Ford F-150 (2004-2008) :: 2005 - Clunk Noises Several Times When In 4 Wheel
Aug 19, 2013
My 2005 150 4X4 made a "clunk" noises several times when in 4 wheel this last weekend.
Sounded like the transfer case wasn't fully engaged.
This was after doing numerous 3 point turns on a dead end road to turn around. A real nightmare, cliffs on one side mountain on the other.
when we got back to relativity flat ground it ran fine with no more "clunking" noises.
It has 95K of hard miles on it. We didn't want to get stuck out of cell phone range, so we headed home.
View 3 Replies
Advertisement
When I turn the steering wheel all the way one way the truck dies and I was on the highway and getting off the highway and I was doing about 60 and put it in neutral and I was coasting and it died... when I put it in neutral the tach went down to idle then the needle went up to about 1500 and dropped back down to idle then the truck died.
View 5 Replies
I have a 2005 F-150 with ESOF. When I turn the switch to 4x4 or 4low the lights on the dash will turn on but the front tires will not turn. I checked all the fuses and they were good. I'm not very familiar with this 4x4 system, what the issue is or on how to fix it?
View 3 Replies
I have a 2005 Ford F-150 with a 5.4L V8 engine. Few months ago I started getting this squeaking noise coming from the front tires when I turn the wheel. I took it to the mechanic and he said the ball joints need to be replaced. Do you think it's the only reason why this is happening? If not, what else? The noise is pretty bad and the ball joints have never been replaced before.
View 1 Replies
I bought a 2008 5.4l xlt about a year ago now. For the first time I took it on a trail that had a little mud. With my incredible wisdom, I decided to park the truck rather than wash it off. The next day the engine started making weird noises when I turned the steering wheel. After washing the truck it still made noises so I opened the hood. THE ENTIRE engine compartment is covered in a serious amount of mud. I feel that this has to be what started the noises when I turn. Mud dried in the wrong place? The noise sounds like a whine and its pitch matches the engine rpm until over 2500 where I don't really hear it anymore. Is there a way to flush the engine compartment?
View 7 Replies
Strange noise from what sounds like the suspension when I accelerate and then when I turn also. Truck was in Hawaii so that might have something to do with it. How do I get these noises to stop?
View 1 Replies
I own a 2004 Ranger 4x4 V6 4.0 Liter engine with 118,000 miles. This summer it has been experiencing a clunking/knocking noise for the first time. The noise only happens during days where temps are above 90 degrees and I've been driving for at least 10 minutes. I can hear and also feel the low pitch clunk through the steering wheel. It is more pronounced if I hold the bottom of the steering wheel. I park on concrete and have not seen any fluid leaks under the engine. The power steering fluid is not low. I've jacked up the truck to test tires. The tires do not wobble. A Ford mechanic has inspected the suspension and cannot find anything wrong. Of course when I took the truck to the mechanic is was a cooler morning.
View 8 Replies
I have a f150 with a 5.4 triton I have noises coming from the engine loud when cold get quiet as you increase rpm almost sounds like the valves if you go under truck noise gets louder truck has less than 68000 miles.
View 2 Replies
I've been having this ongoing clunk in the front of my 06 Avalon for about a month now. When I slightly hit the brake i'm getting almost a metal on metal clunk sound from right in front of the drivers side wheel area, or possibly on the other side wheel well area, and not sure if its related but a popping noise when i turn my wheel a certain way it seems.
Replaced:
Both CV axles
Both Rotors
Both transmission mount and engine mount (left and right side)
Dog Bone torque bar on top
Drivers side caliper
Control arms
Struts were replaced 6 months ago, and reused old mounts, so I took it out and replaced the strut mount with the bearing on passenger side only.
Control arms have been replaced 4 or 5 times in 6 months because they keep cracking, they are being installed correctly and still having the issue, they're slightly cracked right now (many tiny little rips in the rubber rear bushing of the front control arms) perhaps this is the problem and they're flexing too far? They're Dorman and ordered off of amazon. I have 2 replacement ones arriving tomorrow and will throw them in.
124k miles. I have had multiple shops look at it and cant figure it out, they said everything is tight. One shop said it was internal transmission.
View 6 Replies
I have a 2008 Ford Lariat F150 with 53k miles. The transmission seems like it slips at times. Here's the scenario. When I take off from a standstill and going through the gears at a normal acceleration pace, say I momentarily lighten the acceleration pace then try to resume. At that point, the transmission seems to slip momentarily, then bumps back into the pull mode. It feels like there is slack in the drivetrain until it re-engages, or like the lockup torque converter momentarily releases until the computer has time to react to the accelerator positioner calling for more. One guy said the transmission is, at that point, between two gears... either trying to decide to downshift or to upshift, but you can feel the surge in rpm momentarily until it decides ... then bump and your off and running again. If I push the O/D button, it stops doing it. What I can do? Because the dealer can't seem to get it to act up when they test drive it. It does it fairly regularly on me though.
View 4 Replies
I have changed my drivers side axle within a 10,000 mile period twice. I recently had my rack and pinion changed with sway bar links and front shocks. The problem existed before all of this so I know it was not a mechanics/ shop fault. I can hear my axle clunk only once when i'm turning the wheel and it only happens when I am on the brakes at the same time, if i turn with out pressure on the brakes it doesn't make a clunking sound. Every time I replace the axle the sound goes away for a couple of months than proceeds to come back. I can't pin point the problem, maybe its the hub assembly or the axle seal but none of it makes sense in my head.
View 2 Replies
For the last little while I have been having an issue with the 4wd in my 2006 F-150 with about 93k on the clock. Sometimes it would engage when I switched to 4H/4L and other times it wouldn't. A friend of mine works at a Ford dealership and said it could be the vacuum solenoid on the firewall going bad. So I bought a new one and as I removed the old one, noticed debris in one of the inlets. So I cleaned that out and neither old or new solved the problem. Then I went through ALL of the vacuum lines and found some debris in parts of them....
Cleaned them all out and still nothing. Then I got to thinking it may be the ESOF motor on the transfer case. Checked to make sure there was power to the plug, which there was. Removed the motor and turned switch, and the motor seemed to be working. Reattached the motor and the 4wd would engage/disengage without problem. Pretty much everywhere I went I would check it and it worked fine . Then all of a sudden it didn't . So I took the motor off, turned selector and it worked fine. No issues yesterday at all.
So, I am not sure if it is the motor going bad or not. Could there be a contact problem? I talked to a mechanic this morning and he told me to drive around with it in 4H for a while because more times than not it doesn't get used enough. I'm just not sure what could be going on...am I missing something?
View 8 Replies
I have 2006 single cab stx and the little orange airbag guy below the speedometer has been on over a year and a half and he always flashes a code 51, but I've never worried about it.
About a month ago I started occasionally getting the 5 beeps 5 times, and now it does it more frequently but not every time. The Passenger Airbag Light above the radio works properly. It comes on when I start the truck and then goes off. When I put weight on the seat (usually my Jack Russell who only weighs 14lbs) it turns on and stays, and if the seat belt is buckled with no weight it also stays on. This is proper function correct ?
I've tried things I've read from replacing or cleaning up the crash sensor in front of the radiator, even cleaned the connections under the seats with contact cleaner, pulled fuses and none of them are blown. Are the code 51 and the beeping alarm somehow connected ?
View 1 Replies
So our 2006 f150 fx4 has been having an issue with stiff steering... at times like it doesn't have power steering at all.
We recently had the lower ball joints on both sides replaced. Before that the upper control arm on the drivers side was also replaced.
There are days that it is better... other times not so much.
View 6 Replies
3 months ago.. I had my fan clutch replaced, along with alternator.. a few coils.. a belt and an oil change. While installing fan clutch the shop accidentally poked a hole in radiator so they got a new one ( After Market) and replaced it. After leaving the shop, I noticed the fan clutch was not rotating smoothly, it had a considerable wobble to it, so took it back and it was replaced..new one did same things.. so it was replaced again. Truck seemed fine after the 3rd one was installed, and then after a a 3 hour drive.. i pulled over to gas station, and while truck was at idle in park.. it started to run hot. Raised hood, there was no visible coolant in holding tank on side, so after a while.. i took cap off and as I released it... coolant started to bubble back into holding tank. I then started truck up.. it was fine rest of way home.
Over next few weeks, this happened 4 times.. ac will be on, truck sitting still at red light etc.. and truck will start to run hot. So i had a new thermostat installed, and also a new water pump. Took it to a guy who runs a shop i know and also had system vacuumed. ( it was burped prior). Thought we had it fixed.. NOPE.. did it again yesterday. So truck has had new fan clutch, new thermostat, new water pump, new coolant, new radiator.. and it still only runs hot if at idle.. and it wont do it all the time.. but about once a week.. it will... and it will go over to red.. and ill shut it off and after about 10 min.. turn back on and continue on my way.. What I noticed..and this may be a key piece of info to someone who may know what is going on... it seems that the times it has ran hot.. while at idle the fan clutch was off.. and once i reved engine up to 2500-3000 rpms.. I got clutch to engage and bam !!.. truck comes back down to normal temp.. midway on gauge .. AS long as I am driving down road.. no problems.
** Also as a sidenote.. my engine does have a engine coolant temp sensor on it. Part # DY 1025 motorcraft. On some vehicles.. this part tells the fan when to turn on.. not sure if it does on mine. Originally , I took truck in bc fan clutch was staying engaged to much..meaning fan was on all the time. So.. maybe it could be the sensor ?... now all the new fan clutchs that have been put on do not come on like they are suppose to.. work right sometimes.. other times.. truck has to be at high rpms to get it to engage.. not working right all the time at low rpms.
Are their fan clutch relays ?.. I have an electric fan clutch.. This seems to me that this is a fan clutch issue.. and this is the 3rd one on the truck.. came from autozone.. it is the correct one for truck and has a warranty. Mechanic now wants to try going with a ford fan clutch by motorcraft.. 2007 F150 5.4 V8 ...
View 3 Replies
So from my previous post of might having a tranny problem or differential issue, it turns out that my front passenger side wheel hub is bad. Here is the odd part......the front passenger side wheel has some side to side play and it does make a clunk noise but it spins freely. On the driver side, there doesn't seem to be any play but it has resistance when spinning the wheels. Are both front wheel hubs bad or just one?
View 1 Replies
I've been having this occasional starting issue with my truck. I turn the key and the engine acts like it's going to fire up, so I let go of the key and it doesn't start. Then I try to restart it and either it cranks and fires a few times before it starts, or it fires right up and the starter grinds because I couldn't let go of the key fast enough.
I've had this problem a few times before, but lately it seems to be happening more often. It works normally 98% of the time. Maybe I'm just not letting the engine crank long enough to get it to run before letting go of the key.
Also, the spark plugs were just changed 10k miles ago and when the truck is running it runs great.
View 14 Replies
I have a 2007 F150 with a 5.4. I am having an issue with my A/C and more.
Here are the symptoms:
1) A/C doesn't blow cold, at times.
2) Compressor not coming on, according to mechanic.
3) Engine sounds like a freight train, at times. Like on a super cold day and it has to work hard.
4) Very poor fuel mileage since this started.
I took it to a shop, and they said it was the engine cooling fan that would not come on. So I replaced it. Same issue. I then took it back and was told there is a wiring problem. After 3 days they couldn't find it. I needed my truck back and dropped it off again. Then they said it was the A/C compressor, maybe. They wanted to try it and then see what happened. I told them no way.
Temperature, according to the gauge is good. Noise comes and goes. Not dependent on anything. Weather, temperature, car heated up or dead cold. Just comes and goes.
View 3 Replies
So I recently bought a 2006 f150 XLT with a 5.4 and of course the previous owner failed to tell me that it has an annoying beeping problem. It chimes 25 times total about every 20 minutes of the truck running, I've read the owners manual and found that it could possibly have to do with the passenger air bag.
View 3 Replies
I have a 04 4.6 f150 4x4. I have had some off road wear on the truck but put a stop to it here recently. I have replaced ball joints , struts , sway bar linkage , hubs , and now have a clunking sound going over every bump no matter the speed. Everything is tight underneath while stopped, other than the front driveshaft. It seems to have too much play to me? What it could be ???
View 8 Replies
I've got a lifted 2006 F150 crew cab lariat and I understand mileage is poor 10-11 per mile. 35" tires under a pro comp 6" lift. I have changed out my plugs twice last year and am still very under powered. What else can i do? I also have a clunk when i accelerate, sound like the rear end or drive line possibly. Had my transfer case replaced recently by ford and don't remember the noise prior.
View 11 Replies