Ford - Explorer :: 2006 - Trans Slipping - Shifts But Requires More RPM To Move?
May 26, 2015
My wife's car, '06 explorer 4.0, experienced trans. slipping issues last year. The trans was replaced under extended warranty. Now it's doing the same thing. Warranty expired. The dealer claims they can't find a problem. It does it when you slow down at a light and then accelerate without stopping, or going around a corner and accelerating. It shifts but requires more rpm to move. Almost like I am dragging a piano or something.
View 2 Replies
Advertisement
2002 CAvalier 2.2 automatic with 123'000 miles. I was asked to look at this car for a slipping trans problem.
I drove the car about 3 miles and in 1st and Reverse it feels normal, even on a steep hill, but once it shifts into a higher gear the trans slips and you can go only about 15mph.It is shifting, because if you move the shifter into a lower gear while traveling....you can feel it downshift.
There is a code of P0502 Vehicle speed sensor. and there is no Trans fluid visible thru the filler cap on the trans top.
Previously someone else worked on this car for the slipping trans....changed some sensors....but couldn't fix the problem. The owners don't know what parts he replaced. He works for a Tire outfit and I've known him to lean towards used parts a lot.The previous mechanic convinced them that it needs a new Cluster. I presume he means instrument cluster.
I have a feeling that he just threw parts at it hoping that something would stick.
I presume that he replaced the VSS, and it didn't cure the problem.Come to think of it....the code could be from before the other persons work. I should have cleared the code and test drove it again.
I'm looking at dropping the pan, replacing the filter, refill the fluid, and replace the VSS
My questions: Could a instrument cluster have anything to do with the shifting problem.
Is the level of trans fluid supposed to be above the ledge under the filler cap, or is there a "full level" plug in the side of the trans. If he replaced the VSS with a new one....and the fluid level is good....whats my next step.
View 15 Replies
My boyfriend bought a 1999 ford explorer, he put about 2,000 miles on it in four months... I believe it now has roughly 110,000... Now the other day, he was pulling out and shifted from reverse to drive, we heard like a loud clunk/thump noise... It shifts into drive, and revs but won't move, it feels like neutral... If you shift to second, first, or reverse it's fine... Tranny fluid is good... O/D is always engaged...
View 3 Replies
I have 99 f350 v10 4x4 and trans shifts great under light rpms but 2-3 shifts very hard. At wide open from about 35 mph it will shift down and take off like a bullet but wont shift until I lift my foot and then it bangs hard from 2-3. All other gears are smooth. I did some searching and have found some threads saying it could be an accumulator spring that is broken? Truck has 115,000 miles on it. love the truck but want to fix this before it does some damage.
View 1 Replies
Long delay bringing new travel trailer home last week. Shift cable not placed properly in retainer during assembly (there is NO way it popped out) and it was resting on exhaust manifold. Evidently towing camper made enough heat to burn through the shielding and truck trans would not move out of drive.
The good news is that I could climb under (getting too old for that stuff!) and put it into gear/park by hand. But of course I didn't know that for the first 4 hours.
View 8 Replies
my wife has an 06 with 77,xxx miles on it. as far as i know there has never been any tranny upkeep done on the vehicle. we have owned the care for approx 15 months. it doesnt act up all the time. it will shift real hard into reverse, feels like it is popping into it real bad. then at times it feels like it slips very little going into overdrive. and at times it will pop when shifted into drive. it is hard to predict, i thought maybe when it was warmed up and the fluid was warm it might not do this, but it does. i know nothing about this thing, the dealer wants me to bring it in so they can plug it in?
View 5 Replies
I have a 2006 F350 4x4 dually (6.0 diesel obviously) automatic. It's got 200kml on it and a second motor (found the sticker on the valve cover). I just bought it a month ago and have only driven it like 100-150 miles. Previous owner imported it to Finland 3 years ago, but never registered and only drove it like 500-1000 miles (with temporary plates to carry his racer few times). Original owner was a company in Southern Midwest that had some equipment on back. (It's was sold as a chassis cab new.)
Now I was getting the truck tested for registration yesterday. Drove it there 30 miles (country roads and highways), no problems. Then we had to do the smog-test, which is a bitch. They rev the engine to limiter (4200rpm) couple of times and measure the particles flying out. Passed it flying colors, but when trying to pull out the transmission wont engage!
Shifter linkage ok. Oil in tranny clear and plenty. When I put on R or D the engine RMP rises very slightly (maybe 50-100 rpm) and then settles back. But nothing else happens.
Luckily got a friend with large flatbed that we used to carry my baby home. But now I don't know where to start... ...well, I do have couple of ideas what could be broken. Specially if there's something simpler than dropping the whole tranny out (it's HEAVY and it's cold&wet out there) and rebuilding the whole damn thing.
Previous owner told he had some shifting issues couple of years ago (maybe 500 miles ago) and they "rebuilt" the tranny. He DID replace the hydraulic "logic board" and solenoids + new packs while at it. Naturally new filter & oil too. He said the torque converter was "tested" to be in good condition and they used the old one. I can tell the tranny has been out of the truck and the seller felt legit (a car guy too).
View 14 Replies
Tranny started acting funny recently...shifting hard into reverse at first, then last night it was like it was stuck in high gear or slipping on the way home. Limped it home and took the following codes:
P0743 TORQUE CONVERTER CIRCUIT ELECTRICAL
P0750 SHIFT SOLENOID A MALFUNCTION
P0755 SHIFT SOLENOID B MALFUNCTION
P0760 SHIFT SOLENOID C MALFUNCTION
P0765 SHIFT SOLENOID D MALFUNCTION
P0962 PRESSURE CONTROL SOLENOID A CONTROL CIRCUIT LOW
P0966 PRESSURE CONTROL SOLENOID B CONTROL CIRCUIT LOW
P0970 PRESSURE CONTROL SOLENOID C CONTROL CIRCTUT LOW
View 1 Replies
I have a 95 f150 5.0 with a 4r70w Trans. What to check now no overdrive Trans shifts and drives great but no od the od off light on shifter is lit up and just never goes into overdrive solenoids have been replaced and new shift lever and button where do I go from here is not throwing any codes...
View 7 Replies
Feels like my transmission is slipping from 40m/hr to 65m/hr. But only when I am at a constant speed and not when i am accelerating. only happens when I am at approximately 1400rpms and while in overdrive. Does not happen in any other gear just overdrive.
View 1 Replies
1996 F250. I think its a Ford works great until yesterday. Put it in reverse had to rev it up to get it to move and when it did kind shook and sliped an does back up but doesn't like it....
View 5 Replies
2007 escape 4wd 3.0. I've notice some random hard shifts for the past month and today the trans has trouble shifting out of 1st. If I get the rpms between 3,000-4,000 and ease off the accelerator pedal it shifts into 2nd without drama. It will not shift at lower rpms with the same easing off the pedal. The trans light is steadily blinking.
View 7 Replies
Ok so when I come to a full stop my truck doesn't want to shift right when I take off where do I need to start looking
View 7 Replies
2001 7.3 auto, 2wdr, 291,000, Transmission sometimes shifts hard from 1st-2nd, 2nd-3rd. Problem started after I found trans dip stick tube broken and loss of fluid. Anything I can do without going to a shop. I've replaced the Broken Tube.
View 2 Replies
I have a 1997 F150 4 x 4 with the 5.4 overdrive transmission. When I accelerate from a stop I can feel the slip of the transmission until I reach exactly 35 miles an hour. Above 35 seems to be normal and have plenty of torque.
The funny thing about this is I have had a 2001 Windstar same 35 miles an hour. I have also owned a 1997 Ford Explorer with this exact same issue. Three different motor and trans combination that will not lock up until you reach 35 miles an hour.
The truck has 213,000 I have replaced all coils fuel filters catalytic converter and torque converter. Have exterior tranny cooler. engine runs good and strong. And no code I have a reader.
View 6 Replies
So ever since I picked up the truck from getting the springs swapped out the tranny has started to slip more and more. It's about at the point now where it does it at the 1-2 and 2-3 gear change every time unless I give it a little throttle so it shifts harder. It's just the normal shifting pause and then the slight jerk when the next gear starts. Time to a new torque converter, or am I looking at getting my whole thing rebuilt? If it's the converter I can give that a shot myself but if I have to have it rebuilt it's going to have to wait until January or February.
View 14 Replies
2002 Escape XLS 2.0L 4-cyl 5MT FWD. Slipping Clutch.
I've read here n there that the Escape clutch is a poor design & others have reported that a clutch repair doesn't solve their shuddering problem. After putting off the job for a while, I'd like to replace the clutch.
Here's a topic from here : Manual Transmission shudder / fill & drain access?
View 2 Replies
I have a 99 Ranger 3.0L automatic, ext cab, 2 wheel drive. Door sticker show code "T" which I looked up as the 4R44E. The trans seems to be slipping in 1st and 2nd. Thought it was "reared shudder", from a "limited slip" differential but mine is not limited slip. just the regular 8.8 with 373 gears.
Wanting to know what if any options I have for buying a new / rebuilt tranny? I've seen where depending upon the year and motor, Ranger can have 4r44e, 4r55e, 5r55e, etc.
View 3 Replies
I have a 1989 tioga 460ford and the trans appears to be slipping when i get around 50mph. The engine revs up but it won't go more than 50. The engine again revs up but there does not feel like the power of the engine is being transferred to the trans. the coach runs fine up until i try to go beyond 50. I have 34000 miles on the rig. Some one suggested that I check the catalytic converter. what else should i look for?
View 2 Replies
Ok so here is my problem now. I'm sure its in the tramny but not sure what else. My shift from 3-5 has always been a little hard. Yesterday on my way to work I noticed shifts 1 thru 3 were hitting hard. Once I got up to 65 mph it was okay. Then pulling into work when I shifted to reverse it didn't go into gear right away and then it would hit into gear. Later that evening on my way home from work it was shifting the same but seemed worse. Then my tow/haul light started flashing and it seemed like the torque convertor wouldn't lock in. It would just stay in 5th gear and the more throttle I gave it the rpms would go up but I would only get a little response from it. Then a few miles down the road it just completely shut off on me. It will not even try to turn over. I could also hear a noise coming from underneath the truck. Something ive never heard before. I really need to figure this out
View 14 Replies
I recently purchased a 04 f250 with the 6.0l powerstroke. I drove it for about 3 weeks now, Ive put my trailer behind it with small loads and just today tried to use the tow/haul button. When you go to pull out the tranny never shifts from first gear?? Its pulls and runs fine until you push the buttan and no shifting........
View 6 Replies
