Ford F-150 - 1997-2003 :: 2002 - Intermittent Squealing Noise
Oct 31, 2006
Over the last few days my f150 has developed a really annoying squeal that's intermittent. I can never really predict when Ill hear it. Usually I first hear it when I am accelerating to a speed greater than 30 or 40 mph. And it will continue if i keep my foot on the gas or if i slowly hit the brakes. Usually the only way it will stop is if I slow down to under roughly 30 or if i hit the brakes. pretty hard.
But sometimes Ill hear it at various speeds just for a second or two, usually when I am turning or when I am decelerating by taking my foot off the gas and not braking. again its hard to predict. It sounds really similar to a car with squeaky brakes. and just like squeaky brakes, you can hear the noise slow down as the f150 slows down. but again it doesnt only happen when i hit the brakes. I dont know what it is.
View 10 Replies
Advertisement
I have a 2002 SuperCrew 4x4 that makes a squealing sound that starts at 3000 rpm and slowly goes away as it approaches 4000 rpm. It does this when you are in park or in gear. I believe the torque converter is going bad, but just want to make sure before I tear it all down.
View 1 Replies
I have a 1997 f150 with the 4.6l triton that just started to make a squealing noise. I have replaced a couple of pulleys that were bad but that did not get rid of the problem. It only makes the noise when I give it some gas and it is coming from around the fan clutch area.
View 5 Replies
I've had this truck almost 2 yrs now. It is not a 4 x 4. The trouble I am having is on the driver side. What happened first was while I was driving it i heard a loud squealing noise then a loud pop. After that the truck seemed fine I checked under it and everything looked ok. After that I drove it to a couple stores did fine but i heard the loud pop again. Once I left the store I was driving on the highway and it jerked to the left and i heard a grinding/rattling noise. I put my flashers on slowed down and every once in a while it would still pull to the right but the grinding noise remained constant. I parked it waited for a tow and i turned the truck around and drove it up the ramp there was another pop sound but I didn't hear the grinding. It seems to happen on and off. And it doesn't matter if I am turning or going straight.
View 2 Replies
1997 4.6L.. Have an intermittent grinding / dragging noise coming from the pulley (?timing) area that I'm trying to pin down. Both the alternator and tensioner were replaced prior to the noise starting. The ac compressor and the power steering pump are original. The fan clutch was replaced about 4 years ago and the water pump 8 years ago. Timing chain / guides / tensioner are all original.
I don't notice any of the common ps pump indicators (whine increase when steering) but noticed the fluid level was down slightly and that the pulley seems to have some inward - outward play with the belt off. I also don't have any other engine symptoms like rough idle or any codes being triggered. How to isolate the culprit?
View 2 Replies
I have a 2011 Elantra with about 18,000Km on it. I'm now hearing intermittent high pitch squealing when driving below 40km/hr, seems to be coming from the right side but it's hard to tell.
It tends to go away when I apply the brakes or accelerate. I doubt it's the brake pads.
I remember some time ago while servicing the car at the dealership after the first two years, they recommend to have the brakes cleaned. I opted to not do as I thought it was a cash grab.
View 13 Replies
I just purchased a 99 Rodeo 4X4 with the 5-speed stick. It makes an intermittent high pitched squealing noise at highway speeds. This noise comes up through the floor right about where the center console glove box is. In fact, it really sounds like it is coming from the console glove box.
View 1 Replies
My girlfriend's Elantra (mid 90s model, I think) makes an intermittent noise when on the highway. It sounds to me like it could either be from friction or some sort of wind noise, but I suspect it's the former. It only seems to happen at speeds above 50 or so. When it occurs, it is always the same pitch and loudness -- these don't seem to vary. It's rather loud, to the point where it is pretty unpleasant to drive when this is going on. It has happened both when my foot is on and off the gas pedal. When the noise happens, it can last anywhere from just a second to up to a minute or more. I haven't been able to identify anything obvious that it's correlated with -- wind direction, grade of road, etc. The only thing I do know is that it only seems to happen at highway speeds. We never hear it during city driving. So far one mechanic has confidently misdiagnosed the problem as a bad wheel bearing.
View 3 Replies
I bought my current truck this past December (2002 SCREW Lariat FX4) and recently had my first reason to engage 4WD. I noticed a rumbling noise at speed (35-40mph.) After searching this forum, I checked the heat shield near the front drive shaft, and it is not rubbing. Everything looks to be in good working order. The sound is coming from somewhere in the front driveline, not the transfer case, as it the sound continues after the t-case is switched to 2wd, before the center disconnect disengages.
Checked the front diff fluid and it is topped-off. The drive shaft has some significant surface rust, so it could be the u-joints, but it's a pretty straight shot from the t-case to the front diff, so I don't think the sound is coming from there. Where the noise is coming from? CV joints in the half shafts, perhaps? Truck has 106K miles on it, and is in immaculate condition. I doubt it's ever seen any serious 4WD duty, but it did spend it's first two years in the Detroit area, so it may have seen some winter highway use. My last truck was an '01 4x4, and it was always whisper quiet in 4WD.
View 3 Replies
I have a 2002 f150 with the 5.4 motor and a auto transmission and when I go in reverse the rear end makes a loud whining noise? The fluid level is fine. Should I add the gear oil additive to the rear end or change the rear end oil and add that? I am looking to sell the truck so what could cause this noise?
View 1 Replies
I have a 2002 f150 5.4 with 3.55 limited slip... For months now every time I hit a bump with the front right side there is a loud bang (sounds like a wore out bushing), and if I am driving slow at an idle you can here a thump every time the wheel goes around. And when I turn all the way it sounds more like a grinding sound.... The noise is getting very bad, what it is. I am very mechanically inclined but cannot figure it out.
Everything in the front end seem tight. When I lay under it if I get someone to spin te wheel the thump sound sounds like its in the front dif, kinda echoes through the front drive shaft but u joints seem good. I really think it's in the dif, and I'm hoping the banging noise I hear when I hit bumps is the same problem as the noise when the wheels go around....
View 3 Replies
2002 f150 fx4 ... I changed both front cv shafts cause they were making noise and the u joints and I still have a clicking noise in reverse if I turn my wheel at all to the right ...
View 1 Replies
2002 Screw 4X4 with 5.4 ... Truck has 180K miles.
Howl / Growl noise we think from the front. Both front wheel bearings have been changed without improvement. A rotational issue as it only does it when moving and still does it if you put it in neutral and let it coast.
2 WD or 4 WD does not seem to make much difference. Been checking and testing everything without success. Drive shafts and u-joints are tight etc.
How to test it? It was my truck and is my son's truck now. They have run it on a hoist and tried to determine where the sound comes from. Going to try that again but it might be different when the wheels are not on the ground and there is no weight on things.
View 4 Replies
I have a 2002 f150 4.6L triton. I've been having problems with it making a clicking noise. It only does it when its in gear. I put it in park or natural I hear nothing. But as soon as I put it in drive or reverse and put a little pressure on throttle it starts to tick pretty loudly.
View 4 Replies
I have an 02 Passat GLS. Its seems that when uts really cold out and I got to start my car in the morning it lets out a squealing noise. I just had my engine serviced so I doubt its any of the belts but I dont know for certain. Any VW buffs out there who know?
View 1 Replies
I am now getting a random 'whirring' or 'squealing' noise from the front. When it starts, I feel some vibration in the steering wheel and floorboard and for sure can hear it. Starts on it own at random, sometimes when I hit a bump in the road. Stops at random, sometimes when hitting a bump in the road. Lasts for different lengths of time. Always stops when coming to a stop at about ~15 mph. Seems to change pitch ever so slightly if turning when it is 'whirring' or 'squealing'.
View 4 Replies
2001 F150 ... I'm having trouble with my truck starting after its been running for awhile and then I shut it off.... I have to let it sit for a few min. Before I can crank it again and it will start. I was driving down the road and it just died on me the other day that's what started all this...
The fuel pump and filter was already replaced and I just replaced the cam and crank sensors ... but its still acting up...... I'm not sure where to turn next... No check engine light ..... I have a scan tool and checked for soft codes but nothing.
View 5 Replies
I have a 2001 F150 with the 4.6 engine. I get an intermittent drop in the idle from 700 RPM to about 500 RPM. The computer catches it quickly and brings the idle back up. It might drop several times and clear up or it might not happen at all. Seems only to happen on a hot engine, never when cold and in gear, if in park or neutral seems to idle ok. Changed the idle air control valve but no different. Runs fine except for the idle dropping when stopped.
Never get a check engine light, and no codes from the computer when I had it checked. Could this be the vapor management valve turning on?
View 8 Replies
The Truck...
1999 F-150 Supercab
170K miles
4.6 Litre
Automatic Trans
The Problem... About every other day, I try to start the truck, and it doesn't fire at all. It cranks fine, everything seems right, but no start.
What I've done...
Replaced Fuel Pump Relay.. (no luck)
Sprayed Starting Fluid In and Cranked... It Fires On Fluid.
Other info...
This problem never lasts long, and the problem mysteriously fixes itself after no more than an hour.
This problem has occurred both when the truck was warm and completely cold.
View 3 Replies
01 supercrew 4.6. Have had intermittent no start. The first few times it did start with a jump. Cranks fine but I thought the battery was weak. Replaced battery, same issue. 40 psi gas pressure at the fuel rail with analog gage. Theft light blinks with battery inserted. Theft light not illuminated while cranking. Battery light flashes while cranking. Battery is brand-new and charged. Opened and closed inertia switch several times to check.
View 12 Replies
Ok I've been getting a intermittent misfire on my truck for soem time now. It ran great all winter but now its getting hotter it intermittently misses. Last summer I replaced all the coils. And the coil inquestion now was replaced since last summer with Motor Craft Coil. I have red the check Engine Codes a d here is the freeze Fram data
DTC :P0351
Fuel System I : Closed Loop
Calculated Load: 71.37%
Engine Coolent temp: 199.4 F
Short Term Fuel Trim Bank 1 : 3.91%
Long Term Fuel Trim Bank 1: 0.78%
Short term Fuel Trim Bank 2: 6.25%
Long Term Fuel Trim Bank 2: 0.78%
Engine RPM :1613.25
Vehicle Speed Sensor: 4.35 MPH
What might be my problem? Since The Short Tem Fuel trim from bank 1 and Bank two are vastly different could that mean my fuel injector is not working correctly?
View 11 Replies
