Explorer :: 1999 V8 Auto AWD - Lack Of Power / Motor Bogs Down When Going Up Hill
Jul 8, 2013
I have a 1999 Explorer. 5.0 V8 auto AWD. Motor bogs down when going up hill. Smoke coming from under vehicle. Recently tuned up & oil change. 157,000 miles. No warning lights. Not over heating. No burnt smell from oil or trans fluid. No leaks from motor or trans. Oil & trans fluid look clean. I have a little mechanical knowledge. Someone said it could possibly be a bad catalytic converter.
View 2 Replies
Advertisement
While I'm cursing at highway speed everything is fine. But when u punch it it pass someone it's like I actually slow down, same from a red light. I've got a livewire programmer in it and this problem is somewhat new. It just seems to keep getting worse, I was going up a hill on the interstate this morning and at 2800 rpms I was actually slowing down. I'm not sure if the fuel pump is going out or if the transmission is slipping or what.
View 7 Replies
I have a 99 F150 4x4 with the 4.6 Motor approx 150000miles. Transmission went out so I decided to try and replace it...
New/rebuilt tranny went in with no problem but something is not right. It will drive but seems like it is stuck in high gear and bogs the motor down. It is giving me error codes P1747, P0750, P0755, P0743, P0102. All the wiring harness is in good shape with no burns or other noticeable problems. Somehow the transmission isn't reading right?
When I bought this rebuilt transmission I was told it was set up for 2wd but he would convert it for 4wd. The only difference i noticed with the new tranny is the shaft coming out of the tranny, where the safety neutral switch is, has a diamond shape instead of the oval shape that connects the shifter cable. No big deal i think, just had to buy a new link for the shifter cable with the diamond.
Also on the passenger side of the tranny there is a nine pin plug. My wire harness from the truck has one pin hole that is opposite of the tranny. Not sure why. Do I need a new harness or wrong tranny?
View 1 Replies
I have a 1987 Mercedes 560sl. Has new fuel pumps, fuel filter, spark plugs, air filter, fuel strainer cleaned, fluids at proper level, and new brakes/rotors. Runs fine until I get to a hill. Then when I push the accelerator it bogs down and then dies. Continues this and will only idle.
View 2 Replies
We have a 02 explorer with the 5R55W transmission. We lost power starting up a hill. Now it has nothing. No reverse, forward. Does not even think about moving an inch.
We can not find the dip-stick. Looks like a nut on top of the transmission that you stick a finger into or makeshift dipstick to see if it is topped up. It probably has a cooler on it.
Never noticed a loss of fluid. Nothing at the bottom of the hill...
View 8 Replies
I have a 99 explorer that stops blowing air when I get on the gas or climbing a hill. The motor is still blowing but it stops air coming out the vents. What could be causing this? It works fine other than that.
View 3 Replies
My issue I'm having - 2002 F350 7.3L has an 8 inch bds lift with 37/13.50 tires. I realize these tires are big but... while driving 100kms/hr or 60 miles per hour and I hit the gas the truck barely wants to move (without pulling a load). Thought maybe a turbo but I have no mechanical skills so here I am!
2nd issue, there's a bullydog chip in that truck when I bought it. he said he always ran it on extreme. I found it puffs way to much black when on extreme and on performance it seems a lot better so that's where I have it?.
3rd issue, the transmission gauge on the dash goes into red when climbing up hills ( I live in the rocky mountains so a lot!) but the bullydog chip says the tranny is only at its hottest 140C? I don't believe that's to hot but I do believe my truck is derating a little while the tranny gauge on the dash is in the red? is there any quick fixes out there for these issues.
View 6 Replies
I was wondering if fuel injectors throw a code when it goes out. I have a 02 7.3 been running rough when you accelerate bogs down and looses power not sure but sometimes gas light would come on knowing I have gas in it could that be a sign of the sending unite and that's why it runs rough..
View 3 Replies
Long story short, when going up hill or any incline for the matter it feels like it's struggling and lugging, blowing carbon everywhere. It's an automatic so I yeah can downshift sometimes but even turning overdrive off doesn't work in a lot situations. My EGTs are way too high and I'm not about to tow my project car to OKC unless I get this figured out. I live around Salt Lake City so towing can be hard up surrounding passes. Just cruising to park city at 70mph on I80 up a pretty good incline my EGTs were 1,000. Just driving around the city, some hills I see 700-800 when I'm going 35mph.
At stop lights I'm seeing 400 at idle. My probe on the pyro is going bad starting to flutter but even if I fix that I'm still having issues up hills. Boost is good, up-pipes don't appear to be leaking but fuel pressure is a little low @56 and I know it's not the fpr because I just messed with that yesterday, put a new poppet and oring in, I haven't checked the fuel pump yet or dropped the tank either. If it is in fact fuel pressure related, does it make sense for me to see smoke coming out, wouldn't that indicate too much fuel? I'm lost, it's driving unloaded like I'm pulling an anchor.
Regardless of which spring I put in the frx I get 56psi, even with the black one I may see 58psi but even with 58psi it was still lugging it's butt off up hills and making that terrible drone sound like F you down shift me now.
View 14 Replies
I have a 2002 F350 4wd with the 7.3. I was driving the truck and all of a sudden it was running like crap. the engine light was on. after a minute or so the engine light goes off and the truck is running fine. then again starts running like crap. I am close to the house so I limp it home. runs like crap.... will barley climb small hills. engine light is on. get home turn it off... next day... starts up and runs great for 10 - 15 min. engine light comes back on... runs like crap.... my neighbor says "It's the crank position sensor" I replace it.... runs great for a month.... now it's doing the same thing......
View 9 Replies
Picked up a second 7.3, just finished installing the new transmission last night, took it on a drive last night, everything was fine.
Went to bring it home last night- and found myself unable to maintain 50-55mph on back roads at 3500 rpm.
At first it almost seemed like I wasn't getting 3rd/4th gear, but upon taking it for a spin with torque pro, I am getting all gears, overdrive works, TC locks- all appears good there. Trans is getting really hot- but I believe I messed up the bypass lines or the bypass valve is not opening correctly- not the biggest concern.
I let the truck cool to more normal operating temps, took it for a spin, same story. I top out flooring it at about 55mph. No fault codes other than my faulty glow plug module. Everything I'm monitoring on torquepro looks fine with the exception of boost. When I floor my other 7.3, I get 15-20 psi, this, I get like.. 4. Unplugged MAP, nothing changed.
Turbo shot? Glogged pipes? These are my first initial thoughts. Let me know if I'm going in the right direction here, I can rebuild a gas motor in my sleep, but diesels are a newer animal to me, I've only had them about 2 months.
View 7 Replies
The front motor mounts are bad. This has been confirmed. When I am cruising at a constant 45 or 55 mph and choose to accelerate because traffic is clearing, etc. the car will thump a bit and only slowly creep faster. It feels as if there is very little response other than the mild thumping. Getting to 65 mph takes time. The car has 70k miles and performs almost flawlessly at slower speeds. Is the thumping/lack of acceleration a symptom of the bad front motor mounts?
View 12 Replies
I have a 1997 Ford Explorer with a 4.0 SOHC engine. It bogs down and won't go over 20 MPH. I'm showing codes P1405 and P1151. Would either of these codes cause that issue? I'm not even sure how to start diagnosing this.
View 1 Replies
We have a 2009 Matrix, 68000 miles. automatic transmission has a loud clunk when down shifting on a hill. Has only happened a few times and cant seem to make it happen. Am really concerned what this might be.
View 5 Replies
99 Explorer Blower motor quit working. Disconnected and hot wired to a battery and blower motor worked. So I know it is in the switch and/or wiring. I need this truck everyday so going into the shop is out. Live in Northern Mn and the temp was -15 degrees. So as a temp fix what does everybody think of running a wire from the battery to a switch inside and then to the blower motor and then to a ground. Would have a inline fuse. If this will work what gauge wire and what amp fuse would you use. Its getting cold without heat.
View 4 Replies
I have a 2001 7.3 with 243k. I think the injectors are shot but other people including a local mechanic say it's not the injectors. What the truck does is smoke white. Sometimes little puffs when accelerating. Sometimes clouds that make the people behind you drop back a 100 feet. I have a ts6 on the truck and that alone with the 243k miles is enough to think its bad injectors. It smoke white. The exhaust is moist to the touch with soot built up like crazy. It doesn't really smell sweet and it's not really blue at all. It's getting horrible mpg. And lacks power. I don't have a high enough psi gauge to test compression. All arrows pointing to injectors?
View 8 Replies
I drive an 08 f-350 with 120k no tune or deletes..(yet). I was driving home yesterday when I all of a sudden I have a lack and power. I then notice i have no boost at all. I heard an exhaust leak and instantly checked my boots on inter-cooler pipes....
After farther inspection, the bolt fairy came and I am missing some bolts on my up pipe where it meets turbo. Is this break in vacuum system the reason I'm having no boost? What is easiest way to get to up pipes without removing cab? Where did the bolts go? I got to get this fixed because I need truck to get around town.
View 5 Replies
2012 F150 5.0L ... Running the stage 3 motorsports Tune on the SCT X4 device ... Noticed higher gear while going up a hill the motor is Pinging. Running 89 Sunoco fuel for two fill ups in a row and I have the 89 Performance tune loaded. It would not surprise me if the Gas station is selling 87 for the 89 Price!
View 7 Replies
Can the power window regulator motor on a 96 Explorer be repaired? I can hear the motor make a thump noise but it is bound. I have seen videos on earlier model Fords where the motor can be taken apart and the plastic spheres can be replaced but I didn't know if that can be done on a 96 model.
View 1 Replies
Decided to try a new wheel to see if I can stop the surge during hill climbing with our 5er. Old wheel looked great with no dusting or nicks. New wheel sure has a whirl when it spools up, but sounds cool. Haven't pulled trailer since swap yet. Truck still only has 85k on the clock.
View 7 Replies
My truck is a 2003 f250 / 2wd automatic, 7.3 powerstroke, 284000 well maintained miles.
Just last week I sprug a large oil leak and had to replace the hoop outlet o rings..problem solved. This week I can drive 15-20 miles on the freeway and the truck starts to act like ota running out of fuel. Bogs down to 40mph then starts missing. I pull over, and when revving I have un burnt fuel and oil smoking out of my tailpipe. I let it sit for 5-10 minutes and it will be fine for the rest of the drive and this happens intermittently, there is no pattern.
The truck has a ton of power, starts great hot or cold. I did a ton of research and found a IPR could possibly cause this, as could plugged screens in the fuel pickup. Then I read about all the injector harness issues but I don't think that I my issue.
View 8 Replies
