Ford F-150 (2004-2008) :: Truck Doesn't Really Want To Move Forward When Let Go Off Of The Brake
Mar 17, 2011
What should the idle be at for a 2004 f150 fx4. When I first start the stuck it jumps to about 1200 or so and then after a few seconds settles at about 500 and stays there at all stops. It seems to be smooth but when I let go of the brake, the truck doesn't really want to move forward. It is a crew cab so I know there is some weight there. If anything is wrong, what are some possible fixes.
View 3 Replies
Advertisement
Before I got my GX someone posted they had to press harder on the brake to keep the vehicle from moving forward. My truck idles at 550 rpm and the vehicle will barely move forward even with NO brake. Just resting my foot on the brake will hold it easily.
View 6 Replies
Long delay bringing new travel trailer home last week. Shift cable not placed properly in retainer during assembly (there is NO way it popped out) and it was resting on exhaust manifold. Evidently towing camper made enough heat to burn through the shielding and truck trans would not move out of drive.
The good news is that I could climb under (getting too old for that stuff!) and put it into gear/park by hand. But of course I didn't know that for the first 4 hours.
View 8 Replies
Have a 99 Ranger XLT, 4 cyl, manual transmission with 191K miles. Was running good as ever last night but went to start it this morning and throttle's stuck open, causing truck to move forward when in 1st gear. Even with clutch in, near impossible to get vehicle in or out of gear. Managed to get it into reverse, but truck was having none of it. What is the cause or causes of my trouble? Or how much the repairs might cost? I'm on the road so no chance of doing this myself.
View 2 Replies
I have an issue with something when I stop. When I apply the brakes and come to a complete stop, right when the forward motion is completely stopped the ex kind of rocks back on the shocks. When that happens the ex jerks just a little. Kind of like if the brakes were sticking to the rotor, or the shocks are sticking. Then when I start to accelerate it jerks again. How can I tell if the brake hoses are bad, calipers are bad, or if it's the caliper slide pins, or if the shocks are bad?
View 11 Replies
2008 Sonata 4Cyl
My Driver Seat Does not move Forward any more. It will go back, up & Down Just not Forward.
Is there a Seat Reset Switch somewhere I don't know about ? How do I troubleshoot this?
View 7 Replies
I had terrible issues driving in the snow /ice last month. The car literally would not move forward. I bought 4 new Michelin Tires (Weatherwise II) but am thinking I should put on Snow Tires. Can I put them on the front only since the car is FWD? Also, which tire to choose?
View 11 Replies
My emergency brake works fine when I am parked nose down; it prevents my truck from rolling forward. When I'm parked nose up, the e brake doesn't stop the truck from rolling backwards. 2.3L 1993 ford ranger manual trans.
View 3 Replies
At 2:30am this morning I looked out my window and saw my brake lights and third brake light come on for about 5 seconds and then go off. This scenario kept repeating itself. I went to drive my truck 2007, and the brake lights remained on even when the lights were turned off when I was driving. I also need to seal the third light. Brake regulator has been replaced.
View 2 Replies
I'm new here and I am having issues with my Lumina. It is a 93 Chevy Lumina Euro 3.1L 6 cylinder and has 192K miles on it. It has had one owner for the past ten years that I know for a fact.
Here's what happened. I was coming back home (2hr trip) The brakes had started making that roaring sound on the way down and had gotten worse when I got ready to make the trip home. Okay so I know the brake pads needed to be changed. No big deal. Well going down the road at 65mph I round a curve and my car starts making this REALLY LOUD grinding clattering noise. It took me forever to get it stopped. I will still in the road and I needed to get it out bc it was right around a curve. So I put it in drive and it wont move. So I put it in reverse and it moves just fine with no problems and no noises made. After backing it out of the road I tried to put it in drive. It moved forward a few inches and stopped like something was binding it up.
So here's the problem.. it will move in reverse with no problems at all and only creeps a couple of inches forward then stops. The harder you press on the gas the more it tries to lurch forward but will not move.. like it's caught on something.
We changed the rear brakes on it. Discovered that the driver side rear rotor and caliper were broke beyond repair so we replaced those too. Still the same.. moves forward a lil bit and stops but will go in reverse just fine. We don't seem to think its the tranny bc it pulls hard and seems to not have any problems pulling.. but its like something is bound up somewhere. That is the best way I know how to explain this situation.
View 8 Replies
My trailblazer will not move in reverse , and will barely move forward, i checked transmission fluid hot and it's not even on the dipstick but when it was cold. it was?? Do I add more or what?..
View 9 Replies
After washing my 08 GX and putting in the garage to wax dry I have found that the next time I get in it to drive-often a day or so later,the car will not move in reverse ( or forward) without me revving it up quite high to overcome the locked up pads on the rotors. Sometimes its even screeches the tires to get in unlocked. I just washed it and letting it sit outside for a bit to see if the sun will dry out the rotors/pads and that would work.
View 10 Replies
My 2004 expedition wont go into any gear the shifter will not move I changed the stop light brake switch and a 30 amp buss fuse I found blown and also the check engine light is on now too this was after I parked it I also changed a 30 amp buss fuse I found blown out but it still don't work the only way I can get it into gear is to push the little button under steering wheel...
View 2 Replies
I'm sure this is a common issue, but I don't know exactly what to search for. I have a 2001 F250 7.3L. When I stop my truck, with my foot on the brake, the steering absolutely doesn't work. I replaced the PS pump, which it needed, plus all the hoses and it got better, but the no steer problem while braking is still there. I have seen that an upgrade in pressure hoses may work?
View 1 Replies
On Friday I opened the liftgate using the button by the driver side and it was normal. I pressed the same button to close it and I heard a crunch type sound and went back to check if the lock closed on something but it was all clear. I tried opening and closing again using the driver side button and the key fob and it makes the beep beep sound and it sounds like something mechanical is going on back there but the door doesn't move. The button in the glove box has not been touched and I checked the fuse compartment in the hood of the car and it appears to be intact.
Now the door won't open or close unless I manually open it and close it. After the beep beep the door sounds like its attempting to open but it just stays closed. And when I manually open the door and try to push the button on the door itself, or by the key fob or by the driver side button, it also just makes the beep beep sound and sounds like its mechanically struggling to do something and just stays open.
On Saturday I went up to the snow. It was freezing cold and higher altitude and as I was unpacking the back I tried to close the liftgate manually and it wouldnt even close. It closed a few inches and then it seems like the pressurized hinges got stuck. I eventually got it to shut but now I'm not sure if the problem is those hinges or is it something electronic or is the lock of that door just messed up somehow.
View 9 Replies
My 2005 RX330 has 140,000 kms...and I am now witnessing frequent periods of hard steering. I even sometimes find that after I turn a corner, the steering wheel doesn't return back to straight as I move through the turn - I have to forcefully return the steering back to straight steering. There is plenty of power steering fluid, and there are no abnormal whining noises from the power steering assembly. And since the ease of power steering does still work...I suspect that a ball joint needs looked at.
View 14 Replies
It's an 04 F350 6.8L This past winter when it was cold I would start it up and it would rock forward and bounce back as is you shifted in to park while rolling. Now that it's warmed up it won't jerk forward but the whole body shakes only at start up. As much as I like the idea of of the raw torque being so powerful the truck twists with power I don't think that's the case.
View 5 Replies
1997 ford f150 automatic 4x4 was perfectly fine till today ,no slipping no warning nothing.pulled in the driveway and about 30 minutes later had to run out.the truck tried and pulled like it wanted to go while in drive but wouldn't.then i tried it in reverse and went fine like nothing is wrong.i put it back into drive accelerated for a minute then it went for about 15 miles.while at a red light tried to go and it wouldnt move but was able to put it in reverse to back out of the lane.so i had it tow roped back home and halfway there while accelerated about 10 miles into it it caught and ran fine till i slowed down.at home i changed the tranny filter and fluid.no foul smell,the fluid looked perfect,no metal nothing in the tranny pan,i tried to put it in 2wd and 4wd to see if it would go and still did nothing.after accelerating the gas a minute it pulled and tried to move forward but nothing.
View 9 Replies
I just purchased my 06 f150 about 6 months ago, now I am experiencing some issues!!!!! my reverse works fine but it will not go forward in any gear? nor 4 wheel, that leads me not thinking its the transmission but ppl have said otherwise including mechanics! i did get codes p0174 and p2106 throttle body p0720 put put speed circuit!!!!
View 6 Replies
2000 ranger v6 automatic trans electronic 4wd shift on the dash. Plowing snow all of the sudden lost both forward and reverse never slipped or made any noise. Transmission fluid is fine to the level and clean. Put in drive nothing and reverse nothing put it back in park you can hear the park paul trying to click in. Towed it back to the shop thinking maybe the transfer case was junk. Decided to check the actuator on the transfer case no power going to it, go back to the switch no power there either check the fuses both are good and have power. The question i have is could a bad GEM module cause all this? ps the windshield wipers do work.
View 6 Replies
I bought my wife a 2010 Explorer a couple years ago, nice car but when it gets to 0 or -0 it wont move. After idling for an hour and some persuasion with the throttle it will lunge forward and then there is no issue until it is shut off and cooled down again. I'm wondering if there could be water in the tranny and its freezing but there is no way to check it.
View 4 Replies
