Ford F-150 - 1997-2003 :: Truck Suddenly Shut Down And Now No Spark
Jul 20, 2015
1997 F150 4x4 4.6. Truck was running fine ...suddenly shut down & now no spark, no fuel pump run, no start
1. Shot ether -no start
2. pulled plug - no spark
3. Checked crank sensor - reading .5 - .6
4. Checked fuel inertia switch - seems good
5. Switched fuel relays - no change
Thinking ECM/PCM. Also.. ?? will the "no spark" condition create a "no fuel pump run" condition ? or visa versa? I'm not positive about the reading from the crank sensor... it stays solid at .5... should it move up & down or remain constant ?
View 5 Replies
Advertisement
All of a sudden my 2002 F150 6cyl, will crank but won't start. First thing I did was hook up my timing light to see if I'm getting spark when I crank. Tried a few different plug wires.....no spark. Can a coil just go out like that? I have a multimeter, what do I check to see if the plug that goes to the coil is providing correct power and input?
View 14 Replies
My Truck : 1999 Ford F-150 Extended Cab 4x4 5.4L V8
So the other day I was driving the truck and it just dies on me. Tried starting but it just cranked and cranked. Got it pulled over to a parking lot and then tried to start and I got it to run again. Died a couple mins later uo the road and it will not start at all anymore. I got it towed to my driveway and I've started diagnosing some things.
I dropped the tank thinking it was a pump I replaced awhile back. The pump wasn't running but jumped to conclusions and took it back to the auto parts store. They bench tested and it works fine. I checked for voltage at the pump connector. NOTHING. So I'm not getting power to Fuel pump. Then I checked the fuse and relay for the fuel pump. Everything was okay.
I did some research and decided to check for spark. NO SPARK. Another thing I noticed the other day was that the odometer is displaying all dashes. So I'm really unsure on what to really troubleshoot. I am going back to the truck tomorrow to check a few other things. I'm not sure if the Theft light is blinking or not so I will check that tomorrow and get back to you.
What to check? Any other relays or fuses besides the fuel pump? What about any modules to check like PCM, GEM, etc. Or I've heard the crankshaft sensor could be an issue.
View 14 Replies
Last weekend my number 4 spark plug blew out while on the highway. The truck stayed on long enough for me to get off the highway and pull over before it died. I towed the truck home. Last night I repaired it with a helicoil and replace the spark plug and coil. Now the truck cranks but won't start. I noticed that my theft light flashes fast and doesn't stop after a few seconds or during cranking. I still haven't tested relays or fuses because it was late after the repair. I will be checking those tonight.
I will be reading and taking suggestions and posting my results tonight while I'm working on the truck. I will be checking the fuel pump and PCM relay tonight. I will also try 2 different keys and checking the Inertia switch on the fuel pump to see if that tripped. The truck is a 2001 F-150 Lariat Supercrew with 150k miles on it. 5.4 liter engine.
View 9 Replies
I have a 2001 F150 4.6L auto. This truck suddenly started running rough. Cleared all codes and re-scanned after starting truck. The codes are as follows; P0135, P0155, P0443, P0740, P0743, P0758, P1451, P1460, P1747, and P1760.
My question is; is it normal to have this many DTCs come up at once? Could my PCM be faulty causing this problem? Can you swap a pcm from the same year truck with the same options without reprogramming?
View 2 Replies
Truck in question is 2002 F150 4.6 with 150K miles. Crew was on interstate tonight driving 65 MPH and truck shut off. They called me out to trouble shoot. Engine had oil (was a quart low) and will not start. Starter engages but will not turn motor over. Had truck towed back to my shop. I removed belt just to see if it may be a locked up pulley i know, long shot)... it was not.
Employed called a shade tree mechanic he knows and trusts. He said was likely a broken timing chain and that is a common problem in 4.6. Said locked engine is probably because broken chain is wrapped around shaft. When I turn key fan does move about 1/4 inch.
1) Does this sound like a possibility or even a plausible explanation? Just trying to verify the information.
2) If this is the case, would a repair be advisable, or is engine likely shot and i should just replace it?
View 4 Replies
I bought a 01 F150 with the 5.4 motor in it not much over a year ago. The truck needed quite a few things but the price was right. I have been dreading fixing one issue I knew about when I bought the truck. I figured I would ask here before contemplating taking my 12 year old truck to ford.
I have done quite a bit of reading about the airbag codes and in some cases people suggested the passenger switch led can burn out causing the light to occur. Here's what I know,
The truck has not been in a accident. I bought it from the owners son who only knew where to put gas in the truck. The father took care of the truck and he assured me it was not accident related for what it's worth.
Upon start up there are no flashes of the airbag light. From the time the key is turned ign. on to the time I shut the truck off it is a solid light. Early this spring I soldered a new led in the passenger on/ off switch with no change. I wonder if the switch is bad but I did not see a proper way to test it.
A airbag light code reader would seem to possibility but I have not seen any auto-part stores that borrow that type and my obd2 scanner cannot pull those codes. Where to start with troubleshooting?
View 3 Replies
My 2001 f150 is having a issue with the dome light. Sometimes when I park with the truck leaning to the right the dome light won't shut off when closing the door. What is the name of the switch that shuts the dome off? I assume it is located behind the kick panel.
View 1 Replies
My emergency fuel shut off switch triggers when my truck sits. Never on the road. Why would it do this?
View 3 Replies
I have a ford ranger 1996 4 cylinder. The truck was driving fine then all of the sudden it shut off and wouldn't start... I checked spark and that is fine also changed fuel pump and made no difference. We also sprayed lighter fluid and that did nothing. It sounds like it wants to start but wont.
View 10 Replies
On Monday, I was driving my 03 Ford Taurus. I had my cruise set at 57mph, all the sudden I started slowing down. I pushed the gas to the floor to try speeding up, but I kept slowing down. The car never shut off. I still had all of the electronics and the motor was still running, had my power steering as well. I pulled over and shut the car off. I started it back up and continued down the road and it happened again. Same thing, slowed down and pressing the gas and no speed. This happened 5 times within 65 miles. I got to my destination and was there for about 15 minutes, when I made the return trip. On my way home, I didn't experience this issue at all. What the cause may be?
View 10 Replies
Ok after rebuilding trans and being down a couple of weeks, I went on my 1st run since completing. Noticed when I started truck this morning it didn't turn over as fast as it was. 30 miles down the road Airbag Light comes on, and then volt meter dropped to 8 volts. Got stopped with truck still idling checked everything I had the tools to do so for. Decided to get back to my shop where I had tools, and 5 more miles and 55 mph truck just shuts off. Lost all power, truck would only click. Put my booster box on battery and gauges went back to normal but still wouldn't turn over but maybe once? Only place within a mile of my location was Walmart. Bought 2 new group 65 batteries, installed them and Shazam cranked right up no more problems. Short of the story bad batteries that checked Good with a load tester don't mean squat!
View 10 Replies
I am fairly new to powerstrokes, but have a general understanding how the 7.3l operates, and how the fuel system works.
The problem i am experiencing is a crank, no start. The truck has been great for the year and a half that i have owned it. Always cranked great and never any starting or running issues. One day upon cranking, i started the motor; it started normal running good for a minute until the motor suddenly started shuttering and then the motor shut off, happened rather quickly. The truck started up immediately after that and died....repeating the shutter until dead. Now the truck will not start.
Specs on truck:
2002 7.3l
230,000 miles
Manual transmission
Here's what i have replaced so far:
New parts include:
IPR (motorcraft)
ICP (motorcraft)
EBPV (napa)
CPS (napa)
IDM (reman)
Here are some of the diagnostic values i have collected during cranking: (FYI: i am a little confused on what the values mean and what they should be in order for the motor to start):
ICP: 2218 psi
ICP duty cycle: 41%
EBP: 265 kpa
battery voltage: 12.0
Rpm: 355
Things i have checked so far:
Oil is new and level is good.
WTS light cycles as normal.
Fuel bowl is full and over flows with cap off while cranking.
Fuel tank is above half.
Glow plug relay is good.
I was throwing a code for the PCM, but i removed the bully dog tuner and the code has since cleared.
HPOP oil is an inch below full.
I made a gauge set and dead headed HPOP yielding 1500psi.
Upon cranking i am seeing some smoke, i guess, but its kind of hard to tell from the drivers seat.
This is where i am at so far. I don't have a way to buzz test the injectors or tell if they are leaking past the orings. I have the valve covers removed, but i have been putting off pulling the injectors to replace the orings.
View 14 Replies
I have a 2003 Elantra 2.0 with no spark, no codes... anymore. The car was driven about 6 miles, shut off, went back out to start it, it ran for 10 seconds then shut down. Now it will not restart.
What I did: As per some of the advice of others I replaced the crank sensor, cam sensor, ignition coil, check compression, pulled codes from the ecu with one being a crank sensor. I have power at the fuel pump during crank, i can smell gas during crank, plugs are dry just no spark. Timing belt and timing are fine, engine sounds as it should during crank but no spark. There is power at the coils, crank and cam sensors. MIL is on when key is turned and goes off during crank.
View 14 Replies
I own a 2003 Chrysler town and country. I was driving home and all of a sudden the car just shut off. I coasted to the side of the road and tried to restart and nothing. The warning signals( i.e., seat belt etc.) came on normal but when I turned the key nothing no sound. I have no clue as to what is wrong with it. Had it towed home and here it sits.
View 6 Replies
I have a 1997 F150 4.6 V8 and as we all know these trucks are notorious for the spark plug blowing out. Although when I bought it I never had an issue until we put motorcraft plugs in. After a couple weeks of having these plugs in the porcelain blew out of the plug with the threads still in the head. The spark plug screws into a threaded insert which then screws into the head. We replaced the plug and nearly a month later the porcelain blew again. Replaced it, same story a week and a half later. Before the motorcraft plugs I had autolites in it, and I never had the slightest spark plug blowout problem. Should I just put an autolite in the cylinder that's blowing them?
View 4 Replies
I had a plug blowout last Thursday on the freeway. I wasn't sure of what happened with my truck, it was a shutgun going off. I had to towed to my local Firestone.
My truck is a F-150 4.6 2003 with 206,000 miles.
The short of the story, plug #3 blowout. It trashed the coil and I needed a new plug. They used a Helicoli and I have been reading that they shouldn't have used a Helicoli. They should have used a Time-set.
What's wrong with the Helicoli's? Is this fixed going to last for awhile? They said the helicoli worked well. The truck had 7 NGKs and 1 motorcraft. It has all new motorcrafts now.
View 12 Replies
No start, gets fuel, check injector plugs they lite. Ran fine shut it off went to re start and no go. Gets no spark what controls it?
View 2 Replies
I recently took a 4.6 from a 98 e-150 van and put in a 1997 f 150. put new oil pump, bearings, and rings. Got everything hooked up and ready to roll. turn over but no spark to any cyl. What it might be?
View 14 Replies
I have a 99 7.3, I took off driving the other day and after about 10 minutes the truck just dies like I shut the key off but everything was still on. I tried to restart it and it would fire for just a sec then die. I set for about 15 minutes and tried again it fired up and ran about 5 mins then the same thing. I had a buddy hook it up to his scanner and it has a p0605 and another icp code.. We changed the icp then erased the codes.. Ran some rest through the scan took with the truck running and no codes so we took it for a drive made it about 20 minutes away and same thing but this time has the p0605 code again. Could the pcm be bad? I also noticed the electric pump is always on all the time it will cycle at least 30 seconds every time the key is turned??
View 14 Replies
Had it before, code p1401. Changed out dpfe and it worked for 6 months. Now spark knock again. Now though I have no codes though. No vacuum leaks that I can find. New egr from before I had the problem. I applied vacuum to the green hose and it stumbled so the ports should be ok. Snytime I go above 3000 rpm i get the pinging. I replaced the dpfe again and no difference.
View 3 Replies
