Camry :: 2009 - Check Engine Light On / Error P0500
Feb 6, 2012
Currently I haven't been tweaking anything to my car after driving to go and home I left to go get something to eat and after driving for a few min out of nowhere the engine light, brake and abs comes up. So I freak out a pull over to the nearest gas station and turn my engine off for 2 min and turn it back on and this time only the engine light come up. So I drove to autozone to get it scan and error p0500 comes up. Which means short circuit, vss and poor electricity something I am not exact but is it serious? Like I am freaking out right now.
View 1 Replies
Advertisement
A couple of weeks ago the check engine light came on and when I had the codes checked it showed a problem with the EGR valve. I replaced it and the light went off. A week later the check engine light came back on but when I had the error codes checked there weren't any. After a few days the light went off but earlier today it came back on. There are still no error codes.
I forgot to mention that it's a 2000 Camry, 6-cyl.
View 4 Replies
I have a Lexus es300 1995 and lately its been acting crazy. It all started when I had to push the pedal all the way down just to get to 60 mph and when i took my foot off the pedal the car almost stopped completely, would not coast well. Then the check engine light came on. Took it to dealer got codes p0500 and p0720..they said get a new ecm and dash cluster. Got both used from a junkyard. Car drove fine, then check engine light came on again and drove crazy again.
I was told the ecm needed no programming just plug and play ..is this right? Did I get a bad ecm? Coud it be another problem?
View 8 Replies
I've got a 2000 ex limited with the v10.4x4. The engine light came on. So I had it scanned. Also the a.b.s light is on.and the overdrive off light was flashing but now isn't. The parts store that scanned it said code was po500. Told me it's a speed sensor but that there's 3 of them on the truck. Which sensor it is.
View 14 Replies
I am far from home. Taking a road trip. Day 2 out of 6. My check engine light came on, so I just pulled over. All fluids were fine. Found some place to read the code:
P2757 TCC pressure control Sol Ckt Perf / Stuck off
The guy said it was something to do with trans.
View 3 Replies
I have the code P0500 on my 2009 Matrix. The odometer doesn't function, all error lights are on, the power steering is not completely out but it's reduced. Also, the rear windshield wiper is constantly on. I replaced the vehicle transmission sensor today because I thought that would fix it all. It had absolutely no effect.
View 5 Replies
My check engine light keeps coming on sporadically and giving me a PO101 error code...then I'll reset it after making sure my MPG hasn't dipped a significant amount (which is my "concrete" way of gauging if it's performance is impaired) and it'll come on 1-600 miles later. There's no consistency in environment or conditions that are triggering this sensor, at least it's not obvious to me. I finally looked under the hood at the filter and it's a little dirty, but not nearly dark enough for it to be the problem.
View 4 Replies
So yesterday I decided to wash my truck and after taking care of that I took it for a short drive and the tranny started acting funny. Check engine light comes on and the code is P0500 . It calls for a VSS but I cant locate it. Also the fact that it did after washing the truck is making me think its a wiring issue... F250 SD 5.4 4x4 ....
View 5 Replies
My sister has a 09 camry le I4 and on her way home her VSC Trac off and check engine light came on. What the cause is ( she checked the gas cap )...
View 4 Replies
My 2009 Camry check engine light is on. Dealer said the two O2 sensor both are dead and need to replace. After dealer reset the check engine light I have driven two days for 50 miles and the check engine light doesn't come back. If the O2 sensor is bad how long does it take for check engine light on again? Is it possible the check engine report on by mistake since two O2 sensors got bad at the exact same time is really rare.
View 13 Replies
My wife called to tell me that her Camry would barely pull away from a standstill this morning. Very sluggish until about 2500 rpm, at which point she said it took off normally. This accompanied by the Check Engine light, which just appeared this morning. I haven't been home yet to check fluid levels or take a test drive. Anything in particular I should be looking for?
View 6 Replies
A few days ago my "Check VSC" warning came on along with the check engine and traction lights being on. I left my car in a parking garage for a week when I was on vacation and the lights came on once I started the car after getting back from my trip.
I have had the "Check VSC" warning before and I fixed it by replacing my gas cap. My gas cap seems fine this time around so I got my codes scanned and the only one that came up was P0300. Having this issue with the 2007 Lexus GS 350? I still feel like it's my gas cap because I bought a cheap replacement last time around.
View 8 Replies
My Lexus was working fine till yesterday, but today when I started (button press) it, it started giving me a Check VSC error and Check engine light along with Slip Indicator started showing up
Took it to Autozone for the codes and got
P0015
P0304
C1201
B2799
View 7 Replies
Check engine light came on. Just over 100,000 miles. Car running fine, no new noises or rough running or lack of power. Wife took to get oil changed next day. Dealer diagnosed as a sticking valve. Personally I would have cleared it and seen if it reoccurred but dealer already special ordered valve. Searching on the p0012 code I see nothing like this.
View 3 Replies
Last night I was driving home in my 2002 Prius, and the 'triangle of death' as you call it, went on. I got off the #405 and parked for 10 minutes while I read the manual which said get to a dealer as soon as possible. I started it back up and the engine seemed to be fine but the 'triangle of death' was still there, so I decided to continue to drive but stayed in the right lane.
I must have gone another 20 miles when I suddenly lost engine power, the headlights and dashboard were fine, and hazard lights worked fine. I was able to get to a safe place and towed the car home. Along with the 'triangle of death', the check engine light (little red icon) was on but I didn't get the 'Main Engine' error message.
View 4 Replies
2003 1.8t passat wagon. 50k miles... The check engine light came on today. Oil and engine temp are fine. Can most shops plug in and diagnose? Can I get one of those code readers at Advanced Auto parts to read the error code?
View 5 Replies
After only 1k miles after purchase my Check Engine light as come on. P0440 and one other (left the paper at work)
I haven't overfilled on Gas, the Gas Cap is completely on (2 clicks), and I haven't OVERLY pushed the car either haha.
The only update was replacing the STOCK filter with K&N Drop In Filter.
View 2 Replies
What is the meaning or the fault concerning 4608. The above error code was reported on the computer diagnose machine and it referred me to look into the vehicle ownership manual book BUT its rather unfortunate that i could not find that book. So, what to tackle or replace on the engine to enable the check engine lite go off.
View 17 Replies
I got a P0118 error code on my car. Looked up some things and most people were saying change coolant temperature sensor. I changed it 2 days ago and have not had a chance to clear the CEL. Its still on now, guy at Autozone would not clear it, said it was against company policy.
Will this turn off automatically once problem corrects itself? I went to Autozone and had them rescan the error, this time another code poped up P0444, EVAP(Evaporative Emission System)Evaporative Emission Control System Purge Control Valve Circuit Open. What this can be?
View 3 Replies
I recently had my check engine light come on (again) and it's registering a P1175 error (again). This is apparently indicates a problem with the "fuel trim cylinder balance" in bank 2. And according to what I've read can be caused by a number of things, such as a faulty oxygen sensor, ignition problem, fuel injection problem, or some other condition.
I say again, because I had it come on about two months ago with the same error and when I took it in they flushed the fuel injectors, which was apparently recommended by bulletin 03-06-04-030H.
Unfortunately the light has come on again, and stayed on. This happened after I stopped to get gas on my 6 hour drive from visiting family in Michigan. Another interesting data point is that this code has been in the warning state in my engine for over a year from what I can tell. I've only used my OBD2 reader a couple of times. First was 9/2011, and no problem was detected. Six months later in March 2012, I checked it again and P1175 was a "pending code". I hadn't used the reader until this problem. But now, over a year later, the issue has apparently moved from a pending problem to a more serious one.
What this all boils down to, is that I'm asking opinions as to what the problem may actually be. I'm curious at to what could have been so long in developing. I intend to take the car in to get looked at shortly, but in the mean time I figured I'd ask around.
For reference, my car is a 2008 Saturn Aura XE, with about 71K in mileage (over 13k since I got that reading in 2012).
View 9 Replies
I have a 2008 Camry Hybrid and recently got a "Check VSC System" warning light. A diagnostic resulted in a C0210 error code. The code is for a right rear speed sensor malfunction.
I had a local shop look at it and he replaced the hub accembly including the speed sensor. It didnt work. He and I took a ride and on his diagnostic tool, the speed reading for the right rear wheel was all over the place.
The next day he replaced it thinking that the new sensor was bad. This worked, however only for a day. Now the light had come on again with the same error.
View 2 Replies
