on the first turn and only when the ac was on. Now when I start the car up there is a noise coming form the pulley/belt area. I wouldn't classify it as a squeaking noise more like a grinding. I've looked at the belt and it seems to be fine. After I start to drive the car the noise goes away. If I start the car again after a drive within about 2 hours the noise doesn't happen when I start it. What this noise could be? and also could the noise and the steering wheel tightening when the ac is on be connected?
View 1 RepliesLeaving on a 200 mile trip in the morning and when checking the fluids, I found the serpentine belt trying to get off the AC pulley. I've put in on twice and it immediately jumps half way off when starting the engine. How long it's been doing this. Nothing is obviously loose or moved. What is likely causing this?
View 8 RepliesAfter finally identifying a bad serpentine belt tensioner for being the the culprit for my engine noises, my mechanic said that the 'thru-bolt' is siezed. Since the replacement job was at my budget limit he said he doesnt want to get into it in fear that he has to brake the bolt and drill it out (requiring 2-3x more labor cost according to him).
If this is the case, and the 'thru-bolt' is seized, is this in any way something I can make a an effort to tackle? I have a jack and jack stands, and plenty of time.
2002 Camry 4 cyl. Can the idler pulley alone be replaced on the serpentine belt tensioner? I noticed a very slight side to side play when I had the belt off. No noise from it. When I looked at rock auto, they sell the whole bracket with the pulley.
View 2 RepliesI noticed my serpentine belt started squeaking about 3 days ago. And yesterday as I was driving to work I heard a clicking sound coming from the left side of the hood, then my car started to gradually shut down and white smoke was coming from the engine. When I got to the stoplight it completely turned off, but I was able to turn it back on again to turn into the parking lot before it shut off again. When I checked it there were no visible leaks, my reservoir for my coolant was still full, and my meter never went up indicating that my car was over heating. I'm not sure what's wrong with it, but after it sits for awhile it is able to turn back on again for a while.
View 3 RepliesHave a noise coming from the serpentine area. Sometimes it's a bit of a chirping, other times it's almost like a solid grind.
I pulled the belt off and the idler pulley had a bit of play so I replaced that. The tensioner pulley felt fine. I'm suspecting the fan clutch, as the noise only appears after the clutch has disengaged the fan (although it could be this is just masking the other noise because I've got a heavy duty / loud fan clutch setup).
How can I be sure that the fan clutch is the culprit before replacing it?
I plan to take the timing cover off tomorrow, but I wanted to post this video. You can hear the rattle immediately in the beginning of the video below and then intermittently after that. Also, is that whistling noise you hear while the engine's running normally?
View 7 RepliesRattling noise in the belt area of the engine...
View 3 Replies