Corolla / Matrix 2009-13 :: 2010 LE Transmission Upshifts If Foot Off Gas At Highway Speeds
Oct 2, 2012
Is this behavior normal: I test drove a 2010 corolla LE with 4-spd auto, 41K miles. Noticed that on level highway 60 mph that whenever I eased up on the gas that the RPMs would shoot down. Vehicle speed was barely decelerating since I was on level. As soon as gas reapplied (gently), then the RPMs would shoot up. I'm guessing the delta was like 300 RPM. I get the impression that at highway speeds the car is mostly in 3rd gear or shifting up and down a lot. I've read a lot about a TSB for 2011 corollas but nothing for 2010. And I think that problem is different. So my question is whether this is "normal" for driving at highway speeds?
View 5 Replies
Advertisement
I have a 2010 LE with auto trans. This happens when I start the car first time in the day. I shift it to drive And it takes maybe 1.5 seconds to catch before I can drive it. Is this normal. Would a fluid change fix it?
View 11 Replies
I have a 2010 corolla le with approx 54k miles. Should I have the trans serviced/flushed? Can I just do a drain and refill? Is it true that replacing the fluid will cause the trans to fail later on?
View 1 Replies
I recently purchased a new 2010 Toyota Corolla LE auto and I really like it. I have about 2000 miles on it now and just recently noticed a faint gear whine coming from the transmission at around 60 mph. You can only hear it when the radio is off and you really listen for it during the acceleration. It only does it when transmission fluid is fully warmed up after driving for about 15 miles. 2010 corolla uses U341E transmission that specifies Toyota WS transmission fluid. I noticed that 2001 - 2005 Supra uses the same transmission but it requires T-IV fluid which has more viscosity than WS. Noticed this faint gear whine on this car or do I need to take it to the dealer? My other car 2003 Toyota Echo uses U340E transmission and it has gear whine as well, except it is more pronounced than in Corolla, so I an trying to figure out if this is normal for this transmission or not.
View 10 Replies
I have a 2010 Corolla S with automatic transmission. Today it started giving a push or a jerk when the 1st gear drops, so from 1st going to 2nd it pushes or jerks the car ahead. Not sure what is wrong with it, it has 56000 miles on it.
View 14 Replies
I just recently had an oil change yesterday to be exact. I have never looked at my RPM when I drive, but at every oil changes the dealer always does the "Multi-point inspections", of which I do not like since the tech may ruin something that's not broken or does not put something back together correctly and may cause problems down the road. Anyways, I usually drive at least 80 on the highway. Yesterday I drove home, and I noticed that around 70-75, the RPM was at 3, and a bit over at 80. I've driven other cars and the RPM is never over 3.
View 3 Replies
I had some issues over the past couple of days with my 2009 Corolla EPS. It would occasionally go off, after all the indicator lights would flash momentarily. This only happens at low speeds, under 10 mph, and as soon as I got it up to speed the power steering would come back on. (note just about 140,000 miles)
I took my car into the dealer and he told me my battery needed to be replaced, its the original, and my rear hub and bearing assembly is corroded and there is electrical damage back there.
Did my first repair this summer, the alternator and water pump. But I didn't think the rear hub and bearing would have electrical connections or sensors effecting the EPS. I'm sure there is rust, but would that cause EPS issues? Could there be electrical damage? I also tested my battery yesterday and got 12.5 - 12.6 V with if off and 13.6 -13.7 on, but my battery is old.
I am going to pick it up from the dealer and just try changing the battery first. The total repair they suggested would cost $1875.00, which is crazy to me? Could there be a bigger issue though, and could the EPS just cut out on me while I'm on the highway or something?
View 2 Replies
I just finished a 2 hour road trip(about 80 miles per an hour) on my 2013 Corolla S. I have realized what it is about the steering that I am having an issue with. Off the highway, the steering is great and I love the steering feel. But on the highway it tightens up and is real firm. I would like it to be more loose and not as firm on the highway. With it super tight on highspeeds, the usual correcting it with a minor left and right requires signifcant more push/pressure from the arm and hand. Also, need it feels more sensitive to degrees. I find myself shifting around trying to find a relaxing spot to steer and apply that much pressure to steering without my arm/hand getting tired.
Is there anything that can be adjusted to make the steering not tighten up at highspeeds and also be so sensitive? Will it lesson over time? I am using the 17" alloy wheels with Goodyear tires.
View 11 Replies
I'm new to owning a Toyota. I just financed a 2010 black Toyota corolla S with 36 miles on it from a local dealership after i decided my last car was pretty much a money pit (2001 expedition)...blew the head gaskets, then after that was fixed developed a bad knock...anyhow i just decided i was overdue for a new car. Its a 5 speed manual and at highway speeds (65-70mph) I've noticed the rpms are bit high...like around 3grand. Is that normal? Just seemed really high to me, I really think this car would do great with a 6 speed. Also is the corolla governed? I was on a long stretch of road and i quickly got to 110ish with no sign of a governor kicking in...?
View 14 Replies
2011 Corolla S, the RPM's drop by couple hundred suddenly when easing off the gas pedal. This is more noticeable at speeds of about 60-70mph. I got it checked out under warranty and the dealer said it is normal as the car shifting out of overdrive.
They may be correct in this as it is the speed around which the overdrive comes into play but it just does not feel right, although it may be related to the overdrive, they should have a fix so that the car slows down gradually, not suddenly.
I have read other TS-B updates which resolves the problem of fluctuating RPM's at steady speeds or the RPM not dropping when letting off the gas pedal, however my issue is slightly different in that the RPM's drop suddenly and then jumps back up again. I wonder if that same TS-B flash will resolve my issue.
View 5 Replies
Shifted accidentally from third to second on highway, revved way up and engine shut off, turns over almost started an hour later but didnt want to try to completely start it. still under warranty so how do I get around the OBD reports and get it covered or am I screwed.
View 2 Replies
year: 2009
miles: 80160
This usually happens when im on the highway i guess because im usually going over 50mph I hear like a loud humming and vibration and if I turn the steering wheel left or right it becomes unbearable, like deafening. What may cause this, im thinking maybe i need an alignment or wheel balancing or just new suspension.
View 2 Replies
I have a 2009 Corolla (smaller 4 cyl) with auto trans. at 101K miles. I have a whine at hwy speed when the drive line is unloaded. What I mean unloaded is there is no acceleration or deceleration. The whine does not change pitch or level with speed.
View 1 Replies
So when i hit ~80km/h (50 miles) some weird extremely small vibration is coming on. You cannot feel it from anywhere but when u touch something, like handbrake then its there. Tho the sound is kinda loud. So the pattern is like, 0.3 seconds it is vibrating and 0.3 is quiet, it does not matter on which road i drive.
This problem cannot be caused by wheels (got other alloys and same problem), also already got alignment and have balanced my wheels. So, what to do?
View 10 Replies
I have a 2010 Model S that has 38,000 miles on it. I am hearing a rattling in the front brakes when cruising along at almost all speeds. If i hold a little peddle pressure it goes away. Sounds like the pads are rattling to me. I am running the stock pads with about 45 to 50% remaining on them.
View 6 Replies
I've owned this vehicle for the past year. This 2009 Corolla XRS manual has a very annoying steering rattle which took me the whole year to finally breakdown and diagnose. There are many forums stating this rattle is associated with the intermediate shaft assembly #2. I did end up replacing this part 45260-02110, hoping this would fix the rattling or knocking issue. It did not, but smoothness the steering has improved. I removed the upper portion of the intermediate shaft to pinpoint the sound. Originally I believed the noise may have been coming through the bulkhead from the intermediate shaft #1 or steering rack. I checked under the boot and everything was snug. Then I rattled the steering wheel around and this what I found.
It seems the noise is coming from the pinion where the power steering motor meets the steering column. You can hear the knocking noise with settle steering wheel movements. As I move faster, the knock turns into a rattle at higher speeds most likely vibration from the road. At this time, I do not want to disassemble the whole column just to see if I can adjust the motor height (if possible).
YouTube : [URL] ......
View 6 Replies
I have a 2011 corolla S with 32.5k on it, so my 3yr/36k warranty is running up in a few months. my car from day one (that I had it, at 17k)has had an annoying rattle in the headliner ahead of the sunroof, near the overhead lights. If I press up, even slightly on the lip of the headliner around the front of the sunroof cutout, it goes away. Dealer thinks its normal and says repairs wouldn't be covered under warranty.
The second is a new one, when I go over a bump in the road at highway speeds, there is a squeak coming from the center of the dashboard, at first I thought it was a strut, but after driving back and forth on the same stretch of road for half an hour, I found it to be coming from somewhere behind the radio. Dealer says, squeaks will happen as a car ages.
Do I need to take it to a new dealer (about an hour away) or can I fix this myself?
View 6 Replies
I have a 2014 screw 4x4 v8 that has been in the shop 5 times now for something that the dealership can't duplicate, and that is intermittent enough for me that I can't determine what the conditions need to be in order to duplicate it myself.
My transmission will shift hard under two different situations:
1) when rolling through a stop, or a momentary stop at a stop sign, the transmission holds up between 3 and 1, and when I bring the rpms up, the transmission shifts down into 1, making a hard clunk;
2) at highway speeds, more so when using cruise, if I accelerate and the truck shifts down from 6 to 4, there will be a hard shift as well. In fact, when I'm on a long stretch of flat, open road using cruise at 70-75, I can feel a slight bump through the steering wheel and floorboard, as if the cruise is trying to engage the throttle a bit more, but only for a split second. But that will happen quite a few times within a couple miles until I come up on a grade and the throttle has to engage for a bit longer to keep speed. Sometimes, the hard shift will do occur going to 5 as well, but 90% of the time it will be a 6-4 shift. If the truck decides to shift from 6-3, there's no issue and it shifts and accelerates like it should.
Again, this is so intermittent, but when it happens, it happens several times. I've had the service tech ride in the truck with me, all the while not being able to duplicate the issue. I understand that these are learning transmissions, so the only thing I can think of is when I try to duplicate it by accelerating over and over, that the transmission adjusts the shift pattern or fluid pressure to compensate.
View 14 Replies
Car - 2011 Corolla S - Auto Transmission
My transmission seems to slip when it is shifting from 3rd into 4th. The second that it shifts into 3rd gear the rpm drops and shifts into 4th (This is when i have light to medium pressure on the pedal). If i push the pedal down 3/4 of the way once the transmission shifts into third then the rpm rise for at least 4-5 seconds (which seems more normal). In addition the shifts are a bit rough when the transmission is shifting up or down.I am looking for some insight before having a dealership jerk me around.
View 2 Replies
My transmission blew out at 64000 kms.
At first I thought it was my calipers - on my breaks that were frozen. Very laggy when I was driving there one day - took the car into car wash sprayed the breaks with hot water. Then Air Dried the with compressed air from compressor.
Next day while driving to work - the car got really sluggish again and this time there was a funny sweet smell coming through my vents.
Stopped car - called tow truck to take me to break shop - When tow truck arrives - He lifts my car up and there is a dark red fluid under transmission.
Called the right place because they also do transmission work.
View 4 Replies
I just bought a 2013 Barcelona Red Corolla S in Manual transmission. Already, I've noticed how rough the transmission is when I shift. But it's only roughy when I first step on the clutch. But if I keep the clutch pedal down, all the gears shift smoothly, until I release the clutch and press it down again, then the first shift is really rough. Especially REVERSE, when I shift into reverse, it's so rough that it shakes the car. There's no grind, just very rough. It sounds like someone cocked a shotgun. Everything is smooth when driving tho, only happens at full stop.
View 14 Replies
