Ford - Contour :: 2000 - Occasional Hard Shift When Driving
Mar 26, 2014
I have a 4 cylinder 2000 Ford Contour 133k miles
I've only driven the car for about 2 months, Ive never had an issue with it until yesterday other than an occasional hard shift when driving the car hard. Yesterday when I dropped the car in drive it wouldn't pull at all, I sat in my apartments parking lot continually revving the car high in drive but it wont do anything, its like the car is in neutral. Reverse works and I can drive by manually shifting from first to second and then putting the car in drive, but if I put it into drive before reaching 3rd gear it jumps back to neutral.
I checked the linkage, and the lever it connects to on the transmission; when put into drive the position of the lever coincides with the neutral position. I called a few local transmission shops and they diagnosed is as a broken sprag, but from reading online it seems like it could be a clogged transmission filter or a faulty transmission range sensor. Prior to this issue I would sometimes here a whistle coming from under the hood when driving, I didn't know until today that a whistle is indicative of a vacuum leak, but wouldn't it throw on my check engine light? I have checked my transmission fluid, its at the correct level and is a nice cherry red, it doesn't have any bad or burnt odor.
View 7 Replies
Advertisement
My 2012 Toyota Camry SE V6. 37,500 miles. Occasionally when I'm parked shifting down to reverse it's so tight/put effort to shift & it literally thumps the entire car.. I heard to put the E-BRAKE/PARKING BRAKE down BEFORE shifting it to park & it worked but occasionally even with the E-BRAKE/PARKING BRAKE it still jerks the entire car going from PARK to REVERSE.
Also going from REVERSE to NEUTRAL it gives off a little vibration underneath me ALL THE TIME going from REVERSE to NEUTRAL.. I know these are so many questions that are probably a no-brainer answer but I'm looking to see if any one here had/has or heard of a similar or exact problem. Is the trans fluid low or dirty? I saw the CARFAX I didn't see the services he's done it's only been 1 owner on this car I'm the second. Previous owner leased it brand new.
View 7 Replies
On my 2006 Azera Limited with about 27,000 miles on it. Occasional hard shift issue. Normally the car is only driven 10 miles a day to and from work no problem. But on longer trips have hard a few instances of hard shift.
The first time this hard shift bump occurred was when I was driving on city streets 2 minutes after getting off the freeway after a 2 hour drive. On a scale of 1-10 this was a #5 bump like feel followed by a #3 bump in the next few minutes while accelerating from a signal light. There were no further bumps that day, even after another 2 freeway drive.
The second time the #3 bump happened was on an on ramp after a 3 hour freeway drive and a short rest stop. No further bumps that day even after another 3 hour freeway drive.
The last time this #3 bump happened was on a city street after a 45 minute freeway drive. No further bumps on the return trip. I am not sure which gears this bump happens between.
I have no MIL set. So I took it too a transmission shop and they could not find anything wrong but said there was a code C1616 CAN Bus Off Failure. His opinion was that this problem maybe an electrical issue.
View 4 Replies
I have a 99 contour svt and every once in a while the hazard lights will flash even while I'm driving.
View 1 Replies
I was driving the car yesterday and was getting on the highway ramp and stepped on the gas and car went crazy. It started to accelerate and decelerate by itself. I had no control of the car whatsoever. When driving at 0 to 40mph no problem so far, but anything over this car will jerk, like it's changing gears by itself, 'going fast and slow.'What is this? Do I need a fuel filter, or plugs or what? I don't know when the last time I changed anything the car mileage is 135,000
View 1 Replies
Almost everytime I drive the car for more than 2 consecutive it acts as if it drops a cylinder..running rough. The next day it will run fine until 2 hours go by...and so on. I have changed plugs wires and coil pack.... 4 cylinder .. automatic
View 2 Replies
I just purchased a 2000 ford contour and it only has one major problem, the tail lights stay on after shutting off the engine and turning the lights off, you actually have to pull out the fuse to get them to turn off and then replace it before driving again, I looked through the owners manual and cod not find a solution. Also, the brake lights don't get brighter when you press the brakes, I'm not sure if that is part of the same problem or another issue entirely.
View 3 Replies
2000 ranger 3.0 auto 4wd hard to shift. Are the cables known to stretch?
View 6 Replies
My '00 V10 4x4 w/ 163k miles has had a rough shift from 2-3 (30-40 mph) with high rpms. If I let off the throttle before the shift I can get it to shift smooth, but if I don't let off the throttle it can shift really hard. I only have this issue from 2-3 and it has not gotten worse since I bought the rig almost two years ago. Driving conditions are around town on occasion and for towing a 3k pound pop up. Maybe 2k miles a year so far? The hard shift happens whether towing or not.
I have done just a drain and fill on the trans fluid a year ago. Have not had time to change the filter (even though I have read it's not necessary). I am planning on doing another drain and fill soon along with the filter since I have one and cleaning out the trans pan.
When searching on FTE I read a post about the accumulator springs that can go bad and was wondering if maybe this is the problem? Since I am planning on doing the filter change I was going to do the spring replacement while the pan was open.
View 9 Replies
2000 Ranger 4R44e transmission.Hard shift from 2-3 gear and when i run about 35-40 mph and brake then acelerate it downshifts hard . Whats wrong with it?
View 14 Replies
I have a 2000 F150 5.4l 4x4. When I am going over 50 on the highway and I am in OD, if I let off the gas a couple of seconds later it feels as though the brakes come on because the truck slow down so drastically and when I give it a little gas it slams into gear. It feels as like there is a "gap" where nothing is engaged before it slams back in. This is a rebuilt tranny with less than 7K miles on it. I took it back once and they said it was the motor mounts. I had those replaced and still the same problem. I replaced the spark plugs 6K miles ago and the COPs 3K ago. There is 170K on the truck. I only drive about 8K miles a year.
View 2 Replies
I have a 1988 F150 which is in beautiful shape. My father in law had it since 1989 and had "babied that truck" according to him. So it's running great, has a mere 92,000 miles, is an automatic with 4X4 with manual shifter to put it into 4X4 or Low 4X4. Here's the questions: When driving in rear-wheel drive mode (I never drive it on the street in 4X4 - we don't get snow here in SC) it has developed a hard shift from first to second. It feels like it bumps when shifting. When empty it shifts at about 3200 RPM at average acceleration, which I think is a little high. Does RPM even matter when the shift occurs? Can the tranny be adjusted to shift at a lower RPM? Is my tranny about to go kerplunk? The transmission fluid was a tad low so I topped it off but that didn't seem to work.
View 2 Replies
It's happened to me the last 3 times I've taken my truck out and drove through some deep snow. I have a hard time shifting the transmission from drive to park. The snow must get packed up under the truck near the shift linkages.
View 14 Replies
In hot weather or even warm / humid weather, my very low mileage Mazda 626 (2002) becomes almost impossible to shift, especially from neutral to first, after about 20 minutes of driving. If I stop driving and the car cools off, it's okay again, until another 20 minutes of driving. It's fine in cool weather. This problem started in the summer of 2010.
View 4 Replies
Has 118,000 miles and we have replaced speed sensors and changed transmission fluid and updated computer software. It runs perfectly for 30 minutes whether driving in town or highway but then hesitates and jerks when shifting from 1st to 2nd and downshifting also. After it shifts into 3rd, it is fine. Repair shop says it could be gear box or computer problem. No one in town seems to know what it is for sure. 2004 Saab 9.3 2.0T
View 2 Replies
I have a 1999 GMC Suburban(5.7) with 173k miles. When the outside temperature is above 80 degrees F and I have been driving for about 30 minutes, I get a hard/firm shift from 1st to 2nd. It shifts to the other gears normally. When the temp is below 80 degrees, I can drive all day without any problems. Any clues for what may cause the hard shifting on hot days?
View 2 Replies
I have an 04' R32 with about 56k on it. Here's the problem; when I drive it hard and speed shift from 2nd to 3rd it grinds just a little. It doesn't do it when I'm just cruisen grany shifting. For awhile now I've been thinking that the synchronous from 2nd to 3rd gear was going bad, till I talked to a friend with a 20th GTI who said that the 6 speed trannies will start to do that, and there's really nothing you can do about it. Is this true that I just have to deal with it or can it be fixed?
View 12 Replies
If I brake hard a dozen times, 8 or 9 will be normal, a couple times it will pull to the right but as long as your hands are on the wheel you can barely tell, and maybe once it will pull really hard. I have Hawk super duty pads and Ebc rotors with less than 5k on them and I just replaced the front calipers and hardware because I thought that was the problem.
It's not even consistent. Could possibly be rear calipers (rear also has new Hawk pads and Ebc rotors with less than 3k on them) but I don't think it would pull that hard. Tire pressure is even between sides btw.
View 12 Replies
When cold and not running, the shift lever sticks especially in 1st or 2nd and lacks that springy return to center. When cold running, Almost impossible to get in and out of 1st and 2nd, 3rd-5th stiff but manageable. After 5-7 min of driving, Shifts like butter. Tranny fluid has been replaced with amsoil syn.
This wasn't a progressive condition, shifted great one day (approx 2 weeks ago), next morning the fun began!
Is there anything other the control cable that cause the extremely sticky shifting when the car is off?
View 5 Replies
Why does my 2000 chevy impala whistle when i accelerate? it also seems to shift hard.
View 10 Replies
I inherited this car from my grandmother when she passed. It has low miles, around 40k. Since I paid zero for it, I would like to keep it. Historically I have done all my repairs, but never trans work.
Here are the symptoms. The car has issues shifting into higher gears. I have to punch the gas and then it will switch gears. It then began to do this for reverse, and now now reverse does not work at all.
At first I thought it was a speed sensor problem, but when I took it in to be read, it came up with P0734. It could be electrical (Speed sensor?), low fluid (it's not low), or 4th gear.
Is this transmission worth me fixing or paying to have it repaired, or should I move on?
P.S. If I drop the pan and find shavings, I understand that to point to 4th gear and bearing (also what the computer code read as the issue). Do shavings mean it definitely is 4th/bearing, or could it be another blown part?
View 4 Replies
