Ford Excursion :: 2003 - Turn Signal / Brake Light Stopped Working On Rear Right
Apr 1, 2013
2003 X limited, 2wd 6.0L
Last week wife's right rear turn signal/brake light stopped working. The left one flashes normally. The right tail light works fine which is a different bulb. I tried changing bulbs (didn't work).....tried a new socket with new and old bulb (didn't work). Could it be a relay? Or not relay as they would be both out (left and right)?
I looked at my trailering wiring plug down by bumper and the white wire with green stripe looks split a little towards the end. Could it be a bad ground or short in that wire? Would the trailering wiring have anything to do with it? I was going to try to replace the relay if I could find it, what is the part number for it.
View 3 Replies
Advertisement
Experienced problems with their right taillight, both brake and turn signal light stopped working. This occurs intermittently. I have replaced my rear license plate lights with error free leds .
View 4 Replies
My trailer left turn signal and brake light stopped working. The running lights work on the trailer. The lights all work on the truck. I am hooked up to a 2007 F150 and it all worked 'yesterday.' not sure where to start.
View 6 Replies
This passenger side rear turn signal stopped working two weeks ago after a period of intermittent operation. All other lights work. I replaced the bulb and fuses. I am not an expert about auto electrical. The relay box is under the hood on the driver side. There is another fuse box under the driver side dash left of the steering column. Auto parts stores want to sell me a "flasher" that, well, I can't figure out where it goes. The "TNS relay" in the relay box is smaller than the flasher the parts stores are selling me. My little owner manual is not useful. Any theories about what is wrong? Wiring? Relay? Where does that flasher go? Somewhere under the dash?
View 2 Replies
I just bought an 05 F250 XLT. I noticed tonight that the rear turn signals and brake lights dont work.
the front turn signals work fine, although they flash fast. I know that usually means a light on its way out. neither taillight flashes though, which puzzles me.
my second issue is that, of the 3 brake lights, only the high mounted light illuminates when I hit the brakes.
View 4 Replies
I have a 2006 F150 and the left rear turn signal and brake light has quit working. Also the license plate lights do not work. The cruise will disconnect when signalling a left turn. I have checked fuses and bulbs and the wiring/connector at the multifunction switch with no luck.
View 2 Replies
I have a 1997 F150 5.4L 2wd long bed w/ tow package.
Right (passenger) turn signal/brake light is not illuminating. The tail light on the right side does illuminate when headlights are on. (Same Bulb) All other lights are functioning properly.
When the MFS is in the right turn position the right arrow on the dash flashes and clicks faster than normal.
This happened about a month ago and it turned out to be a blown fuse. The fuse was for the trailer lighting and right turn/stop light, found in the small fuse box under the hood that only holds 2 fuses. Problem solved temporarily...
Now the issue is back, Here are some things I've tried so far:
Replaced the fuse again; Turns out the fuse didn't blow this time, but I tried a new one anyway.
Cleaned the ground for the rear light wiring harness.
Replaced the bulb.
Replaced the relay.
Checked continuity on multi-function switch, right turn position reads 2.8 ohms IIRC
Repaired pin #5 on the multi-function switch wiring connector (wire backed out, right turn related)
Replaced the bulb socket.
Inspected the wiring for broken insulation/exposed wires from that socket to under the hood, didn't find anything exposed. All wires are still in the loom.
I replaced this wiring harness and wiring looms about 6 months ago because the previous owner had done a hideous splice job for unknown reasons, so it should be ok. Should I get a new multi-function switch, or try something else? If the switch doesn't work what's the next step?
View 10 Replies
My wife's 2003 sportrac has developed a problem. The left rear turn signal brake light will not work. The tail light does. When you turn on the left turn signal the front bulb and the dash light flashes real fast. I have changed both, the front and rear bulbs with no luck. I've read on here about the tilt steering column deal. I have moved the steering column while operating the turn signal with no change.
View 4 Replies
I have a '97 AWD and my brake light, turn signals and emergency flasher have stopped working. I've checked all the bulbs, checked all the fuses (under the dash) replaced the flasher just in front of the fuse box...nothing. All the running lights work, and the 3rd brake light above the rear door window works.
View 3 Replies
I now have a 2002 Camry and the left rear turn signal has stopped working. When I put the signal on, it flashes about twice as fast inside and in the front, but nothing in the back. I replaced the bulb but it still didn't work. I'm going to switch the bulb here with the right one and see if it's still good just to be sure. Anyway, the rear left flasher doesn't work either. I've had turn signals be fuse related before but not when it's just one signal that's not working. Live in the city and driving without it is no good.
View 5 Replies
As the says I have a 1999 Yukon Denali that the Rear Brake and Turn signal on Drivers side are not working. Also brake light on trailer DOES work but not the turn signal on that side.
I tested the Tail light circuit by plugging it into the passenger side and it works so that rules out that. What wires to test under the dash to test the combo / multi switch?
Also the tail lights or park light do work (both top and middle bulb lights up when the vehicle is running) its just brighter filament does not light up when breaks are pressed or turn signal is on.
View 6 Replies
85 f150. My driver side brake light and turn signal in the back quit working. The tail light works tho which is a different filament. The bulb is good and I changed the flasher relay...the circle thing in the fuse panel. Everything else works just fine. looking for a starting point.
View 7 Replies
I have checked all wires for krosion and fuse's are good so confused! Just put brand new tail lights bulbs in! The top one comes on as a running light but nothing else works. I also checked under hood fuses too!
1.Only Hazard light that works is on the Right Front passenger side.
2 Drivers side Brake Light & Turn Signal Doesn't Work. But passenger works fine! Left turn signal is out and blinks really fast!
3.Passenger Side Overhead Outside Light on cab is out . Okay that's probably just a bulb!
View 13 Replies
I'm having problems with my left turn signal not working. It sounds like it's blinking super fast from inside the vehicle, the left turn dash light does not illuminate, and the outside front bulb does not blink. When I turn my emergency flashers on, the left front still doesn't work, but all others do. All the other bulbs are in working order. I searched through some old threads on this and couldn't find much other than to replace the bulb and bulb housing, which I did with no luck.
View 14 Replies
Turn signals quit working on my 2006 E-150. Swapped out the relay under the dash and it did nothing. Also noticed the brake lights aren't working. The headlights and taillight a are working. I pulled the fuses under dash for the lights and they tested ok. I did notice the flasher relay was making clicking sounds intermittently even when not touching anything.
View 3 Replies
Put a new bulb in the right front turn signal, still doesn't work (parking light works though).
View 10 Replies
I have a 2003 V10 Excursion with an electrical problem. The right turn, right brake and right hazard light do not work but the flasher makes the clicking noise. When the right turn signal is on, the right front turn signal light works but is at double speed. The right rear light does not work. Same when brake and hazard are applied.
I checked the bulb socket with a multi meter and have no current. I also checked my trailer plug and have all functions work. Fuses were checked also for the brake circuit and were all ok.
View 4 Replies
The right turn signal on my 1998 Ford Explorer recently stopped working. The flasher was making a horrible buzzing sound when I tried to signal right, but worked fine signaling left.
I just replaced the flasher, which has cleared up the buzzing noise when trying to signal right. The flasher clicks like it's supposed to, but the lights still do not flash.
Here's a summary of the current symptoms:
-Hazard lights work fineFlasher clicks; interior indicators flash; exterior lights flash
-Left right signal indicator works fineFlasher clicks; interior indicators flash; exterior lights flash
-Right turn signal does not work
-Flasher clicks
-Interior indicator stash off; exterior lights stay off
What to check next???
View 4 Replies
My left front turn signal stopped working. Rear turn and mirror light both work normally. Checked the socket and it is clean. Switched bulbs with right side to confirm. This one is driving me crazy and I don't want to spend a fortune at the stealer to fix it.
View 5 Replies
Driving home the other day my right turn signal stopped working. Checked all lights when I got home and the front signal had a constant but low illumination and all the other lights were mostly out as well, very little was working actually.
Pulled the bumper and head lamp tonight. The plastic connector on the low beam was melted and the wires were burnt. The problem was the two brown wires that are sort of routed together. Third wire (grey or another shade of brown depending on headlight manufacturer) was OK.
Headlights are aftermarket, Volx Tuning, < 1 yr old. The rest of the harness inside the assembly looks good- certainly don't see any opportunities for a short.
I replaced the connector and bad section of wire and plugged it back in for a test. All lights were then 100% operational. I removed the assembly to find that the same lamp was smoking again. (I sort of expected this, but had to try.)
Clearly I've got a short somewhere but where do I start? The part of the vehicle's wiring harness that is visible behind the assembly is in good condition. The lamp itself (H7 I believe?) appears OK as well, I don't guess I get so so lucky as to hear those can develop an internal short in the base or something?
View 1 Replies
I have a 1994 ford ranger .the problem is with the right rear turn signal. it works fine except when i step on the brake. At that time, it turns dim and will not flash. All of the other turn signals are not affected like this.i have checked the bulbs and they are all good. I mean the three in the rear tail lite.
View 3 Replies
