Elantra HD (2006-10) :: 2008 - Engine Shudder / Vibration Whenever RPMs Are Between 1000 And1500
Jul 30, 2012
I drive a 2008 Elantra automatic,and have a constant engine shudder/vibration whenever the rpms are between 1000 and1500. The engine shudder stops as soon as I accelerate above 1500 rpms,or take my foot off the gas completely.
The dealer recommended cleaning of the fuel injector system,not sure if thats the course to take.I do know my model has had fuel pump issues,but the dealer has told me all recalls on the car have been processed.
View 3 Replies
Advertisement
I purchased my 2013 F350 PSD July of 2014 and immediately noticed "the shudder" when the engine was lugged down to 1000-1100 rpms on a hill. Sounding like somewhere around the turbo belching air too. At first I was startled but learned to manually downshift to higher rpms and it will stop. Once or twice I tried accelerating out of it and it shuddered as bad as the poster who said it made the steering shudder too.
My truck has 16,000 miles and I never let the rpms drop now. So I figure I have a real problem I'm not imaging. What should I tell my dealer is the TSB or remedy ?
View 1 Replies
I have several problems with my 06 FEH maybe some of you had same issues. I have imported this car from new york in my country 1 month ago, this is first Ford for me. Love this car but there is some issues and want to figure them out.
1. seat heating is turning on without clicking on the button, but not always it's random. Often on passenger seat some time on driver side to. I try to disable fuse but it also for 4x4 so it's not an option.
2. My engine idle RPMs is always higher that 1000. Maybe it is normal but want to be sure.
3. car cannot climb the hills here is the video.... car is just doing nothing to climb no rev up no trying just stall in middle. In my country there is some roads with hills like this and I want to visit that places.
4. Cruise control is working random to maybe it will start speed control in one click or after 20 -s try.
5.Is there any way to see soc? factory unis is replaced in my car with aftermarket radio. I have elm327 and tourque pro but can't find that option.
6. When monitoring with obd water temperature is always lower then it was on my other cars. its around 158-176F on other cars it was 200F.
YouTube......
View 2 Replies
I leased a 2015 Honda CR-V AWD LX on March 11, 2015. The following day I noticed a rough vibration/shuddering/chattering that appeared to be coming from the transmission when the rpms ranged between 1,000 and 2,000. The roughness was evident at any speed (mpgs) when the tachometer reading was between the previously stated range. The service technician reported feeling the same roughness, but noted that the problem was characteristic of the CRV with a CVT transmission. On Tuesday March 17, I went back to the dealer and discussed the problem with the service manager. He also stated that he was aware of that particular problem and that it was peculiar to the 2015 CRV with the CVT transmission. He took my car for a test drive and admitted feeling the chattering. It was also evident to me as I sat in the passenger’s seat. He then took out another new CRV and it too exhibited the same characteristics.
View 18 Replies
I have a 2000 b5 wagon with a 2.8 5spd with 200k on it .... Its slammed on coils and i get this squealing in reverse i dont know what it is i just rebuilt the front end ie control arms... also have a nasty vibration from 1000rpms to 3000 rpms could that be engine mounts/snub mount?
View 7 Replies
I recently purchased a 2013 elantra.
I have noticed that there is engine vibration and noise felt in car and pedal when accelerating at around 2500-3000 rpm's before it shifts. Is this normal behavior? It just does not seem as smooth as it should be. I have only put about 600 miles on the car.
It has been very cold, but it does not go away after warming up.
View 10 Replies
I put a link below on the video that I made. But when I come across 1,000 RPMs weather I turn, go straight, left or right it makes this noise like a humming or rubbing noise. I took it to the dealership and they fed me crap saying when it gets worse or when it happens every time brig it back.
[URL] ....
I don't think this link is working I'm trying to figure out this iPhone. Search my YouTube channel Kill3rcr3w that's the channel I just uploaded it
View 2 Replies
We have a 2006 F150 w/new engine, new everything but transmission and cat. converter. When driving in warm weather with the AC on and at low speeds or idle the engine will knock and want to cut out but you rev and turn off the AC and it stops. Only with AC on. We replaced fuel filter, fan throttle took to dealer and updated the software which it stopped for 3 days and started again today. Could it have to do with AC compressor or low refrigerant?
View 4 Replies
My 2001 BMW 325Ci has an occasional "surging" idle problem. When coming to a stop or at idle, the engine will rev between 500 and 1000 rpm's. Sometimes it will correct the problem and idle normally, or keeps surging until it eventually stalls. When restarted it works fine. Tried fuel injector treatment, fuel stabilizer treatment, and replaced thermostat. Still surges about 50% of the time. Had it to a dealer, and computer says its running fine.
View 1 Replies
Well, it's looking sort of depressing for my '06 Sonata! I had an oil change done yesterday and now I'm getting a Low Oil Pressure Light on idle under 1,000 rpm's. Today the check engine light came on and it's code P0021.
I also experience very noisy "bearing" type noise upon start-up which happens for about 10 seconds or so. This has been going on for a month or so.
During my online research it's appearing that I may be suffering from the dreaded Timing Chain Tensioner I've read a lot about.
I'm aware of the TSB (10-EM-006) and have a copy of it if needed.
My question is this...my Sonata has 151,000 miles on it, well beyond the 100k warranty period. Will Hyundai repair my issue as a warranty item under that TSB?
View 8 Replies
I just bought a 2008 Elantra SE with 26K miles. So far, I've really enjoyed it, except for, at times, it does vibrate somewhat during idle.
I took it to the nearest Hyundai dealer, and they clipped the throttle cables to the inside of the firewall. This did make some improvement, but I still feel vibration during idle when the engine is warm (doesn't seem to as long as RPMs are up). It's almost as if the idle is set a little too low.
Maybe this is just normal vibration? It's not too bad, just noticeable. Can idle in these cars be adjusted? It seems the car is too new to have clogged fuel injectors. Everything else about driving it feels great, acceleration, etc. Do you think using a higher octane gas would work?
View 2 Replies
IOur 2003 suburban often gets a "reduced engine power" displayed by the computer and the RPMs drop to below 1,000. The vehicle will not accelerate and will not go above 1,200 RPMs no matter how much gas it is getting. Flooring the gas pedal has absolutely no effect and the truck continues on its merry way at about 20 miles per hour.
I have been told by various amateurs that it is the gas lines or electronics that regulate the gas flow. The reduction in engine power seems to happen randomly, but most often if the vehicle is idling for too long (and I'm sure the 110 degree heat doesn't work). I can get it fixed much quicker if I know what the problem may be.
View 10 Replies
My V8 is "sputtering" between 1000 - 2000 RPMs. Not only can you feel it, but you can see the tachometer bounce up and down as well. No problems accelerating or putting the engine under load - it's only between that RPM range where there seems to be hesitation. The car is not giving any fault codes, and I just recently had all plugs and coils changed. (The car ran great for 2000 miles following the plug and coil change.) It started on a road trip, and I took it to the local dealer. They thought it was bad gas. (I've since run several tank fulls through it...)
My suspicion is a mass air flow meter beginning to go, but until it triggers a fault, I can't say for sure. The dealer wants to check the MAFs values and to do a fuel tank pressure test to see if it's the fuel pump. I do have the Real Driver warranty, but they will not cover investigative costs. I'm not too excited about throwing money to test a bunch of different things.
View 12 Replies
My 2006 Tundra with 45000 miles on it has an engine vibration in neutral between 1400 and 1750 RPMs. It does not feel or sound like a miss fire rather a definite vibration. I have heard this is common with Toyota 4.7 litre engines. What might be some things that could cause it? It has always done it and after 8 years hasn't resulted in any engine failures.....yet.
View 5 Replies
I have a 1997 Saturn, and have noticed for the past couple of months that when the car is idling at a stoplight, the engine seems to rev or almost skip a little bit. The RPMs go from about 1000 down to 500 for a couple of seconds, and this will happen once every 10 seconds or so. Otherwise, it runs fine...but this is happening more and more frequently than it used to.
I had the transmission rebuilt over the summer and its still under warranty. What might be causing this?
View 3 Replies
I recently got the EGR system in my 1998 Rav4 working (replaced VSV) after driving with it non-functioning for several years. Without the system functioning, the engine ran great, but fuel efficiency suffered. Now, when the engine is warm only, the engine knocks and lugs between 1000 and 2000RPMs. This usually occurs right when I shift into 2nd gear. There are no engine trouble codes.
View 8 Replies
2010 F150 ... So I have the tick noise at rpm's 800-1000 at drive through, stops, etc. So I did research on it a few months ago and saw that it might be VCT's but should be able to drive. so I drove it waiting to save money and have it go to a shop. well this past weekend while coming home from work my oil light came on the pressure dropped to zero, I was on the highway so I drove about another mile to get off highway and once I got off my truck died. I had it towed to my house and I thought I blew my motor. So I started doing research here and found that the VCT's AND cam Phaser could be bad. so I replaced my VCT on driver side put it all back together it started and loud knock was gone. then after 5 mins it was back very loud knock!
So I shut it down and took apart the passenger side once I got the valve cover off I found the problem.... The bolt that holds the cam phaser in place snapped off and was riding along the camshaft. So I took that out and extracted remaining part of bolt. inspected my camshaft and it was really messed up. so I bought new Phaser and Camshaft. the camshaft just came in today and I am trying to put it back in. but the hole for the pin in the phaser doesn't line up and I cant spin the shaft to make it line up. should I spin the cam phaser? I marked the chain and the phaser is where it should be on chain, but with that bolt snapping off could that have thrown the timing off so my mark is no good? when I lay the camshaft in place it sits perfect and if I just move the phase over 2-3 links it will all fit together. Should I do that?
View 5 Replies
At the beginning December I put my brand new winter tires (general altimax arctics) on the factory steelies and put them on the car gearing up for the snow. Not to long after the install I notice that I was getting a very strong engine vibration starting at 3,000 rpms and it stopped around 3,100 rpms no matter what gear I was in. At first I though it maybe just the cold affecting the engine. Well...
Last week I put my summer rims and tires back on for the 1,600 mile trip to MO and back, and like magic, no more heavy vibrations. Smooth acceleration throughout the normal driving rpm range. I just changed the oil and tranny fluids Tuesday after we got back and with the warmer weather the car is running smooth as silk. Still an awesome car with awesome mileage and couldn't be happier.
View 7 Replies
With my car sitting, out of gear or clutch in, I rev the engine to say 4 thou. As the engine decelerates I get a perceptible vibration or shudder. It feels like an out of balance. In gear, accelerating, no problem. In gear, decelerating, no problem. And it doesn't happen all the time. It does, or doesn't do it hot or cold.
View 10 Replies
I have this bucking a jerking when pulling my Sundowner LQ horse trailer, primarily in the 40-50 mph range. I can let off throttle and it stops but resumes unless I feather the throttle.... 2008 f 350, 4WD, 6.4, 48k miles....
View 1 Replies
Ok, I have a 95 F150 5.0. It's sat for 6 months with the engine taken apart. I just finished putting everything back together with a new alternator. Well, I pulled a bone-head move and forgot to connect the harness when I fired the truck up. Other than not charging though, it ran fine. When I connected the harness, it began to chirp and shudder at low RPMs and squeal and vibrate at higher RPMs and it over heated VERY QUICKLY.
So hot the case was too hot to touch and the pulley smoked the belt. The engine didn't even have time to get up to operating temperature. I've had the alternator replaced twice, and this last one tested good putting out 14.5 volts. The work I did on the engine was to replace the valve springs, install a direct drive timing gear, replace a spun harmonic balancer, bypass the smog pump because it froze up, new distributor, a new ECU and O2 sensor.
View 7 Replies
