Corolla / Matrix 2009-13 :: Buzzing Noise After Replacing Brake Fluid
Nov 25, 2012
Last Thursday Nov 22nd, I took my 2010 Corolla for a regular oil change service by an Toyota agent. The service representative recommended to have the brake fluid replace since it had already 39000 km since new. I agreed.
The same evening, I start hearing a strange high pitch noise from the front while braking light at low speed. It does not occur all the time. I did a search in this forum about the brake noise.
That strange high pitch noise could come from the ABS actuator when it activates or modulates at that light braking.
I did a visual check on the bleeding nipples of the brakes today. It seems that the two nipples for rear brake were untouched and this would mean they did not bleed the rear brakes and air could be trapped in the rear brake lines.
Will take the car back the Toyota service. As search from our forum, the cause for the abnormal modulating of the ABS actuator could be :
(a) a bad speed sensor or
(b) air trapped in the brake line.
Since it starts at the same day of replacing the brake fluid, the most likely cause is air trapped in the brake line.
View 2 Replies
Advertisement
2009 Corolla LE 1.8, Auto Trans
I went in for an oil change. The following day my ABS and brake light came on. I looked under the hood and the brake fluid was totally empty! I called the place back and said "Don't you check fluids? It's bone dry".. well maybe bone dry is not totally true, it might have been lubricated in the reservoir still, but definitely empty. I put fluid in and the light is still on.
So, I went back. They say problem with my rear ABS speed sensor. After doing some Google work on my cell, I thought it was expensive so I'm going elsewhere.
I've got 100,500 miles so I'll probably get spark plugs also.
But anyway, they did that oil change and at the same told me my transmission fluid is dark. I'm just wondering if I should be worried about doing a transmission flush and fill.. I hear conflicting stories from all over the web.. one place says this, one says that, one says this type of oil is best, etc...
View 8 Replies
So my passenger front door is vibrating inside somewhere ... tho' it could be the door panel itself possibly !?
I've removed the door panel hoping to find something loose inside that is causing this buzzing. All the door panel's locating pins are intact and secure the panel as they should. In other words... The door panel secures as it should and nothing looks broken at it's attachment points.
The noise does not occur on a smooth road surface...and only occurs on rougher road. So I realize the vibration is being transmitted by road vibrations.
I can hear/feel a lite jolt from the tire's contact with the road's surface irregularities and if the road surface remains consistently rough ... that jolt turns into a buzzing drone type noise. Well ... at least until I hit a smooth road surface again. Then the buzzing subsides. No, it is not an electrical buzz/noise.
Sounds more like plastic vibrating against the door's inner surface... But I don't see a scuff mark or anything giving me a clue as to what it could be !?
I've thought of removing the door panel...then take a test drive without it installed. Just to be sure it is not the the window glass support/channels... door lock/lever mech. rod or loose wiring. But haven't done that as of yet. With the door panel removed... I don't see anything that looks loose or could be causing this rattle/buzzing noise ?
It's difficult to say exactly where this noise is transmitted from... but if I were to guess... I have to think it's possibly near center... around the arm rest area. I see behind that is only some wires coming from the window control unit. But I don't see how those could be culprit of this buzzing noise ?
My '10 is still under the 36K warranty...
View 8 Replies
I have a 2009 matrix 1.8 automatic with 103,000km on it. The brakes were making a noise so I pulled off the front wheels and inspected and cleaned the front brakes which were in great shape. I pulled the rear wheels and found that the outer disc pads were wearing on about a 30 degree angle. The inners were just fine! I've been doing brakes for over 40 years and have never seen this! Also, the rears don't work hard and should outlast the fronts by at least 2! I called Toyota Canada and they blew me off until I asked to talk to someone higher up! They are doing a technical review, but I believe they will tell me it's just my car! I think it's a design flaw!
View 13 Replies
I changed out the brake pads, now it is making a hissing noise. I bled all the brakes starting from the back. Here is the video : [URL] .....
View 2 Replies
My Axles started to make noises couple months ago While making Sharp turns. I bought some new axles for the front, but this will be my first time replacing CV Axles.
Any tips and or recommendations on what to do and not do, and tools to use? I watched a couple Youtube videos already. I plan on changing them out this weekend.
View 1 Replies
Occasionally, when I play songs, I hear my speakers kind of buzzing, where they sound like they are going bad.
Its super annoying, but I can't think how to replicate it. Any way to show them or what should I do?
My warranty would cover this, right?
Also, if I have installed footwell LEDs, might they argue about that effecting my warranty or anything?
View 5 Replies
We added a 2011 Cor LE auto tranny to our 2005 LE.....like it a lot but for one issue. I didn't notice it test driving it (I was far more worried about the pedal locations and the electronic steering) but now I feel it a lot more.
Around 2900-3100rpm there is a buzzing feeling through the pedals/steering wheel. You notice it a lot more going up hills. The dealer noticed it too and is contacting "TAS" to see what they think.
What I'm wondering is if this is just a normal engine harmonic deal and it is what it is? I test drove other models (Civic,Focus,Elantra) and I didn't notice them having it.
View 4 Replies
I went into a shop today and got my corolla checked out and they said that its shock absorbers and struts should be replaced because the oils were leaking and they told me the total estimate of my cost (parts+labors) are about 1300 dollars.
Like, do I need to buy all shock absorbers, struts and strut springs for each of the wheel? (front 2 + rear 2 = total of 4 of each) ??
View 12 Replies
Eventually, I'd like to replace the steel wheels on my Corolla LE (P195 65 R15) with ultra light wheels and low rolling resistance tires.
View 12 Replies
I own a 2009 Corolla. Cannot locate where the power steering fluid reservoir is. I googled and also looked under the hood, no luck.
View 6 Replies
So I was on my way home i was 2 miles away from my house and my abs light and e-brake light randomly go on. I got home and turned car off and back on and it was still there.
View 14 Replies
Our brake reservoir cap is rubber, and just pops on. There's a little top hat on top of that that plugs the tiny little breather in the actual cap. I lost mind down in the depths of the engine bay.
View 2 Replies
I have an 09 corolla S with 119000 miles.
My car shakes when i brake on the freeway and I just got new tires so Im sure it must be the rotors.
Is it better to just get new rotors or have a shop machine the old ones down.
Which way is more cost effective?? and how hard would it be to install them myself?
View 6 Replies
On my 2010 s ,my pedal brake begin to work on low position, I have 35000km it is normal? my wife hate this car because this.
View 4 Replies
On my 2009 Matrix XR (2.4L), my right rear brake pad is wearing unevenly. I'm up to 87000 km (54000 miles). My first pad change was one year ago. I kept the pads and only noticed this time that the wear was at an angle on the outer pad, both times.
The inner pad is ok.
Multiple pictures below:
The other pictures:
View 4 Replies
i have a 2010 Corolla XRS and was wondering the following:
-How good are ceramic brake pads?
-Do they last longer than normal OEM pads?....under normal driving.
I was considering buying a complete set of drilled rotors and ceramic pads for my car.
View 14 Replies
So I have a 2010 corolla s with 30k miles. I replaced my rotors and pads about 2 weeks ago to get rid of this problem. The problem was gone for a week and now it's back. I get tons of squealing and screeching when I brake in reverse.
View 5 Replies
Basically, whenever I brake, my front brakes squeal. But they only do this if I use about 25% to 33% force. If I press on the pedal harder, the squealing goes away and the same if I reduce the force.
I replaced my pads with Wagner ThermoQuiet pads in March 2015. The noise started a month or 2 after replacing my pads, and I've only put about 12k miles on them. I had my car in a couple weeks ago for an oil change, and the inspection showed that the pads still had plenty of life on them. I brought it up to the service advisor, and he suggested that my rotors might be warped and need to be machined. The problem with that is I feel absolutely no vibration in my brake pedal that would indicate warpage.
So the only other thing I can think of is the shims might be causing the noise. I was going to get some grease and apply that and see if it works. Also, when I was replacing the pads I bled out a little more brake fluid than I intended. But it hasn't seemed to affect my braking ability so I ruled that out.
Any guesses for what might cause this? Like I said, I have plenty of material left on the pads and I can stop without problems, so it's not a safety issue, just a tad annoying.
View 3 Replies
My Abs traction control vsc off (keeps flashing) and brake light went on in my 2010 corolla....
View 2 Replies
My 2009 Toyota Corolla LE is squeaking. The noise is coming from its rear break -- driver side. It happens only at a low speed when pressing the brake half way to slow down the car until it stops. Only 60-70% of the time though that it has the noise and only when going slow in the traffic and hit the brake. It doesn't seem to squeak on the highway.
The car has about 40k miles. I've heard that the rear brakes suppose to last ~100k miles. My questions and concerns are:
1. Is it too soon to replace rear drum breaks?
2. How to check the rear break pads to see if I really need to change them?
3. Are they just dirty? How to clean the rear breaks?
4. Finally, if I really need to replace them, how much does it cost in general?
I wish they were dish brakes -- so much easier to replace them.
View 1 Replies
