Ford F-150 (2004-2008) :: 2006 - Truck Trans Would Not Move Out Of Drive
Aug 8, 2011
Long delay bringing new travel trailer home last week. Shift cable not placed properly in retainer during assembly (there is NO way it popped out) and it was resting on exhaust manifold. Evidently towing camper made enough heat to burn through the shielding and truck trans would not move out of drive.
The good news is that I could climb under (getting too old for that stuff!) and put it into gear/park by hand. But of course I didn't know that for the first 4 hours.
View 8 Replies
Advertisement
I have an 08' 4x4 with the 5.4. When i back out of a parking spot for example the rear end "Clunks" when i but it in drive and give it gas to move. Also does the same when your driving fwd, put it in reverse and try to back up. I had a 98' 4x4 ranger that had the same noise under same circumstances and it was recalled and repaired.
View 12 Replies
I have a 2004 6.0 with the 5L110 transfer and torqueshift transmission. While test driving after installing everything, I didn't get 7 ft down the road and the tires locked up and she came to a dead stop. Now I only have reverse but I can still feel the tranny engaging into drive but will not move.
View 2 Replies
What should the idle be at for a 2004 f150 fx4. When I first start the stuck it jumps to about 1200 or so and then after a few seconds settles at about 500 and stays there at all stops. It seems to be smooth but when I let go of the brake, the truck doesn't really want to move forward. It is a crew cab so I know there is some weight there. If anything is wrong, what are some possible fixes.
View 3 Replies
My 06 f150 v6 auto died on the way to work last night. It said trans fault on the dash. The trans has been shifting fine no slipping no hard shifts. The trans has 113k I replaced the motor and it has 57k. Both have been working great until last night. I plugged my scanner up it had a bunch of codes so I cleared them and done a koeo test and got 10 codes.
P0141
P0161
P0740
P0743
P0748
P0750
P0753
P0755
P0758
P0962
With the key in the on position the truck was showing 27.3 psi on fuel.
View 8 Replies
Just fully rebuilt transmissin 4r75 replaced all planet gears clutches etc. Now with it all back together the speedo does not work on truck goes into limp mode. I replaced the vss sensor an no luck
View 8 Replies
I have a 2008 F-150. When moving gear selector from park to either reverse or drive, trans has a delay engaging. After engagement, it runs fine, shifts ok, downshifts ok....
View 7 Replies
Last night I backed up out of a parking space and when I put it in drive it wouldn't move. It seemed like the transmission was locked up. What happened? The truck was running fine. It's a 2002 Ford Ranger 3.0 with auto transmission. Getting it serviced? I'm tempted to go to a dealer. What the problem is? Repair costs? The fluid looks good - no burning smell.
View 5 Replies
I have an 03 Escape that is very difficult to start after it rains, if I open the hood and let it dry out for a few days it starts fine, however if I put it in drive or reverse and press the gas it will not move... if I hold the brake while it is in gear and give it gas it does not rev up, however if I put it back in neutral or park it revs up. I normally cover the hood with a tarp to prevent this from happening however I was shutting the tarp in the door and a lot of water got in the floor board of the truck I sucked it all out, that night the radio started playing all on its own, I came out to the truck turned the radio off it stop went back in came back a while later and it was on again, so I pulled the fuse... but there are two buttons that stay lit on the radio the preset button 1 and 2 stay on all the time and I can not figure it out either. This is my beach truck I only use it for that purpose..however it is fall fishing time and I really want to go...
View 4 Replies
I have a 2000 Excursion diesel 7.3. I drove it for an hour yesterday and it drove great. When I arrived home I left the truck running and put it in park. Checked the mailbox and jumped back in the truck and put it in drive and it would not move. Tried FWD and reverse. Moved a little in reverse.
I turned the truck off then cranked it back up put it in drive and it drove fine..... Took it for a test drive and seems fine.
Did the same thing today. Went to drop my kids off and I put it in park and left the engine running. Put it back into drive and it would not move.
Turned the vehicle off and back on. Put it in drive and it drove off fine.
Fluid is full, red and no burnt smell. Wondering if this is converter or electrical and how long I can drive it like this.
View 1 Replies
Truck moves fine in reverse but won't move in drive it is an automatic transmission...
View 12 Replies
Well I am not sure if i have trans problem or not. If I put the trans in drive and go through the gears when the RPM's get to about 2000 the truck almost stops accelerating, until you give it much more gas, this happens in every gear. but If you push the button to take it out of overdrive and drive like that it doesn't do it.
View 1 Replies
My wife's car, '06 explorer 4.0, experienced trans. slipping issues last year. The trans was replaced under extended warranty. Now it's doing the same thing. Warranty expired. The dealer claims they can't find a problem. It does it when you slow down at a light and then accelerate without stopping, or going around a corner and accelerating. It shifts but requires more rpm to move. Almost like I am dragging a piano or something.
View 2 Replies
I have a 2006 F350 4x4 dually (6.0 diesel obviously) automatic. It's got 200kml on it and a second motor (found the sticker on the valve cover). I just bought it a month ago and have only driven it like 100-150 miles. Previous owner imported it to Finland 3 years ago, but never registered and only drove it like 500-1000 miles (with temporary plates to carry his racer few times). Original owner was a company in Southern Midwest that had some equipment on back. (It's was sold as a chassis cab new.)
Now I was getting the truck tested for registration yesterday. Drove it there 30 miles (country roads and highways), no problems. Then we had to do the smog-test, which is a bitch. They rev the engine to limiter (4200rpm) couple of times and measure the particles flying out. Passed it flying colors, but when trying to pull out the transmission wont engage!
Shifter linkage ok. Oil in tranny clear and plenty. When I put on R or D the engine RMP rises very slightly (maybe 50-100 rpm) and then settles back. But nothing else happens.
Luckily got a friend with large flatbed that we used to carry my baby home. But now I don't know where to start... ...well, I do have couple of ideas what could be broken. Specially if there's something simpler than dropping the whole tranny out (it's HEAVY and it's cold&wet out there) and rebuilding the whole damn thing.
Previous owner told he had some shifting issues couple of years ago (maybe 500 miles ago) and they "rebuilt" the tranny. He DID replace the hydraulic "logic board" and solenoids + new packs while at it. Naturally new filter & oil too. He said the torque converter was "tested" to be in good condition and they used the old one. I can tell the tranny has been out of the truck and the seller felt legit (a car guy too).
View 14 Replies
06 with 5.4 and AT. It shudders in overdrive during light to no acceleration. I was told it was the converter. I was also told by a technician in a trans shop that the Trans-X additive for hypoid oil in a posi-trac was ok to use even though the back of the tube says "Not safe for automatic transmissions". Do this is accurate or if the guy was just blowing smoke?
View 5 Replies
I have a 2006 F150 4x4 5.4L 43000mi. My four wheel drive is not working. I have the dash mounted switch to switch it into 4x4 Hi 4x4 Low. When I put the switch into 4x4 Hi nothing happens. 4x4 does not engage, and the 4x4 Hi light on the dash does not illuminate. I get the same symptom when the switch is placed into 4x4 Low. I have checked all of the 4x4 fuses and they are ok. I checked all of the vacuum lines to the hubs and they appear to be intact. What I should check next? What would cause this?
View 14 Replies
I've got an 06 F150, 5.4l crew cab lariat. So to start, I had a programmer screw up my ECU, so when I got it re programmed at ford, everything works except for the ABS sensors. I recently had someone break into my truck and broke my stereo when they couldn't get it out. So I was driving home from work the other day and lost my whole instrument cluster, windows wouldn't roll up or down, wipers worked very slowly until not at all. shut off the truck and wouldn't restart. I jumped it and started it. ran fine. with the exception of the previous problems. I noticed when it got dark out that my my taillights and head lights were on very dimly with the switch off. Also hearing a clicking sound coming from under the truck, at the back of the cab and front of the bed. the only thing electric that's back there is the fuel pump (i believe). I am at a complete loss.
View 5 Replies
I have a 2006 F150 5.4L 3V with 105,000 miles on it. Recently, it has developed a misfire that is progressively getting worse. It happens when the truck is in overdrive, with engine RPM between about 1200 to 1800. Cruising at this RPM the truck runs great. If I increase the throttle, I develop a pronounced misfire. Once the truck down shifts out of OD and engine RPM exceeds 2000 RPM the misfire goes away. I have never had the CEL light come on during any of these events. The truck has the original plugs in it AFIK. I have not changed them.
View 6 Replies
i need a serpentine diagram of my truck in order to place it back on.
View 4 Replies
I need to change my plugs in my 06 5.4 122,000 miles truck is bucking and not right under acceleration but its my only transportation to work and I am afraid of breaking a plug and then having no clue what to do after that. Need input on making the plugs come out easier ...
View 6 Replies
I just went out to move my truck to take out garbage and it cranks but doesn't start. It is 4.6L 4WD. I sprayed ether in intake no change. Checked all fuses all good. It has been raining pretty hard the last 3 days and it has been sitting in rain all 3 days. I checked for codes with a simple code scanner no codes. But the code scanner I used is not able to do KOEO or KOER tests. I know it needs new plugs but it has never sputtered or died on me. Has slight misfire but not engine stopping. I havnt had any check engine lights or problems before.
View 3 Replies
