Ford 6.7L Power Stroke Diesel :: 2012 - Coolant Leak From Lower Radiator Hose
Jan 3, 2016
Just had to replace radiator at 38k on my 2012 SD. Now I have another leak at 41k. Looks like it's wherever the lower radiator hose leads. Kind of a weird junction. I don't think it's coming from above there, but not sure. It's the primary dgas bottle that was low. The radiator was covered under my ESP. We'll have to see what's up with this one. Been eying a denim blue SD at dealer, thinking this is going to talk me out of it though. Not especially happy right now.
View 3 Replies
Advertisement
I'm trying to troubleshoot a leak on my 08' F250 with a 6.4 powerstroke. It's been dripping coolant when cold pretty aggressively. Once the truck heats up, the coolant leak seems to mostly go away.
Here's a picture of the drip, it's marked by a dart, so you can see the location from the top (second pic). The radiator house connection around the engine seems dry.
Pic from Top ....
What's hidden here that could be causing the leak?
View 1 Replies
Recently I had a radiator hose split while traveling. The EOT got up to 250 degrees before I could pull over and stop the truck. I flushed the cooling system with water, replaced the thermostat, and added Ford Gold coolant as per the recommendations in the Tech folder. My oil temps are higher now than prior to this incident. Unloaded on a flat road my deltas are about 10 to 12 degrees @ 60 mph.
My water temp will stay around 190 to 195 degrees while my EOT have reached 212-215. I pulled a small utility trailer and saw a delta of 17 degrees this was at about 75 mph. Typically unloaded I would only see a delta of about 8 degrees and this was at 80mph. My question is do you think a EOT of 250 would burn the oil, I had Shell Rotella T5 5W40 in the engine. Would it be possible that the oil cooler is partially plugged from this temp?
View 14 Replies
Had a coolant leak I finally traced to the rubber hose on an egr delete (previous owner installed, not sure of brand). Looks like the jackwagon who installed it cranked the clamps way too tight and they eventually split the hose. I have a piece of heater hose that looks like the right diameter and cut to size should fit fine. I guess I am just looking for some reassurance that it would be ok to use in that situation...
View 3 Replies
I am in the middle of a several thousand mile road trip, and I am with family in Utah when this evening I noticed a puddle under my 6.0 Excursion.
Coolant leak? - YouTube
The fluid does not smell like typical coolant, but from the location of the drip, I cant think of it being anything else.
View 14 Replies
I'm going to be replacing my lower radiator hose so figured might as well switch over to the extended life stuff going to probably go with the Delo ELC.. Supposedly it's good for 750k.
View 14 Replies
On Friday am I noticed a 6" sized puddle on the garage floor. Coolant leak on the drivers side coming off the frame. Dropped it off at the dealer on Sunday and today the tech tells me it was in fact a radiator leak and the new one will be here wed. They hope to have it buttoned late Wednesday. I am assuming all will be covered under warranty.
I have 23k miles logged and had just got home from a 1300 mile run pulling about 18k worth of hay and trailer. Truck performed flawlessly. Averaged 11mpg for the trip. I am hoping this is the first and last radiator replacement I have to go thru.
View 14 Replies
My truck just passed the 3 year/36k by 2 days! I got it on 8/4/10 but it only has 27,000 miles of course I just found a puddle of coolant under the right front drivers side. After a little reading, I guess this is common. Should I push for Ford to fix it or get an extended warranty and turn it in on that or... Aftermarket yet that isn't half plastic like this stock POS?
View 12 Replies
2001 F250- V10... Lower radiator hose has coolant leaking - Right now I cannot tell if its the hose or the radiator itself (hoping not) - I tried to take the clamp off and it broke - Any tricks to removing the hose? its on there pretty tight.... I guess if I don't want to save the hose I can rip it off with a pair of pliers but before I do that wasn't sure.
View 2 Replies
2012 F-350 King Ranch Diesel. I am eventually going to purchase a camping trailer to pull with this rig. I am thinking of bypassing the radiator with my transmission coolant lines. I did this on another vehicle and it worked GREAT! That vehicle was a 2001 Isuzu Trooper with that crummy 4L30-E transmission. My trans temps stay round 170 to 175 on the freeway which is far better than the 190 to 200 range that GM says they will run. At any rate, 2011-2017 F-250 to F-350 applications? I was thinking of adding a filter or two with a fan-cooler from B & M Racing Equipment.
View 14 Replies
I own a Honda Crv 2000. I took the car for an oil change at a local oil change shop. They overfilled the oil. I went to the city and came back, and next day the underside of the car was oily and leaky. The car was dripping oil. I immediately siphoned out 300ml of extra oil from the car. After that the leaking stopped and it does not leak/drip anymore. At the same time I saw coolant dripping from the lower radiator hose (where it meets the radiator). I noticed when the fans come on it start dripping. But as of today the coolant dripping has stopped. I am thinking of changing the hose.
View 6 Replies
Coolant seen leaking under passenger door it was running down frame rail looked under hood and seen coolant around the air filter cover . Tank was low 2012 cab chassis 33,000 miles
View 4 Replies
After chasing the smell of coolant for a couple weeks, discovered that the upper radiator hose was leaking at the engine. Based on my schedule and drive schedule, and unfamiliar location this last week, I took my truck to the last people I wanted to - the Ford dealer, where they attempted to charge for the hose replacement. During this time I discovered the nature of how these hoses work and asked the tech why they don't just replace the O-rings ... "Ford Motor Company wants to sell you a new hose with labor" - a direct quote from the Ford tech. And that is why Ford is the LAST place I want to go for repairs I cannot perform. I kept the old hose - any spot where you can get the O-rings alone?
View 5 Replies
Noticed this past month on colder days my upper hose is collapsed, typically a symptom of a bad radiator pressure cap.
This hose is connected from the water pump to the radiator. The radiator is connected to the Degas bottle which has a nonstandard radiator cap.
Do these plastic caps vent the same way a typical cap does?
Cap for 2011 Ford F-350 Super Duty|9C3Z-8101-B
View 3 Replies
This weekend while towing a light load I noticed my FWT and EOT starting to climb rapidly, EOT reached 260 FWT I think about 240. I exited the interstate to find I had a busted radiator hose. I replaced the hose and filled the system with distilled water, but didn't add antifreeze at this time. The system wasn't completely empty.
I noticed once back on the road my EOT seemed to be higher than normal but FWT seemed to be normal. Could the lack of antifreeze cause a greater delta between FWT and EOT? I have seen articles which state do not use Ford Premium Gold Coolant, but to use CAT EL-1 coolant instead. Which should I use?
View 6 Replies
My wifes 2002 gls has a coolant leak from the top radiator hose. I put a new hose on and two new clamps on the leaking end and it still leaks!! I have never seen anything like this and I am not sure how to stop it.
View 3 Replies
The inter cooler to throttle body hose and it seems to have coolant all over it.
View 12 Replies
I have a 1999 jeep cherokee 4x4 four liter inline 6. have a coolant drip at bottom radiator hose, change hose. but still drip. Could water pump be leaking. and it running down on the bottom radiator hose.
View 4 Replies
I just bought a used 09 yaris, 5 speed manual tranny. There seems to be a small coolant leak on the top hose coming from the radiator, the one that connects to a plastic flange or adapter and then go's to the engine block. The car does not get hot and it drive fine except it leaks at that spot. I try using a regular hose clamp and still leaked. Is the thermostat not opening up or is the water pump intermittent stopping? or something like that. Or maybe the hose itself is bad. Since this is a used car who knows what the previous owner did, I might change out the hose over the weekend and replace all the coolant to the correct Toyota long life system. to be on the safe side.
View 3 Replies
2 1/2 years ago I installed a BPD remote oil cooler with BPD filter. The stock oil cooler was clogging up for the second time and didnt want to chance it. The BPD oil cooler works great. I have never seen high oil temps in any driving condition. Last week I was replacing the hubs and seals on the front of the excursion and noticed the oil was leaking from the 90 at the end of the hose oil filter location. I called BPD and sent them a picture. The 90 is corroded and is failing. They said something about a 2 year warranty but because of the rust they would not send one out for free. I purchased a new hose and the other 90 that goes right after it.
They recommended that I spray it with undercoating or something. I live in upstate NY and deal with a lot of salt on the roads in winter. I do keep the truck clean in winter as much a possible. I am posting this so if there are any others in similar situation you should do something to prevent that 90 from rusting like mine did. If I had known this when we installed it prob would not be replacing it now. Will be replacing it tonight or tomorrow. BPD said I will need a 1 1/4 crow foot or remove the turbo to get to the other end of the hose. Not posting this to bash on BPD just sharing so any others can prevent this part from rusting out.
View 14 Replies
I have a 2005 F250 with 6.0 and almost 175,000. On vacation right now and noticed when I came out of a store that there was a puddle of water under the passengers side. Chalked it up to AC defrost. The second time I was not running AC and puddle again.
Felt and smelt of it...antifreeze. Just put in all new Zerex G05 and a new degas tank because when working on it I noticed a pin hole in the base before we left. I replaced the EGR cooler and hose from Sinister about 3 plus years ago.
Would the EGR cooler hose be leaking? I've noticed that white residue on top of the intake around the where the hose is. What would cause this, Heat, wear and tare....my luck ?
View 2 Replies
