I just bought this little car. It ticks at an idle and it burns 1/4 qt of oil a month. It doesn't stop ticking when I add oil so Im at a loss.. It isn't a loud tick either. It has 200,000 miles on it but it is in great condition besides this.
View 13 RepliesMy 1992 Toyota, Celica had developed a really weird idle surge. The idle surges between 500 to 750 rpm. The surge goes away with the AC on and it idles steady at 900 Rpm. It also has a slight off idle bog that may just be another symptom of the weird idle.
I did the diagnostic test today and it doesn't flash any codes. I pulled the EGR valve off and cleaned the gunk out of it and it didn't make any difference. I tried to check the timing and it idles so bad the timing bounces 7-10 degrees with the surge. When I did the jumper to check the timing it would kill the engine. The plugs and wires are new with in a couple thousand miles. It runs fine above idle and pulls to redline easily in the lower gears.
Yesterday when I was messing with it I had the car running with the air boot from the air cleaner to throttle body off. I sprayed carb cleaner into throttle body and it seems to clear up a little bit. Then it went back to surging again.
I tried to pull the TPS off yesterday and of course the bottom screw stripped out. Now I will have to pull the throttle body off to get the screw out. I wish it would throw a code so I could have it give me a clue.
It's a 1992 Celica, GTS 2.2L for reference.
After driving down the highway I noticed my temp fluctuated from half way to full and bounced around until I arrived at the closest Canadian Tire/Station. I looked under the hood and noticed the stain on the coolant container wasn't the actual level of coolant. I then topped off the coolant and parked the car for about a week. When I tried to start her up, I was faced with a weak and poor idle. Almost as if the car is struggling to run. I have had times in the recent years in the summer months were I felt I had to pump the pedal on really hot days to kickstart her so she would run. Was this a warning sign? Other than this problem I face, the car runs smooth. I did a good tune up 2 years back, replacing the ignition coil, plugs, etc..
The idle goes from 0 - 500RPM in neutral and when I apply gas it struggles to gain power. The car is parked, I don't dare to take her around the block. It stutters and seems like she is struggling to get fuel. I say that because, when the key is turned to the on position I do not hear the fuel pump underneath the back seat activate. I did try jumping the terminals, something like B+ and FP.... The pump turned on and I heard fuel but when I started the car, I still had the same problem. I would need to pump gas or she would stall out. I do not know where the fuel line is to try and check the pressure or even where the relay is located.
Could it be the Fuel Pump?
Could it be the Fuel Pump Relay?
Something Else?
My guess is the Fuel Pump, but if you could take a few mins and replay that would be great. I have had my Celica for about 7 years and I would like to keep her going!
I just bought a 92 Toyota Celica for something to play around with. It's got just over 200,000 miles and everything seems to run alright except there is a really rough vibration at idle. The vibration is so bad that it's almost visible. You can still feel the vibration in drive but it isn't nearly as bad.
Any clue at what could be causing the vibration? I'll try to get a sound clip or video uploaded ....
I recently bought a 92 Celica gt (5s-fe). The engine feels like its misfiring and wont idle on its own.
I've done all the normal maintenance to it and the spark plugs all show normal signs of wear. I haven't verified fuel and spark yet. Check out the video below. The piece of cardboard is to keep the throttle partially open. Also, the exhaust is broken off at the flex pipe so excuse the awesome sound ...
[URL] ....
Alright so I got a 92 toyota Celica 2.2 5SFE recently and guy before did a head gasket.. well i started to work on the car. fix things here and there. well one issue I cam across was low compression.. 170 170 30 90.. so i was like ok the guy didnt do it right.. took it apart. found out valves were stuck open. So i ordered a remmaned cylinder head to put in and new head gasket set etc.. replaced all gaskets that came with it..
Also put in remanned fuel injectors due to one leaking so i just replaced em all. New plugs, wires, cap, rotor, timing belt, followed the oem manual word for word to install and remove and timing is right. But I got it all back together and ran great. until my tps went out(replacing that soon). Compression is now 180 across the board.
Now I got a knocking issue, Its quite apparent at idle/ low rpm.. solid sound, goes away at higher rpms, gets plenty of oil to cylinder head, started bout 150 miles after finishing. Im not sure where to start.
My wife has a stock 03 Passat 1.8t.
1. The car seems to shift too soon from 2nd to 3rd and i can hear the turbo drop pressure. It sounds like a quiet blow off 3 or 4 times when it shifts from 2nd to 3rd.
2. There is a vacuum control valve that sits on top of the air cleaner box and it ticks a lot. it has a electric plug going to it.
3. The car has a rough idle while in drive and sometimes shifts hard. I changed plugs, trans flush and filter change.
I would take the car to a VW dealer but the closest one is about a hour away and my wife needs the car.
I have a '03 Civic DX 5 speed. It has 128000 miles on it. I've notice now that it is getting colder, my engine ticks when it is warm - I can hear it at idle and low rpms, but not at higher rpms. It sounds perfect when it's cold, but once it is warm, it has a "tic-a-tic-a-tic-a-tica..." sound. Tom and Ray talked about a Dodge Dakota that made the same sound when the engine was cold (about 8 episodes ago). So what does it mean if it only does it when warm?
View 9 RepliesMy brother was the original owner then passed it on to me. I then passed it on to my younger cousin about two years ago. The car is completely stock and has never been modified. Everything is OEM.Just a couple of weeks ago I was called by my cousin saying the car broke down on her .The problem is that we took it to a few mechanic shops but they still haven't fixed it ...
Problem with car: When pressing on the gas, the idle drops and then the car dies (a scary event that happened to us and on a main road). I do not wish to bring it to another fail mechanic shop.What the shops did: changed all fluids, distributor cap and plugs, new spark plugs, and replaced air intake piping with oem piping.
I have a 1992 celica 2.2. Its had been running fine till this summer. I go and start it up this morning and drive a mile or so turn the car off go take care of some stuff letting it sit for about and hour and a half. Start it back up then go to drive off and it dies and won't start back up. I let it sit for an hour and then it started back up and drove fine.
I have replaced the spark plugs, and the ignition coil inside the distributor and checked for codes but got none.
I starts fine on the first start of the day but after that it doesn't want to start.
I have a 1992 celica GT 2.2l A/T. I was on my way home today from college and my car started to overheat right before i made it home. It was steaming a bit and the temp gauge was tacked out. when i pulled into my apartment i noticed a light brown colored liquid in my parking spot, and alot of it.
I saw this same liquid at my college campus and assumed it was a coffee someone spilled near my car, but now i know it came from my car. I haven't had a chance to check my houses yet as i just got home and my cars still really hot. I know its not power steering fluid b/c that's been empty all week b/c my reservoir leaks. Why my car is overheating and what liquid is coming from it. Oh also the liquid seems to be coming from the right front portion of the car.
I have a 92 celica gt with a 2.2 and I got it on the road and the next day it wouldn't start just kept turning over and not firing and it flooded itself I plugged in the block heater and about 20 to 30 minutes later it started no problem and now 3 days later I'm having the same problem but can't plug it in because it's at my work..... what it might be????
View 9 RepliesI have a 1992 toyota celica st204 i got my dignosis and it come up with 12rpm signal cranking just wondering what it is and if it will cause my car to lose a bit of power .
View 1 RepliesFan works and the ad button lights up but my rpms don't go up and the air doesn't get cold.
View 3 RepliesI've had this noise on my 92 GT since I bought the car and it hasn't got any worse but I still am wondering what it is in case it's something serious. I hear a rattle/clatter coming from the engine or thereabouts, and it only happens under load (doesn't have to be heavy load, but I can't hear it in neutral or when the clutch is disengaged). It only happens above around 3000 rpm and the frequency of the rattle corresponds to the engine rpm. It's difficult to pinpoint the location of it because it only happens under load. Anyway, I made a short video of it and uploaded it to YouTube....
View 8 RepliesI have a 1992 Celica 2.2. I've been having trouble with it starting after it has warmed up. I will go to start it and it will only crank but I can let it cool down normally like an hour and it will start up fine. I have replaced the ignition coil, fuel filter, spark plugs. And have checked the fuses and the distributor and they are fine. I wonder if its the actual fuel pump but I am no sure.
View 3 RepliesTemp knob is turned full to hottest setting and heat only blows warm. I checked the hose from the IACV and hose from just past the Thermostat housing and they are also hot. Where the hose enters the "Damper" just outside the firewall, it is hot but the small portion of hose after the damper into the firewall is only moderately warm. Is it possible that damper is clogged or is the heating coil iside the car clogged?
View 4 RepliesI have a 92 Toyota Celica GT five speed that won't going to gear occasionally. I can drive several months at a time without having a problem and then all of a sudden when I start the car to put it in gear and I have to literally force it into gear or turn off the car and put it into gear. I can go 5,6,7 months at a time without having a problem. Then all of a sudden it won't work. I would say within the last year I have had the problem I'm maybe three times. The last being yesterday since about September. I have had the car for 10 years and have replaced the clutch maybe three years ago. I have been driven a manual shift car since I was 16. Last year around March I replaced the slave cylinder and the problem seem to go away. Do I really need another clutch?
View 5 RepliesSo I bought a Celica a while back and the fuse box is uncovered meaning the cover that tells you which fuse is for what is gone. I can't find the cover saying which fuse is what online anywhere. If someone has a '92 Celica and can take a picture of it, that would save the day for me. It's a 1992 Celica GT 5 speed, 2.2L. Note that there are two fuses missing in the picture. I'm working on it right now, that's why.
View 2 RepliesChanged the plugs, wires, cap and rotor. I can't seem to pinpoint what causes the failure to start to occur. The starter engages and the motor turns. Letting it sit for an hour seems to solve the problem.
I have not replaced the distributor yet.
So I just replaced the timing belt, water pump, power steering pressure line and all associated seals and gaskets including the oil pan gasket and valve cover gasket. I fired the car up and everything appeared to be fine so I decided the next step was a nice little drive just to make sure all was well.
Everything checked out until I was a couple hundred feet from my driveway when I stopped to talk to a neighbor the oil pressure light started to flicker on and off, occasionally it stayed on for a second or two. when I accelerate the light goes away. I have not put a pressure gauge on it yet.
For example lets just say the pressure is good??? then what??? and the oil pressure switch is brand new. the oil pump passed the inspection listed in the manual and the only thing I did that it didn't tell me to was assemble the oil pump with some assembly lube after changing the shaft seal and housing gasket.