Ford Excursion :: Coolant Temp Gauge In Instrument Cluster Bounce According To Road Bumps
Nov 6, 2014
For a while now, my coolant temp gauge in the instrument cluster would bounce according to the bumps on the road, only when engine is fully warmed up. So I disconnected the ECT sensor to see if there's anything unusual. Nothing suspicious found, so I plugged it back in. Now my temp gauge is at "Cold" all the time. OBD reader shows normal coolant temp rise.
I shorted the ECT connector to simulate a hot condition--gauge still shows Cold. Checked the yellow/red wire against ground--5 ohm. Disconnected battery for 30 minutes--no change.
Now, it looks like I'll have to pull the instrument cluster, which is not something I want to do since I don't really have a place to work on the car, but I take this drastic measure.
Mine is a 2001, with the analog cluster.
View 6 Replies
Advertisement
98 accord v6, when we first got it about a year ago the temp gauge was a little erratic. Sometimes it would stay all the way down (cold) after driving for awhile. You can take your finger and thump the plastic and it would jump up to normal. At first it was only temp, but now all gauges including gas level are not working. Odometer still works right but the speedo goes to about 45 and stays there. Thumping still makes the needles bounce around.
View 10 Replies
So a couple weeks back I'm on expressway home and I look down and and temp gauge is pegged out overheating I immediately pulled off and shut it down and towed to a buddy of mine's shop he flushed it filled it up w antifreeze and checked for leaks and couldn't find one. I drove it for about a week and got out to for a quick stop , Ex parked on a slight decline and came out to prolly half gallon of coolant on the ground..I limped it to my buddies shop as it was not running hot .. he has checked it out but can't find any leaks, even after having it run 30 or so minutes..
View 6 Replies
I found a instrument gauge cluster out of a 2005 XLT that I would like to put into my 2005 XL. It has the tach that I miss. The mileage is less. Will I have any problems switching them - i.e.,: lights not working, etc? Will the onboard computer correct the mileage?
View 4 Replies
I have a 1997 Ford Expedition, 5.4. My research indicates that fuses 2. 19. 29 are associated with the instrument cluster (IC), could you identify their specific function in relation to the IC? My IC gauge lights are not showing and my alternator is not consistently charging. The blinkers, battery, oil, brake, and ABS indicator lights are showing in start. Regarding the alternator, my research indicates that a failing alt light on the IC may cause the no charging condition? As a note, I have a brand new battery, brand new alternator, brand new 3 pin wiring harness. Also, when the alternator is not charging and I connect the a jumper from the exciter wire directly to the pos battery terminal, the charging starts.
View 9 Replies
I have a 2005 F 350 with a 6.0 Diesel! My heat quit on my wife and I the other night! I replaced some fuses and started the truck to make sure the heat was working and it was! So I thought while I am here I should replace some bulbs in the cluster that were out!
I took the cluster out, looked at the bulbs and they looked oK so I put them back in and put the dash back together! When I went to start the truck once I turned the switch on my gauges and lights started flickering on and off fast and all it will do is just click when I try to start it! I just had it running 15 minutes before this!
I went through all the fuses and if I take one of the relays out and turn the switch on all the lights and gauges seem to work right but when I try to start it, nothing! I replaced the relay and it starts flickering again! I had the relay checked at Napa and they said it was good! The relay was for the Powertrain module!
View 2 Replies
I've been getting a random, periodic flicker of the light on the instrument cluster. It seems like it occurs when the rpm's are increasing to 2000. Does the light come on for over voltage as well as under voltage? When I check the voltage at the batteries at idle, I'm in the 14.5 v range. I cleaned/tightened all the wires to the battery and alternator and it is still occurring, will be doing the ground wires on sunday.
2003 4x4 7.3 no tunes
View 6 Replies
I like the 05 - 07 F 250 Instrument Cluster better than our stock excursion's. It is just plug and play or is it much more complicated.
View 6 Replies
I am a beginner when it comes to anything involving wiring. I am looking to re-wire all of the wiring coming off of the instrument cluster gauges. Once I have completed all of the wiring on the gauges, I may feel confident to move onto something else. As of rite now, it appears as though my truck is still running on all of the original wiring, and over the past few weeks, I have been having many wiring related issues. I found a schematic that includes the wiring for the gauges that I am going to go off of. I have a couple of questions before I begin.
1.) On the schematic, it shows connectors such as "Connector G" which is moving all of the gauges wires to there locations. Do I need to use a specific Ford connector, or could I purchase a new connector at any hardware store that carries them? As far as I am concerned, connectors do the same thing as all other connectors. (Let you connect and disconnect for easy instrument cluster removal.)
2.) I am not looking to purchase one of those expensive wiring harnesses. I would like to just purchase some wire that I can cut / use myself. What brand / type of wire should I be looking to purchase? I do not care if it is striped / colored as I will use wire tabs to name / label each wire.
Other than that, I feel confident enough to attempt something such as this. Here is the wiring schematic I am going to use.....
View 10 Replies
I just Put an 98 1.8 T engine into a 2000 2.8 passat , Everything is working fine , But The Tachometer , The Rpm And The temperature Gauges in the cluster are not working ... The Fuel Gauge also Beep and indicate low fuel when i'm turning ... Actually , the car has the V6 Cluster , i switch those and it make no difference ....
All the wires are hooked up in the ecm compartement , each wire with good color ...
Is someone has both wiring diagram of ecm compartment plug ?? 2000 v6 and 98 1.8T
View 2 Replies
My Gauge Cluster and Climate Control lights are out. Both still function properly. The mileage is light up and the turn singles work, the dummy lights even light up but when the headlights come on, the gauges don't illuminate. Same goes for the climate control; it works and the display is good but the buttons don't light up.
I replaced the headlight switch was I wasn't getting power to the light blue/red wire on the dimmer side. (Dr. Google told me to do this) Both failed at the same time so I'm thinking it is not a bulb issue. What to chase next?
View 9 Replies
I have a 2012 F350 XLT that came out of Canada. So of course the speedometer is in KM. (Large numbers are km and smaller numbers are mph). I am trying to find out if I can simply change out my cluster with a mph cluster???
View 4 Replies
Well I have got a 2000 Excursion with v10 that I've been having some electrical problems with lately. All started with a no start issue and gauge cluster warning lights staying on along with fuel and volt gauges reading without the keys being in the ignition. Took it in to the dealership to get looked at and they are saying it needs a new fuse box and gem module put in it. Was also told that it is an obsolete part and gonna be tricky trying to find the correct one for my truck as it needs to be identical to what my truck has as options. Is there any other places out there making new ones or fixing gem modules? Dealership pretty much told me if they can't find a new gem module for it that the truck is pretty much dead in the water.
View 3 Replies
I have a 2002 supercrew 5.4 triton. My coolant temp gauge is acting up. When it starts up its obviously in the cold range but when the truck begins to get up to temp, the gauge only goes up 1/4 full. What it can be?
View 4 Replies
My '97 F250 5.4L is pumping coolant on to the top of the motor which is burning off causing it to smoke like it's overheated but the temp gauge is operating in normal range. I'm losing coolant but can't see where. It's not going to the ground. It just pools up on the top of the motor. I've already replaced the water pump in the last 2 weeks because of the same issue. It stopped for a few days but now it's back again. Bad water pump from O'Reily's or is there some other issue here? I've checked while the motor's running and can't see where the coolant is coming from and there's no coolant coming out of the bleed hole in the top of the new water pump. I need this truck up and running.
View 7 Replies
I have a 2001 Excursion Limited V10. 146000 miles 2 wheel drive. I have had it about a year and this is my first winter to really have experience with her.
When the outside temperature is very cold and the engine is cold from sitting all night, at start up, the oil pressure gauge reads nothing and the oil pressure/temp idiot light is on. Only does this during the first very cold start up or after sitting and engine getting very cold again.
I can drive just a short distance (2 blocks) and both gauge and light go to normal and stay there for the rest of my drive. I am using a quality 5/20 oil and filter and the level is good. Warmer days it has never happened. Truck runs fine, smooth idle, no "limp mode". She has not had any recent work done. All the other dash gauges read fine.
There is something about really cold temperatures that have to be causing the issue , I think. ??
View 5 Replies
Today was drive my x 2000 v10 limited 4x4 114k miles). It was 90 degrees Out and was driving in light traffic going 40 and noticed my temp gauge almost up to h then dropped fast. So shut the ac off and it continue to rise and drop fast I went few more miles to where I was going checked everything could see no problems it sat for about 30mins then left on my drive back home 36 miles and had ac on and no problems stayed where it normally is. I am thinking of just replacing the belt cause I never have. No weeping from water pump. Or any smell.
View 6 Replies
Bought this truck, and the engine coolant temp gauge does not work, so I replaced the sender, still don't work.
View 8 Replies
I've got a 2012 F250 SD and when i go over some bumps in the road or even down a gravel road, the door panel on the driver side vibrates and it's noisy. Is there any way to pull the panel and add some foam padding or something to stop this? I can see the panel vibrate or heck, maybe it the whole door.
View 10 Replies
'05 Ex overhead console temp is showing -40 deg... Had the board out looking for loose diodes, didn't see any. Have any of you ran into this before?
View 14 Replies
I am going to install an aftermarket gauge on my Excursion. Just would like to know the best place to install the probe. Hopefully it isn't that hard.
View 14 Replies
