The tech folder "Coffee Table" book link is broken - no more visual aid from there! So, Looking for a copy of the illustrations that show the EGT sensor locations?
View 3 Replieswas looking for the oil pressure sensor and can't find it got it narrowed to 2 there is a sensor between the the oil filter and fuel filter i think thats the temp sensor and then there's 1 at the say 11 o'clock position behind the the oil filter...both have a 2 pigtail connector.
View 4 RepliesI've been searching and searching but I just cant find out the location of the Transmission Speed sensor, It would be the one that controls your speedo and Transmission pressure? Is it located on top of the rear differential?
View 4 RepliesI'm looking to use a 5V location for the Dash Boss fuel pressure sensor. I know most of the sensors (except the CMP & CKP sensors) use a 5V reference voltage. Which one to use? AIT & EBP are close to the sensor mounting location.
View 14 RepliesI am looking for a fuse panel diagram for a 07 F350 6.0 ? The truck didn't have a owners manual in it and I have a couple things not working and testing each fuse is just more self hate than I can submit myself to today.
View 3 RepliesMy truck didn't come with factory option aux switches. Can it be added, and is wiring present?
View 14 RepliesI was wanting a fuse digram for a 2011 f250 6.7. My right brake light is out and I don't have a way of knowing what fuses have to deal with the lights. If some one could tell the which ones or send me a diagram
View 2 RepliesWhere I can find a wiring diagram of the inside and outside lights on the 6.0s? I'm trying to wire up my running boars lights to my dome lights and tail lights but don't know the colors or locations of the wires. The tail lights wouldn't be as hard to find as the dome lights, what is the location and color of both.
View 14 RepliesI have a late 03 f350 and see some relay boxes under the hood drivers side rear bolted to the fender, looking for a diagram of what those relays do,also one box has a 10a fuse. Also any have a fusebox breakdown for same truck in cab under steering with 4 plastic cover screws?
View 12 Replies2013 F350 Lariat with the factory OEM rear view camera. I am replacing the tailgate with a 5th wheel tailgate for a few months and would like to still retain the convince of a rear view camera.
I have obtained a Ford camera harness to use as a jumper for a non OEM camera which comes with the standard basic RCA wiring which I plan to mount to the bottom of the 5th wheel tailgate.
My hope is to wire the camera direct to the Ford wire harness which is a 6 wire pigtail. Which wires on the camera mate to which wire on the trucks wire harness.
I need to connect a remote start stop for a bucket truck attachment to this new 2016 F550. Found everything except the ignition wiring harness diagram. Need to know what I can tie in to.
View 4 RepliesThe service truck threw a CEL, and i pulled oxygen sensor performance bank one sensor one code. That would be driver side sensor between the manifold and cat, rite? Don't want to change the wrong one...
View 11 RepliesTrying to locate my a/c drain tube on my super duty. Noticed the other day no water draining with the a/c running. Wanna check to make sure the tube is not clogged.
View 14 RepliesI've had a 2007 Coachman Freelander class C RV with E-450 for about 8 months now. We have been on 7 camping trips to the same location this summer, and the engine has sputtered in exactly the same place on 6 of these trips. It's pretty freaky, like the road has bad mojo there.
We have to come down a steep incline for about 2 miles, dropping about 500' vertical at about 6500' elevation. Then we drive for 2 miles on the flat before hitting a big mountain climb up to 7500'. About 30 seconds into the climb, the engine will sputter, and kick out smoke from the tailpipe. The first time I pulled over, and it idled fine. I took off and climbed the hill just fine. Now I just drive through the sputter, and it goes away after a minute.
So what's happening? Is the fuel tank sloshing crud around? I never get a water-in-fuel alarm, although the E450 doesn't have much of a message center. It doesn't happen on other sections of mountain road. This rig has about 38,000 miles, and is bone stock. I put new oil and fuel filters in before the summer. This rig is the same size as my old '82 RV E350 w/ 460, and boy is the 6.0L an improvement!
just picked up a 2004 (May, 04) F350 DRW with the 6.0 Powerstroke. I love this truck so far. After sitting in the driveway overnight, I noticed a decent sized puddle of oil on the driveway, probably the size of my fist. I took several pictures for diagnosis:
Any quick thoughts as to where this oil leak is originating?
2012 F350 Lariat - want to install cab lights. Can't locate correct wire to tap for power. I want to use the same power that powers the parking lights so these come on as they should. Is the best connect on the driver or passenger side, and what color wire is it? I've read yellow with green stripe (and found about 4 of them) and a brown wire I couldn't find.
View 1 RepliesGot the upgrade done this week to allow manual regen. Instruction sheet says 'press the 'Info' button until 'EXH FULL XXX%' illuminates. Not sure I have that button. I've scrolled through everything in the info center and am seeing nothing under any menu item that gets me even close.
View 14 RepliesJust asking where about's the ficm relay would be under the hood of my '04 6 liter, I have 3 boxes to chose from.
View 9 Replieswhere the oil pressure switch is on a '05 E350 6.0 PSD? My filter is on the bottom, is it near or part of that housing?
View 9 RepliesWhere the air intake for the cabin air conditioning system is? The past several trucks I've owned had a cabin air filter which I replaced annually. They get filthy and I can see why this dirt should not get into the evaporator coil. It will reduce air flow and here in Texas we need all the air flow we can get (106 today). It shouldn't be too hard to improvise a filter to wrap over the intake (for a cheap fix).
View 3 RepliesHave a 2010 Lariat crew cab and I just bought an upfitter switch set and relay harness. Found where to mount the relay block and have been able to get the switch panel installed in its home. For the life of me though I cannot find the plug in the main harnes under the dash to plug the relay harness into to power everything up. I've read several threads here and even found the drawings that indicate plug #C215 in a diagram for the 2011+ trucks. When I get access panel out and look underneath the dash where it should be....no spare or open plug. Is the plug location diferent in 2010 from the 2011?
View 2 Replies