Ford 6.7L Power Stroke Diesel :: Steering Oscillates At Speed In Turn?
May 9, 2017
I have an oscillation in the steering wheel at speed in a turn. Feels like the pump is trying to straighten the wheel then gives up then trys again then gives up etc etc..... The oscillation is slow so its not like the wheel is shaking or about to fall off. The faster you go the more pronounced it is the tighter the turn the more pronounced it is. Doesnt matter left or right. Seems like its there at any speed but just gets worse the faster you go.
View 9 Replies
Advertisement
I have a 2015 Platinum Superduty that came with a heated steering wheel but cannot figure how to turn it on and off. I have looked for a dash switch and in the climate portion of the touch screen with no luck. My wife's car has a simple dash mounted switch and also a temp sensor that cuts it on automatically when cold. No such luck with truck.
View 14 Replies
I have an 04 6.0 psd and if I am stopped in drive with the brake pedal down I can't turn my steering wheel at all. If the truck is in park and my foot off the brake pedal I can turn the steering wheel both ways just fine. When I am driving I don't have any problems with the steering. I have checked the power steering fluid and it is full. This makes it kind of hard when I am trying to pull in and out of parking spots. What could be causing this and what the solution would be to fix it?
View 10 Replies
I have an 8 inch lift with 37x13.5 inch tires and dual front steering stabilizers. when I'm stopped I can barely turn the wheel. my buddy has a 6 inch lifted excursion with 35 inch tires in his is easy, one hand no problem. Would the difference in tire size really make that big of a difference or am I having a steering pump issue?
View 9 Replies
The steering on my truck has become a little heavy after making a turn and bringing the steering wheel back to center. The steering feels heavy like I had a front tire half way down. There's a lot of drag then once on center it's gone. Could it be the beginning of the end for my ball joints?
View 10 Replies
A month ago I got into my truck in the morning and when I turned the key to Run everything lit up like normal and after the glow plugs warmed up, I turned the key and there was about a two second delay between me turning the key and the engine cranking over.
The next couple times I tried starting the truck that same morning I had to try to start it a couple times because it wouldn't try to crank over the first couple times but it would always eventually start.
It's been continuing to give me problems but never stopped running once it was started and then this morning I tried starting it for 45 minutes with no luck.
What I have tried so far is:
Resetting batteries
Jumping the truck
Checked to see if the starter is getting power. ( I put wire testers on it while someone else started and I didn't get a good reading even when it did start. New starter was put in 9 months ago.)
I also made sure wire going to starter wasn't corroded
Battery terminals are also not corroded
Checked fuses
Tried starting truck with fan clutch disconnected
Cussing at it
Tapping starter with a hammer while trying to start it
Also, everything sounds perfectly normal when I turn the key, it just doesn't even try to turn over.
View 7 Replies
I have an 03 Excursion with 220,000 on the clock. Started getting harder starts randomly about a month ago, maybe a little more, pulled codes got p2290. Reset everything, changed the oil, oil filter, both fuel filters, eventually the ICP sensor itself and rebuilt the IPR with new screen kit and rings. Hard start went away for about a week but ICP pressure was dropping drastically during hard throttle or even trying to go up a good sized hill. I had a bypass oil filtration kit on and noticed that the connection on top of the oil filter housing was weeping at idle and leaking enough at throttle to possibly cause an issue. Replaced with new OEM filter cap and fill cap, and ended up with a no start and low ICP pressure.
Got it started today after a long crank (15+ seconds), ICP and IPR at idle both warm and cold are mid 600's and low 20's (I can get actuals if needed). After reaching operating temp starts fine after shut off (both immediate and after sitting for 20 minutes). I picked up a selection of parts and tools including an ICP air test tool. Also grabbed a hpop gasket kit and the updated O-rings for the whole system. Live scanning wise I have an Edge CTS and also an SCT x4 that I can use.
View 14 Replies
My f350 6.0 has seem to have lost its power, while I was driving home it would only accelerate at one constant speed, and driving up hill it would not accelerate at all, I also noticed an elevated exhaust temperature.. There are no warning lights or dash lights indicating any problem.....
View 8 Replies
Saturday while moving some items for the inlaws my truck, while moving at slow speed, reduced power to the point where it almost stalled, anti lock brakes were growling, right rear tire was dragging the brakes skidding the tire. maybe ten seconds then ran normal. got to stop sign and made a right turn and at about 30 mph started doing the same on and off for maybe 30 seconds. All the time Advance Track light blinking 3 times then pause, and repeating.
Stopped in a parking lot for a couple mins, did not shut off but drove the rest of the way home normally. At home we could smell brakes cooking, right rear brake disk was very hot. Drove to dealer Sunday morn with Advance Track over-ridden and ran normal. What would happen at highway speeds or towing my fiver? Bet they cant reproduce the prob, left no code etc. You know what that means.... I will update later.
View 6 Replies
What makes a 6.0 or 7.3 "clack"? I am not experienced enough with internals of a diesel to understand it.
Reason I ask, is my 6.0 is clackier than ANY other 6.0 or 7.3 that I have encountered. I mean it really cackles. Injector timing?
the engine was "bulletproofed" and (as the seller stated to me) was "flashed with a custom designed tune made by a Powerstroke specialist"... to which I have no further information on. This I assume was done for longevity and not performance.
Its quiet on the highway, but in town and stop-starts or low-speed acceleration it is crazy crackly.
View 14 Replies
I was taking a trip the other day and needed to pass some slow traffic and found that the engine quit making power at around 95 mph. From 45 to 95 comes fast. Not good to have power stop when passing.
I know it is not safe to be driving our trucks at around 100 mph, but for a short burst to pass traffic, it is more dangerous to have the engine quit making power while you are trying to pass.
We purchased our truck new in 2012 so since I just found out about the problem, I have not had the truck up to 95 before now.
View 14 Replies
So my fan speed sensor popped up on Torque. I almost never hear the engine fan in the first place. But once in a while I do. I've only ever heard it when I'm laden with enough weight to really strain the engine. It sounds like a freight train when it does kick on. Should I be worried? I've done the EGR delete. New oil cooler. 4" straight pipe from turbo to just behind the cab. 130k on the works. 6spd manual.
View 8 Replies
I have a 2012 F350 I keep the hubs in auto all the time. In the winter I just flip the switch to 4 high when I hit snow conditions. I know to shift in or out I need to be below 55mph. How fast can I safely drive in 4 high on the interstate? I drive hundreds of miles at a time in the winter. Some times if the roads clear I will cruise at 70-80mph. This is a question of mechanical safety on truck components not driving safety.
View 13 Replies
My power steering is only working when i turn it to the left. When I turn it to the right i have to get a 1/4 of a turn in until the power steering takes over. So i get under my truck to discover what seems to be a piece of my tranny missing. How screwed am I ???
View 11 Replies
I've been getting a surge or revs when getting up to cruising speed before it drops into overdrive or or a constant speed. Happens around 1800-2200 rpm before up shifting to the next gear. More noticeable if under a load or going up a grade when it will hold gear longer before shifting. Only thing I can think of that would be related is the truck does lack some power on a cold start for the first couple miles before getting up to temp. I've cleaned the ebp sensor and it appears to be working correctly, reading within .1-.2 of BAR/MAP key one engine off. VGT solenoid is clean but have no real way to tell if it's working correctly. Other values icp/ipr temps fluid levels appear to be correct. Just changed the oil and it continues, changed the transmission oil and filter about 3000 miles ago. I've had this going on for about 1000. Started about the same time I changed tunes to PHP. They haven't been able to find anything in the tuning yet that could be causing this or if it is just making it show up now.
View 14 Replies
While driving I went to speed up and heard a bang. I lost all drive. I have no movement in any gear. I got the truck home and looked around. Trans fluid looked and smelled ok. I couldn't move the rear drive shaft by hand with engine in neutral. I drained the transfer case and that fluid looked fine also. What it could be or what else to look for. The truck is a 2006 f350 with 6.0 and 185,000 miles. Up to this point I had no trans issues.
View 14 Replies
I've been searching and searching but I just cant find out the location of the Transmission Speed sensor, It would be the one that controls your speedo and Transmission pressure? Is it located on top of the rear differential?
View 4 Replies
I've mentioned in the recent passed a vibration I have and thinking it may be one of my hub bearings. Now I really can't tell if it's that or something else as it feels like powertrain when accelerating but at speed feels like I'm driving on gravel?? The vibration is a tight one if that makes sense..it's bugging me to death.
View 14 Replies
So this '06 F350 is blowing fluid from the steering pump fitting when you move steering wheel to either side all the way(lock). Is the internal o-ring blown in the fitting? Do these have the teflon seal at the pump? Pretty new to the 6.0 scene. Got a new line ordered.
View 6 Replies
When replacing the power steering pump on my 2006 should I go OEM on the pump or save some money and get a Napa or aftermarket remaned unit with the pulley installed? Also, whar is the fluid capacity of the power steering system?
View 14 Replies
After my recent cooling system upgrade and power steering pump/HP hose replacement I am still hearing and feeling the power steering whine. I flushed the fluid and used Mercon V ATF fluid. I jacked the front end up with tires off the ground and cycled the steering lock to lock 100 times or more now and the whine does not stop. Do I need to put a vacuum on the system and try to purge it that way? There was no whine before but I just replaced the pump while I had room with everything out of the way and replaced the high pressure line because the fitting was leaking at the pump. This is very irritating because I thought replacing the pump would be beneficial.
View 2 Replies
