Ford 6.7L Power Stroke Diesel :: 2015 - No Outside Temperature Display


Feb 2, 2015

I cannot believe outside temp is not available on 2015's...I don't see it on any screen or in the manual.

View 13 Replies

Advertisement

Ford 6.7L Power Stroke Diesel :: 2015 - Check Coolant Additive Warning On Display?

My 2015 F350 6.7 has 13,400 miles and displayed the check coolant additive warning as I pulled into town from an 850-mile round trip this weekend. If the radiator in 2015 is still the same as the one used in 2012 etc discussed in another thread?

I will call my local dealer tomorrow. I do not see any obvious leak at this point. I had the oil changed before taking the trip and assume all fluid levels were checked.

View 14 Replies

Ford 6.0L Power Stroke Diesel :: No Power At Operating Temperature?

This is my wife's daily driver so I've got to get it done this weekend. 05 Excursion with 04 motor, 95,xxx miles. No problems until Friday. My wife drove to Seattle for a physical therapy appointment for my daughter and when leaving she said it felt like it was idling a little weird. She was at a stop light and when it turned green she could barely move, no power. Called me and everything sounded good from the Edge. Had the truck towed from Seattle to our house, about 60 miles. Idles really rough in drive, smooth's out a bit when in neutral. Starts totally fine when cold or hot, but doesn't start acting up until at working temp. When I say there is no power I mean the truck won't even pull up our drive way that only has a slight incline and is the length of the Excursion.

Only code I get is a P1000, but that is always on the tuner for some reason. I pulled the upper fuel filter and I'm getting fuel. Checked all the fittings I can see and nothing electrical seems out of the ordinary. New IPR and ICP within the last year. Tried disconnecting the EGR and it ran the same, but threw a P0403 and P0405 code. I've tried researching this and can't seem to find anything having to do with loss of power when hot. Sitting in the street in front of the house with the truck running I show an ICP of 750psi IPR of 28% @ 680 RPM VGT is 64.6 and MAF is 44.0. I can hear the turbo whistle, but show 0 boost which I think is normal when no load. I tried pulling into the drive when at temp and the truck was hitting 1000 rpm with pedal to the floor and wouldn't move, shaking and rough the entire time. Before all this my delta on EOT and ECT were under 5*

View 14 Replies

Ford 6.0L Power Stroke Diesel :: Transmission Average Temperature?

What is the average temp the transmission runs at? Wondering because it slipped the other day and the fluid smelt like it was burnt almost. Wanting to monitor it on my scan gauge and just try to ride it out as long as possible..

View 14 Replies

Ford 6.7L Power Stroke Diesel :: 2015 - Shaking Under Slight Load Due To A Small Incline And Loud Diesel Sound

So I have just over 14k on my 2015....... I love the truck but have had a few small issues. I had a water leak coming in from the roof that would leak through the grab handle. Nothing major dealer replaced one clearance light seal and they said the windshield needs to be re sealed.

Then I had a god awful irritating squeak in the dash..... It only does it late In the day when it's been hot. The dealer said it was a loose air bag. I have had the truck back a week and it's doing it again.

Those are little issues that will get resolved...... I hate having problems with a brand new vehicle but I understand it happens and that's what warranty is for.

I also reported a bad shake to the dealer...... The truck will shake very violently and have a very loud "diesel" sound. It's very specific at when it occurs. It has only done 4 times in the past 6 weeks including today. The odd thing is the 4 times it has done it has been the same time of day in the exact same spot on the exact same road!!!!

Basically I leave my office sit in some traffic and by the time I get to the parkway it has been35 minutes or so. Only happens in 6th at 60 which is roughly 1,400rpm a slight load due to a small incline and it shakes real bad! The typical "diesel" sound you get when under a load is very pronounced almost to a knock. It will continue to do this as you slowly increase throttle until it down shifts and then goes away. I also caught it doing it and I manually shifted to 5th and it went away.

Because of the rpm at which it happens with slight load only doing it in 6th I lean to a Trans issue and more so a converter problem. It feels like converter shutter. I just don't understand the engine sound.

I gave very descriptive info to the dealer..... Several techs drove it and could not duplicate. I just picked the truck back up last Thursday and the dash squeak is back and the shake happened yesterday and again today. So I am a bit irritated to say the least.

I really hate the fact that I know there is a problem but I also understand if a tech can't duplicate it he can't diagnose it. However today I did get a video of it with my phone so they will know I'm not making this crap up!

View 8 Replies

Ford 6.0L Power Stroke Diesel :: 2004 - Will Not Restart If Shut Off After Getting Up To Temperature

I have a 2004 f350 6.0 and it makes 550 horsepower and lately when I go to started in the morning it'll start at once everything gets up to temperature if I shut it off it will not start again without starting fluid into the air box if it's warm...

View 2 Replies

Ford 6.0L Power Stroke Diesel :: 2006 - Two Temperature Gauges On Dash?

I have a 2006 Super Duty 6.0L, and I'm what are the two temperature gauges on the right side of the dash are? I'm sure one is engine temp, but what is the other one? Also, which gauge is which (in terms of top/bottom)?

View 11 Replies

Ford 6.0L Power Stroke Diesel :: Low Oil Temperature - EOT Jumping Around For No Apparent Reason

I've had a Scan Gauge II in the truck for the last 3+ years and usually have it showing ECT EOT FICM main power and volts. For all that time, my numbers have been normal until last month. With the engine up to temperature (ECT at 190 or higher), my EOT is lagging behind - sometimes 20* cooler. I've also noticed the EOT jumping around for no apparent reason.

From what I understand of the 6.0 cooling system, the oil is cooled by the coolant and what I'm seeing shouldn't happen if the engine is up to temperature. The obvious fix is to swap out the EOT sensor but I figured I'd ask the experts first. Any thoughts?

2005 dually crew cab with 105k.

View 6 Replies

Ford 6.0L Power Stroke Diesel :: Boost Display Drops To 0?

On my monitor, when I really get on it, I see the boost come up nicely and then when it gets to about 22 -23 lbs, it drops to zero on my monitor display, but the engine does not seem to falter in anyway. Why or what I might do about it?

I find it very annoying and do not believe it should be doing so, thus figure it might be causing some other problems or so. ..? I hear others talking about seeing 24 and up boost being displayed... why not me?

View 8 Replies

Ford 6.7L Power Stroke Diesel :: Configuration To See Gear On Display?

I know that when you are in the manual mode you can see which gear you are in on the right hand side of the small display between the speedo and tach (forget what that display is called). Is there a way to configure that screen so you can see which gear you are in while in "Drive"? With six gears to go through and these things shifting so smooth, I just think it would be nice to be able to tell what gear you are in at any particular time (especially when towing). -Glenn

View 14 Replies

Ford 6.0L Power Stroke Diesel :: Fan Stays Engaged Until The Truck Hit Operating Temperature

I replaced my fan clutch... Not a bad job, did it a couple weeks ago. I don't drive the truck much, but took it out today for the second time in the two weeks since I replaced it. The fan stays engaged until the truck hit operating temperature it seems. Is that normal?

View 1 Replies

Ford 6.7L Power Stroke Diesel :: CEL - Ambient Air Temperature Sensor Circuit High

P0073 Ambient air temperature sensor circuit high. Preliminary inspection, right outside mirror badly damaged/broken. Guess where the sensor is?

View 6 Replies

Ford 6.7L Power Stroke Diesel :: 2011 - Engine Won't Warm Up To Operating Temperature?

My best friend has a 2011 Ford F-250 6.7 ltd power stroke diesel XL. He was driving to Denver in -4 degree weather when all of a sudden his windows iced up and the temperature gage would not sit at normal operating range. ( stayed all the way down on the cool side) the heater seemed to be blowing warm air not hot like it usually does. The thermostat was changed 2 months ago any thoughts on this one?

View 14 Replies

Ford 6.7L Power Stroke Diesel :: Check Coolant Message On Display

I have my check coolant message on my display again... I need to get the fuel filters changed so I'm thinking of having the coolant flushed too. 45,500 or there abouts on the ODO.

View 9 Replies

Ford 6.7L Power Stroke Diesel :: Instant Mileage Display Froze Up

Own a 2011 6.7 diesel, 59K mileage, short bed 4 WD. Was driving at 70 mph and noticed my instant mileage display read 0. Usually I see a instant mileage reading of at least 16. No regen was in progress. Steady gas throttle. Display could be changed to other screens. After a few minutes it came back. But it jumped to 16 and did not ramp up.

View 3 Replies

Ford 6.7L Power Stroke Diesel :: 2015 - Low Fuel Pressure - Reduced Power?

1st diesel was a 1997 F350 dually (White Lightning). Upgraded last year to a 2015 F350 (The Rocket Sled)- the kids named it hahaha. Had to take the 6.7 (9200 miles) into the shop... Last Sunday I took the truck out and about 5 minutes from home I got the low fuel pressure warning. Pulled over and tried to purge air out of fuel system- the low pressure pump was making a terrible racket. Turned around and limped home- reduced power came on soon after. Parked it until I could get to the dealership on Tues. Long story short- dropped it off at the dealer (low pressure pump still making noise/ no low fuel waning, just CEL light).

Called to check status today- dealer can't seem to duplicate problem. Service advisor said if mechanic can't find anything wrong, service manager was going to take it out and try to duplicate. The is the 2nd time I've got the low fuel pressure warming. The first time (around 4000mi. ) was in winter- I changed out fuel filters and it went away. I was towing the 5th wheel. Just had to vent-I have to get this figured out. I wouldn't thing the filter could get clogged within 5k miles. Have a camping trip scheduled next week!!

View 8 Replies

Ford 6.7L Power Stroke Diesel :: Change Oil Life Display To Show A Percentage?

How do I change the Oil Life display to show a percentage? The owner's manual isn't very clear on this. Presently it shows "OK" until it wants an oil change. The bride's '13 Explorer shows the Oil Life as a %.

View 9 Replies

Ford 6.7L Power Stroke Diesel :: Exhaust Filter Clogged Message On Display

My truck started to display exhaust filter clogged and cleaning exhaust filter multiple times today. The cleaning exhaust message stayed on until I hot OK and then it comes back later. Not sure what this means?

View 14 Replies

Ford 6.7L Power Stroke Diesel :: Gear Indicator Display Quit Working

So for 4500 miles since new my truck has been displaying, on the right side of the instrument display in the center dash, the actual gear the truck is in. I would shift from park to drive and move out and the truck would display what gear it was in by placing a lighted box around the gear number as it shifted 1-6. Now that display is gone. It's not anywhere. If I go to the manual mode it will display that, but the normal numbers from 1-6 , bottom to top , are gone.

View 14 Replies

Ford 6.7L Power Stroke Diesel :: Tire Pressure Monitor Fault On Display

Well, at a little over 10k I have my first issue. My monitor displayed a Tire Pressure Monitor Fault. All tires are OK. Light won't go out. Guess it just earned a trip to the dealer.

View 14 Replies

Ford 6.7L Power Stroke Diesel :: Adding Blank Gauge Display Screen?

I came across a post where someone said it was possible to add a gauge/setting to the blank "gauge display" screen. I've searched and searched but can't find the post. Ho to add to the gauge display blank screen.

View 14 Replies





Copyrights 2005-15 www.bigresource.org, All rights reserved