Ford F-150 (2004-2008) :: Truck Missing Pretty Bad Going Uphill Or Under Load
Oct 25, 2015
I have a 2008 XL 4.2 auto trans with 60,000 miles on it. We purchased a new travel trailer with a total weight just under 5000 lbs that we pulled for about 2000 miles this summer. On the last trip we noticed the truck was missing pretty bad going up hills or under load. After we got home I started to notice the miss at times even not towing. Did a tune up with Motocraft plus and wires and seems to still have a miss at an idle and very low RPM. What would be best to check next?? Would Coil be logical?
View 10 Replies
Advertisement
2005 Ford F150 lariat 5.4
I had a misfire under a bit of a load (acceleration) and up hills. I changed spark plus with OEM Motor craft ones, truck ran super nice for a couple week.
Had the engine light flash, slow down and the RPM go up a tiny bit then back down and the light goes off
Now I'm back to miss fire different location, and a rough idle. I've swapped coil packs around and the miss fire stayed on cylinder 4.
Spark plug screwed or injector or ?????
View 14 Replies
I have a 2004 150 with 165,000 miles I sometimes pull a 5 by 8 trailer. when pulling trailer in overdrive and excelorating the engone will cough several times. I took it to a mechanic and he told me that there was nothing he could do that I needed a new engine. I can pull trailer out of overdrive with no problem. don't undrstand why I need new engine....
View 3 Replies
My truck decided to have some issues last weekend coming home from a friends house. After being on the road for about an hour the truck shuddered, lost speed and was incredibly sluggish trying to get up the hill. It flashed the CEL and then went out. I was doing about 75 with the cruise on.
After slowing down to about 60 it stopped the shuddering and resumed operations as normal. Until about 20 minutes later when it repeated the above.
The next day I grabbed my reader and found the P0302 and P0306 codes. I cleared the codes and took it for a "test" drive up and down the mountain to see if it would trip the codes again. It didn't flip the codes. I thought I might have been dealing with a "one off" issue and left it alone for a few days.
Two days ago the CEL light came on and stayed on this time. Sure enough P0306. Cylinder 2 did not throw a code this time. After doing some research on here I ordered two new COPs and bought a mechanics stethoscope and some new spark plugs just in case.
The stethoscope confirms that cylinder 6 is having some issues. The COPs came in today so I'll take it apart tomorrow and see what I see. I'll be looking at both the COPs and the plugs to see what may be causing the problem. The "nice" thing about this is that at least it's one of the easier COPs to get to.
Should be a nice day for working on the truck.
View 7 Replies
2006 fx4 f150 5.4 flex 52,000 miles ... Just got home from a 800 mile round trip vacation, seems I've developed a miss or a tranny problem. The truck runs/idles fine, shifts fine, everything is as normal. Except maybe 12 times while under a load, like climbing a hill, the truck would "bump" that's the only way I can describe it. I only noticed it in Drive/Overdrive. I hoped I had water in the gas so I added gas treatment at 2 fill ups, still seems to do it occasionally. Where to start? I'm going to get a fuel filter today, the one that's on it only has about 12k on it....
View 13 Replies
My truck trailer connection has no power to the + pin, called the Trailer Tow Battery Charge. I traced back to the fuses and relays and discovered the relay missing. Unbelievably Ford is having a hard time with this relay. They don't seem to be sure which one it is. My owner's manual says it is a Full ISO relay. But Ford doesn't like that description.
What can I use there? Is there any after market relay available that would fit. Napa said they don't have anything listed, and O'Reilly and Autozone look at me with a stupid expression. I also need one for the starter relay. Mine was replaced with a anti theft device that has a remote control. I want that removed so I need the realy.
All the relays appear to be the same. I plugged in the blower motor relay in the trailer tow charge position and got power to the + pin. But I need the blower motor. The Ford guy said that it might be the right one, but he couldn't be certain and if I plug it in and it doesn't work it's my loss.
This is for the 2006 F-150, 4.6l truck.
View 5 Replies
I was towing my camper uphill and my 03 6.0 started missing and blowing black kid smoke. Next thing I know I hear a loud pop and steam is coming from under the hood and the truck dies. I pull over and discover the degas lid is stuck on and the bottle came apart at the the seam and the truck will not start. 6.0 with 120k miles
View 1 Replies
I just replaced my drivers side wheel bearing that was squealing pretty bad. After replacing it I now have the same noise only consistent where before it was only when I turned the wheel to the right. I noticed the teeth in the cv shaft where a little warn down when I changed the hub. Now also along with that noise I'm getting a clunking sound. Should I just change the cv shaft or is there something else I need to be looking at?
View 1 Replies
I have a 1998 F150 5.4L 4WD with 192k mi on it. Recently ( suddenly ) the vehicle began shuttering pretty alerting under light load at 35 - 45mph. The engine idle was intermittently smooth then rough. I quickly drove the truck home and ran a Trouble Code check with my Autoxray EZ-scan 4000 and found the two trouble codes P0302 and P0171. I have checked for vacuum hose cracks and found none.
Replaced the fuel filter, PCV valve, and cleaned the MAF sensor ( dirty ).
Right after cleaning the MAF sensor the idle remained smooth - but stumbling immediately when put in drive. Driving at 35-45mph still exhibits intermittent shuttering and occasional very short bursts of what feel like complete engine shut-down. This all is evident under light to moderate load .
At this point what would you recommend ? Replacing the O2 sensor bank #1 ? Or is there a possibility maybe the EGR valve is faulty - or another vacuum valve somewhere ? Intake manifold leak ?
The severe stumbling and very short complete engine shut downs would indicate that maybe the computer is failing or it's a fuel delivery issue? What rational steps to take next ?
View 14 Replies
I have a 2000 f250 crew cab short bed 7.3 on a 6inch bds lift and 37 inch tires. When I accelerate pretty much any load above 1200 rpms I can feel a vibration, kinda feels like it may be coming from the front left but I'm not sure. I have heard that a wheel bearing going out can cause this, would this maybe be what's causing it?
I thought wheel bearing because it kind of sounds like there's a howl when decelerating, probably when accelerating as well but the trucks too loud and I can't hear it. or also have heard motor mount gone bad, I've also heard ujoints but the ujoints were done this summer. the front ujoint is bad but the front driveshaft shouldn't be turning when out of 4x4 and hubs unlocked.
View 4 Replies
So my 01 has been parked in the garage for about 2 months. Normally on battery tender but it accidentally got unplugged and I didn't realize til yesterday when I went to start it. So I got the battery charged up and put air in my rear drivers tire since every time it sits it goes flat. Well I did all this I so I could take it to get tires today.
Driving to work and its shaking pretty bad at highway speed. Don't recall it doing this yesterday. Never really did this before either. The truck also pulls hard to the right. Its done this for a while so I'm not sure if it's just the tires or needs alignment or something else. Or all of the above.
I'm mainly concerned with why it was shaking. The front tires don't look low however I will check the pressure on my lunch hour today.
View 13 Replies
i own a 2005 f150 supercrew fx4. Today as I was attempting to go out of town I was accelerating up hill and heard a noise, sounded like air coming through a window seal or scratching, which is not the problem. The noise only came on when i increased the acceleration, there is no power loss, the truck still accelerated properly and had good power, just that the noise came on. so i returned home only to hear the problem on flat land also, when pressing the gas to accelerate. The truck seems to idle fine and have no problem with low acceleration.
View 2 Replies
I have a 97 F150 4.2l auto 4x4. The truck seems to surge or hesitate at pretty much all speeds. I have had the truck on fords so-called super "sbds" computer and they found nothing. I am taking it tuesday to have the o'2 sensors and CAT. Convertors checked at a local parts/service store. Also found out today that my speedometer is 5 mph to slow (doing 65 but speedo only registers 60).
View 14 Replies
1999 F350 7.3 Super Duty surges when going uphill with a load. The only time we drive it is when towing the horse trailer - also has a camper on.
The truck doesn't physically surge, just the RPM gauge goes up and down and along with it a humming noise.
Also, What conditions should I engage the towing button on the end of the gear shift? I've heard several answers. Should it be engaged when towing or off?
View 2 Replies
Have a friend and looking at his truck for him. He was towing a boat and climbing a steep grade hill. As he described it, it felt like he lost all power. Did manage to get it to the top of the hill and stopped to check it out.
Noticed the under of the truck dripping oil. Checked the motor oil and none on the stick. Put 4 quarts in the motor, started it back up and oil pressure is good and motor sounds fine.
The strange thing is the motor is dry. Can not find where the oil leaked out. All the oil is located on the transmission and transfer case. I'm not too familiar with these Triton 5.4's but where could that oil possibly have come from? I'll re-look this morning.
Also, with oil in motor, and it is idling, there is no oil leak or drip anywhere. Is there a pressure regulator in this oil system and the load he was exerting cause it to release?
View 13 Replies
Have a problem with a stutter when I press the accelerator while going up hill. I even had this problem driving on a flat road but that was a 1 time thing and happens every time I go up hill. Had a coil replaced that came off of an '04 because one of mine went bad which caused it to shake whenever I came to a stop. Wondering if the coil has anything to do with it... 2007 5.4L ....
View 1 Replies
I have a 2004 f150 lariat crew cab 4x4 with the 5.4 3 valve. It now has 113 000 miles. Since i got it at 85 000 miles its had a hiss when the engine was under load. So like light acceleration or driving into wind. The guy i bought it from said that it had a manifold leak so that's what i figured it was. I got the manifold fixed and it still hisses. There are no check engine lights. It almost feels like my engine lags when it starts hissing. It sounds like its coming from right on the other side of the fire wall. What it could be?
View 3 Replies
I have a Lariat 4x4 supercrew cab with a CD 6 disc changer head unit. Error message. No Disc, and Load Error. Will not eject any of the 6 loaded CDs. Pulled/reset fuse. No luck. Banged on dash while trying to eject any of the loaded CDs.. no luck. Unit cycles when first starting the engine. Radio works fine. Unit locked up....Ford Mx tech says the solenoid that holds the CD is frozen in position and will not release.
View 3 Replies
Hard to describe sound, but it only happens under load. It happens at any speed, but more predominently at higher speeds. When I lift off the gas it stops. I can keep it going up hill since I'm maintaining speed rather than accelerating over the limit. The other day I heard another F150 beside me making the same noise going up a hill.
View 14 Replies
I have a 04 5.4 w/ a whipple supercharger. truck has 104k miles. Has a misfire in cyl 4 (p0304, p0316) And spark knock.. I've changed the plugs, coil on cyl 4, fuel filter, and today the o2 sensor(pass side upper, bank 2??). I've ran tecron injector cleaner threw it, and always used Chevron 90 octane. (highest in Alaska)
The noise only happens when under load, or accelerating with more then half the throttle. doesn't happen when i slowly get up to speed. What I could do next? About to take it to the dealer to run a full diagnostic test on it.. Also, does not hesitate or bog. drives normal just with that noise
View 5 Replies
My 4.2 liter F150 suddenly started missing under load. A little background: It is a late 2003 and has 75k miles. It has been in my family since new, and I have had it for the last 4 years. This truck is as stock as they come, and has been well maintained.
On my way to work yesterday, it began missing. Not bad at first, but got worse. It misses while under load and under acceleration. The "check engine light" never came on. I have not put fuel in in several days, and it ran fine until now, so I doubt it is bad fuel. I started the engine after dark and looked for arcing. None visible, and I even sprayed the wires with a mist of water. I pulled the plugs and they all look normal. The gaps were all way too large, so I regapped the plugs to .054". I pulled the coil pack and it checks within range with my VOM. Can the coil pack be the problem even though it checks out on the bench? Can the large plug gaps have contributed to a coil pack failure?
Where to start. I HATE just throwing parts at this thing, and I don't like wasting money... If I let one of the auto parts stores run a scan, will it show a code even though I have no check engine light? I used to think of myself as a pretty good diagnostician, but then again, when I used to spend a lot of time under the hood, those cars had points, condensers and carburetors...
View 4 Replies
