Ford 7.3L Power Stroke (1999-2003) :: Little Black Sticky Soot Coming Out Of Tail Pipe / Higher Oil Pressure?
Nov 27, 2015
I recently installed a Banks Ram Air Intake on my stock 1999.5 powerstroke and wow did it ever wake up the turbo. A few weeks later i installed a Flo-Pro 5" stainless exhaust from turbo back with no muffler. The truck is running better than it has in years and with 272000 miles, I am pleased with the results. HOWEVER, I have since noticed a little black sticky soot coming out of the tail pipe, a bit of vapor (no oil spitting) from the oil filler tube with the lid off, and now my dip stick tube where it enters the oil pan is leaking. What is going on , or am I now chasing and fixing week points on this truck?
View 6 Replies
Advertisement
Ok I'm working on a 2000 7.3 on a F550 truck was running but had no power so we changed out all the injectors and glow plugs and rebuilt the turbo now there is no start it turns over and were getting black smoke from the tail pipe. What is going on with it?
View 2 Replies
Truck started running rough on way home the other day. First gave me P0404 code and would get black smoke along with whitish smoke coming from the tail pipe. I haven't been able to notice or track an amount of coolant loss yet.
Swapped EGR valve this morning and now noticed this once she kicked into high idle (still warming up). About to hook up the IDS, hoping I this is not head gasket .
[URL] .....
View 14 Replies
After running perfectly fine all day my truck will seem to bog down and when I press the accelerator the reaction is extremely delayed and tons of black smoke will come out of the tail pipe before the truck actually gains power and takes off. The check engine light has been coming on but will turn itself off after the truck has been shutdown a few times....
View 10 Replies
I would I have a 01 7.3 e350 with 111k miles. I drove the van a couple of days ago.it sat for 2 days and now it wont go past 30mph.the van shakes crazy and went when i hit the petal no power with smoke coming out the tail pipe sometimes. When I shut the van off and restart it to drive it,it sounds better. I changed the fuel filter with motorcraft and changed the oil. Here is the kicker. It ran good after I changed the fuel filter the whole day and now its 4th of july and I went to get some drinks and it happened again.
View 11 Replies
I just came back from a 200 mile trip and parked my truck. Next day, got in the truck and turned the key.... it turned over and white smoke coming out the tail pipe. After doing some research(you tube),I ruled out cps sensor because it was showing low rpms on tach. Replaced glow plug relay and still have same issue.. what else to look at that I can do without getting it towed. Hunting season coming soon and I need the beast.
View 14 Replies
I am not sure what is going on with my car. I have a 1998 saturn sc2 and this morning it started smoking from the tailpipe. The oil is black but the smoke smells like something is burning......
View 3 Replies
My buddy install a BPD air/oil oil cooler in his 2003 F250 last week and now there is coolant pouring out the tail pipe. I haven't seen it but he tells me there is quite a bit coming out. It wasn't doing this before we installed the BPD oil cooler. Normally I would say bad EGR cooler but his EGR is deleted. This is the 3rd BPD cooler I've put in and this is the first time I've had any issues after the install. The install went smooth other than we broke the radiator and had to install a new one. I feel bad cause I'm hoping it wasn't something I caused but I just can't think of anything I did during this install that would cause coolant to be getting into the exhaust. He just had it towed to the local Ford dealership.
View 3 Replies
I have a 2003 Superduty with 193k miles that is bone stock. I sold the truck to a friend and when he decided to not pay the remaining balance on the truck, I took back ownership. The truck was having heating issues and it set at a mechanic shop for nearly 2 years waiting for a diagnosis on the heating issue. Fast forward to the present and I now have the truck at my home. Heating issue was the radiator but this is no longer a concern. When I went to pick up the truck from the mechanic, the truck started fine. Every other day for the last 4-5 weeks I would start the truck with no problems.
I get the truck tagged and start driving it on a daily basis. I've put several hundred miles on it but the more I drive it, the less it wants to start. Now it's to a point where it only cranks but won't start. I can take a gas rag and hold it in the intake and eventually it will start. Once it's running, it runs great and has no issues starting. But once it sets for 3-4 hours, it won't start without some sort of assistance.
While trying to find the issue, I've found and repaired 2 fuel leaks and in the process I replaced fuel filter, air filter, replaced glow plug relay, replaced batteries, replaced CPS. Fuel pump is working fine. I've tried the ICP test and doesn't make a difference.
The glow plug light or WTS light works so don't think its the GP. The CES light was on. Had it scanned and it was the air bag sensor so no support from the CES.
While I was working on it yesterday and after cranking on it for 5-10 minutes, it would act like it was going to start and black smoke would be coming out from the exhaust. I let it set to cool the starter it fired up like it had no issues.
View 14 Replies
I recently purchased a 87ford escort and I think it may have been sitting for a while but it runs Problem is it jumps rattles shakes while idling same thing when driving but not as bad. I'm hoping it is just in need of tune up but it continues to blow out black smoke from tail pipe,getting oil changed today. Do you think the smoke could mean the rings are bad? Also some times it takes awhile before the car shifts when I am driving till it gets warm.
View 19 Replies
I've got a thick layer of black soot-like buildup on the lower passenger side of my intercooler. Just bought the truck (2008 F250, 6.4L, CC, SWB, 4x4, 150K miles).
What would cause a buildup like this on the intercooler?
View 11 Replies
I seem to have a glitch in my ignition switch box or column. Most likely in the column itself. Whats the recommended course of action here? Contact cleaner and then white lithium grease in the column? Can WLG be used on the ignition switch box itself, that's bolted under the column?
View 14 Replies
Got a 2 wheel drive 2000 Excursion with approx. 215K miles with the 7.3L.
Slight shake in motor + you can literally floor the pedal and you'll move a little faster than a snail.
Does this sound like bad injectors? Also - tried to start it today and it was just cranking forever...Couldn't get it to start..I did notice while I was in drivers seat looking out the window...some white smoke coming from tail pipe while it was cranking...
View 13 Replies
I have a 2003 Ford f150 5.4. Heater blows hot, then cold, then hot then cold. When it start blowing cold it pukes out the degas bottle. I have burped it, did the combustion test to make sure not a blown head gasket, the oil clean, there is moisture coming out tail pipe but it has no coolant in it. flushed heater core, pulled water pump off and checked it, its good. Changed thermostat 2 times, put front on ramps to get any air out. I am at a total loss now.
View 8 Replies
'99 7.3, 258k miles, looses oil fast, oil found in coolant (though not a lot) and the fuel bowl is full of oil.
I re-ringed the oil cooler. Most of the coolant and oil is drained. The HPOP holds its oil level and does not leak down.
Someone shared the below test. Though it says #4 ORB, the actual thread on my IPR is #8. I removed the IPR and threaded in the #8ORB to air hose adapter. I regulated the pressure to 20 psi. The air is rushing out of the CCV.
I suspect I am missing something in the below test and that I'm pushing air back through the low pressure oil pump and into the crank case.
The test shared with me elsewhere:
Apparently someone named "Cody" on the forum did a test and it was labeled that way.
AIR TESTING THE HPO SYSTEM:
7.3L Powerstroke engines may experience hard start and or no start issues. In some cases the no-start issue may occur only with the engine hot. If the observed ICP pressure during cranking is less than the required 500 PSI, then the problem is in the high pressure oil system.
One of the first checks that should be made is to remove the plug from the top of the high pressure oil reservoir (in front of the fuel filter) to observe if the reservoir is full. If the oil is standing within an inch of the top of the reservoir, then the problem is in the high pressure oil system and could be caused by one of three things:
- The high pressure oil pump itself
- The IPR Valve
- A high pressure oil leak
Tools: Adaptor ORB #4, Air Compressor capable of maintaining 90-100 psig, Air Line Adaptors which will allow connection to the #4 OBR , IPR Test Harness, Grease Gun Whip or any whip with a .0625" NPT.
Remove the IPR valve and insert the ORB #4 Adaptor. Attach Shop Air and pressurize the system. Wait for approximately 30 - 60 Seconds while the air travels throughout the HPO System. Listen for air escaping through the Oil Fill Tube (cap removed).
External high pressure oil leaks would have, of course, been obvious. The primary concern is internal leaks under the valve cover(s). These could include leaking injector O-rings, or leaking injectors. Listen for any air escaping under the valve covers and correct if present.
If the center injector O-ring has failed, high pressure oil may be forced into the fuel system. Remove the fuel filter cap and observe for air bubbles in the fuel. If necessary, individual fuel lines running from the fuel filter assembly to the cylinder heads can be disconnected in order to isolate the problem to which side it is occurring.
2. 7.3L: If no air leaks are observed, the next step is to isolate whether the problem is with the IPR or the high pressure oil pump. Remove the IDM fuse or unplug the IDM or injector connectors at the valve covers to prevent starting.
3. If this test does not assist in diagnosing the issue, remove both valve covers and witness oil from the deflectors as being uniform, look closely at the injector base for any sign of air or oil escaping during test. This is an indication of a loose injector or O-Ring failure.
The same can be done at the ICP Ports (Oil Rail) on either side to determine leaking O-Rings in that Bank.
View 8 Replies
Yesterday my car ran fine. Today it started running rough when my wife drove it. When I started it to see what was going on it ran very rough. I gave it a little gas and black smoke came out of the tail pipe and now it will not start. I can hear the fuel pump running when I turn the car on. I have spare at least at the coil pack to the wires. The check engine light is on but I don't have a tool to read it and I can't start it to go get it read.
View 11 Replies
There's a black form around the end of my minivan tail pipe. This form is created by smoke, I can have it on my finger if I touch it (like BBQ ashes), is this normal or my minivan running rich? I don't see any black smoke coming out of the tail pipe as it is driving.
View 4 Replies
I have a 2003 Toyota Camry, XL-E, 4 cylinder vehicle with 156,200 miles on it. The car has been serviced regularly since buying it new and is in excellent condition. My problem is that when starting it for the first time every morning, quite a bit of white/bluish smoke comes out from the tail pipe. It then clears and I don't have the problem for the rest of the day no matter how many times I start the vehicle. The next morning the same thing occurs on the first start and first start only. This problem has been occurring for the past six months. The vehicle seems to be running good. I recently put 1500 miles on a vacation trip and it ran fine. I have discussed this problem with several mechanics and they cannot provide a definite analysis or solution. I have been told that it is possibly a cracked head gasket, cracked gaskets or oil leak being burned off the engine when started for the first time. What do you think might be the problem and what course of action would you recommend I take?
View 8 Replies
I have a 1994 chev Blazer S 10. that has thesy troubles. when it warms up it runs high and hot exhaust and ruff idle. with a hot cat. Replaced EGR carbon build up at times.replaced fuel pump, and all the senors under the hood. Still runs the same.
View 3 Replies
Have a lot more smoke from the tail pipe when they are running their tow tune vs their street tune? For me it seems like a lot especially right now being cold out but I still notice a haze at idle when the engine is warm. Also can smell a difference.
Getting a ficm tuner from php tomorrow so interested to see what that does for things.
View 7 Replies
I try to turn on my truck today and it will not crank. The day before I had change two injectors and I turned on the truck when two fill up my tank and I put a full bottle of injector cleaner with it. When I drove off, a few blocks down the truck turn off on me. I started to turn on the truck and every time I did it would blow heavy white smoke out the tail pipe and then it would shut off. I did this about 10 times until I decide to call a tow truck. The next day I empty out the fuel tank and fill it with diesel only. I tried to turn on the truck and it would not crank. I ended putting two new batteries and still the same result. What can this be ? 2007 6.0 Diesel ...
View 14 Replies
