Ford Escape / Hybrid :: 2007 - Passenger Side Low Beam Won't Urn On When Headlights Turned On
Jan 13, 2017
I have a 2007 Ford Escape with a passenger side low beam that won't turn on when the headlights are turned on. I have replaced both low beam lights and checked all the fuses. Fuses are ok,none are burned out. My high beams work perfectly as well as my fog lamps. I need any and all advice and information , including any simple wiring diagrams that could be of use . Is it possible that the multi function switch for the turn lights and headlights is the problem?.
View 10 Replies
Advertisement
My passenger low beam headlights went out. I replaced the burnt out bulb but it still won't work.
View 2 Replies
2007 ES350... My passenger side HID headlight shuts off after both are turned on. Is it time for a new bulb?
View 14 Replies
This morning a dash light informed me a headlight bulb was out. It was my DTR light on the passenger side.
I purchased Sylvania H7 high intensity, installed it and it failed to work properly. Daytime light on only drivers side works.
High Beam on , both lights works.
I checked my manual and it said to check fuse in the 5 slot on the driver side dash/door panel and there actually is no fuse in there. I checked the driver side and there was no fuse there either.
I replaced my driver side bulb last year and it took 5 mins....i am already 4 hours into this!
View 4 Replies
What is the location of ptu on drivers side or passenger side???
View 4 Replies
Have had the '13 SE 2.0 for a week. Wife said there was a squeak ?? I drove it today. Seems to be from front passenger side..
View 14 Replies
Passenger side DRL/Low beam is out. Flickers when turned on then out. Where can I order a replacement?
View 3 Replies
I was just changing the oil on my wifes 2008 Escape and noticed a oil leak. At first I thought it was an oil pan gasket,But its higher than that. Then I thought maybe an axle boot but it's also higher than that. It's on the passenger side about the middle of the engine right under neath the biggest pulley.
Its a cylinder shape mold coming off the engine about an inch long with a bolt on the end of it. I'm not seeing oil any higher than that and seems to be coming from there from what I can see. Is this something common with the Escapes?The truck has 55,650 miles on it and this is the first issue so far.The wifes first escape we traded for this was an 01 with 200,000.
View 4 Replies
I just bought a 2010 3.0 V6. Oil is leaking down the engine on the rear passenger side of the engine. It starts near the top. I replaced the rear valve cover gasket but it still leaks. I am concluding that it must be the timing chain cover. I can't find any info on how to diagnose and how to repair.
View 8 Replies
Noticed my passenger side HID low beam went out about a week ago... 2008 ls460, out of warranty
1 - changed HID bulb, still out
2 - checked applicable fuses in fuse box in engine compartment, all seems fine
3 - changed to new ballast, still nothing
All the other lights in the headlight are operating fine, only the low beam is still out. Somehow the ballast is not receiving power.
View 12 Replies
A few weeks ago my passenger side low-beam failed to come on during a short road trip. After a failed attempt to find a replacement at 9PM I had no choice but to continue on my way, about an hour later, as I was driving along, it suddenly came back on with no trouble since. I haven't touched any wires or fuses.
View 3 Replies
Lights come on when the ignition is on, regardless of the position of the headlight switch. They shut off about 1 minute after the engine is shut off. The warning chime dings the entire time until the lights shut off.
I want the light to work with the switch and not come on all the time.
It is not just the daytime running lamps. High beams also work with the headlight switch in the off position, ignition on.
Ignition off, the headlights switch functions as it should.
I bought the Escape about 1 month ago. Dealer purchase so I don't know how to get a hold of the previous owner.
It only has 51,000 miles, very clean and all service records.
View 8 Replies
I have an 07 Passat Wagon. The headlight malfunction indicator light came on for my passenger side low beam. I replaced the bulb, which was visibly burn out (broken filament), but with a new bulb in, the light still is not working and the malfunction indicator is still on. What is the cause of this? I have the regular headlamps, not the xenon lights.
View 2 Replies
The cooling fan runs on high as soon as the a/c is turned on, regardless of the engine temp. I have the sensor(6F9Z-19D594-AA) that mounts on top of the accumulator. If i replace the existing sensor, will the refrigerant leak out?
View 10 Replies
I have a 06 Mercury Mariner and this past week fuse #26 keeps blowing turning the HVAC blower motor off. I replaced the blower motor since i had one already in the garage and same thing is happening. The AC will run for awhile and in about 10/15 mins the fuse will blow. Fuse #26 is the Climate control system mode switch, are these known to go bad? Is this the part I should replace or look for other problems IE compressor?
View 2 Replies
I have a 2001 ford escape V6 3.0l. Dropped a new motor in it, got everything running fine. Surprisingly the most frustrating part was when we mixed up the order of the front 3 coils but we got it!
It drove "ok" for a week and a half. Then it started to shudder at 45-55 mph. Got it home that afternoon and started to diagnose why it would shudder. Suspect its not shifting right.We started to diagnose what was wrong, made some adjustments to IAC, MAF and checked a few other things. We then went to test drive, started up fine, drove up the driveway 50' and it died. It didnt sputter and die, it just lost all power and died.
Got it back in the garage and tried to get it started again. Turned Key... nothing. Dash lit up but starter and fuel pump didnt fire. Odometer reads ------. I can jump the starter by pulling the starter relay. Same for the fuel pump. I use a jumper wire between two pins and I can get the starter to crank and the fuel pump runs when I jumper wire the relay too. So I know its not a bad starter nor a bad fuel pump.
Odd part of everything is that It drove just fine that day (other than shuddering). Then started just fine, then died. When it died we were making a sharp left turn in the driveway. We've messed with the steering wheel because it was "accidentally" put upside down when we dropped in the new engine. Could something have grounded out in the steering wheel? Air Bag? Maybe a problem in the clock spring? What would stop it from The fuel, starter and spark all at the same time? Bad PCM? Grounding issues?
View 8 Replies
I am running into some issues with my 2011 Escape 2.5L. I am pulling a total of 7 codes. Two codes keep repeating, which those are P0455 and P0457. And I am also getting a C1963. Accompanying the engine codes, my HUD is displaying "Check Fuel Inlet" when I first turn the vehicle on.
View 10 Replies
Where I should start looking for the root cause of the following leak? My wife noticed that when it was raining water dripped off the handhold by the front passenger seat. The ceiling liner is dry, no evidence of water soaking into it. I am thinking windshield or door seal as there is no moon roof and the liner is dry but before I start tearing into it I want to see if there is even a chance I can fix it myself.
View 3 Replies
So I just bought this escape last month with 93k on it and just realized the moonroof is leaking onto the passenger seat. I hope it's these drains I've read a little about. Where they're located or where they empty and the best way to clean them. Hopefully it's warm enough for any ice in them to melt today so I can try that first.
View 2 Replies
I wanted to try FordJunkyNC's way to run a jumper to stop the alarm from going off, but my problem is the passenger front, not the rear... different color coding on the wires..
Jumped the passenger front door? If so, which wires did you jump? Want to jump the 06 Escape doors, just don't want to short anything out...
View 1 Replies
The passenger door on my 2002 Escape is locked and the power lock is not working on that door. The door is closed, how to get it open.
View 14 Replies
