Celica :: GTS - Car Shakes When Engine Idling
Sep 10, 2011
So I just recently bough a Celica GTS off an old friend, and the test drive went smoothly. Bought of course, as soon as I got it home, things started going bad.
Sitting in the driveway for a moment, I started to feel the car shake when the engine was idling. I ran the engine up to 1.5K RPMS and it smoothed out, but you could still feel it, just barely. As soon as you let it drop down to the 1K, its horrible again.
Temperatures were fine, no trouble codes. I've Isolated it to the 2nd cylinder from the right, and I've already checked plugs/wires and done compression tests on all 4 cylinders. Fuel injectors are also working fine.
View 1 Replies
Advertisement
I own a Celica '00 and have been driving it for 8 years. In the last year I've noticed that my CEL started coming on. Did some scans and got P0171 error code from Autozone. The Celica was running lean and took some time to accelerate but run fine for a while. It got worse soon and I took it to a mechanic. He diagnosed a bad Cat Converter and he replaced it with an universal one. He also replaced the first Oxygen sensor, Spark Plugs, Fuel Pump and the Mass Air Flow sensor. Car's CEL came back one after 10 miles of driving. At that time I put in a 4" silencer for my muffler. The silencer had a 2.5" opening and worked well to lower the muffler noise.
The CEL was still on and I disconnected the negative on the battery to see if I can reset it. Well, once I connected it back and tried to turn on my Car all hell broke loose. The engine now has extreme sputters, shakes and hesitates to accelerate above 5-10mph. I barely drove it back to the mechanic. He still is not sure what the problem is, he thinks replacing the other sensors and troubleshooting the coils should be the next step. I'm wondering if my silencer could have caused any damage? Also, I'm wondering if there is valve damage inside the cylinder? The code we're getting now is Cylinder 4 misfire. What about the Fuel filter? I don't think it has been changed at all. The car is at 122,000 miles right now.
View 13 Replies
I have a 95 Celica ST (so it has the 1.8 7A-FE engine). When the AC is turned on and you rev the engine, when the rpms come back down it almost dies.
So say the engine is idling at 700 rpms with the AC on and I rev it up to 2,000 or something. When the rpms drop back down, instead of stopping at like 700 they go all the way down to like 400 or less and it almost stalls out. After a few seconds it comes back up to 700.
What does that sound like? All the vacuum lines are brand new, the throttle body/intake and egr valve were all completely cleaned of any carbon buildup.
View 6 Replies
Its a 1991 Toyota celica with the 1.6 and 5 speed trans. the motor on cold or hot start up shakes really bad and has a lot of valve chatter. Along with that, the motor does not want to rev at all, almost like you are not even touching the gas, but you have it to the floor. A little back ground on the car is, the car sat for 6 months and i bought it from a friend to drive back and forth to work to keep miles of my supra. He said that the CAT was plugged so i replaced it. I have replaced the coil pack, distro cap, spark plug wires, spark plugs, rotor button, catalytic converter, air intake, and all the air tubes that looked like they were cracking. Now I can start the car, and it does the same thing. I thought it may be out of time, just because that is sort of what its acting like. I have had the motor rev up 3 times since i have had the car. But everytime I do it back fires and DIES, the car will not start til after the car cools down.
View 2 Replies
My '99 volvo s70 t5 with 132k miles is idling poorly causing the car to shake, and the mechanic who looked at it said I am not getting compression in cylinder #5. He recommends a valve job (not sure if it is the intake or exhaust valve but said 95% of the time that is the issue). The mechanic said they completed the compression test, and that is what told him it was cylinder #5. Cost is 3200-3500 for the repair.
and if the price is accurate. Given the age and mileage on the car, I am reluctant to invest 3-4k.
View 1 Replies
I have a 2001 Toyota celica GT auto. It has 120k miles. I seem to have an issue that really is not causing a problem except for annoyance. After coming to a stop the car seems to exhibit the signs of stalling (car idles rough, shakes a bit) however the car never stalls. Once I start driving all is well. Now I took it to the dealer and they replaced the Idle Air Control Valve which is under the throttle body. They said it was getting stuck and due to the higher mileage possible. It was replaced and the problem is still there. The funny thing is even though the car exhibits these stalling symptoms the idle does not drop below 500 rpm (both dealer and I have verified this).
View 3 Replies
My Yukon, with 140,000 miles, will sometimes start/fire up right away but other times it sluggish to start and then when it finally does it will shake for a while. Also, sometimes when idling at a stop light it will shake. It will also shake sometimes when I get around 60-70 mph. The rpm's are fine.
I replaced the fuel pump last spring and had a tuneup last summer. What could be causing this? I've had my mechanic look at it and he's hooked up his handheld diagnostic tool to it and it never shows any codes.
View 2 Replies
I purchased a 2011 ES350 today with 38k miles. I didn't notice it at the time of purchase, but the moment I put it into drive with my foot on the brake (idling), the passenger seat does a little dance. It's not terrible, and doesn't shake much while driving, but I would much rather it not be there because it's taking away from the experience of driving this beautiful luxury car.
On a different note, I had a 1999 ES300 that I recently gave to my 85yr old grandpa. The car now has 115k miles on it...it does not shake, and it drives like a dream.
View 9 Replies
Whenever I turn on my A/C and the car is in idle, it will turn off. Then I have to put it in park and turn it in again.
View 1 Replies
I've owned the truck for 8 months, did a fair bit of maintenance in the first two months (plugs, tranny fluid change, maf cleaned, o2s replaced), 320,000km runs very well, no codes.
When the truck is in gear and I put my foot on the brake after a second or so idling, the engine shakes. Releasing the brake, the shake stops, but it does it every time. Also, the belt or one of the pulleys will squeak a bit at the same time, but only idling with the brake on.
It doesn't seem like it is a serious problem, but what and why? My instincts are telling me it may be transmission related.
View 5 Replies
My 1999 ford ranger, when started, shakes and then while i am driving. my check engine light is on and reads a #3 cylinder misfire. I have taken it somewhere to get it checked out and they can't figure out what is wrong with it. this problem only happens 50% of the time. I don't know what to do. Also just got a tune up.
View 14 Replies
I just bought this transmission from a reliable parts dealer. Should have about 50k miles on it. Looked really clean when I got it.
The guys who put in the tranny cracked a speed sensor, so I bought a new one and put that in. I dried off the sensors and screwed them into their spot on the tranny after removing the intake filter that was in the way.
Even with the new speed sensor the car is still doing the following:
1) Does not go into reverse until I've gone into drive for a couple seconds, pulling forward. Reverse does not work. However, when I unplug the speed sensor reverse works right away, but we still experience the following...
2) car goes from first to second gear to third gear smoothly, as it should. Seems really smooth like a car should shift! However... it won't go past 3rd gear and then it won't downshift! So, even after stopping and idling, I can't leave 3rd gear.
3) When I turn the car off, then turn it right back on, I can go through first, second, third gear again then... it stays in 3rd gear.
Another issue that has come to my attention since I got the car back, is the steering wheel shakes pretty hard while idling with no gas. While driving it seems smooth -- idling again it shakes heavily. what could they have damaged while putting in the tranny to cause this shaking?
So far as the funny tranny stuck in 3rd gear, it seems to me like it's a computer issue? But, what could be the cause? What tests can I do to determine the cause of this problem besides the ones I've run so far?
View 17 Replies
My truck starts right up, then immediately almost stalls or stalls completely. It also shakes a little when idling while its in Park. I just recently had my egr valve, pcv valve, spark plugs&wires, and fuel filter replaced. it has 104,000 miles on it. What could be causing it to do this?
View 9 Replies
We recently had the timing belt replaced in our 2003 Volkswagen Passat (1.8T). Now it shakes and vibrates badly when we put it in drive and idle. It ran smoothly before we had the belt replaced. The mechanic hasn't found a solution yet.
View 2 Replies
My gpa just got a 2010 f150 and when is idling the whole front passenger side seat shakes. ik that is not suppose to happen and I am wondering what is the cause of that?
View 2 Replies
Car started idling funny and stalling. Finally wouldn't start. Changed crusty spark plugs, started up once, then stalled and wont start again. Checked for spark, no spark. Changed crust dist cap and rotor and ignition coil and still no spark. Checked ignitor activity and appears to be working.
What else is there? There's a little doofer next to the coil that looks like it has two wires come out of it, looks magnetic (has metal shavings on it, probably from old rotor)... Could the ignition switch be the problem? It cranks, but no spark.
View 9 Replies
I had an engine transplant (JDM) and am now getting P0300, P0301, P0302 and P0302 OBD2 codes with my Check Engine light. These are all cylinder misfire codes. A post on Google suggested these may be due to a leaking intake manifold gasket and suggested a replacement. My 2001 Celica GT is stalling out from standstill, idling roughly and hesitating.
View 8 Replies
I have a 1989 Toyota Celica ST and I am having a few concerns with my engine. The engine has less than 50k miles on it, and I took it to the mechanics a week ago and was told nothing further than what I had done (tune up, oil change, change of filters) would be needed for the engine to run optimally.
Even after taking my car in, I am still experiencing a few problems.
1) Sporadic Idle - When the car is idling, the RPM shifts around. At some points, it will be so loud that it sounds as if engine parts are clanking together, and at some points it is so quiet that I wonder if my car is on.
2) Slow Start Up - Sometimes when I start my car, the engine sounds as if only 2/4 of the cylinders are running..then, after about 30 seconds, the car will turn off. This has never occurred when starting my car the first time of any day, and has never turned off while I have been in transit.
3) Problem Starting Up after putting in gas - Whenever I fill up my tank from about 1/4 full, it takes my car at least 3-4 minutes to idle smoothly.
View 1 Replies
I got an 88 celica convertible from my neighbor. This is a fixer upper. It needs a battery and an alternator. But i jumped it and after idling for 10 minutes, the temperature Gauge was almost in the red. Yes the radiator has water in it. Is it the thermostat? Or the head gasket?
View 2 Replies
Car was warming up and I went to "check" the oil. As soon as I pulled the dipstick out a little all I heard was a sucking type sound and then the engine started to shake and make sounds like it was bogging down. Almost like it wasnt getting enough air. As soon as the dip stick went back into the motor, things became normal again. I tried one more time in order to see whats up as this is the first time something like this has happened. Same exact thing. Engine started to shake and make gagging noises until i put the dipstick back in.
View 24 Replies
R32 with 97,000 on it. UM tune. Engine shakes/shudders a lot, no CEL. Its hard to get into gear. I bought DLI motor mounts hoping that the problem is just broken motor mounts.
View 7 Replies
