Corolla / Matrix 2009-13 :: ABS And Brake Light Came On / Fluid Reservoir Totally Empty
Jan 31, 2015
2009 Corolla LE 1.8, Auto Trans
I went in for an oil change. The following day my ABS and brake light came on. I looked under the hood and the brake fluid was totally empty! I called the place back and said "Don't you check fluids? It's bone dry".. well maybe bone dry is not totally true, it might have been lubricated in the reservoir still, but definitely empty. I put fluid in and the light is still on.
So, I went back. They say problem with my rear ABS speed sensor. After doing some Google work on my cell, I thought it was expensive so I'm going elsewhere.
I've got 100,500 miles so I'll probably get spark plugs also.
But anyway, they did that oil change and at the same told me my transmission fluid is dark. I'm just wondering if I should be worried about doing a transmission flush and fill.. I hear conflicting stories from all over the web.. one place says this, one says that, one says this type of oil is best, etc...
View 8 Replies
Advertisement
I own a 2009 Corolla. Cannot locate where the power steering fluid reservoir is. I googled and also looked under the hood, no luck.
View 6 Replies
Our brake reservoir cap is rubber, and just pops on. There's a little top hat on top of that that plugs the tiny little breather in the actual cap. I lost mind down in the depths of the engine bay.
View 2 Replies
I have a 1985 Chevy 2500. after sitting for about 3 or 4 months the rearmost brake fluid reservoir is empty. Does the rear reservoir supply fluid for the front or rear brakes?
View 14 Replies
Last Thursday Nov 22nd, I took my 2010 Corolla for a regular oil change service by an Toyota agent. The service representative recommended to have the brake fluid replace since it had already 39000 km since new. I agreed.
The same evening, I start hearing a strange high pitch noise from the front while braking light at low speed. It does not occur all the time. I did a search in this forum about the brake noise.
That strange high pitch noise could come from the ABS actuator when it activates or modulates at that light braking.
I did a visual check on the bleeding nipples of the brakes today. It seems that the two nipples for rear brake were untouched and this would mean they did not bleed the rear brakes and air could be trapped in the rear brake lines.
Will take the car back the Toyota service. As search from our forum, the cause for the abnormal modulating of the ABS actuator could be :
(a) a bad speed sensor or
(b) air trapped in the brake line.
Since it starts at the same day of replacing the brake fluid, the most likely cause is air trapped in the brake line.
View 2 Replies
I had a 2006 Corolla S 1.8L automatic with 232,000+ miles that was taken away too early by two other cars making a sandwich out of it. It was still getting 32 -37 mpg consistently and about 370 - 390 miles per tank at least before I'd look for gas. I just replaced it with a '13 Corolla S 1.8L automatic and average out near 28 - 32 mpg (but it's winter). My issue is the readout on the gauges. I've got a 120 mile round trip for work daily (all highway). On the way home yesterday, gauge showed 1/4 tank and distance said 85 miles (enough to get home).
At about 26 miles left, yellow light came on. At gas station 19 miles left til empty (or so I thought), yellow light shut off and gas gauge went back up slightly off E. Filled her up and it only took 10.2 gallons after topping it off a couple times after the pump shut off. Distance traveled was about 320 miles on that tank so around 32 mpg. I'm o.k. with that but I thought these had the 13 gallon tank like my '06? Were there still 3 gallons in there and the sending unit may be bad or am I missing something? BTW car only has about 6600 miles on it as of right now.
View 9 Replies
So I was on my way home i was 2 miles away from my house and my abs light and e-brake light randomly go on. I got home and turned car off and back on and it was still there.
View 14 Replies
On 2010 Corolla. If I fill the reservoir it empties on ground rapidly. Will not spray before it is completely empty. Seems like a hose has come off in reservoir area. I have never had this happen with any other car.
View 1 Replies
I just filled up my gas tank and when I turned on my car the gas light turned on and the needle read empty. But before I put gas, the gas light wasn't on yet and. Was at 1/4 of a tank. Maybe I filled it up too much and it'll resolve itself after the gas goes down?
It's a 10.5 if it matters.
View 4 Replies
I have a 2010 coroola "S" and the ABS and Brake light have come on recently and it seems to drive fine. I have read the codes and the are : P000A and P050B
View 4 Replies
My dad has a 2010 Matrix base model, and we can't seem to get the driver's side burnt out bulb out. I did a Google/Bing search, as well as Youtube, but most results were about the Corolla, and the Matrix and Corolla have 2 different tail lights.
View 2 Replies
I've a problem with my 2000 Nissan Maxima GLE. Recently I started hearing noise from Passenger side of the car, and I noticed that the Power Steering Fluid Reservoir is almost empty. Looking more closely, I see some kind of leak. Could this problem indicate something wrong with the Rack and Pinion or the Pump itself.
I went to autozone today, and bought a Power Steering Fluid with Stop Leak. I added the liquid, and turned Steering Wheel to the right and the left. After doing this, I checked the reservoir again, and I saw the reservoir level was very low again. I repeated the above steps until I reached the point where the reservoir level was to the high point.
I would drive for couple of days and see if the reservoir level goes down again which point to leak still existing. While waiting on this test, thinking what could have gone wrong here that is causing the Power Steering fluid to leak. I've also attached the picture which point to suspected point of leak.
View 4 Replies
I have an 09 corolla S with 119000 miles.
My car shakes when i brake on the freeway and I just got new tires so Im sure it must be the rotors.
Is it better to just get new rotors or have a shop machine the old ones down.
Which way is more cost effective?? and how hard would it be to install them myself?
View 6 Replies
On my 2010 s ,my pedal brake begin to work on low position, I have 35000km it is normal? my wife hate this car because this.
View 4 Replies
I have a 2009 matrix 1.8 automatic with 103,000km on it. The brakes were making a noise so I pulled off the front wheels and inspected and cleaned the front brakes which were in great shape. I pulled the rear wheels and found that the outer disc pads were wearing on about a 30 degree angle. The inners were just fine! I've been doing brakes for over 40 years and have never seen this! Also, the rears don't work hard and should outlast the fronts by at least 2! I called Toyota Canada and they blew me off until I asked to talk to someone higher up! They are doing a technical review, but I believe they will tell me it's just my car! I think it's a design flaw!
View 13 Replies
On my 2009 Matrix XR (2.4L), my right rear brake pad is wearing unevenly. I'm up to 87000 km (54000 miles). My first pad change was one year ago. I kept the pads and only noticed this time that the wear was at an angle on the outer pad, both times.
The inner pad is ok.
Multiple pictures below:
The other pictures:
View 4 Replies
i have a 2010 Corolla XRS and was wondering the following:
-How good are ceramic brake pads?
-Do they last longer than normal OEM pads?....under normal driving.
I was considering buying a complete set of drilled rotors and ceramic pads for my car.
View 14 Replies
So I have a 2010 corolla s with 30k miles. I replaced my rotors and pads about 2 weeks ago to get rid of this problem. The problem was gone for a week and now it's back. I get tons of squealing and screeching when I brake in reverse.
View 5 Replies
Basically, whenever I brake, my front brakes squeal. But they only do this if I use about 25% to 33% force. If I press on the pedal harder, the squealing goes away and the same if I reduce the force.
I replaced my pads with Wagner ThermoQuiet pads in March 2015. The noise started a month or 2 after replacing my pads, and I've only put about 12k miles on them. I had my car in a couple weeks ago for an oil change, and the inspection showed that the pads still had plenty of life on them. I brought it up to the service advisor, and he suggested that my rotors might be warped and need to be machined. The problem with that is I feel absolutely no vibration in my brake pedal that would indicate warpage.
So the only other thing I can think of is the shims might be causing the noise. I was going to get some grease and apply that and see if it works. Also, when I was replacing the pads I bled out a little more brake fluid than I intended. But it hasn't seemed to affect my braking ability so I ruled that out.
Any guesses for what might cause this? Like I said, I have plenty of material left on the pads and I can stop without problems, so it's not a safety issue, just a tad annoying.
View 3 Replies
My Abs traction control vsc off (keeps flashing) and brake light went on in my 2010 corolla....
View 2 Replies
My 2009 Toyota Corolla LE is squeaking. The noise is coming from its rear break -- driver side. It happens only at a low speed when pressing the brake half way to slow down the car until it stops. Only 60-70% of the time though that it has the noise and only when going slow in the traffic and hit the brake. It doesn't seem to squeak on the highway.
The car has about 40k miles. I've heard that the rear brakes suppose to last ~100k miles. My questions and concerns are:
1. Is it too soon to replace rear drum breaks?
2. How to check the rear break pads to see if I really need to change them?
3. Are they just dirty? How to clean the rear breaks?
4. Finally, if I really need to replace them, how much does it cost in general?
I wish they were dish brakes -- so much easier to replace them.
View 1 Replies
