My v10 Ex blowing black smoke, RPM goes up and down, when put it in gear stalls and dead, engine is shaking and all this happened after one small 80mi trip, it was perfectly running until I turn off the engine .for almost 2 minutes. So what to do ?? And there is no code .
View 6 Replies6.0. 115,000 miles. Everything stock, except bully dog intake filter.
I replaced the FICM recently, with one that I bought from the guy who makes those cool You Tube videos, Diesel Tech Ron. I also replaced the EGR valve. I also replaced the intercooler boots on the hot side. I cleaned the intercooler pipes. I cleaned the intake filter as well. I'm still blowing out black smoke, if I floor it when I need to pass someone.
Follow up question: I bought those boots from Riff Raff Diesel and I bought new clamps, too. I'm not sure if I installed correctly. It's already blown one off (it blew the top of the intercooler pipe off, by the turbo, but the boot stays on the turbo) and I put it back on and tightened it all the way down, and I've had to re-adjust 2 times, now, since it acts like it still wants to slip off. Do I simply have the other ones misaligned???
Driving home 2003 6.0 started blowing a ton of black smoke, cars wouldn't get behind me. Found an exhaust leak on the driver side up y pipe. Would that cause this much smoke? 2 codes were 0284 and 0281, I replaced those injectors about 10k ago, at the same time replaced turbo, hpop, egr valve and cooler delete, and new oil cooler.
View 9 RepliesFound a 2004 Ex, Eddie Bauer edition says it has injector issues, blowing black smoke........ It is apart cause he thought it was the EGR. Has 245,000 on the clock. If the body is super clean I'll give him a offer, it's going to get a motor either way and I'll have my Ex back.............I really miss that truck!
View 2 Replies1988 4.0 - noticed fuel mileage going down and an occasional stumble for a while but now I am getting some black smoke more when I let off the throttle than when I going down the road if I rev the truck get all kind of black soot all over the floor otherwise runs fine idles fine the iac has been replaced air filter replaced check the fuel pressure regulator for any gas leaking into the vacuum line and its clean.
View 14 RepliesOk I have a 2004 f250 6.0L, has 104k on it. A little back story... truck was running well when I started to get surging on takeoff and it was blowing black smoke when it surged. After it hit 1600 rpm it would blow out and run normal. So did some research and found it could be the FCIM, I have the 4 pin and tested it and had 48.5v so it tested good. Did some more research and found symptoms leading towards the ICP so I replaced that and the ICR also.
Upon doing this my surging issue cleared up but now I'm getting a miss around 1200 + rpm weather it's in park Reving it or driving, but it is not throwing any codes, I did check with my code reader. I have also changed both fuel filters and have the EBP sensor on order as I hear they can be troublesome. My question is what should I do next or look at? I was trying to avoid the dealer so I can learn more about the truck in diagnosis.
I have just replaced the EGR cooler, Oil Cooler, professional turbo reconditioning, both dummy plug's and stand-pipe's, blue spring, fuel filters, oil changed, cleaned the EGR valve and intake manifold. I am in the process of doing a coolant flush when my issue occurred. I was on the road for about 10 minutes when I lost power and started blowing black smoke. I have normal power till about 45 mph then nothing. I can baby the truck up to 55-60 and then nothing and the whole time blowing black smoke.
I stomp on the pedal with no power. I hear the whine of the turbo. The truck idles and sounds fine. My SCT showed my oil and coolant temps within 15 degrees. I opened the hood and saw soot all over the top of the engine from the compressor to the EGR valve and all in the valley from valve cover to valve cover; but more so on the driver side to FICM. I obviously didn't connect something properly. I am just about to remove the intake manifold and reinstall, but before I do just wanted some input.
I have a 06 6.0 Powerstroke 6 Speed every time I get on it or even try to get going I have no power and I have pure black smoke blowing out the exhaust somebody told me to change the fuel filters which I did which they were pretty nasty then after I did that I seem to still have the same problem so then they told me to check the EGR valve put injector cleaner in it to clean the injectors which I have not done a gr or injector cleaner yet just wanted to know, what it could be or what I can do to prevent the black smoke I have no power either...
View 1 RepliesMy 2006 F-250 (6.0 Diesel) started blowing black smoke under acceleration yesterday. It has 181k miles on it now. No loss of power, no rough idle, no smoke unless there's a load on the engine like accelerating, but then it doesn't matter if it's 1500 or 3000RPM, just the higher the RPM the more smoke it blows from the exhaust, dark black.
The truck has ARP headstuds, no programmer. Replaced both batteries and the A/C system about 2 weeks ago. About 3000 miles ago it got new glow plugs & harnesses, new alternator, all fluids changed, new aftermarket EGR cooler, new EGR valve, new turbo & actuator, new EBP sensor, new HPOP incl pipes and IPR.
Trucks starts up just fine, runs normal, just yesterday going down the Freeway about 65mph I noticed it started smoking black going up a hill, then smoke went away going downhill... Now every time I accelerate it's smoking black. Taking off from a stop sign it made a little puff of white smoke then went back to black smoke, but that only happened once.
Where I should start looking? No codes so far. But I have an AutoXRay EZ-Scan 6000, what sensors do I need to look at?
I have a 2003 F250CC 7.3 with 200,000 miles on it. I just purchased this truck about a month ago. My question is it blows black smoke. A little at idle but mostly when you give it any pedal. I have replaced all of the injector o rings and that didn't make a difference. Then I had it tested and it failed a CCT test on #2 cylinder. I have an injector to put in it, but am curious to find out if 1 bad injector would be enough to make it smoke all the time. I keep getting P1211 ICP pressure above desired. I had a friend of mine who used to work at a ford garage take a look at it with his computer and he said that everything looks good other than the CCT test.
View 14 RepliesTruck has been running like a champ the entire time I had it. Took it in yesterday for an oil change. They also changed the fuel and air filters.
Drove off the lot and noticed some loss of power. This morning truck still feels sluggish but it is also blowing out black smoke pretty much every time I touch the gas pedal. I am even being super gentle with it. Starting from a stop, I hit 1500rpm and it's blowing thick black smoke as if I was flooring it. Same thing while rolling to get a bit more speed to pass.
Ok so the wife and I were heading home, she was in her 2.0t sedan, I was in my 3.6 4motion wagon. I got stuck behind a slow driver on the highway (doing 50 in a 70 mph zone) so I get in the passing lane and I floor it to pass him. When I get home, my wife tells me she saw a good amount of black/blue smoke coming out my tail pipes when I went to pass the other driver. This is on a engine with 2400 miles.
I take a look, and the chrome exhaust tips I had installed not long ago are now all black, covered in a oily thick residue. These same exhaust tips were on my previous 07 3.6 4motion wagon for 10k miles and was still shiny when I took them off. but after about 1k miles on the 08, they are now all black. I check the oil and it still reads full.
So what could this black smoke and this oily residue on the exhaust tips be caused by? should I be concerned? Engine runs fine with the exception of sometimes stalling when trying to start it after a short stop. (VAG-COM doesn't show any error codes logged.
Well my problem went from bad to worse. My 05 started running rough at idle, then smoothed out a bit but started smoking on acceleration a little. At this point it felt like it had more power than ever before and even ran smoother running up to 3k RPM before shifting (manual transmission). But now it's smoking so bad, I can't really drive it. It's smoking white or gray at idle but blowing black smoke on acceleration. I had a cylinder 5 contribution code but with the amount of smoke it's hard to believe only one injector is a problem. I pulled the EGR valve and it doesn't look stuck open but I'm going to replace it anyway.
View 3 RepliesI was towing my camper uphill and my 03 6.0 started missing and blowing black kid smoke. Next thing I know I hear a loud pop and steam is coming from under the hood and the truck dies. I pull over and discover the degas lid is stuck on and the bottle came apart at the the seam and the truck will not start. 6.0 with 120k miles
View 1 RepliesI recently had the Blue Spring installed on my 04 X. After having it installed I still noticed a lot of hesitation on take off, and after a few seconds of trying to take off it kicks out a large cloud of black smoke and away she goes. The problem is very noticed when at the bottoms of hills it seems powerless and makes a wierd noise from the drive side of the engine bay, until I press the pedal enough to make it downshift then comes the large cloud of black smoke and she climbs up. All I know is I'm getting worse fuel economy then I should get and something just doesn't feel right when driving the X. The truck doesn't feel like it missing at all so I don't think it would be injectors especially as They are all brand new and less than 6 months old.
View 12 RepliesI have a 2003 Ford Excursion with the 6.0 diesel. Just driving the truck today and it was putting out black smoke. What could be causing it? No tuner on my truck, just a 4 inch straight pipe and a k&n air intake (bullet proofed, but thats not for performance) ....
2003 ford excursion 6.9, black smoke, why? - YouTube ....
I bought a 2003 Vw Gti 1.8t ... What to do or look for when something goes wrong . About a two months after driving it, it won't idle and it shuts off while in Neutral . I've done my research and i believe he didn't install the BOV in right, only bc it is not recirculates the air. Make sense? Is there ANYTHING i can do so it will run better and idle?
View 5 RepliesI am only at 141,000 miles and I'm seeing blue smoke while I idle! It started as a small puff of blue smoke when cold starting up...now it is much more consistent. I am also getting a diag trouble code of P0674 (glow plug in cylinder 4) can that be the cause? I'm nervous since I didn't watch my tech put oil in the truck at the last oil change...I think he put four gallons in instead of 15 quarts...is that a prob?
View 1 RepliesI've been told by friends driving behind me that every time I accelerate I emit a plume of black smoke followed by a stream of black colored "water". I checked today by having the wife rev the engine to 4.5k...sure enough, black water shoots out of my exhaust, probably 3 oz. I also see a black puff of smoke which I assume is more normal than the water. Is this commonplace ?
View 2 RepliesStarted with lots of black smoke all of a sudden. Not under any significant load at that time. Reached destination (barely) and started the search. Have taken off blue connectors on CAC passenger side. Top is marginal but see no holes. Pulled the MAP hose and see nothing unusual. Have not checked the driver side CAC or the BPV sensor. Have a ScanII device that shows no codes. Got my other scanner and it too shows no codes.
Had it towed home over 100 miles 'cause now it just barely runs. Idles fine but have a engine noise change (deep and hollow) every once and a while at idle. EGR leak? Doesn't blow black smoke anymore. More of a white/blue. Exhaust smells odd. Absolutely no turbo activity. When shutting hear no whine down of the turbo. No boost evident on the dash or on the scan II. I am at a loss at this point. Will check fittings again.
Have a 2009 Ford F-150 with 5.4 ... Recently installed a cold air intake and now when I start it burns black smoke for maybe 15-60 seconds.
I have to rev the engine up by pushing on the gas or else it will stall.... after the 15-60 seconds the smoke turns clear and it idles with no problem and sounds normal.
This happens every time I don't use it for over 9 hours or so if I leave it for a couple hours it will start normal and idle normal....