Ford Excursion :: Adding Hydroboost Set Up?
Feb 5, 2015
I am thinking of doing a hydroboost setup on my ex??
View 2 Replies
Feb 5, 2015
Advertisement
Ford Excursion :: Master Cylinder Leaking And Winding Up Under Hydroboost Unit Via Gravity
I replaced my hydroboost unit about 10,000 miles ago. Today I noticed it was wet under the unit. Only this time, it's not red PS fluid, rather, it is brake fluid. So, I assume the master cylinder is leaking and winding up under the hydroboost unit via gravity. Or at least that's my theory.
Any way Rockauto lists 2 motorcraft master cylinders.
One is BRMC-26 for Hydroboost
The other is BRMC-27 for speed control.
I have obviously Hydroboost, but also have speed control.
Ford Excursion :: Adding Auto And Fog Lights?
Was about to buy a headlight switch with the Foglights option...realized I miss the auto lamps.
Is there a write-up on how to add these? Looked in the tech folder and didn't see one
What parts are needed?
Ford Excursion :: Adding A Leaf On Each Spring?
The local shop here suggested getting a set of F350 springs and they would take them apart and a leaf to the front and rear springs.
View 2 RepliesFord Excursion :: 2000 - Adding 3rd Seat To The Front?
I have the 2000 Ex. Tan leather seats. Two seats in the front. I need to add a third. I used to have a F150, that had a flip up/down center console. It was a seat when flipped up (the console became the seat back). What are my options with the Ex?
View 10 RepliesFord Excursion :: Adding Turn Signal Mirrors?
My driver mirror has small clip failed, only way is a new mirror. I found a pair of mirrors with heat like mine BUT they have the turn signal.
View 9 RepliesFord Excursion :: Wiring Diagram Of Adding Relay?
Working on the dang ram 3500... I am needing to add a relay, however, i need to strap the coil of it with a diode to protect the frigging cluster (the new dodges aren't very mod friendly!). My question is, should I add a second diode before the relay to protect the cluster against back emf, or will the one strapped across the relay coil be enough?
Since I am sure you're curious now, the cargo light (light that lights up the bed) gets its power from the gauge cluster of all places. I need to add a relay to the cargo light circuit to drive some other lights, and I am worried the back emf from the relay coil will fry the cluster circuitry.
Ford Excursion :: Adding Speakers In The Barn Doors?
I am interested in putting speakers in the barn doors of the Ex.
View 14 RepliesFord Excursion :: 2000 - Adding Bluetooth To Stock Radio?
Is there any way to add Bluetooth to the stock 2000 Ex Radio?
View 1 RepliesFord Excursion :: 2006 - Adding Remote Start System?
I have a 2006 F250 and it has the stock keyless entry. I would like to have remote start system as well. I know I can buy an aftermarket system, but I'd prefer to no cut any wires. Is it possible to add on the OEM remote start system that may have been used on a superduty or excision of this vintage? and if so, is it a plug in type installation? or do you still have to cut and splice the stock wiring harness.
View 12 RepliesFord Excursion :: Adding Sliders To The Middle Row Captain Chairs?
My third row gets used once in a blue moon. Usually the first two rows are enough. I have captains chairs but when I put the drivers seat all the way back it doesn't leave the middle row passenger much foot space, especially for how large the truck is. I've thought about buying a set of eBay sliders and putting them between the second row seat frame and the floor. That way I could keep all the factory features like the flip and fold, but still slide them rearward a few inches. I'm not sure I'll ever get around to it but I have had it on my mind a while.
View 12 RepliesFord Excursion :: Adding Kenwood DNN770HD In Dash Unit?
After doing some extensive searching it appears Kenwood is well liked as far as their in dash GPS/touch screen units. I know there is one model above this one that is more expensive and one or two under it without the WiFi features etc. that are less expensive.
Getting ready to pull the trigger on a unit..... Kenwood - DNN770HD
Ford Excursion :: Adding OEM 2001 To 2004 Fog Lights On 2000 Model?
Looking for a guide to adding OEM 2001 to 2004 fog lights and light switch in a 2000 model?
View 4 RepliesFord Excursion :: Adding In-line Filter Setup To Power Steering Setup
I want to add an in-line filter to my power steering set up. I'm replacing my pump, lines and steering box and I want to add a magnetic filter that will be easy to clean and change the filter without dumping fluid every time I want to replace the filter. I'm thinking of adding the Magnafine pro filter with aluminum billet housing. I know the plastic magnafine filters have been used alot and the knock off Raymundo's as well. Has anyone used this filter before and where did you mount it? I'm thinking of placing it between the PS reservoir and the air filter with fuel fittings and a fuel shutoff to close while swapping out the filter. Is there a better filter set up out there that I should consider?
View 11 RepliesFord 6.0L Power Stroke Diesel :: How To Get Master Cylinder Pushrod Out Of Hydroboost Unit
Im replacing hydroboost and master cylinder and I cannot for the life of me get the master cylinder pushrod (which must be reused) out of the hydroboost unit. There is a spring, retainer and pushrod that I cannot get to release. I know it has to be very simple, I just cannot see how it releases.
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: Hydroboost - Vibration In Brake Pedal
So I have my 2000 F250 in the shop because I was feeling a funny vibration in my brake pedal. (isn't warped rotors, I know what that feels like). It also felt like the brakes were on, then would release a little, lengthening my stopping distance.
I took it to a small local shop and the guy said it sounds like the hydroboost. I told them to fix it. Next day, before they start to fix, they call and say they can't guarantee it's the hydroboost and may be the Power Steering pump.
My question is; is there a way to test it to know for sure which part is failing? How do I figure out which one is causing the problem?
Ford 7.3L Power Stroke (1999-2003) :: Hose From The Pump To Hydroboost Leaking
Had a lot to do yesterday and had stock trailer hooked up and loaded with debris.
Got 120 miles away, stopped and got the groan from hydroboost/p/s system.
The hose from the pump to the hydroboost was leaking but it was the actual seal on the fitting that gave up rather than the rubber.
Could not find the seal but luckily the Irish place had the line in stock for a reasonable place.
Transmission got hot too backing up and puked out the front seal. I was doing a lot of twisting to get the trailer in the hole.
Ford 6.0L Power Stroke Diesel :: 2007 - Leak Near Hydroboost - Replace Entire Part?
So I take my new (for me but used) 2007 F350 to the local Ford Dealer to have the oil changed, along with fuel and water separator filters. I even added some Archoil 9100 since it treated my 03 so well. Since I had no history of the last change I wanted to do it right away.
While its on the lift he notices a leak near the hydroboost. I think there on crack...but that's my opinion.
Anyways I look at it and I see a leak at one of the connections under the Master Cyl. Its the connection closest to the firewall. My question is there a oring in there that can be replaced or will I need to replace the entire part?
Ford Super Duty (1999-2016) :: How To Get Master Cylinder Pushrod Out Of Hydroboost Unit
Im replacing hydroboost and master cylinder and I cannot for the life of me get the master cylinder pushrod (which must be reused) out of the hydroboost unit. There is a spring, retainer and pushrod that I cannot get to release.
View 2 RepliesFord 6.0L Power Stroke Diesel :: Hydroboost High-pressure Line Coupling Leak - Replaced ORing?
I've been watching fluid build up on what I think is the hi-pressure line on the hydroboost. It appears to be originating at the coupling in the line because it is dry back at the unit.
Is there an o-ring or nylon washer in this fitting?
Can it be tightened?
Does the o-ring or washer need to be replaced?
Is it a sign of something else, like a build up of pressure in the line that is too high?
I currently have zero problems or noise coming from the steering or brake system.
Ford 6.0L Power Stroke Diesel :: Small Power Steering Leak Where Master Cylinder Bolts Onto Hydroboost
2007 F350... I noticed I have a small power steering leak where the master cylinder bolts onto the hydroboost. Is there a o-ring or seal between the two? or do I have to replace the hydroboost? Been looking online for a schematic but can't seem to find one.
View 13 Replies