I just purchased a 50 inch straight light bar it is 5D so just mainly projection focused spot beam, mounting one towards the back end of the roof? what to be used to mount it and how ? Also driving in the snow should not be an issue because it is a projection Focus being but if you have mounted one and driven in the snow.
View 1 RepliesI am looking to mount a viair tank and compressor on my truck, I was thinking underneath on the frame. Have any pics?
View 14 RepliesI have just installed air bags on my 2015 F350 DRW and looking for a location for the air compressor and control unit for the wireless manifold.
View 14 RepliesHave a 2012 F250 4x4. Have read many posts about different lifts etc. I don't want to go real big but I would like to go to a larger tire than the stock Michelins.
On a F250, done a 2 inch front leveling kit and switched out the rear blocks to F350 blocks. Assuming I wanted to put new shocks on with this change, what level kit and what adjustable track bar (from what i've read this is pretty much required).
I have a 4 inch MBRP turbo back straight pipe and I hear a lot of other 6.0 that sound much louder.
just curious as to why that may be?
I have a 2011 f250 crew cab lariat that actually sits about 3" higher on the passenger side in the rear. I never noticed until I put some 4" pro comp blocks on the rear. I measured before and the rear left was 40" and right was 41-3/4". Now the drivers side rear is 42" and rear passenger side is 45"? I have looked at the blocks to make sure they are seated properly and everything is installed correct so what gives? What could be causing this. I bought the truck with 99k miles and now it's at 130k miles. I do tow a small cargo trailer sometimes but it is only about 3k lbs. Now I am thinking of buying some new leaf springs to see if that corrects the problem.
View 4 RepliesWhere can a transmission temperature sensor be mounted on a 1999 manual powerstroke transmission? What is the part number for an applicable sensor that will work?
View 2 RepliesThis morning I went to start her up, and she fired right up and I let her warm up until oil temp got to 100F, when I realized that I wasn't leaving right away so I shut it down and came back about an hour later. Oil temp now at 78F, but she wouldn't start. Have Torque Pro running, and the IPR is going straight to 98.6% every time while cranking, sits at 14.7% with KOEO.
Truck's been running fine, recent oil/filter change (T6 10-40W), cleaned & re-installed CAC tubes/boots for leaks. All else seems good. Pulling the ICP sensor shows HPOP going to 2800psi, with IPR @ 30%, still no start and not even a cough.
The IPR is original, rebuilt once several years ago.
New to me 2002 F-250 PSD, done brakes all the way around for piece of mind.
Job went very well, replaced one caliper and its bracket, serviced all pins and replaced one set of pins as well, (different corner). Bled brakes all day via gravity, watching reservoir and filling as needed as to flush in new fluid. Truck is in great shape. Mileage 153,000 no rust, turned all rotors just to re-surface.
Now here is what's happened, my pedal is good but it pulses in the first 1/2 inch of travel and once passed that no pulse, got under and watched the pedal rod do this as I very easily touched it in that first 1/2 inch of travel, you don't even begin to get much brake started here if any! Truck running; yes-Truck not running no pulse action occurs.
I'll add this: fluid removed had a green tint to it but had no moisture or bad odor. Different fluid??? I didn't know. Used Dot 3 Off the shelf O'Reilly's.
Hydro-booster didn't like fluid? Air? Master cylinder? No leaks before or after this procedure.
Got some road noise going on always noisy while driving straight or turning to the right. If I take a turn at speed on the highway to the left the noise stops. Sounds normal, once I straighten out the noise returns. So my thoughts are clearly drivers side, but not 100% sure where to start my search. Wheel hub is my first thought, is there anything i can do to check if the hub is good since they are sealed?
View 4 RepliesI connect the batteries and the overhead lights don't out, plus the theft light is blinking. Bad door switch maybe? I don't have the original Ford key
View 1 RepliesThe thing is the truck seems to run fine. But, when it hits 30 pounds of boost it goes in to limp mode. Good way to get yourself run over on a highway. I'm wondering if the computer or whatever has gotten off somehow and is sensing a problem too early ? Would a re-flash possibly correct this ? BTW, it is a 2005 with 63,000 miles.
View 4 RepliesI have a 2005 F250 with 6.0 Crew cab
Wanted to change out factory bulbs to LED's. The factories were working just fine, just wanted LED's. Broke a couple of center bulb holder's/clamp. Don't really know what they are called. Went to junk yard got a couple of used ones, those worked because when we opened the doors on wrecked trucks Dome lights came on! Got home put them in and NOTHING. No dome, no map lights with LED's. Changed back to factory bulbs and only map lights come on, NO dome lights on front or back and my 3rd brake light quit along with the 2 bed lights. Checked the wiring plug and have power to one wire. What fuses would I need to check or to check where next? Owner's manual is not very specific about which fuse.
So this morning, I stopped for fuel. My low fuel light had come on yesterday, so I planned on filling it up this morning. Swung through the local Safeway (my usual fill-up haunt) and threw 25 gallons of diesel into my Excursion. Truck started up right away, like always, pulled around in the parking lot, pulled into traffic, then got stopped at a red light. I noticed a slight unevenness in the idle for a couple of seconds, then the light turned green. Pulled out, truck accelerated a bit more labored than usual, and in my passenger's mirror, I looked back and saw some light greyish blue smoke.
The smoke progressively got heavier, power diminished, and I was no longer able to maintain speed with traffic. I pulled off onto a side road, shut the truck down, and scanned for pending codes. Nothing. So I hoped that it was just a gremlin, started the truck again, got tons of the same smoke, really rough, super clattery idle, and the engine wouldn't even accelerate in park. No hint of boost, nothing. So I turned the truck off, called a tow truck, and had her flat bed hauled home.
Background on the truck, roughly 150K miles, changed the fuel filters not too long ago (less than 7K on them), recent-ish oil change, but I was planning one for later this month. Truck is all but stock, only an aftermarket cold side intercooler tube. I recently replaced my EGR valve, less than a year ago, because it was stuck partially open, replaced it and the truck ran great after that.
I've been seeing some scary writeups for similar things, stuff involving cracked pistons, bad rings, engine teardowns, new engines required, things like that. For me, it just seems like a ridiculously convenient coincidence that the problem would happen immediately after refueling the truck. At this point, I'm planning on replacing both fuel filters and doing an oil change as preventive maintenance and as the easiest possible fix, but what else should I be looking at? Some posts suggest FICM, some suggest ICP sensor, some are saying my injectors may be shot.
My low fuel light came on tonight. I drove about 2 miles, stopped and shut the truck off. When I restarted it and began to drive off to the fuel station a notice came on that isaid power reduced then a check engine light came on. I was about a mile or less from the fuel station so I filled up. I cycled the key but the engine light is still on. No low power message tho. The power is fine.
I came home and drained the water drain on the filter, didn't see any water but hoped it would solve the problem. I cycled the key a few times and started the truck but the light is still on. My truck is a 2013 f350 6.7 and has 211500 ish miles on it. I bought it a month ago with 18500 miles and haven't had any issue until tonight. My only thought is maybe the fuel filters need changed. I don't know if or when the previous owner changed them.
i just installed a Dash Cam and it needs power all the time. Is there a way to tap into the dome light?
View 2 RepliesI started my '16 6.7 this am and drove it about a mile.
The check engine light came on and at the same time the display said "Reduced Power". I decide to turn around and try to make it back to my shop but shortly after turning around the display said "Low Fuel Pressure" and within a couple of hundred yards it shut down leaving me stranded by the side of the road.....
I called my local dealer who gave me the Ford Cares 800 number. I got a flat bed in about 1.5 hours which I didn't think was too bad considering I live in the country and they brought it to the dealer. The SA said it might be a couple of days before they could look at it as they were pretty busy... What it could be? The engine is stock with 9100 miles on it...
I have an 03 excursions with 6.0. I downloaded the sct livewire ts and the problem started. Through truck has no power the thief light flashes codes for cam and crank sensor and on when it acts up the glow plug light comes on. On the on the ts monitor it says no key in the ignition.
View 11 RepliesOk yesterday while driving my truck the glow plug light came on couple times and lost power but the light would turn off and power came back. It has done this before and it was the injector harness grounding out on the engine. I replaced that last time. I checked over the knew one and did not see any chaffing on the harness.
Now this morning I go outside to start it and I can hear my fuel pump and vacuum pump but injectors wouldn't cycle. It has also done this before but I could never figure out why. Last time I tore into it checking through my wiring harness and couldn't find anything. When I put it back together it started fine.
2004 F-250 6.0 Turbo Diesel W/ Torque Shift Transmission. Im having a problem with my Check Gauge light coming on and Tow Haul light flashing on my 04 F-250. I got a Transmission Fluid Temperature Sensor from my local Ford Dealership. They also said i needed to replace the Transmission harness for this application because of an open circuit.
My questions are, Is Mercon SP the only ATF that can be used on the Torque shift transmission and do i really need to replace the harness or just the sensor? I have read up a little on this and so far everything say's drain the fluid, drop the trans pan, swap out the sensor, replace the trans pan (torque setting is 11flbs I believe, correct me if I am wrong, replace with Mercon SP ATF and your good to go.
Friday I pulled my steel gn 3 horse trailer about an hour each way. with the horses it weighs right at 7000 pounds. no issues. Saturday morning I drove to town, no issues. Saturday evening, I got in it to run down the road and about 2 miles from the house, the check engine light came on and the tow haul light started flashing and the temp gauge is dead. drives and shifts normal, tow haul button still functions. Truck is stock except for an EGR delete. No tuner, FICM was rebuilt. I had it on a battery minder before I left and was thinking about pulling the batteries and letting it sit for a while to see if it clears. Scan Gauge II shows no codes.
Sunday: So I let it sit all night, batteries connected and it was completely normal this morning. will see what happens when I drive it to work tomorrow
Later Sunday evening: So I just took it out for a test drive, went a couple miles down the road, shifting normal for a cold start. Temp gauge is working, just as I am almost back home. 5 miles at the most, temp is coming up to normal, gauge goes dead and check gauge light comes on and tow haul starts flashing. I think it might be the sensor.
This morning: I got about 6 or 7 miles from home, trans just got up to temp, pulling up a hill, it shifted out of overdrive, tft gauge went dead, check gauge light came on and the tow haul light started flashing. still shifts like it always has and the tow haul button still functions.
I am thinking it is just the temp sensor. Truck has 159k on it.