We have a 2003 Ford F250 Super Duty, gas engine. This will start fine, then a day later, it won't. Wait 30 minutes, then it starts.
Starter and battery are fine. It acts like it isn't getting fuel. Fuel pump? Filter? What else might cause this?
2001 F150 5.4 Auto ... Truck was running excellent. Engine light and overdrive light begins to blink and it acts like its running out of fuel or water in gas. Baring made it home. Cleared the code and it comes back. Transmission seems fine.
View 2 RepliesBeen having an odd problem with getting my truck to start. Pass couple of days I've gotten out from work and gone to start the truck. It cranks just fine but wont start, acts like there is no gas. Let it for a minute or two and try again and it will start right up and keep running with no other problems. Go to leave for the work the next day and the same issue. Weird thing is the problem only seems to happen when its cold out 30F so or below. I was thinking fuel pump but I'm not sure. What to check?
Edit Its a 2002 Excursion XLT with the gas 5.4
I am working on a 2000 f-150 XLT 5.4L 4x4 Automatic. It tries to crank over but acts like its stuck. things done: New starter, new battery, fixed connections. I can turn the crank counter clock wise but won't turn clock wise. Not sure if i should say the engine is bad or could trans be stuck? Heard 5.4L's have timming chain issues. Is that true? Point me in a direction and i'll go forth.
View 14 RepliesIve got a 2001 f-150, 5.4L, 121k miles. I've replaced the fuel filter, removed and cleaned all injectors, cleaned MAF, changed 2 faulty coil packs, and installed all new plugs.
No codes thrown, truck runs smooth. Problem is intermittent. It will act as though it's got no power, usually won't happen till it's warm. I can drive it for 2 hours, runs strong. Sometimes when I pull onto a highway and get on the throttle a bit, it starts to hesitate, rpm's go to about 3k and it hesitates, but does not miss. acts like trans is slipping but I'm positive it's not.
So when it starts to do this, it's constant. I can continue to drive and it's runs terrible, does ok if you barely use any throttle. But.... I can be driving 40-50mph while it's having this problem, toss it in neutral, turn it off and restart, and all the power is back, great acceleration, as if nothing ever happened.
Our car starts, then dies. It starts fine, then dies. This only happens in warm weather, which we have finally been experiencing in Northern Illinois. It eventually gets to the point where we can drive it, but then might die at a stop sign, or it can go the rest of the day and not have any difficulties. I know later models have timing chains, not belts. Does our car have a timing belt problem or maybe fuel pump? And why only in warm weather?
View 7 Replies2002 Excursion, 7.3L 375,xxx miles ... As the weather is cooling off, my excursion has a starting problem for a few years.
Replaced all the glow plugs last year. We (my brothers and I) thought it was injectors, but in the summer time or if block heater is plugged in, she starts normally and idles smoothly. And no smoke and runs fine once she warms up.
When cold, it acts like 1 or 2 injectors are not firing. Have run all kinds of cleaners through the oil and fuel.....
Don't want to swap injectors just to swap parts. Would like to diagnose problem....
My car starts fine, when i want to change my gear to drive or reverse, its stuck on park, it wont move. My break lights do not work, i press the brakes and the back lights dont go on. The only way for me to unlock the gear is i have a spare and with my car running i put the spare key in a hole that is next to the gear and it unlocks. What it could be?
View 4 RepliesSo after work tonight I went to start truck it turned over fine but wouldn't start, when it finally did it barely ran and then it was fine, I had it b4 when I start it would turn over for a little bit b4 starting, would that be fuel pump?
View 1 RepliesThe Engine cranks over fine, but won't start. When it does start everything is okay and it runs good with no codes. I noticed that by taking the key out of the ignition, I was checking under the hood, and put it back in the truck fired right up. Also it has never done this to the second driver who has a different key. The truck runs fine at all speeds and loads, even when hauling twenty bags of wet mulch. It's a 2001, 4.6 L, RWD. Could the PATS Chip be failing?
View 9 RepliesAfter the details below, the truck finally started & I let it idle over an hr. Then turned it off for the night. Just to check, immediately tried restarting. Turned over very fast. Started once almost immediately & ran for 1 - 2 sec, then died. After that it turned over fine, but no attempt to fire - just as it's done in the past.
2000 F150, 5.4 L gas. Couple weeks ago it didn't start. Cranked fine - no sign of starting. It did this once a couple mo before that - wife was shopping & didn't start at the store. By time I got there, it had started. Her "solution" was loosened / retightened the gas cap (no, don't know why).
Never found a problem - didn't do it again for months. Then it did. Figured a code scanner would show something relevant to starting problem. It didn't - as far as codes go.
Couple weeks ago, battery was NOT dead by any means, but slightly weak (hadn't driven for couple weeks). I charged the battery (< 1 yr old). Seemed to take charge OK - didn't take long. But, after charging, volts at the battery = 12.8v.
Is it possible that's too low for these trucks & cause starting problem? It turned over quite fast - still no sign of firing. Gas isn't old. New Autolite spark plugs. Clean air filter.
I decided then to use the "jump start" setting on my charger (2 weeks ago) - still didn't fire & made no difference in cranking RPMs. Jacked around that day a couple of hrs. Checked all fuses (inside & under hood).
Bought the scanner - needed one anyway. Actron 9580A. All it shows on codes is a problem ABS wheel sensor (C1230) and a non-MIL code:
P1000: "OBDII Monitor / Drive cycle test not complete."
Suggested fix: "drive vehicle until drive cycle test is complete."
I don't think that's keeping it from starting. No idea about the drive cycle test. The battery hasn't been disconnected OR dead since I replaced it. It's certainly been driven hundreds of miles since new battery. Right after reading the codes today, decided to try starting. Didn't turn over quickly - battery somewhat low after 2 weeks w/o driving.
Surprise - it started - though didn't turn over fast. I let it idle some, then started recording data w/ the scanner. Where a couple weeks ago w/ the engine turning over like mad, it wouldn't start or even fire.
Note: only real difference in today (when finally started) & 2 weeks ago, or the time several months earlier: today is much cooler - in the 60's - vs. 90's the times it didn't start.
So, right back at square one - no signs of what's keeping it from starting. Maybe need some instructions on using more advanced features of the scanner / recording live data (if it starts again).
2002 f150 7700 with 5.4 triton and 4r100 tranny started chugging under acceleration and now stalls when put in D, 2 or 1. park and neutral are fine and reverse works perfectly.
Now when I put it in drive it chugs and stalls immediately... 1/10 times it will keep running but chug violently like its running out of gas. will get worse and stall if you press the gas. i can light the tires up for a block in reverse however.
Changed coils 1 2 and 3, IAC, bank 1 knock sensor, camshaft position sensor
So my aunt has a 2002 ford f150 king ranch 5.4l and a night ago it started this problem which when you put it in drive which she has to put it in 2nd for it when she pushs on the pedal it will rev up to 2500rpms than jerks and goes and its usely fine till she stops than goes and it does it again...
Than today it wouldn't even go in anything but reverse... So than we herd about the Range Sensor on the side of the transmission and it seems like it was it so I unplug it when it was running and when i push on the pedal and it revs up to 2500rpms it will go forward and have power. So we went to get a new range sensor after like 4 hours trying to get the dam thing off and another 2 to get it back on.. I started it up and only reverse works again... So I unplug the harness to it again and we got the gears but 1st and 2nd will just rev and go.
We at a lost right now i even tighten the shift screws under the dash cause our expedition was loose at one time and the gear shifter was loose like hers. But even tighten the bolts it still don't fix the looseness or even the gears.. Is this a transmission problem? OR even the torq covertor?
My girlfriend has a 2003 f150 4.6lt pick up its a great truck most of the time. Problem is when the temp gets in the neg double digits it becomes very hard to start it cranks fine but doesnt want to fire. When it does fire it might stall a few times before it stays running. The last cold snap we had I replaced the battery and in the summer the starter got changed. I have heard that this model of truck are known for hard cold starts. I am just wondering if this is true and any other thing besides block heater. It is strange that my 89 gm pickup will start no matter what temp and I'm having problems with the newer truck.
View 1 RepliesI've got a 2001 4.6 F150, starter spins just fine, but it won't start. Checked all the basics, but it has no spark, and no pulses at the injectors. Is the PCM dead? Wore out the Haynes manual on this one....
View 12 RepliesThis 97 F150 4.2 is new to me, originally a very base 2wd white fleet vehicle, with 189,000 miles, runs smoothly and quietly, idles well, transmission shifts smoothly. Gets reasonable gas mileage.
Problem statement: the truck has an intermittent starting problem. The failure to start happens about 5-10% of the time. The motor will turn over fine, but but immediately stumbles while trying to start. Turn key off and then re-start attempt will be again followed by a bucking stumble. Some times the motor might try and run for 2-3 seconds bucking and stumbling. It is possible the problem happens more often when the truck is warm and has been shut off for 15 minutes or so. Once the problem happens it is very repeatable. It won't start again unless I wait about 30 minutes to an hour. Once it starts it seems to run very nicely. I have noticed some times when I go to successfully start the truck it might run roughly for the first 3-4 seconds bucking and sputtering a bit and then smooth out and not have an issue until the next re-start attempt.
The truck runs so nicely when it is running I doubt it is an issue with the plugs, air filter general tune up. Could it be an intermittent fuel pump issue? The next time it occurs I will check fuel pressure. Could it be fuel pressure regulator? Also tested by fuel pressure. ECU? The truck runs very nicely most of time that seems like a long shot. Crank sensor? Bad fuel? I did add some dry gas.
My van starts sometimes and runs fine but sometimes it won't start. Acts like not getting fuel. Once it does start it runs fine. Doesn't do it all the time but happening more frequently. The van will turn over but as soon as I let go of the gas pedal it just turns off. I have put a new battery and changed the fuel filter. I don't think it's the fuel pump cuz it runs good once it starts?
View 3 RepliesSo my "farm truck" is idling very rough, to the point that sometimes that it stalls out. At high idle it runs fine but when its at a idle its very rough. Its been running fine until probably a month ago or so and its just getting worse. What it could be? I am thinking it might be that something is dirty but i just dont know where to start with figuring out what the problem is.
View 9 RepliesI have a 01 f-150, 4.6L, with 160k miles on it. Symptoms: It idles fine with an occasional surge. It sputters in all gears like a misfire (all plugs and COPS replaced 2 months ago). Sometimes it stalls out going down highway or as I turn in my driveway. It also seems like its slipping a little without the "hard jerking into gear". Occasionally the rpm meter will peg low and then return to normal.
The only code that I received was P1451. I changed the canister vent solenoid but the symptoms remain. I've checked voltage on the TPS (the variable voltage checked out but I didn't get the 5V ref. voltage). I've cleaned the MAF sensor. I've also changed the fuel filter. I've resistance checked the connector to the PCM and found several pins that are at ground. I'm not sure what to do next.
I have a 2002 F150 super cab with the 5.4 liter v8. I hit a large water puddle on my way to work Tuesday. I was going faster than I probably should have been. After hitting the puddle the truck lost power. It idles fine but as soon as I put it in gear it sputters and has no power. Also, the O/D drive light is now flashing. What might be going on with it.
View 4 RepliesI've got a cold start problem. Turn it on, wait until glow plug light goes off, hit the starter and it fires right up. It acts like it runs out of fuel and dies. Hit the starter and it fires up and dies again. Third time it stays running. It's not a long crank either. 1-2 seconds at most. Fuel pressure is 59, HPOP immediately goes 1000+, everything looks good. It will start fine the rest of the day until it sits overnight. This is an early 04.
View 14 Replies