Ford F-150 (2009-2014) :: Transmission Works Overall But Shift Late And Creates A Mushy Feeling
Dec 12, 2012
I have a 2009, 4x4, 5.4L with 78k miles. The transmission works overall but it seems to shift late and creates a mushy feeling. If you put your foot down, it will downshift and take off so it's not a power issue. As I've read on this forum, mine also searches for the right gear often and overall seems to shift too much. Seems like a computer reflash would fix it as I think it's just the shift timing. Computer reflashed? Is this possible or available from the dealer?
View 4 Replies
Advertisement
So against my better judgement I rebuilt my C6 myself. It's all back together and in my 79 F150 2wd 400cu. It seems to not want to shift into 2nd on it's own. I can manually shift it into all the gears but 2nd feels like it slips. So here is a list of parts with questions:
I used Mercon V instead of Type F. The transmission is a 1987 and the bottle says it covers vehicles requiring Dextron/Mercon.
I installed a FF servo lever with a P servo. My kit didn't come with a new spring. What effect would a worn spring have?
When adjusting the band, I set it to 120in/lbs and backed it off 1.5 turns. This seemed very loose to me. It leaves the set screw finger tight/loose, so I tried turning it in 1/2 turn but that made no difference and I won't drive it until I readjust it. Also it's a RedEagle wide band, but that shouldn't make a difference.
One place I think I could have a problem is with the modulator. I didn't have a scale to do the 12.5 lbs method, but I had a big syringe, vacuum guage, tubing and t fitting. I could hold the -15" of mercury but the rod didn't go in to the notch like it said it should. I was going to stick the old one in but it's bent and the rod is missing. Will a bad or misadjusted modulator cause the tranny to slip in 2nd? I don't think it's inbetween gears because it does accelerate in 2nd.
I used the BadShoeProductions video along with a Ford Shop manual to assist me.
Complete list of replaced items:
New Modulator
F servo lever with P piston
All Friction and steels
Pressure plates for additional friction plates per video.
All Seals and gaskets
New wide band
New pump
Hughes torque converter
TransGo shift kit
New Sun Shell (Took my end play from .070 to .012)
Everything was cleaned and tested ok per video.
Then only problem with the video is it doesn't tell you what to do when you have a problem, only shows you how to tear down and reassemble.
I used a torque wrench for everything, but if it turns out it's a valve body problem then I will go back through it but only using a nut driver.
The kick down rod is working properly.
My gear selector is set properly.
View 3 Replies
2011 F-150 Scab 5.0L 25k miles. Why my transmission is waiting several seconds after being placed into drive or reverse before it actually slips into gear when first started in the morning and why it has a hard shift between 1st and 2nd than again between 2nd and 3rd and maybe why when it shifts into 2nd and 3rd gear it slips back out than back in?
View 7 Replies
I have a 2014 screw 4x4 v8 that has been in the shop 5 times now for something that the dealership can't duplicate, and that is intermittent enough for me that I can't determine what the conditions need to be in order to duplicate it myself.
My transmission will shift hard under two different situations:
1) when rolling through a stop, or a momentary stop at a stop sign, the transmission holds up between 3 and 1, and when I bring the rpms up, the transmission shifts down into 1, making a hard clunk;
2) at highway speeds, more so when using cruise, if I accelerate and the truck shifts down from 6 to 4, there will be a hard shift as well. In fact, when I'm on a long stretch of flat, open road using cruise at 70-75, I can feel a slight bump through the steering wheel and floorboard, as if the cruise is trying to engage the throttle a bit more, but only for a split second. But that will happen quite a few times within a couple miles until I come up on a grade and the throttle has to engage for a bit longer to keep speed. Sometimes, the hard shift will do occur going to 5 as well, but 90% of the time it will be a 6-4 shift. If the truck decides to shift from 6-3, there's no issue and it shifts and accelerates like it should.
Again, this is so intermittent, but when it happens, it happens several times. I've had the service tech ride in the truck with me, all the while not being able to duplicate the issue. I understand that these are learning transmissions, so the only thing I can think of is when I try to duplicate it by accelerating over and over, that the transmission adjusts the shift pattern or fluid pressure to compensate.
View 14 Replies
Starting to develop an issue where the trans will exhibit an extremely hard and abrupt shift every now and then - most only during the first couple hundred yards of driving and I think its the 1-2 shift. Only will happen once and only rarely but its becoming more frequent. I have an '11 5.0L supercab auto 4x4, but my father has a similar truck but with the ecoboost which does the same thing on a MUCH more frequent basis. He has been in numerous times with no resolution so I am loathe to expend the energy on "dealing" with them.
View 12 Replies
I have a 2013 with the 3.7 in it with 24,000 miles on it. I bought the truck used with 8,000 on it was a pre-Owned certified and it already had a k&n air intake which I know it's not needed and I would much rather have the factory intake instead.. 7 months ago I took it to the dealer because I noticed at stop lights it idled rough sometimes almost feeling like it was going to stall out so I took it in and they said that the motor was getting to much air and causing it to run like it was and they said the cooler weather was making it worse and said it should get better when it warms up and they said it wouldn't hurt anything... Well I live in Florida and it's been in the 90s and it still idles like crap you can feel the vibration through the truck...
And it's so aggravating and annoying and I wish I had a stock intake that I could install on the truck to see if it fixes the problem but I don't and I've researched the problem and have seen people with the same issues without the k&n air intake and I've also been told that the stock air intake gives the motor just as much air as the k&n so with that being said did the dealer take the easy way out and blame the intake or should they be responsible for installing the factory intake back on since they made it a certified pre-owned with the k&n on the truck? It's been frustrating because I don't know a whole lot about gas motors.. And I'd like to get the problem fixed while I still have warranty ..
View 8 Replies
Well it's been 300 miles since Ford applied their "special grease" and put on clamps to eliminate the clunk when slowing and the slipping feeling at take off. Now the clunk is back. Every time at 25 it downshifts and clunks, then once again at 10. Drives me nuts. My service advisor wants me to "log" these visits so we can be more aggressive with Ford to get this resolved. I love the truck, but this is annoying driveline slop. Almost like the splines weren't cut right and Ford is using heavy grease to fill the gaps......developing...
View 3 Replies
I have a 95 F250 with 7.5 and E4OD. I was towing my Jeep and trailer out for the weekend a few months back (its been parked since) and heard some noise coming from the trailer. So at a stop light I put it in park with the engine running for a second, went to put it back into drive and it hasn't gone back into drive since. Reverse works perfectly. Fortunately I was able to back up onto the center divide, unload my Jeep and back the truck onto the trailer and tow home with my buddies Chevy. Anyways, its been dead since. Where I can start to look? None of the forward gears work at all.
View 13 Replies
For the last week or so I noticed that my a/c wasnt working on the "1" setting, but the 2,3 and 4 settings worked fine. Last night leaving work, the blower was on the "3" setting and the blower suddenly just stopped blowing. I have cold air in max a/c mode only on 4, if I take it off of max a/c and just use the vents it will work intermittently on the 2 and 3 setting but never works on 1.
I know the 04-08 trucks had resister problems that would cause like symptoms, but I read somewhere that the entire system is different on these trucks. The truck has 4200 miles on it, so when I get off of work Wed off to the dealer it goes, I am just wondering what the problem might be for speculation purposes.
View 6 Replies
Perhaps it's always been this way but my trucks A/C fan speed seems to only blow air out on speeds 3 & 4 is this normal? I have a 2011 XLT, 5L but should be the same system no matter what motor.
View 9 Replies
I got my blazer look at and here what they come up with so far. Transmission fluid is discolored. Transmission shifts late between 3rd and 4th at 52 mph. Transmission slips between 2nd and 3rd gears at 32 mph. Lock up 41-43 mph in and out. I never told them this but I change the transmission fluid about a week before i took it there and when I check the fluid it was nice and clean and not burned like he said it was. He said most likely it internal damage.for them to take a look in side to see what is wrong with cost me 400.00 and I said no.
View 6 Replies
2009 F150 4wd.. I have no - power windows, door locks, radio, blinkers, will not shift out of park, no dome lights. all started last night after it was parked for about an hour the lights flashed on their own and when I went to leave this morning all of this is going on. I have :
- checked fuses - good
- checked for codes - none
Truck runs fine, you have to press the shift lock button to get it out of park,runs like normal.
View 2 Replies
I recently bought a 2010 f150 5.4 extended cab 4x4, i noticed when in traffic and the truck goes into 2nd gear just rolling slow when i come back to a stop it bangs going back into 1st?
View 6 Replies
Any solutions for the tranny/rear end hard shift from 1st to 2nd at low speeds on a 2011 f150xlt / off RD package with the 3.73 rear end/ elec lock. Had FORD do an update earlier and seems to be worse !!!!!. I will get a bang out of rear end when going over a speed bump and tranny shifts to 2nd. I am bringing back for warranty service and would like a some information to be educated before going.
View 7 Replies
Hate to make a question like this my first post here, but anyway. Just got an '11, 5L, Scab, only have 350 miles on it and absolutely love this thing. Since I've never driven any other '11 F-150 I'm not sure if what I am feeling is normal or not for these trucks. With a light foot, driving around town my truck feels like it has a very slight shutter just before the 2-3 up shift or between 20-25 mph.
I have felt it in the 1-2 up shift but it appears to be intermittent but almost 80% of the time. Had a cup with ice-water in the cup-holder and exactly between 20-25 mph on the 2-3 up shift the water in the glass slightly ripples and caused the ice to slightly chatter. Is this normal or should I take it back and have Ford look at it?
Oh forgot to mention if I give the truck more aggressive throttle pressure I can't feel it, only seems to be low speeds, such as driving through a neighborhood or parking lot. I hoping it just needs to be broken in yet.
View 3 Replies
I have a 2010 Lariat and it randomly gives me fits by not letting me shift out of park. This started yesterday and I want to know where to start looking so I don't get stranded in BFE! Its a center console shifter.
View 2 Replies
My 2011 F150 limited started great bout 3 blocks away from home. The truck glitch. Then it wouldn't shift out of 3rd gear even at take off it was in 3rd. There was also a delay going from fwd to rev. With a clunk as it when in gear. I took it to the dealer ship. EVS Ford Random Lake WI. They were great fast and explained the prob to me. They had to reprogram the tranny. The temp sensor was wigged out n didn't know its own temp so it went into a fail safe mode.
View 1 Replies
I have a 2011 Super Crew, 5.0, 4x2. I've been told this hard shift at low RPM and speed like idling through a parking lot is normal? We bought the truck used a few months ago and I've been told this is normal.
View 4 Replies
My problem is this. I hear my transmission shifting through my heating system. I will explain. When I have my heating system on I hear my transmission shifting like a humming. The transmission shifts just fine. When I turn off my heating system the hum goes away.
The truck is a 2012 F4 ecoboost with 149000 Km or 92000 miles.
View 2 Replies
2014. Noticed the feel and sometimes clunk when shifting to 4 high? My house sits up a hill and this time of year, routinely have to use 4X4 to get up. There is a little more noise and vibration than im use to. Usually shift coming down a semi flat dirt/ice road at low speeds, typically about 10mph. Going in for first oil change soon and was gonna ask them to check it out for peace of mind.
View 6 Replies
So I drove my F150 to work as always, with no problems. I went to leave and it fired right up, but it wouldn't shift out of park. The emergency brake light was on even though the brake was not applied, the traction control light was on even though I wasn't moving, and the tire pressure warning light was on even though all tires are new and inflated properly. I removed the cables from the battery and brushed the contacts even though there was no grime on them, and when I went to start it, it just kept cranking without turning over. So I turned it to off and gave it one more shot and it fired right up, and drove like it was perfectly fine. Why this happened? I got 75k miles on it and have never had a problem...
View 6 Replies
