Ford F-150 - 1997-2003 :: Missing / Died On The Side Of Road And Have No Spark?
Apr 9, 2012
I recently purchased a 1997 F150 4.2 Liter. On the way home it started missing. Within the next few days it died on the side of the road. After towing home I found no spark. A few days later I t started but only for a few minuites and died. No spark, coil pack is new so I replaced the CKP and it started up. Drove it about 1/2 Mile and died again, No spark again. Not getting power to coil pack when I am turning it over. So in short, new coil pack and CKP sensor and no spark. If it sits for a few days it may start or it may not. But if it does it only runs for a short period and then no spark again.
View 3 Replies
Advertisement
This a 02 with 5.4, had codes po306, pulled and checked sparkplug had moisture in it. Fixed that ran ok for a little bit then started again, no codes now and smells a little like rotten egg.
View 1 Replies
I have an 1999 f150 4.2l only 82,000 original miles.i have had truck since new .i just replaced the spark plugs for the first time.i used autolite plat. I also changed fuel filter the truck started to run like crap now shaking and sorta like missing.i pulled the plugs again rechecked the gp reinstalled them installed new wires still runs like crap.went out bought new motorcraft plat. plugs gapped at .054 still runs like crap..so i checked the gap on original plus that have been i the truck since new the gap on them are .074-.075. should i try and gapp the new ones to this the truck ran like a dream with the original plugs at this gap????
View 14 Replies
My Truck : 1999 Ford F-150 Extended Cab 4x4 5.4L V8
So the other day I was driving the truck and it just dies on me. Tried starting but it just cranked and cranked. Got it pulled over to a parking lot and then tried to start and I got it to run again. Died a couple mins later uo the road and it will not start at all anymore. I got it towed to my driveway and I've started diagnosing some things.
I dropped the tank thinking it was a pump I replaced awhile back. The pump wasn't running but jumped to conclusions and took it back to the auto parts store. They bench tested and it works fine. I checked for voltage at the pump connector. NOTHING. So I'm not getting power to Fuel pump. Then I checked the fuse and relay for the fuel pump. Everything was okay.
I did some research and decided to check for spark. NO SPARK. Another thing I noticed the other day was that the odometer is displaying all dashes. So I'm really unsure on what to really troubleshoot. I am going back to the truck tomorrow to check a few other things. I'm not sure if the Theft light is blinking or not so I will check that tomorrow and get back to you.
What to check? Any other relays or fuses besides the fuel pump? What about any modules to check like PCM, GEM, etc. Or I've heard the crankshaft sensor could be an issue.
View 14 Replies
I have a 2003 Ex 6.0 psd, 155k miles, and was on my way to work to a site 40 miles from nowhere. I was about 10 miles from my destination cruising around 65 when the Ex started losing power. I would say within a couple of miles power was gone and i had no choice but to pull over. I popped the hood, got out had a look around and saw no leaks or anything out of the ordinary. Let it sit for a few minutes and tried to restart it to no avail. There was no check eng light or any signs something was wrong.
I just so happened to have my OBD scanner with me and plugged it in and read for any extra codes. Three popped up on the screen: P0232, P0263, and P0278.
P0232 Fuel Pump Secondary (Feedback) Circuit High Voltage,
P0263 is described as a cylinder number 1 contribution/balance. In essence, this code is stating that the number one cylinder in the firing order is experiencing a fuel-related problem.
P0278 same as above for cyl 6.
Right away i thought the fuel/lift pump took a dump on me and was causing the fuel issues in the two cylinders.
View 12 Replies
94 Camry, 4 cylinder. 204,000 miles. New fuel pump last year. Timing belt replaced 30K ago. Plugs and plug wires, as well as distributor cap and rotor, about 2 years old. New ignition coil about 300 miles ago. Generally very well maintained and in good shape. Today it died on the NJ Turnpike, 200 miles from home; started missing and it got progressively worse over the span of about 30 seconds to the point that the motor died. Towed to local Pep Boys (I know, but it was the only choice on a Saturday and I don't know the local area).
Mechanic says no spark but was unable to fix it. As things now stand the nearest Toyota dealer is scheduled to move the car to their shop on Monday. All the dash lights come on, including chimes and such. It will crank like a champ but will not fire up. I know this isn't giving you all much to go on, but I'm wondering if what happened could be related to the coil. Is it likely to have failed? Would replacing an old coil cause anything else to break down in the distributor?
View 10 Replies
My 2001 F150 4.6 threw the #3 plug on the passenger side while going down the road at 65 mph. It threaded back in and tightened up to make it the last 7 miles home. I have read that Time serts are the best option but I need this truck daily at work. Has anyone tried using the Heli Coil system as a temporary fix? I am going to order the Time Set kit but since I need the truck now, I was wondering if it were possible to pick up a Heli Coil and insert it until my Time Sert kit arrives?
View 5 Replies
On way way to Florida and got 5 hours away and after the truck ran flawlessly for 5 hours it all of a sudden started billowing smoke, lots of knocking, and died. Now the engine won't turn over, tries to but acts like it's stuck. No codes...Accidentally crushed the cord on my CTS so no way to read codes. Just did studs and injectors
View 14 Replies
I have an 03 with a 6.0 diesel, going down the road and started losing power and then died. Won't start, and I don't have a scan gauge. Several sources said ipr valve, and from videos on youtube I thought may be a good place to start. I bought a socket and pulled the valve, to check the screen. There is no screen whatsoever on the ipr. The oils clean, as I had changed it about 200 miles ago, and I ran a magnet in the hole looking for a screen, couldn't find anything so I used my fluid pump in the hole. No trash, screen or anything. Do some ipr valves not have screens? What would be my next step??
View 2 Replies
it's missing at an idle and it acts like it dont wanna take gas but once you get it going on the road it does good. the motor is a remanufacture motor it's only got 6,000 miles, new coils, plugs and wires, cam sensor, crank sensor, idle air control, mass air flow,and temp switch.
View 9 Replies
So today, I planned on switching the belt, idler pulley and tensioner since at least two of them are making noises. After taking all of the stuff off, belt, idler pulley and tensioner... and since I always compare parts I buy to parts that were in, making sure they are identical and I didn't order the wrong one. So first up I checked my tensioner and the position of them or angles are different, completely different.
So Google it to view a few diagrams and bang! it hits me... the one I took out from my F150 is for a non-AC... so back into the truck and I'm looking. Didn't have to go far when I realized that my AC compressor is missing!!!!
I keep looking around and I see that yes, I did have AC in it before I got it; because the guts are there but sliced! Great, so the job went from easy and easy I mean buy compressor and install; but now since the guts were cut, the PO sliced the thing out simply put.
1.) What are the bolt sizes that hold the compressor in place?
2.) Is there a wire connector on the compressor? or no?
View 1 Replies
I have 2002 f150, fx4, ext cab, 110000miles 5.4 automatic truck, i just replaced my spark plugs, it still have a little miss, thought spark plugs will resolve but its the same, im wondering if i should change O2 sensors? clean EGR Valve? IAC valve? i am not getting good gas mileage and maybe its this missfire or something, its runs good without any problems, just this slight miss makes me think if its the cause to bad MPG.
I tried to find threads with pictures of how to change O2, how to clean EGR, and IAC, i remember seeing these threads but cant find em. And you think these three things will resolve my MPG and the slight miss?
View 14 Replies
I have a99 5.4 and its missing slightly when cold mostly. I'm thinking egr poss did tune up 7 mos ago so I don't think it's plugs or coil pacs seems to get better when it warms up...
View 11 Replies
My 4.2 liter F150 suddenly started missing under load. A little background: It is a late 2003 and has 75k miles. It has been in my family since new, and I have had it for the last 4 years. This truck is as stock as they come, and has been well maintained.
On my way to work yesterday, it began missing. Not bad at first, but got worse. It misses while under load and under acceleration. The "check engine light" never came on. I have not put fuel in in several days, and it ran fine until now, so I doubt it is bad fuel. I started the engine after dark and looked for arcing. None visible, and I even sprayed the wires with a mist of water. I pulled the plugs and they all look normal. The gaps were all way too large, so I regapped the plugs to .054". I pulled the coil pack and it checks within range with my VOM. Can the coil pack be the problem even though it checks out on the bench? Can the large plug gaps have contributed to a coil pack failure?
Where to start. I HATE just throwing parts at this thing, and I don't like wasting money... If I let one of the auto parts stores run a scan, will it show a code even though I have no check engine light? I used to think of myself as a pretty good diagnostician, but then again, when I used to spend a lot of time under the hood, those cars had points, condensers and carburetors...
View 4 Replies
I have a 2002 f-150 4.6 that sometimes has a miss upon acceleration but not all the time.the truck is a 4.6 with a manual trans.has no engine codes and scanner never show a misfires but sometimes it does , have replaced all spark plugs and coil boots twice.
View 4 Replies
My 1999 f150 is having issues of bucking while going down the road and it only happen on a hot day. It's like someone is turning the key off then back on.It's only for a split second. I'm having trouble determining if this truck has the fpdm or not. and if this may be the issue. Fuel Pump Driver Module ?
View 8 Replies
I have a 1997 F150 4.6 V8 and as we all know these trucks are notorious for the spark plug blowing out. Although when I bought it I never had an issue until we put motorcraft plugs in. After a couple weeks of having these plugs in the porcelain blew out of the plug with the threads still in the head. The spark plug screws into a threaded insert which then screws into the head. We replaced the plug and nearly a month later the porcelain blew again. Replaced it, same story a week and a half later. Before the motorcraft plugs I had autolites in it, and I never had the slightest spark plug blowout problem. Should I just put an autolite in the cylinder that's blowing them?
View 4 Replies
I had a plug blowout last Thursday on the freeway. I wasn't sure of what happened with my truck, it was a shutgun going off. I had to towed to my local Firestone.
My truck is a F-150 4.6 2003 with 206,000 miles.
The short of the story, plug #3 blowout. It trashed the coil and I needed a new plug. They used a Helicoli and I have been reading that they shouldn't have used a Helicoli. They should have used a Time-set.
What's wrong with the Helicoli's? Is this fixed going to last for awhile? They said the helicoli worked well. The truck had 7 NGKs and 1 motorcraft. It has all new motorcrafts now.
View 12 Replies
No start, gets fuel, check injector plugs they lite. Ran fine shut it off went to re start and no go. Gets no spark what controls it?
View 2 Replies
I recently took a 4.6 from a 98 e-150 van and put in a 1997 f 150. put new oil pump, bearings, and rings. Got everything hooked up and ready to roll. turn over but no spark to any cyl. What it might be?
View 14 Replies
Went to start my truck up about 3 hours ago to take my ol' lady to work. Turned it over and acted like the usual cold start. Well soon as I thought it was good to let the engine spin, it got to about 300-400 RPM and then died. So I shut the vent off and turned my head lights off (turned them on soon as I thought it was good), spun the engine again and when it hesitated once again I gave it some gas like you would on a carb (not pumping just gave it half throttle or so) brought up the engine to about 3K and it ran just fine.
I'm not sure if its the fuel filter (when the last time my dad even bothered to change it since he has done most of the work on it in the time we've had it) or if the fuel pump is going out for the 3rd time in the last 10 years. The last time the fuel pump went it was a bad Walker fuel pump. It was promptly replaced with a Bosch and has been going strong for the last 8 years or so.
If it is the fuel pump, my guess is either my dad is going to junk it or fix it. With it getting close to 260K miles its becoming warn out and showing its age. Been pretty dependable and will do just about anything you ask and it'll do it even if it takes a long time to get going.
The fuel lines are pretty rusty so if its the filter chances are we'll have to put in a new section of fuel line in. Its probably running close to 135K miles on it since it was last done. I've only started doing maintenance on it the last 6 years or so for the most part.
View 2 Replies
