Ford F-150 - 1997-2003 :: 2002 - Transmission Is Shot
Aug 23, 2012
I have a 2002 f150 lariat super crew 4x2 with a 5.4L engine with 145,000 miles. My tranny is shot, and i was told it happened because the tranny cooler went bad. A few people have told me it sounds strange that the cooler went bad on its own. The truck is still at the shop that diagnosed it and i cant seem to figure out if it has the 4R70w or the 4r100 tranny in it. Is this something that's standard or something i will have to look at on the truck itself to figure out.
View 11 Replies
Advertisement
Alright so I got ripped off on a truck that I just bought. Among all the other issues the main one is the bed. The side panels and tailgate are immaculate but the floor is shot. I read in another thread how everyone patched the holes but my issue goes much deeper. Even the bed frame is shot. Is there any way I can get a piece of steel cut to size and put new pieces for the frame and just weld it together? Id hate to have to buy a whole new bed because I am short on cash trying to start school and doing other repairs to what I thought was gonna be a perfect truck. It has the 6.5ft "Styleside" or flareside bed.
View 3 Replies
Woke up this morning and was going to work. Went to unlock my truck and noticed the lights didn't come on inside when I used the remote door unlock. Then I started truck and the tranny lever on the steering column wouldn't go into gear plus the sterring wheel will not lock when the truck is off!
View 1 Replies
I have a 2002 f150 2wd 4.2l engine. With 135,000 miles I just replaced the battery about 300 miles ago and I usually tow a trailer almost always. Also I replaced the Plugs and Plug wires about 15,000 miles ago When I am towing I turn the OD off. Now the problem. I noticed that when I am not towing now that when approaching highway speeds it seems to shift back and forth from overdrive while accelerating only.
But when pulling a trailer with OD off it shifts fine. No engine codes appear. I am due to service the transmission fluid I think I have about 35,000 on the fluid now but before I do I just want to pass this that while I have the pan out. Is there anything else I should check or could this just be a issue with dirty fluid Or Possibly the drivetrain controller because I hardly ever drive without towing..
View 11 Replies
Was looking for some advice on what my problem may be. I just replaced the slave cylinder on my 02 f150 4.2 and two days after I changed it on my way home from work my truck jerked when I was about to turn into my driveway. Then when I stopped I put it in neutral snd it started rattling really bad it stopped when I pushed the clutch in And when i let out it started again. It sounds really bad and im hoping its something I can fix my self and not terminal.
View 4 Replies
Anything else that could cause reverse to go out of an automatic tranny other than the tranny being shot? I don't know of anything but any way to keep me from replacing a tranny.
View 2 Replies
Here's the scoop, was driving down the freeway the other day, car is a 2001 PT Cruiser going about 65-70 MPH when all the sudden it felt as if I had hit something, a loud bump sound which came from underneath the engine, then an immediate reduction in speed and acceleration. After that, I was trying to accelerate the car, the RPMs were revving like crazy but the car would not go more than 15 MPH, while the RPMs were revving and revving, almost as if I was in park.
Got the car to the side of the road, opened the hood and found that the top of the dipstick (transmission) had blown off and shot transmission fluid all over the engine. Unsure of why this happened but sure that was what the loud sound was before the drastic drop in acceleration.
After that I had the car towed to my house, now it will start, but not drive in reverse at all, i'm afraid to try driving it to inspect it further but that's pretty much where I am at right now. There's 117k miles on this car...
View 9 Replies
My 86 diesel mercedes has a history of a bad transmission. Could not drive it for 2 years before having the transmission rebuilt only to end with no 3rd gear. Very loud metal sounds(not grinding) when changing gears as well as having to build up muscle tone to change gears. Anyway, driving along around 55mph when the airbag deploys with no collision. I pulled over safely, not sure how. After cutting away the airbag my husband tried to drive the car home. The stick would only move up and down but not into any gears.
View 7 Replies
1997 Chevy 2.2l 4cyl LS model. Changed fuel filter and am trying the fuel pump tomorrow. BUT if this doesn't work? I want to be ready because this is my only vehicle. Has spark, turns over but acts as if not getting gas. (Recently had new clutch installed.)
View 7 Replies
I have an 03 F250 5.4L
Driving down the highway today, I notice my truck was jerking forward a little, hard to notice almost felt like I was hitting very small pot holes. I revved up a little to see if I could notice any noises and I got a loud pop. after the pop, got a noise like an exhaust leak so I pulled off to the side of the highway and popped the hood (engine still running). Noticed the noise coming from the passenger side most forward spark plug. Then noticed the part that the coil attaches too had broke off from its bracket and was unseated, shut off the engine and pulled it out to find the coil cover had melted to the coil.
The spark plug inside was moving freely so I took it out thinking it stripped from the header. Come to find that the plug had actually separated from its threading completely so just the core part of the plug had shot out from the cylinder, the threading and socket attachment portion still fully attached. I installed a new spark plug and new coil harness and coil. Seems to be running as good as new now. Is there more to this than a simple blown plug that I need to worry about?
View 6 Replies
I was driving my bosses f550 with a 7.3, and while towing a loaded 40' flatbed of hay, it started bloing white smoke and lost all power and had almost no pedal feel. It wouldnt even go past 2500 RPM. Then, all of a sudden, it started billowing black, and BOOM backfired and shot flames out the exhaust. Then, I pulled over at a parts store and replaced the fuel filter, which worked for a while, but then it started blowing white smoke again. Once I limped it home and unhooked it, I took it out and let her rev a bit and it seemed to stop blowing smoke, but it still has less than the normal power it used to have. It has 226000 miles and is completely stock.
View 8 Replies
I have a 2002 echo, and I need some work done on it. I'm pretty sure that my engine mounts are bad, and I know that my front bushings are shot. What should I expect to pay for the bushings/mounts to be replaced? Also, how do I know if my engine mounts are bad? Note that I am a college student living on campus, so doing the bushings will be next to impossible.
View 2 Replies
I recently purchased a 2003 Explorer. Two weeks after I bought it I found out the motor on the windshield washer water pump was shot. The dealership fixed it for free. About a week after I got it back when I was driving in the morning to work I noticed the check gauge light go on and saw that my temp gauge was pointed at HOT!! I pulled over and stopped immediately. As soon as I slowed down the temp gauge went back down to normal. It happened 2 or 3 more times and had it back at the dealership. They are stumped. They sent it to a Ford dealership and they couldn't find anything either.
They said they have checked everything and it is not overheating. They even put a thermometer on it while they drove it and it didn't get over 205* I am surprised it didn't do it to them because it happens almost every morning. I only work 4.3 miles from my house so its not like I am driving very far. It usually happens at about 3 miles. As soon as I see it going up (and I watch it a lot!!) I take my foot off the gas and start to slow down or barely press the brake it goes right back to normal. Then it stays at normal the rest of the day. Is it the sensor or the wiring or did the do something to it when the fixed the washer motor?
View 10 Replies
I have a 1997 Ford F150 4x4. I only have reverse gear, when you put into drive you have to rev up truck and then it will kick into gear & as long as you keep a little pressure on throttle it will stay in gear & shift fine if you let up on throttle it seems to go back into neutral & you have to start the the process all over. What is my problem? I have changed fluid & filter.
View 2 Replies
Looking for any good videos of flushing the transmission out of an 1997 F150. I'm having a hard time locating the input and output lines to the radiator. I don't know which it is top or bottom one...
View 11 Replies
I have a 1997 F150 XLT V6 Speed Manual stickshift. My problem is the transmission will not go into any gears, it is in neutral.
View 1 Replies
Transmission lost 3rd and 4th gears so I pulled it and found the direct drum burnt up, got new drum and changed all seals, clutches, steel plates, aftermarket cooler and put a sure cure kit in it.
Truck drove great until it blew the front seal out 250 miles later, took it to a shop since I was away from home and he said the clutches got hot so he completely rebuilt it. Truck made it 150 miles and lost 3rd and 4th again. He replaced all the solenoids also.
Transmission shop rebuilt it again and it made it 80 miles and now it will not move at all. We replaced the neutral switch, shift cable, and shifter handle on the last rebuild because he thought it was hanging between neutral and drive.
What else could be making this transmission keep going out? Could it be a bad case, bad valve body or what? We are at a total loss on what keeps burning it up.
View 3 Replies
Went in for a tune-up and inspection on my 03 1.8 passat. Turns out my cv boots are shot. How much should I expect to pay for parts & labor, I will not be going to the vw stealership to get this done. It's just the fronts that need to be done.
View 11 Replies
So I was given a 1999 f150 4.6. The transmission was supposedly either new or rebuilt. (I'm going with rebuilt) Driving it for the first time today, I noticed it had very little poor acceleration. When I would get on the gas (to the floor) the rpms would shoot up (3-3.5) but the truck didn't accelerate accordingly. It feels like the power it's getting to the wheels. Driving at highway speed trying to maintain a speed at over 70 the truck wanted to stay at 2500 rpms but if I let off the gas just a touch it would shift up (into overdrive I think) and level out at just below 2000 rpms, but if I accelerated even just barely, it would down shift and go back to 2500. I've also noticed the truck runs 5 mph faster than it reads with stock sized tires. I've check the tans fluid and it is bright red in color and at the appropriate level. I crawled under the truck and noticed the trasfer case mount was wet with fluid (not dripping) and the rear output shaft of the transfer case was also wet. Could this be a transfer case problem?
View 13 Replies
My friend has a 2000 f-150 2x2 and was following him and he said he heard something pop and then no transmission , haven't put a code reader on it yet. It's not the flex plate starer works fine fluid is a little discolored and has no bad burned smell to it.
View 1 Replies
My truck is an XL V8. Transmission is Manual 5-Speed Mazda M5OD-R2.
I bought this truck literally two days ago. It seemed a little hard to shift, but no other problems. The truck had been sitting a short while, the guy said he took it on local trips, but nothing more. I noticed the oil and coolant levels were crazy low, so maybe it had been sitting longer or the guy was neglectful, I'm not sure...
I was driving it home and it seems like what can be described as: the gear ratio went completely out.
For example, 4th gear acted like 1st gear, 5th gear like somewhere between 1st and 2nd gear, so when I'm at 20mph, in 5th gear, the rpms are really high like im going 20mph in first gear (not 5th).
Today none of the gears engage at all... I dropped off a trailer at uhaul, and I got stuck there! (The truck is still there, I walked 4 miles home)
The shifter works fine, all gears sound like neutral (including reverse) when accelerator is pressed. Car won't move at all, nothing is engaging.
Underneath the car, there is a leak from the transmission assembly, maybe around the fill plug? It's only a small puddle. Maybe fluid, shift forks, bushes? or all?
View 8 Replies
