Elantra HD (2006-10) :: Rumble Strip Noise While Hard Braking
Apr 28, 2013
I have a weird problem with my 2008 Elantra GLS 86K Miles on it. I did a couple of searches on this problem but didn't find any threads. About a month ago I noticed that when I braked hard at highway speeds 65 to 70 Mph I would get a noise that sounded like I was driving over the rumble strips on the side of the road. The rumble was the same frequency no matter what speed you are going, it doesn't get faster or slower. The problem slowly got worse to the point that it would happen at 25 to 30 Mph. The noise sounds like it is coming from the front but I can't tell which side. I figured that it was probably rotors and time for a brake overhaul so I replaced the rotors, pads and hardware on the front and the back. I used synthetic brake grease on the slides and guides. I also replaced the brake fluid with synthetic DOT 3.
When I did the back brakes I found that the wheel bearing on the passenger side was leaking lots of grease so I replaced it with a Timken bearing. (I live over an hour away from the nearest dealer so I did the repairs myself.) While I was working on the bearing I pushed the rear shock up and out of the way and it stayed in the up position for quite a while, aren't the shocks under pressure and usually push right back down? (Just an off subject thought) Well after replacing the bearing the rumble strip noise went back to just happening at speeds from 45 Mph and up. I was also thinking of pulling the fuse on the ABS and seeing if the problem goes away but will pulling the fuse hurt the car in any way or trip a code? I know what the ABS sounds like and this is not the same noise you get when sliding on ice.
View 22 Replies
Advertisement
My wife drives a 2006 Honda Civic. She just drove back from Vermont - we live near Boston - and on her way back the idle was unusually rough and twice she said it felt as if she was driving over rumble strips, even though she was on smooth pavement. The first time she was going 40 and the second time she was barely moving. She also noted that once, at a stop sign, the car wouldn't slowly move forward when she took her foot off the brake, as it usually does. She had to give it gas. The thing is, the problem is very intermittent.
She says the only thing that is constant is the rough idle, but the engine check light is NOT on.
The last work that was done on the car, about a month ago, was the replacement of the calipers and shoes on one of the brakes. My wife had driven for some time with the squealing noise that indicates you need to change your brake shoes without telling anyone about it. She used the radio fix.
View 7 Replies
Have a 02 v10 125xxx miles have had grinding noise on drivers side sounds like driving on rumble strip took out the unit hub everything looks good changed out the needle bearing because it was frozen still have sound after needle bearing replacement sound goes away if hubs are locked so question is it the unit bearing or stub shaft...
View 2 Replies
I am experiencing a slight rumble-strip-like vibration/noise when veering to the right. There is no noticeable vibration when driving straight or to the right - sounds like it's coming from the front. I thought it was my tires but had them rotated with same symptoms/ I first noticed this shortly after I had them rotated in July. So it's probably front suspension.
View 3 Replies
I bought a new 2013 Hyundai Elantra Coupe this past August and this is my first car.
My first concern was that Hyundai advertises 27mpg in city and around 37(?) for highway. I acknowledge the fact that Hyundai recently had to lower their mpg estimates for some of their cars and provide reimbursements but however, these reimbursements are for 1-2mpg difference. My car after more than 6 months is still only getting about 14-15 miles on a casual drive in the city and only about 19-20mpg combined and about 24-25 on the highway! I am only getting about half the estimate for in city! I do not drive aggressively. In fact I am a pretty safe driver since I am a new driver and cautious about everything. I am also using premium gas on my car. I called the dealership I got the car from and they were trying to tell me about the reimbursement program which I already knew of... The reimbursement based of the 1-2 mileage difference is not what I want. I want to fix it and get close to the estimated mileage as I can. What is the best way to go about doing this?
The other issue is that sometimes when I hard brake, my car makes a loud grinding noise. My dealership's service center said they could take a look at this. I was mainly wondering if there is anything I should be concerned about for this?
View 54 Replies
Care finally runs well and passed inspection. So I can legally drive it at speeds. Noticed what feels like widely space rumble strips when coasting 2003 explorer. I am now trying to check all my fluids ... trans seemed a bit low (PITA), rear and front differentials seemed full... but should they be checked with the engine running or off??
View 14 Replies
My 2001 Outback has developed a problem in the last few days. When I move the car from a dead stop, I go through a brief period of heavy vibration coming from the back of the car, exactly as if I am running over a rumble strip. It occurs as I am accelerating away from the stop just after the clutch is totally let out. Once I get to a high-enough velocity, I no longer feel it. However, if I maintain a very low velocity I can feel some vibration but not quite as pronounced as it was coming from a dead stop.
I have been able to make this happen in 1st and 2nd gear, I have not tried in 3rd, 4th and 5th. It does not happen in reverse. I tested the clutch by putting the car up against the back wall of my garage, revving the engine and putting the car into 4th and 5th gear and the car stalled, as it should. The clutch did not slip. This clutch has about 60,000 miles on it. The previous clutch was replaced at about 85,000 miles. The problem has been getting worse steadily during a just completed a 700 mile holiday round trip. Could this be the clutch? Could it be something in the transmission?
View 5 Replies
When my 2004 jeep liberty sport goes between 40 and 50 miles an hour it sometimes shakes like it is going over a rumble strip if i release the gas pedal it stops was wondering if it was some sort of trans sensor that was starting to go bad ...
View 3 Replies
I recently bought a 2004 Mustang convertible V6 auto with 180K miles to be my daughter's first car. The car has a driveability issue. It has a "rumble-strip" like vibration at speeds between 35-55 mph. This is when accelerating or decelerating. If I slip the car in neutral when driving the vibration is gone. Here is what I have done: new plugs, wires, coil. New u-joints. Front end needed a new tie rod end on right side, new transmission filter and fluid (only replacing lost pan fluid). Another thing wrong with the car (possibly related?) is that the ABS & traction control lights are stuck on indicating a system failure with the ABS.
Note that when replacing the ujoints I noted a couple of things:1- there is SOME amount of play at the transmission tailshaft bushing. It seemed excessive to me, but a local transmission shop told me that if it is not leaking fluid that it is not a problem. I did not gage the movement, but it was close to 1/16".2 - The other thing I noticed is that the universal joint for the rear yoke was a little bit stiff, meaning that it did not move as easily as I would have thought that it should. This was the case with both the old rear u-joint and the new, This indicates to me that the pinion trunnion ears are not perfectly aligned, but not sure what I should expect.
View 18 Replies
My '05 Expedition will be driving normal at highway speeds, and when I need to apply a little more throttle to start up a hill I get a shutter thru the truck that sounds and feels like driving over a rumble strip. It doesn't last but just a second or two, but it happens frequently. Is it something in the 4wd? Transmission? or.......?
View 3 Replies
My vehicle had a shudder which felt like driving over a rumble strip. It would usually occur after hitting a small bump at around 35 mph and hearing a clunk underneath. The shudder lasted just a few seconds. Checked the whole steering, suspension, chassis, drivetrain, u-joints, rear e-brake shoes etc. Finally found that the RF axle shaft could be moved up and down excessively in the steering knuckle. Removed axle shaft, R&R u-joint, vacuum hub seal and the torrington bearing in the hub. (used to call it a spindle bearing) ...
There was a little bit of wear into the stub shaft where the spindle bearing rides. That removed the play from the axle when it was all re-assembled. I was very happy until about a month later when it started doing it again, but not as bad as it was originally. I think maybe the stub end of the axle shaft needs to be replaced due to the wear in it. I don't want to just throw a somewhat expensive part at it without some info about "superduty shudder".
View 1 Replies
Today and yesterday day mark the first time since I have owned my truck, that I have really taxed it with a load or serious work.
I have 8126, miles to date, and hadn't felt this annoying and somewhat pronounced shudder at throttle- tip in. Only from a dead stop. I'm doing some work to my house, so as I type this I have about 700-800lbs in my box. I've never felt this shudder empty as I do with a load, and starting out on an incline.
It feels like the rear is rolling over a "rumble strip" for the first few feet of throttle input, between 5-10 mph and then smooth everywhere else.
Rob- if your reading this, I can't remember if your shudder was similar, or if yours did it empty or only when towing or hauling a load.
View 14 Replies
I just noticed today that the top part of one of the LED strips on my 2014 Elantra was out. I don't even know how to change the bulbs for these or if it's even possible. The car only has 22k miles on it so it's kind of concerning that an OEM led would burn out this fast. Should I take it to the dealer and ask them to replace it or is this something I can do myself? Am I SOL?
View 5 Replies
GS350 ... The behavior is such that under hard braking, the transmission struggles to get into 1st gear from any speed to 0 MPH. Only happens under hard braking. Basically it feels like the tranny is slow in getting back to first. If im driving at 40 and brake hard to 0, once i stop, the tranny feels like its still getting into 1st for the next 2 seconds and then it hurches confirming it has reached 1st gear.
The second behavior is that when I am driving at 70 MPH or any speed, and i brake hard to reduce speed 10-15 mph, the rpms will go from its normal 70MPH Rpm ~2000 RPM and drop to idle speed around 500RPM while the car is still at 60 mph.
Link " [URL] .....
View 6 Replies
[URL] .... . I don't know what this noise could be. I have a 2009 pontiac g8 gt. This noise happens from braking lightly but not hard. Sometimes also when driving. Also does not happen all the time mostly when warmed up
View 3 Replies
My 07 Elantra SE (5 speed manual) without ESC is terrible in the snow. While traveling at almost any speed, and braking around a turn, the rear end (under icy conditions) will break free and the car is out of control. No warning was given. While traveling in a straight line on hard-pack snow (icy) with ruts, the rear end gave way and I ended up in the ditch. Didn't break or turn the wheel prior to this.I love the car but am afraid to drive it in the snow. Does ESC (electronic stability control) take care of this problem? I love the car otherwise; always get over 30 mpg (usually 33-34 mpg).
View 15 Replies
2001 GLS... Noticed the passenger front door window outer weather strip is loose at one end. Looks like a "tab" on the strip fits into a slot on the door panel. Since the tab is smaller that the slot, is there some kind of clip or something that holds the weatherstrip tab securely in the slot?
View 2 Replies
2004 6.0L Excursion Limited 4x4.
I recently developed a "rumble" with vibration while braking. I describe it as a rumble because I associate it to a similar sound, cadence, and feeling as if you were slowing down on the rumble strips you find on the side of the highway.
It is mostly only noticeable at lower speeds. I know the sound and feeling of warped rotors, but this seems different. If it makes any difference, one issue I've been dealing with is that the front transfer case does not release when 4x4 is off and hubs are in AUTO.
View 14 Replies
When braking the truck shakes terribly, enough to toss a drink out of the cup holder almost. Sometimes there is a slight feeling in the peddle but not always. The shudder feels like it is timed with each revolution of the wheels.
It developed from a perfectly stopping truck over the course of maybe a month. I don't drive the truck that much either.
Things I have checked:
1, all u-joints, they all look and feel good, no play or slop in them
2, air pressure in all tires, even rotated them, no effect
3, brakes-front and back all looked good but I went ahead and replaced front pads and rotors, cleaned caliper pins, zero effect.
4, shudder exists whether in gear and slowing or in neutral, 2wd and 4wd
What the heck else is there to check? My first thought was, front brakes/warped rotors, but after pulling them apart there was so much life left on the rotors and pads and replacing all that with new did nothing! Could bad back brakes cause this much of a shudder? They look fine as well.
View 5 Replies
Passat Front End Noises? Loud "crack" noise when stepping on gas after hard braking....I thought...control arms gone again (replace em @ 55K miles)...so I replaced all the control arms... NOISE LESS but still there! I've replaced motor mounts and just checked them..no leaks, so engine shifting cant be it... I replaced the "stretch torqued" subframe bolts when I did lower rear control arms..so they're tight...What can it be??
View 18 Replies
I recently purchased a brand new 2013 Hyundai Elantra and I have noticed that I sometimes when I brake fast but not fully slamming on them from going about 60-80km I hear a loud grinding noise. When this happens the roads are dry so I know that it is not caused by slippery or wet roads.
View 279 Replies
